• Korean Chemical Engineering Research
• /
• v.50 no.3
• /
• pp.535-544
• /
• 2012

Filtration on horizontal filter medium facing upward is accompanied by sedimentation. When sedimentation phenomenon is not considered, the average specific cake resistance by filtration could be in error more than two times. In the previous paper on this subject, it was insisted that the solid mass fraction of suspension changes in filtration period by sedimentation. But we could not find out the degree of change. At the first half of this paper, the average specific cake resistance measured by permeation will be proved to be exact in several means. The average specific cake resistance conventionally measured by filtration does not give correct results because it uses initial solid mass fraction of suspension. Then we calculated the changed solid mass fraction of suspension due to sedimentation during filtration by the experimental values obtained "filtration-permeation" method. We also determined the solid mass fraction at a certain moment of filtration from the suspension height and a new equation derived in this study. The two results were compared and proven that they almost matched.

• Journal of the Korean Geotechnical Society
• /
• v.26 no.6
• /
• pp.21-28
• /
• 2010

Decomposed granite soil is the most common type of soils. The measurement of the stress-strain-strength behavior of anisotropic decomposed granite soils is very important for the deformation and stability analysis of slopes, retaining walls, excavations. A series of unsaturated-drained triaxial compression tests were performed to know unsaturated strength properties. The sample had three different angles of the axial (major principal) direction to the sedimentation plane (compaction plane): 0, 45 and 90 degrees. The compression strain of specimens subjected to an isotropic compression was strongly influenced by the sedimentation angle. In addition, the time dependence was independent of the sedimentation angle in relation to the deformation behavior during the secondary compression process. The effect of the sedimentation angle on the triaxial compression strength and deformation was clearly shown with low confining stress. The effect of the sedimentation angle on the compressive strength and deformation was more evident in saturated specimens. A new method of predicting the shear strength of unsaturated decomposed granite soils, considering compaction angles, was proposed.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.85-85
• /
• 2020

South Korea experiences few large scale erosion and sedimentation problems, however, there are numerous local sedimentation problems. A reliable and consistent approach to modelling and management for sediment processes are desirable in the country. In this study, field measurements of sediment concentration from 34 alluvial river basins in South Korea were used with the Modified Einstein Procedure (MEP) to determine the total sediment load at the sampling locations. And then the Flow Duration-Sediment Rating Curve (FD-SRC) method was used to estimate the specific degradation for all gauging stations. The specific degradation of most rivers were found to be typically 50-300 tons/㎢·yr. A model tree data mining technique was applied to develop a model for the specific degradation based on various watershed characteristics of each watershed from GIS analysis. The meaningful parameters are: 1) elevation at the middle relative area of the hypsometric curve [m], 2) percentage of wetland and water [%], 3) percentage of urbanized area [%], and 4) Main stream length [km]. The Root Mean Square Error (RMSE) of existing models is in excess of 1,250 tons/㎢·yr and the RMSE of the proposed model with 6 additional validations decreased to 65 tons/㎢·yr. Erosion loss maps from the Revised Universal Soil Loss Equation (RUSLE), satellite images, and aerial photographs were used to delineate the geospatial features affecting erosion and sedimentation. The results of the geospatial analysis clearly shows that the high risk erosion area (hill slopes and construction sites at urbanized area) and sedimentation features (wetlands and agricultural reservoirs). The result of physiographical analysis also indicates that the watershed morphometric characteristic well explain the sediment transport. Sustainable management with the data mining methodologies and geospatial analysis could be helpful to solve various erosion and sedimentation problems under different conditions.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.5
• /
• pp.517-526
• /
• 2009

This research has been conducted to investigate the characteristics of hydraulic behavior within the PAC contactor, the rectangular shape sedimentation basin without inclined tube and the other one with inclined tube those are parts of demonstration plants(capacity : $2,000m^3/d$) in Korea Institute of Water and Environment. As results of tracer tests, the flow within PAC contactor was evaluated to divided into plug flow and dead space distinctly, and characteristics of dead space was close to that of CSTR(Complete/continuous Stirred Tank Reactor). Also, considering Reynolds number, Froude number, Morill, Modal, NCSTR Inex and plug flow/mixed flow fraction, in the case of the rectangular shape sedimentation basin without inclined tube, the characteristics of flow pattern was close to CSTR. On the other hand, in the case of the basin with inclined tube, the region of CSTR decreased precisely compared with the case of no-tube. Until now we have recognized that the inclined hydraulic structure just reduces the surface loading rate within a sedimentation basin. Actually besides, the inclined structure have an important effect on the hydraulic behavior within the basin.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1446-1451
• /
• 2008

The clay found in the river or in any waste water treatment plant usually have a very high content of water. A large amount of sediments hinder the navigation in river. In waste water treatment plant, there is requirement of settling the thick sludge. These problems are overcome by using rapid means of sedimentation and settling. This paper focus on how method of Electrokinetic sedimentation can be made faster. Sedimentation using Electrokinetic phenomenon has been discussed with varied voltage applied and effect and dose of coagulant in increasing the process. The experimental test has been carried out at water content that are generally present in the case of river and small canals carrying waste water. This paper also focus on different heavy metals concentration during the process and the power aspects of process. A series of experiment were done to support the proposed theory and how a bubble formation could hinder the purpose of experiment.

• Journal of the Korean Ceramic Society
• /
• v.47 no.3
• /
• pp.232-236
• /
• 2010

In recent years abrasive water jet (AWJ) has received significant attention as a technology used in the manufacturing industry for cutting materials. In this paper we report the development of a new preparation method of abrasives for water jet by using an air bubbling sedimentation rate control technique. The SiC abrasives prepared by an air bubbling sedimentation rate control technique using latex resin are found to be superior to the conventional abrasives not only in surface roughness uniformity but also in lifetime. The AWJ test results also show that the former has also better impact-resistance and wear-resistance than the latter.

• Proceedings of the Korea Water Resources Association Conference
• /
• 1996.05a
• /
• pp.689-694
• /
• 1996

The purpose of this study is to find sedimentation patterns variation in Seamangum coastal sea region. Water circulations are calculated diagnostically from the observed water temperature and salinity data and wind data and tidal residual current. There dimensional movements of injected particles due to currents, tubulence and sinking velocity are tracked by the Euler-lagrange method. Calculated sedimentation patters of riverine material are highly similat to the observed ones.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.2
• /
• pp.999-1004
• /
• 2011

In this study, nanodiamod's surface have formed carboxyl, hydroxyl, amine radical for the purpose of use of nanodiamond synthesized by detonation, and then it has widely stable dispersion and slowly sedimentation in solvent. Thus nanodiamonds obtained by chemical treatment were used to analyze the structure, surface statement, particle size and sedimentation specification in solvent for method X-ray diffration(XRD), scanning electron microscope energy diffraction spectroscopy(SEM-EDS), Fourier transform infrared spectroscopy (FTIR), automic force microscope(AFM).

• Journal of Embryo Transfer
• /
• v.31 no.1
• /
• pp.73-80
• /
• 2016

An in vitro assay following culture of endometrial epithelial cells is essential for understanding epithelial cell function in reproduction. Several diverse techniques have been developed for isolating endometrial epithelial cells, although an optimal technique has not been identified. In this study, we describe a sedimentation-adherence (S-A) isolation technique with a high-yield cell-separating ability to isolate endometrial epithelial cells from 8-week-old female C57BL/6 mice. We analyzed total cell number, viability, morphology, and expression of cytokeratin 18 as an endometrial epithelial cell-specific marker in cells isolated using a mechanical method compared to the S-A technique. There were no significant differences in the total number, viability, or morphology of the putative endometrial epithelial cells with either method. In contrast, significantly more endometrial epithelial cells harvested using the S-A method were positively stained for cytokeratin 18 than those isolated using the mechanical method. These results confirm that the S-A method is more efficient for retrieving endometrial epithelial cells than a mechanical method.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 1998.11a
• /
• pp.48-48
• /
• 1998