• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.425-428
• /
• 2011

This paper presents a micro-scale solar energy harvesting circuit with a simple MPPT control. Solar Energy is harvested using a small off-chip PV cell generating output voltages under 0.5V instead of an on-chip PV cell. A simple MPPT is implemented using a pilot PV cell and utilizing the relationship between the open-circuit voltage of a PV cell ($V_{OC}$) and its MPP voltage ($V_{MPP}$). With applying the MPPT control, the designed circuit delivers the MPP voltage to load even though the loads is heavy such that the load circuit can operate properly. The proposed circuit is designed in TSMC 0.18um CMOS process.

• BMB Reports
• /
• v.29 no.5
• /
• pp.442-447
• /
• 1996

Mutations in codon 12, 13 and 61 of one of the three ras genes, H-ras, K-ras and N-ras, convert these genes into active oncogenes. The presence of H-ras gene mutations have important prognostic implications in various cancers. In this study, the H-ras gene mutations were investigated by two-step PCRRFLP in patients with bladder and stomach cancer. For the control experiments, T24 and SK2 cell lines were used. In a total of 36 bladder cancer patient cases, five (13.9%) mutations were found by this method. Of these, point 12 mutations were two (5.6%) cases and point 61 mutations were three (8.3%) cases. On the other hand, H-ras mutation was not found in 29 cases of stomach cancer. The results of the mutated H-ras gene confirmed by direct sequencing analysis were correlated well with PCR analysis. From the sensitivity test, the H-ras mutation was found to have about 0.2% of mutated DNA mingled in normal DNA. In conclusion, the H-ras mutation has a higher clinical Significance in bladder cancer than stomach cancer. Moreover the two-step PCR-RFLP method is sensitive, rapid and relatively simple for clinical work in detecting H-ras point mutations.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.2
• /
• pp.180-185
• /
• 2017

In this research, we proposed the simple and efficient method to calculate the shear stresses by using the mid-point measurements in ${\pm}45^{\circ}$ semiconductor resistor-sensor pair. Compared to the previous works, the measurements became much simpler by combining the approximation theory with the technique of mid-point measurement. In addition, we proposed another novel method for the stress calculation in which we could increase the sensitivity of the stress sensor by controlling the applied voltage between the sensor-pair. For the applied voltage of 8 V, the sensitivity showed a significant increase by 100%.

• Proceedings of the KIPE Conference
• /
• 2001.10a
• /
• pp.622-625
• /
• 2001

Photovoltaic generation systems need MPPT (Maximum Power Point Tracking) control because the output power depends on the operating voltage and current. Therefore, many researchers propose various types of MPPT control methods. A new MPPT control scheme is proposed in this paper in order to realize higher efficiency with simple calculation. The line search algorithm with fibonacci sequence which is one of the optimizing method is employed for the MPPT. The line search method is modified for real-time operation. The method is verified by simulations and experiments. It is concluded that the scheme can respond fast variation of irradiance.

• Proceedings of the KIPE Conference
• /
• 2001.10a
• /
• pp.635-638
• /
• 2001

Photovoltaic (PV) pumping systems with maximum power point tracking (MPPT) technique aims at obtaining the highest possible power to the pump under various insolation and temperature, thus overcomes the mismatch between the photovoltaic panel and the pumping load. A simple method of tracking the maximum power points and forcing the system to operate close to these points is presented in this paper. The MC68HC908GP32 micro control unit (MCU) is employed to implement the proposed MPPT controller. Experimental results will also show the performances of the photovoltaic pumping system with the MPPT technique.

• International Journal of Aeronautical and Space Sciences
• /
• v.10 no.1
• /
• pp.37-45
• /
• 2009

A method of conflict detection and resolution is described by using simple geometric approach. Two VAVs are dealt with and considered as point masses with constant velocity. This paper discusses en route aircraft which are assumed to be linked by real time data bases like ADS-B. With this data base, all DAVs share the information each other. Calculating PCA (Point of Closest Approach), we can evaluate the worst conflict condition between two VAVs. This paper proposes one resolution maneuvering logic, which can be called 'Vector Sharing Resolution'. In case of conflict, using miss distance vector in PCA, we can decide the directions for two VAVs to share the conflict region. With these directions, VAVs are going to maneuver cooperatively. First of all, this paper describes some '2-D' conflict scenarios and then extends to '3-D' conflict scenarios.

• KCI Concrete Journal
• /
• v.11 no.3
• /
• pp.211-221
• /
• 1999

A method to determine the fracture energy of concrete is investigated. The fracture energy may be calculated from the area under the complete load-deflection curve which can be obtained from a stable three-point bend test. Several series of concrete beams have been tested. The Present experimental study indicates that the fracture energy decreases as the initial notch-to-beam depth ratio increases Some problems to be observed to employ the three-point bend method are discussed. The appropriate ratio of initial notch-to-beam depth to determine the fracture energy of concrete is found to be 0.5. It is also found that the influence of the self-weight of a beam to the fracture energy is very small A simple and accurate formula to predict the fracture energy of concrete is proposed.

• 제어로봇시스템학회:학술대회논문집
• /
• 1990.10b
• /
• pp.1071-1076
• /
• 1990

This paper proposes a navigation strategy of multiple autonomous mobile robots with communication within a specified space. Assuming that each robot has complete detectability with finite range, simple navigation strategy is derived by introducing repulsive forces between robots and attractive force between a robot and its goal point analogous to those between electric charges. When a robot is close to its goal point, a pseudo-domain based on the distance between the closest point of the domain boundary and the goal point is proposed to enhance its convergence to the goal state. This paper concludes with the results of computer simulation studies on the dynamic behavior of multiple interacting robots with the proposed navigation strategy.

• International Journal of Contents
• /
• v.11 no.2
• /
• pp.9-14
• /
• 2015

We propose a new distance measure between 2-dimensional points to provide a total order for an entire point set and to reflect the correct geometric meaning of the naturalness of the point ordering. In general, there is no total order for 2-dimensional point sets, so curve reconstruction algorithms do not solve the self-intersection problem because the distance used in the previous methods is the Euclidean distance. A natural distance based on Brownian motion was previously proposed to solve the self-intersection problem. However, the distance reflects the wrong geometric meaning of the naturalness. In this paper, we correct the disadvantage of the natural distance by introducing a polar-natural distance, and we also propose a new curve reconstruction algorithm that is based on the polar-natural distance. Our experiments show that the new distance adequately reflects the correct geometric meaning, so non-simple curve reconstruction can be solved.

• Geomechanics and Engineering
• /
• v.23 no.2
• /
• pp.115-125
• /
• 2020

This study aims to explore practical and useful equations for rapid evaluation of uniaxial compressive strength of concrete (UCS-C) during the preliminary design stage of aggregate selection. For this purpose, aggregates which were produced from eight different intact rocks were used in the production of concretes. Laboratory experiments involved the tests for uniaxial compressive strength (UCS-R), point load index (PLI-R), P wave velocity (UPV-R), apparent porosity (n-R), unit weight (UW-R) and aggregate impact value (AIV-R) of the rock samples. UCS-C, point load index (PLI-C) and P wave velocity (UPV-C) of concrete samples were also determined. Relationships between UCS-R-rock parameters and UCS-C-concrete parameters were developed by regression analyses. In the simple regression analyses, PLI-C, UPV-C, UCS-R, PLI-R, and UPV-R were found to be statistically significant independent variables to estimate the UCS-C. However, higher coefficients of determination (R²=0.97-1.0) were obtained by multiple regression analyses. The results of simple regression analysis were also compared to the limited number of previous studies. The strength conversion factor (k) values were found to be 14.3 and 14.7 for concrete and rock samples, respectively. It is concluded that the UCS-C can roughly be estimated from derived equations only for the specified rock types.