• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.26 no.3
• /
• pp.237-243
• /
• 1990

For the improvement of the traditional pots which is using purple spirals for fishing webfoot octopus, Octopus Ocellatus GRAY, some experiments are carried out on the color preference in water tank and also operated practical experiment with PVC pots at sea for the comparison on the basis of the above water tank experiment. The results obtained are as follows: 1. The colors which webfoot octopus prefer in water tank or at sea are gray, red and green in order. 2. The catching efficiency of the pots with small spout(dia. 40mm) is better than that of large spout(dia. 50mm). 3. The results of fishing efficiency between PVC pots and purple spirals are shown almost same tendency.

• Korean journal of food and cookery science
• /
• v.28 no.5
• /
• pp.599-604
• /
• 2012

In this study, the prevalence of microbiological hazard on water purifiers at lunchroom in child care center was investigated. A total of 49 water purifiers and their purified cold water were sampled to test about the total aerobic bacteria, coliform bacteria, Bacillus cereus, Staphylococcus aureus, and Salmonella spp. Total aerobic bacteria was detected over 2.0 log CFU/mL in 6 out of 49 purified cold water (12.2%), ranged from 2.0 to 2.4 log CFU/mL, and the average number of total aerobic bacteria was showed to be 3.3 log CFU/drain spout. The drain spout turned out to be a major contaminant in water purifier and needs to be improved. Coliform bacteria were also detected in 7 out of 49 cold faucets (14.3%) and 7 out of 49 drain spouts (14.3%), but not detected in purified cold water. All samples were not contaminated with the pathogens tested in this study, except for B. cereus, which was contaminated on 2 out of 49 cold faucets (4.1%) and 4 out of 49 drain spouts (8.2%). All of B. cereus isolates produced enterotoxin, such as heamolysin BL enterotoxin (HBL) or non-heamolytic enterotoxin (NHE). The HBL was detected in 5 out of 6 B. cereus isolates (83.3%), including B. cereus PCF-11 and B. cereus PDS-30 isolate only produced NHE (16.7%). These results showed that the sanitary conditions of cold faucets and drain spouts should be improved promptly.

• Food Science and Preservation
• /
• v.4 no.3
• /
• pp.259-264
• /
• 1997

To improve freshness of onion(Allium cepa), it was packed with various packaging films and stored at 5$^{\circ}C$ until 52 days. During the storage, internal gas composition, weight loss, spout ratio, decay ratio, surface color were determined. The used packaging films are two-perforated LDPE (control), LDPE, CPP/OPP/PE, Nylon/PE and Ag-zirconium filled LDPE. Onions were prepared by peeling or dipping in GFSE(grape fruit seed extract) and packed under vacuum or atmosphere with the selective films. Anaerobic condition was shown in the Nylon/PE package after 4 days and, thus weight loss, sprout ratio and color were considerably poor. All onions in the vacuum package after 15 days were spouted. Onions in CPP/OPP/PE and functional film(Ag-zirconium filled LDPE) package showed aerobic respiration until 52 days. Thus, the quality of onions in these packages was superior to the control.

• Journal of the Korean Society for Railway
• /
• v.8 no.2
• /
• pp.128-136
• /
• 2005

The reinforcing subgrade, which first introduced Korea for the highspeed subgrade construction, has the many advantages to maintain the quality of ballast track as well as to prevent the softening of subgrade by mud-pumping. It causes the subgrade soil to spout into the ballast on many lines. Therefore, the application of reinforcing subgrade will be expected to increase in the future. This paper introduces the reinforcing subgrade as a maintenance-free technology f3r the railroad operation and the method f3r the determination of reinforcing subgrade depth. The criteria on reinforcing subgrade depths of highspeed and conventional railroad were verified from the calculation results based on an elastic analysis method.

• Korean Journal of Materials Research
• /
• v.14 no.2
• /
• pp.157-162
• /
• 2004

The object of this research is to develop a carbon molecular sieve(below CMS) which can separate selectively to convert mixture gases spout at waste landfill into fuel. And this research is meaningful from the viewpoint of a quality improvement of CH$_4$ gas and an utilization of by-product. CMS was prepared using coconut shell powder as starting material and the effects of activators, temperature and modifier on the reaction were investigated in this research. Also, pore diameter, surface area of CMS and adsorption rate were measured and studied by cahn balance and ASAP2010. Its specific surface area and pore distribution were controlled easily at 800^{\circ}C and adsorption rate was very good. The CMS prepared in this research is shown to be able to separate landfill gases very effectively.

• 한국연소학회:학술대회논문집
• /
• 2013.06a
• /
• pp.11-12
• /
• 2013

To investigate the effect of an inner diameter of the extension tube on the self-ignition when high pressurized hydrogen abruptly released through a tube, both experimental and numerical approach are used. The result show that there is a possibility to have successful ignition when the tube diameter is decreased even at the pressure that could not give sustainable flame with a larger diameter tube. Numerical simulation show the flame development inside the tube and weak and stretch flame spout the tube for 10.9 mm tube, whereas strong complete flame has been generated for 3 mm tube.

• 한국가시화정보학회:학술대회논문집
• /
• 2002.11a
• /
• pp.85-88
• /
• 2002

In order to visually analyze the flow characteristics, gas was injected into the liquid bath through nozzle installed at the center of bottom of the bath. When gas was injected into the liquid bath, several flow patterns were observed bubble-liquid plumb, the spout flow that occurred at the free surface, liquid circulation flow by bubble's behavior, etc. Various bubbles, from small bubbles to Taylor bubbles, consisted of the bubble-liquid plumb. In the pure liquid region, the large and small several vortices were formed and irregularly circulated. These irregular repetition and circulation play a important role of mixing in the bath. The vortices were developed in the upper and the side wall regions and the movement of flow in the low region was very small. It is known as 'dead zone'.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.43 no.8
• /
• pp.1228-1235
• /
• 2014

We investigated the antioxidant activities and effects of soy-sprout extracts (SE) against $H_2O_2$-induced oxidative stress in HepG2 cells. The major free amino acids were asparagine, valine, pheylalanine, histidine, isoleucine, and leucine in SE. Both soy-spout extract by enzyme (SEE) and soy-spout extract by ultra high pressure (SEP) showed higher contents compared with soy-sprout water extract (SEW). The total polyphenol and isoflavone contents were highest in SEE. SEE had the highest DPPH and ABTS radical scavenging activities as well. To determine the effects of SE on $H_2O_2$-induced oxidative damage, cell viability was measured using XTT assay. Pre-treatment with SEE and SEP significantly increased cell viability compared with $H_2O_2$-treated control cells by 29% and 32%, respectively. These results indicate that SEE and SEP possess antioxidant activity.

• Tribology and Lubricants
• /
• v.24 no.4
• /
• pp.186-189
• /
• 2008

The flow induced vibration in the nuclear fuel assembly causes the fretting wear between the fuel cladding tubes and the supporting grids. The reduction in tube thickness due to the fretting wear could be related to the serious damage on nuclear fuel assembly. In this paper, the effect of the water flow on fretting wear of nuclear fuel cladding tube against supporting grid was investigated through the fretting wear tester with water spout equipment. The test results were compared with the data conducted in the stationary water. At stationary water environment the wear debris was trapped between fretting surfaces, and then the fretting wear occurred by three-body abrasion. However, in the case of water flow, the two-body abrasive wear was the dominant wear mechanism, because the wear debris was easily removed by water flow.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 1993.10a
• /
• pp.686-695
• /
• 1993

A flywheel-type, inclined axis chopper for small-area rice and livestock farmers, has been developed at IRRI Agricultural Engineering, The prototype is belt-driven by a 2.6kW engine and uses four angled blades rotating below a fixed counteredge. Manual feeding is facilitated by a convenient spout presenting the crop to the inclined blade housing and also suction created by the rotating blades . The distance between the rotating blades and the bottom of the housing determines the length of chops, set here for 25 cm. The unit would cost $200 without the engine. Tests with napier grass, corn stalks , and rice straw showed satisfactory performance within the acceptable clearance, speed and moisture content ranges of the material presented. Highest capacities were 1186, 1148 and 744kg/hr for napier grass, corn stalks and rice straw, respectively. Corn stalks required the highest power demand at 2.3kW engine would be adequate as power source. The chopper performance was comparable to higher cost commercial chippers in terms of capacity and specific energy.