• Analytical Science and Technology
• /
• v.36 no.5
• /
• pp.224-235
• /
• 2023

An analytical method was developed for the determination of phenol (P) and the seven substituted phenols in water samples and fish tissue samples collected from three streams located in eastern Gangwon State in spring and summer. The phenols were extracted and then derivatized to phenyl acetates using acetic anhydride. The derivatives were subsequently identified and quantified using gas chromatography coupled with mass spectrometry. P and 4-nitrophenol (4NP) were found at relatively high levels in water, ranging from below the method detection limit (MDL) to 3.32 ㎍/L and from < MDL to 4.91 ㎍/L, respectively. P and 4NP were also the dominant compounds in the fish tissue, ranging from < MDL to 407 ㎍/kg and from < MDL to 870 ㎍/kg, respectively. Phenol concentrations were significantly higher in spring than in summer. The ecological risk quotient calculated for P was higher than 4NP but not high enough to pose any risk of adverse effects to fish health.

• Archives of Plastic Surgery
• /
• v.34 no.5
• /
• pp.574-579
• /
• 2007

Purpose: The number of sore patients are increasing steadily, especially in old ages, chronic disease and paralytic patients. Most of patients need to surgical treatment. The aim of this paper is to assess clinical analysis of surgical treatment and to consider operative methods, complications, and recurrences.Methods: We reviewed the data from 82 consecutive patients with 101 pressure sores from March 2003 to May 2006 to discuss the occurrence rate and recurrence rate according to the site on the basis of the presence or absence of paraplegic and its etiology-the patients were categorized into three diagnostic groups: traumatic paraplegics(TP), nontraumatic paraplegics (NTP), and nontraumatic nonparaplegics(NTNP). We examined the sites and sizes of each lesions, patient's state, primary causes of pressure sore, operative methods as each sites and groups, occurrence of complications and recurrences on each groups. Results: In 82 patients, 52 patients were male, 30 patients were female. The male to female ratio was 1.7 :1. Mean age was 55.8 years. 27 patients were in TP group, 35 in NTP group, and 20 in NTNP group, respectively. The common site of sore were sacral area (50.5%), greater trochanteric area(15.8%) and ischial area(13.9%). In each group, incidence rate of recurrence and complication were 11.1%, 40.7% in TP, 5.7%, 5.7% in NTP and 15%, 45% in NTNP. Conclusion: Surgeons must consider the general condition of the patient and possibility of recurrence and returning of daily life. We propose that cutaneous flap, fasciocutaneous flap or skin graft as well as musculocutaneous flap be useful to repair of sore site as each patient's state.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.28 no.1
• /
• pp.49-57
• /
• 2006

Mandibular fractures have higher incidence rate compared to facial bone fractures because of relatively prominent form. Specially, mandibular angle fractures were known as common fracture site because of morphological anatomic structure. The mandibular third molar appears to be the most frequent impacted tooth. The mandibular third molar have influence on mandibular angle fractures according to it's eruption state. Also, the mandibular angle fracture including the third molar may influence on post operative infection whether the third molar is in impacted or extracted state when reduction of fracture site is operated. The presence or absence and degree of impaction of the mandibular third molar were assessed for each patient and were related to the occurrence of the mandibular angle fracture. The extraction or non extraction of the mandibular third molar were related to the occurrence of the post operative infection in the reduction of mandibular angle fractures. In the presence of mandibular third molar, the possibility of mandibular angle fractures were relatively common. When viewing the mandibular third molar at occlusal plane, the possibility of mandibular angle fractures were high in the class C group. The possibility of mandibular angle fractures were high in the mesial angulation and partial impaction. There was a statistically significant difference(P<0.05). In complete erupted mandibular third molar, the possibility of post operative infection occurs quite often, but there was no statistical significant difference(P>0.05). In the extracted or non extracted of mandibular third molar, the post operative infection showed no statistical significant difference(P>0.05). With the results mentioned above, mandibular third molar was significantly more susceptible to mandibular angle fracture. In the reduction of mandibular angle fracture, it was recommended that mandibular third molar should be extracted especially in case of pericoronitis, periodontitis and other infections.

• Korean Journal of Chemical Engineering
• /
• v.35 no.12
• /
• pp.2327-2335
• /
• 2018

Fluid catalytic cracking (FCC) is an important chemical process that is widely used to produce valuable petrochemical products by cracking heavier components. However, many difficulties exist in modeling the FCC process due to its complexity. In this study, a dynamic process model of a FCC process is suggested and its structural observability is analyzed. In the process modeling, yield function for the kinetic model of the riser reactor was applied to explain the product distribution. Hydrodynamics, mass balance and energy balance equations of the riser reactor and the regenerator were used to complete the modeling. The process model was tested in steady-state simulation and dynamic simulation, which gives dynamic responses to the change of process variables. The result was compared with the measured data from operating plaint. In the structural analysis, the system was analyzed using the process model and the process design to identify the structural observability of the system. The reactor and regenerator unit in the system were divided into six nodes based on their functions and modeling relationship equations were built based on nodes and edges of the directed graph of the system. Output-set assignment algorithm was demonstrated on the occurrence matrix to find observable nodes and variables. Optimal locations for minimal addition of measurements could be found by completing the whole output-set assignment algorithm of the system. The result of this study can help predict the state more accurately and improve observability of a complex chemical process with minimal cost.

• Journal of Internet of Things and Convergence
• /
• v.7 no.4
• /
• pp.9-14
• /
• 2021

In computing systems that require high reliability, the method of predicting the lifetime of a storage device is one of the important factors for system management because it can maximize usability as well as data protection. The life of a solid state drive (SSD) that has recently been used as a storage device in several storage systems is linked to the life of the NAND flash memory that constitutes it. Therefore, in a storage system configured using an SSD, a method of accurately and efficiently predicting the lifespan of a NAND flash memory is required. In this paper, a method for optimizing the lifetime prediction of a flash memory-based storage device using the frequency of NAND flash memory failure is proposed. For this, we design a cost matrix to collect the frequency of defects that occur when processing data in units of Drive Writes Per Day (DWPD). In addition, a method of predicting the remaining cost to the slope where the life-long finish occurs using the Gradient Descent method is proposed. Finally, we proved the excellence of the proposed idea when any defect occurs with simulation.

• Journal of radiological science and technology
• /
• v.40 no.1
• /
• pp.143-153
• /
• 2017

As for the current state of college taekwondo athletes' sport injury, times of occurrence and major causes showed differences in weight class and career, while situations of occurrence had differences in grade, weight class, and career. As for the measures to improve their coping ability, first aid showed differences in grade, while prevention of injury had differences in grade and career. Treatment methods turned out to have no differences. For college taekwondo athletes, sport injury occurred during exercise, mostly when they fell. In addition, lack of skill was the greatest major cause of sport injury. As for the sport injury coping ability, ice massage was used as first aid and self-massage was performed. For prevention of injury, sufficient fatigue recovery was considered to be the priority of prevention of injury.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.12
• /
• pp.5-16
• /
• 2016

This study aims to assess the influence of rainfall patterns on shallow landslides initiation. Doing so, five typical rainfall patterns with the same cumulative amount and intensity components comprising Advanced (A1 and A2), Centralized (C), and Delayed (D1 and D2) were designed based on a historical rainstorm event in Jinbu. Mt area. Those patterns were incorporated as the hydrological conditions into the Transient Rainfall Infiltration and Grid-based Regional Slope-stability Model (TRIGRS) to assess their influences on groundwater pressure and changes in the stability of the slope. The results revealed that not only the cumulative rainfall thresholds necessary to initiate landslides, but also the rate at which the factor of safety decreases and the time required to reach the critical state, are governed by rainfall patterns. The sooner the peak rainfall intensity, the smaller the cumulative rainfall threshold, and the shorter the time until landslide occurrence. Left-skewed patterns were found to have a greater effect on landslide initiation. Specifically, among five rainfalls, pattern (A1) produced the most critical state. The severity of response was followed by patterns A2, C, D1, and D2. Our conclusion is that rainfall patterns have a significant effect on the cumulative rainfall threshold, the build-up of groundwater pressure, and the occurrence of shallow landslides.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.4
• /
• pp.51-65
• /
• 2011

Shear banding, the localization of deformation into thin zones, has a quite practical relevance, as stability and deformation characteristics of earth structures are controlled by the soil behavior within the shear band. In this study, for understanding occurrence and developed pattern of shear band, plane strain compression tests were performed on three soils with different particle-size distribution under various conditions. Digital images were captured during the experiments; then, deformation of a specimen was evaluated by digital image analysis technique. The characteristics of a shear band were evaluated from the state shortly after post-peak occurrence to critical state. Additionally, the statistical procedure was developed to determine the reasonable thickness of a shear band.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.202-202
• /
• 2016

Despite the potentially major influence of rainstorm patterns on the prediction of shallow landslides, this relationship has not yet received significant attention. In this study, five typical temporal rainstorm patterns with the same cumulative amount and intensity components comprising Advanced (A1 and A2), Centralized (C), and Delayed (D1 and D2) were designed based on a historical rainstorm event occurred in 2006 in Mt. Jinbu area. The patterns were incorporated as the hydrological conditions into the Transient Rainfall Infiltration and Grid-based Regional Slope-stability Model (TRIGRS), in order to assess their influences on pore pressure variation and changes in the stability of the covering soil layer in the study area. The results revealed that not only the cumulative rainfall thresholds necessary to initiate landslides, but also the rate at which the factor of safety (FS) decreases and the time required to reach the critical state, are governed by rainstorm pattern. The sooner the peak rainfall intensity occurs, the smaller the cumulative rainfall threshold, and the shorter the time until landslide occurrence. Left-skewed rainfall patterns were found to have a greater effect on landslide initiation. More specifically, among the five different patterns, the Advanced storm pattern (A1) produced the most critical state, as it resulted in the highest pore pressure across the entire area for the shortest duration; the severity of response was then followed by patterns A2, C, D1, and D2. Thus, it can be concluded that rainfall patterns have a significant effect on the cumulative rainfall threshold, the build-up of pore pressure, and the occurrence of shallow landslides, both in space and time.

• Proceedings of the KSR Conference
• /
• 2007.11a
• /
• pp.1522-1528
• /
• 2007

Electric Power cable is the apparatus that receives electric power from the Korea Electric Power Corporation and supplies electric power to electric train and annex facilities of each railway station. With substantial ripple effect during power blackout accidents, such power blackout accidents must be coped with by discriminating the status of insulation deterioration of electric power cable in advance. Discrimination of insulation deterioration of the electric power cable is normally executed while the power is disconnected and it is very difficult to discover, at early stage, the insulation deterioration of the power cable in operational state since the duration of inspection is limited. This research aims to consider method of diagnosing the insulation deterioration of electric power cable in On-Line state rather than diagnosis in Off-Line state in order to secure reliability of power supply by reducing duration of power blackout (accidental blackout and blackout during works) and by seeking reduction in equipment and manpower used in diagnosis of deterioration through prevention of the accident itself prior to occurrence through early restoration of accident due to insulation deterioration of the electric power cable and assessment of performance of the cable under operation.