• Journal of the Semiconductor & Display Technology
• /
• v.20 no.2
• /
• pp.87-91
• /
• 2021

Various Cu ions are discharged into water from various industries, which results in a severe trouble for groundwater, soil, air, and eventually animals and humans. In this work, graphene oxide (GO) is introduced as a Cu removal absorber and the real-time monitoring method is demonstrated. The results show that GO is a very effective material to absorb Cu ions in the solution. In addition, the residual Cu ions in the solution is monitored via optical transmittance method, which well match with Inductively Coupled Plasma Mass Spectrometer (ICP-MS) analysis.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.955-962
• /
• 2008

This study concerns the effect of drainage in reinforced soil on its stability during rainfall. A series of finite-element analysis based transient seepage analysis were performed on a number of cases with different drainage conditions in terms of layers of geotextiles installed in the reinforced zone. The results were then coupled with the limit-equilibrium slope stability analysis to investigate the variation of global stability factor of safety with rainfall infiltration into the reinforced wall. The results were thoroughly analyzed to get insight into the mechanism of pore water pressure reduction effect of the geotextile and into its effect on overall slope stability. It is shown that layers of geotextile installed in the reinforced zone can prevent decrease in suction in the reinforced zone during rainfall, thereby reducing potential risk of decreasing shear strength of the reinforced zone. Practical implications of the findings were discussed.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.27 no.4
• /
• pp.94-103
• /
• 2023

Built in urban ares tunnels is necessary to accurately grasp not only the above-ground environment of the tunnel but also the below-ground environment of the tunnel for design and construct. However, fully coupled analysis of stress and flow is very difficult due to the limited function of the tunnel numerical analysis program and difficulty in using program. This can lead to excessive design that increases the construction cost or occur problems that can lead to accidents during construction. In particular, in the case of an urban tunnel has a low layer soil section above the tunnel and the groundwater level exists in the upper layer of the tunnel. Therefore, a reduction in the groundwater level during underground construction may increase the effective stress of the upper layer and cause the ground to subsidence. So It is necessary to design after accurately evaluating the change in the groundwater level. In this study, the tunnel's behavioral characteristics were analyzed through fully coupled analysis of stress and flow according to the drainage type for an urban underground tunnel.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.10
• /
• pp.173-181
• /
• 2006

A Two Mobilized-Plane Model is proposed for monotonic and cyclic soil response including liquefaction. This model is based on two mobilized planes: a plane of maximum shear stress, which rotates, and a horizontal plane which is spatially fixed. By controlling two mobilized planes, the model can simulate the principal stress rotation effect associated with simple shear from different $K_0$ states. The proposed model gives a similar skeleton behaviour for soils having the same mean stress, regardless of $K_0$ conditions as observed in laboratory tests. The soil skeleton behaviour observed in cyclic drained simple shear tests, including compaction during unloading and dilation at large strain is captured in the model. Undrained monotonic and cyclic response is predicted by imposing the volumetric constraint of the water on the drained or skeleton behaviour. This constitutive model is incorporated into the dynamic coupled stress-flow finite difference program of FLAC (Fast Lagrangian Analysis of Continua). The model was first calibrated with drained simple shear tests on Fraser River sand, and verified by comparing predicted and measured undrained behaviour of Fraser River sand using the same input parameters.

• Journal of the Korean Geotechnical Society
• /
• v.38 no.9
• /
• pp.45-52
• /
• 2022

Because discontinuity in the rock mass and contact of soil-structure interaction exhibits coupled thermal-hydromechanical (THM) behavior, it is necessary to develop an interface element based on the full governing equations. In this study, we derive force equilibrium, fluid continuity, and energy equilibrium equations for the interface element. Additionally, we present a stiffness matrix of the elastoplastic mechanical model for the interface element. The developed interface element uses six nodes for displacement and four nodes for water pressure and temperature in a two-dimensional analysis. The fully coupled THM analysis for fluid injection into a fault can model the complicated evolution of injection pressure due to decreasing effective stress in the fault and thermal contraction of the surrounding rock mass. However, the result of hydromechanical analysis ignoring thermal phenomena overestimates hydromechanical variables.

• Korean Journal of Environmental Agriculture
• /
• v.28 no.1
• /
• pp.38-46
• /
• 2009

Livestock manure is an important source of nutrients for crop production. However, farmers typically do not know the exact nutrient values for livestock manure. In many instances, manure has been viewed as a waste, and as a result it is applied close to the source resulting in over application of nutrients. Thus, the goal of nutrient application has often been applied to reduce the application expense rather than to maximize crop income. This results in wasted money and potentially negative impacts on water quality. Several livestock manure management scenarios were created based on agronomic nutrient requirements using the Utilization of Animal Manure as a Plant Nutrient (AMANURE) software to investigate water quality impacts with the National Agricultural Pesticide Risk Analysis (NAPRA) WWW modeling system. Application of manure at agronomic rates can result in high nitrate-nitrogen losses for some soil types, especially when applied in late fall. The application of manure at an agronomic rate does not necessarily equate to adequate water quality protection, and farmers must take care applying manure at agronomic rates, because nitrate-nitrogen loss potential varies spatially and temporarily. Nutrient loss probability maps for Indiana at 5%, 10%, 25%, and 50% values were created to demonstrate potential water quality impacts when livestock manure is applied to cropland at agronomic rates. The NAPRA WWW system coupled with AMANURE can be used to identify site-specific livestock manure management plans that are environmentally sound and agronomically appropriate.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.38 no.4
• /
• pp.517-526
• /
• 2018

As groundwater recharge shows the heterogeneity in space and time due to land use and soil types, estimating daily recharge by integrated hydrologic analysis is needed. In this work, the SWAT-MODFLOW model was applied to compute daily based groundwater recharge in Jangseong region. The accuracy of the model was evaluated by comparing the observed and calculated values of the unsteady groundwater flow levels after calibrating the observed and calculated flow rates of the stream for a hydrological analysis. The estimated hydrologic components showed a strong correlation with each other and significant spatial variations regarding the groundwater recharge rate in accordance with the heterogeneous watershed characteristics such as subbasin slope, land use, and soil type. Overall, it was concluded that the coupled hydrologic models were capable of simulating the spatial variation with respect to the hydrologic component process in surface water and groundwater. The average recharge rate was estimated at approximately 20.8%.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.2
• /
• pp.35-47
• /
• 2017

Thermal behavior of soils is mainly focused on thermal conduction, and the study of natural convection is very limited. Increase of soil temperature causes natural convection due to buoyancy from density change of pore water. The limitations of the analysis using fluid dynamics for natural convection in the porous media is discussed and a new numerical analysis is presented for natural convection in porous media using THM governing equations fully coupled in the macroscopic view. Numerical experiments for thermal probe show increase in the uncertainty of thermal conductivity estimated without considering natural convection, and suggest appropriate experimental procedures to minimize errors between analytical model and numerical results. Burial of submarine power cable should not exceed the temperature changes of $2^{\circ}C$ at the depth of 0.2 m under the seabed, but numerical analysis for high permeable ground exceeds this criterion. Temperature and THM properties of the seafloor are important design factors for the burial of power cable, and in this case effects of natural convection should be considered. Especially, in the presence of heat sources in soils with high permeability, natural convection due to the variation of density of pore water should be considered as an important heat transfer mechanism.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2022.05a
• /
• pp.365-365
• /
• 2022

강우에 따른 유역 내 유출량은 수문순환에서 중요한 요소 중 하나이며, 과거부터 강우-유출 모델링을 위한 여러 물리적 수문모형들이 개발되어왔다. 또한 최근 딥러닝 기술을 기반으로한 강우-유출 모델링 접근 방식이 유효함을 입증하는 여러 연구가 수행됨에 따라 딥러닝을 기반으로한 유출량 모의 연구도 활발히 진행되고 있다. 따라서 본 연구에서는 물리적 수문모형인 SWAT(Soil Water Assessment Tool)과 딥러닝 기법 중 하나인 LSTM(Long Short-Term Memory)을 사용하여 연구대상지 유출량을 모의했으며, 두 모형에 의해 모의 된 유출량의 극값을 비교 분석했다. 연구대상지로는 영산강 유역을 선정했으며, 영산강 유역의 과거 기간의 기후 변수 모의를 위해 CMIP(Coupled Model Intercomparison Project)6 GCM(General Circulation Model)을 사용했다. GCM을 사용하여 모의 된 기후 변수들은 영산강 유역 내 기상관측소의 과거 기간 관측 값을 기반으로 분위사상법을 사용하여 편이보정 됐다. GCM에 의해 모의 된 기후 변수 및 SWAT, LSTM에 의해 모의 된 유출량은 각각 영산강 유역 내 기상관측소 및 수위관측소의 관측 값을 기반으로 재현성을 평가했다. SWAT 및 LSTM을 사용하여 모의 된 유출량의 극값은 GEV(General Extreme Value) 분포를 사용하여 추정하였다. 결과적으로 GCM의 기후 변수 모의 성능은 과거 기간 관측 값과 비교했을 때 편이보정 후에서 상당히 향상되었다. 유출량 모의 결과의 경우 과거 기간 유출량의 관측 값과 비교했을 때 LSTM의 모의 유출량이 SWAT보다 과거 기간 유출량을 보다 근접하게 모의했으며, 극값 모의 성능의 경우 또한 LSTM이 SWAT보다 높은 성능을 보였다.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.51 no.5
• /
• pp.25-34
• /
• 2009

The objective of this study is to evaluate the future potential climate and vegetation canopy change impact on a dam watershed hydrology. A $6,661.5\;km^2$ dam watershed, the part of Han-river basin which has the watershed outlet at Chungju dam was selected. The SWAT model was calibrated and verified using 9 year and another 7 year daily dam inflow data. The Nash-Sutcliffe model efficiency ranged from 0.43 to 0.91. The Canadian Centre for Climate Modelling and Analysis (CCCma) Coupled Global Climate Model3 (CGCM3) data based on Intergovernmental Panel on Climate Change (IPCC) SRES (Special Report Emission Scenarios) B1 scenario was adopted for future climate condition and the data were downscaled by artificial neural network method. The future vegetation canopy condition was predicted by using nonlinear regression between monthly LAI (Leaf Area Index) of each land cover from MODIS satellite image and monthly mean temperature was accomplished. The future watershed mean temperatures of 2100 increased by $2.0^{\circ}C$, and the precipitation increased by 20.4 % based on 2001 data. The vegetation canopy prediction results showed that the 2100 year LAI of deciduous, evergreen and mixed on April increased 57.1 %, 15.5 %, and 62.5% respectively. The 2100 evapotranspiration, dam inflow, soil moisture content and groundwater recharge increased 10.2 %, 38.1 %, 16.6 %, and 118.9 % respectively. The consideration of future vegetation canopy affected up to 3.0%, 1.3%, 4.2%, and 3.6% respectively for each component.