• 한국환경복원기술학회지
• /
• 제9권2호
• /
• pp.16-22
• /
• 2006

This study was carried out to estimate the physical and chemical soil characteristics in highway cutting slope areas. The soil was sampled in cutting area and natural vegetation area that was located in the upper areas of the highway cutting slope. The average total soil depth, bulk density, and soil hardness were bad in the highway cutting slope sites. The sandy loam was the most soil texture in the study area. The concentration of soil organic matter and nitrogen were very low in all highway cutting areas. The concentration of exchangeable cations was similar between the highway cutting slope and the natural vegetation sites in each highway. The soil pH was higher in highway cutting slope areas than in natural vegetation sites. In conclusion, chemical and physical properties of soil were bad in the cutting slope than in the natural vegetation area because of the loss of soil by cutting of slope area and less organic matter input by less vegetation in the highway cutting slope area. We should employ possible method to reduce the loss of soil, and compost and fertilization treatment could help to increase soil nutrient content in the cutting slope area.

• Geomechanics and Engineering
• /
• 제23권6호
• /
• pp.513-521
• /
• 2020

In this paper, due to the need for cutting cement-soil group pile composite foundation under the 7-story masonry structure of Zhenghe District and the shield tunnel of Zhengzhou Metro Line 5, a field test was conducted to directly cut cement-soil single pile composite foundation with diameter Ф=500 mm. Research results showed that the load transfer mechanism of composite foundation was not changed before and after shield tunnel cut the pile, and pile body and the soil between piles was still responsible for overburden load. The construction disturbance of shield cutting pile is a complicated mechanical process. The load carried by the original pile body was affected by the disturbance effect of pile cutting construction. Also, the fraction of the load carried by the original pile body was transferred to the soil between the piles and therefore, the bearing capacity of composite foundation was not decreased. Only the fractions of the load carried by pile and the soil between piles were distributed. On-site monitoring results showed that the settlement of pressure-bearing plates produced during shield cutting stage accounted for about 7% of total settlement. After the completion of pile cutting, the settlements of bearing plates generated by shield machine during residual pile composite foundation stage and shield machine tail were far away from residual pile composite foundation stage which accounted for about 15% and 74% of total settlement, respectively. In order to reduce the impact of shield cutting pile construction on the settlement of upper composite foundation, it was recommended to take measures such as optimization of shield construction parameters, radial grouting reinforcement and "clay shock" grouting within the disturbance range of shield cutting pile construction. Before pile cutting, the pile-soil stress ratio n of composite foundation was 2.437. After the shield cut pile is completed, the soil around the lining structure is gradually consolidated and reshaped, and residual pile composite foundation reaches a new state of force balance. This was because the condensation of grouting layer could increase the resistance of remaining pile end and friction resistance of the side of the pile.

• 한국농업기계학회:학술대회논문집
• /
• 한국농업기계학회 1993년도 Proceedings of International Conference for Agricultural Machinery and Process Engineering
• /
• pp.1095-1101
• /
• 1993

This paper discussed the action on soil of two-sided wedge in high speed curve movement, with the emphasis on the deformation of soil and its cutting resistance.

• 한국산림과학회지
• /
• 제42권1호
• /
• pp.59-66
• /
• 1979

삽목(揷木)에 있어서 삽상(揷床)의 수분상태(水分狀態)와 상대습도(相對濕度)가 삽목(揷木)의 발근(發根)에 미치는 영향(影響)을 포장실험(圃場實驗)한 결과(結果)는 다음과 같다. 1. 춘삽(春揷)에서는 상대습도(相對濕度)가 70~80%의 수준(水準)에서 발근본수(發根本數)가 가장 많았으나, 하삽(夏揷)의 경우는 90~100%의 수준(水準)에서 많았다. 2. 삽상(揷床)의 수분상태(水分狀態)는 춘삽(春揷)의 경우 0~-0.006bar에서 발근본수(發根本數)가 가장 적었으나 하삽(夏揷)의 경우는 -0.049~-0.124bar일 때 발근본수(發根本數)가 가장 많았다. 3. 상대습도(相對濕度)와 발근본수간(發根本數間)에는 춘삽(春揷)의 경우에만 유의성(有意性)이 인정되었으나 삽상(揷床)의 수분상태(水分狀態)와 발근본수간(發根本數間)에는 춘(春) 하(夏) 추삽(秋揷) 모두에서 유의성(有意性)이 인정되었다.

• 한국초지조사료학회지
• /
• 제10권2호
• /
• pp.96-101
• /
• 1990

This field experiment was undertaken to find out the effect of grazing and cutting management on the forage quality and soil hardness at different legumes sown swards of the experimental field of Livestock Experiment Station in Suweon, from August 1985 to October 1988. The results obtained are as follows: 1. Crude protein, crude fat and ash contents under grazing were higher than these under cutting, but showed the reverse results in crude fiber and nitrogen free extracts contents. Average in vitro dry matter digestibility (IVDMD) under grazing (72 %) was a little higher than that under cutting (71 %). On the other hand, there was little difference among the mixtures swards in mineral contents and IVDMD. 2. The contents of Ca, P and Mg were a little high in the cutting, but K and Na contents were in gazing. Ca: P ratio in grazing (2.97) was slightly higher than that of cutting (2.94). 3. Production of energies(TDN, StE and NEL) with cutting were appeard to increase by 19.4 %, 13.5 %and 19.0 % than those of grazing, respectively. Mixtures swards including alfalfa showed more production both grazing and cutting. 4. Soil hardness in the top lOcm of soil by cattle grazing was changed from 15.5mm at startihg year to 22.6 mm after 3 years, but in cutting slightly increase from 15.5mm to 16.2mm. Generally it was low in early spring and high in autumn.

• Journal of Biosystems Engineering
• /
• 제4권1호
• /
• pp.48-57
• /
• 1979

In order to obtain a standard reference for designing an adequate power rice transplanter, the cutting forces depending upon variety of seedling, sowing density, seedling age and soil moisture content of mat-type seedling were measured by the rice transplanter installed with force measuring device of dynamic strain gage system in the laboratory. The result of this study are summarized as follows : 1. Cutting velocity and acceleration transplanting hoe obtained from jinematic analysis of planting mechanism was 1.32m/sec and 81.5m/$sec^2$ when planting crank-shaft rpm was 160. 2. Little difference between cutting forces on 30-days old seelings of japonica and Indica type was observed, as the cutting forces determined were 2.0kg per hill for Japonica type and 2.1kg per hill for Indica type. 3. Cutting forces determined on 40-days old seedlings were 2.5kg, 2.3kg, 3.1kg and 2.9kg per hill for Milyang No.15, Tongil, Akibare and Milyang No.23 compared to the other varieties. 4. The cutting force was not greatly affected by the sowing densities , only five percent of differences were observed epending upon the sowing densities. 5. Cutting forces were 2.7kg and 2.0kg per hill on 40-days old seedlings and 30-days old seedlings respectively. About 38 percent of more forces was required in cutting 40-days old seedling than in cutting 30-days old seedlings. 6. More cutting forces were required as soil moisture content of mat-type seedling was decreased. 7. Root length after cutting by the planting hoe and their relationships with soil moisture content on 30-days old seedlings, are as follows ; $y=4.147-11.384x+ 28.854x^2$ where , $y$=root length after cutting. (cm) , $x$=soil ture content of mat type seedlings.(%, d.b.) 8. Cutting forces were varied with the width of cuttings ; those on 40-days old mat type seedlings were 2.7kg and 2.2kg per hill when cutting with 14 mm and 10mm of width respectively, about 32 percent of more forces was required when cuting with 14mm of width compared to 10mm of width.

• 한국농업기계학회:학술대회논문집
• /
• 한국농업기계학회 1993년도 Proceedings of International Conference for Agricultural Machinery and Process Engineering
• /
• pp.1073-1087
• /
• 1993

Many investigations have been carried out concerning tillage tool performance, including energy requirement . Since the performance of tillage could also be evaluated through the change of soil , then it is necessary to investigate the soil cutting process and the pattern of soil failure. This study was conducted using indoor soil bin, STILT (Soil Tillage Tool Interaction) system. The result shows that the soil bin experiments could provide the clear understandings about phenomena of soil failure. The movement of sil , the successive failures was clearly visualized. The relations between the horizontal and vertical forces to the linear motion blade, the shear force on the shear plane which devides soil layer into several segments were indicated by the fluctuation/vibration of the recorded resistance and forces. The results show that the horizontal force(Fx) and vertical force (Fz) develope their frequencies as the change of velocity of blade (10, 20, 40 mm/sec) for each cutting angle (35, 45, 60 degrees). Resultant force of Fx and Fz are much influenced by the cutting angle.

• 생약학회지
• /
• 제7권1호
• /
• pp.59-61
• /
• 1976

The purpose of the study is to investigate the possibility of cutting of Eucommia ulmoides $O_{LIV}.$ (Eucomiaceae) by using various soils in Korea. Four different kinds of soil, such as sand, red cray, red cray plus sand and Masa soil, were used in the investigation. It was found that total length, number and rate of rooting were most prominent in the cutting cultivated in Masa soil.

• Journal of Forest and Environmental Science
• /
• 제18권1호
• /
• pp.7-14
• /
• 2001

본 연구는 집중호우로 인하여 절토사면의 붕괴가 발생한 임도를 대상으로 수량화이론(II)을 이용하여 붕괴요인을 평가하였다. 그 결과는 다음과 같다. 임도 절토사면의 붕괴발생에 미치는 요인의 영향은 절토사면길이, 겉보기 토질, 사면방위, 절토사변경사, 산지경사 등 5개 요인이 가장 크게 나타났다. 특히, 절토사면길이는 8m 이상, 겉보기 토질은 토사, 사면방위는 북사면, 절토사변경사는 $60^{\circ}$이상, 산지경사는 $35{\sim}40^{\circ}$ 사이에서 사면붕괴에 기여도가 가장 크게 나타났다.

• 한국토양비료학회지
• /
• 제43권6호
• /
• pp.1047-1050
• /
• 2010

본 연구는 논토양 비옥도에 대한 예취높이별 볏짚 혼입효과를 구명하고자 수행하였다. 예취높이별 잔존량은 1,420 kg $ha^{-1}$ (10 cm), 1,850 kg $ha^{-1}$ (15 cm), 2,400 kg $ha^{-1}$ (20 cm)를 나타냈다. 볏짚 혼입으로 토양경도, 용적밀도는 낮아졌고 공극률이 증가하여 토양물리성이 개선되었다. 볏짚 수거로 토양유기물, 유효인산 및 유효규산 함량이 적어지고 양이온치환용량이 낮아졌다. 토양에 볏짚 혼입시 비옥도 감소 폭이 적었고 예취높이별 잔존량이 많을수록 혼입효과가 크게 나타났다. 볏짚혼입에 따라 수수, 영화수 확보가 많고 등숙비율이 높아졌으며 쌀수량은 관행 (3.67 Mg $ha^{-1}$)대비 28~32% 증수되었다. 연구결과 예취방법에 의하여 볏짚을 혼입한 재배기술이 수거에 비하여 쌀수량을 증가시켰고 논토양을 개선하였다.