• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.4C
• /
• pp.147-154
• /
• 2011

Currently NATM tunnels are designed by applying the initial ground loads caused during construction to the primary supports, conisting of shotcrete, steel ribs and rock bolts. For long term considerations, it is assumed that the primary supports lose its functionality and therefore the secondary support, i.e. concrete lining, is design to resist against the entire ground loads. But the steel ribs, usually applied to bad ground conditions, are embedded in shotcrete causing very little corrosion and therefore the assumption that the primary support will lose all of its functionality is too conservative. Also even though shotcrete carbonates in long term, excluding it from design is also too conservative. In this study, we have, through analytical and numerical analysis, set a rational level of support pressure and allowable relaxed rock mass height sustainable by the primary support for long term design. Changes in sectional forces of the concrete lining considering the calculated support pressure of the primary supports was also carried out. Shallow subway tunnels were considered in the analysis with weathered rock and soft rock ground conditions. The analysis results showed that, by considering the support pressure of steel ribs, an economical design of the concrete lining is possible.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.31 no.2
• /
• pp.150-160
• /
• 2005

Background: For normalization of displaced anatomical structure by large cyst, two-step procedure (decompression and enucleation afterward) has been recommended. However, the histological transformation after cystotomy for decompression was shown frequently in secondary enucleation. Therefore, analyses about effects and histological changes after decompression have been necessary. Methods: 48 cases diagnosed as large odontogenic cyst in the jaw and treated by decompression and secondary enucleation were retrospectively analyzed in clinical, rediographical, and histological aspects. Results: In dentigerous cyst, decompression was much useful. Impacted permanent teeth were erupted and reduction rate was higher than that of odontogenic keratocyst (OKC) and apical periodontal cyst. In OKC, among the 29 cases, 11 cases showed no-keratosis, proliferation and rete-ridge elongation after decompression. 4 cases showed no-keratosis, only. 7 cases showed orthokeratosis and rete-ridge elongation and 6 cases showed reteridge elongation, only. 1 case had no change. And the recurrence rate for OKCs was 10.3%. For all odontogenic cysts in this study, dysplasia was not found in cystic lining after decompression. Conclusions: This study implied that decompression for large odontogenic cyst was useful treatment modality because it was conservative treatment and recurrence rate was low although long treatment period was required.

• Advances in pediatric surgery
• /
• v.5 no.2
• /
• pp.130-136
• /
• 1999

Splenic cysts are uncommon and classified as either primary(true) or secondary(pseudo-) depending on the presence or absence of a true epithelial lining. True cysts (epidermoid cyst) of the spleen are very rare. Three cases of splenic cysts in childhood were treated at the Yeungnam University Hospital in the last eleven years(1989-1999). Two of patients were girls. The ages at diagnosis were 7, 12 and 15 years. Abdominal ultrasonography and computerized tomography were utilized for the diagnosis. Radionuclide scanning was performed in one patient. Surgical resection(one partial splenectomy and two total splenectomies) was performed. The sizes of cysts were 4, 6.5 and gem in maximum demension.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.7
• /
• pp.499-507
• /
• 2003

This paper presents a method for active noise control (ANC) in a duct by using a ring-tyPe smart foam. The ring-type smart foam consists of an elastic porous material of lining shape and a PVDF film embedded In the material. The PVDF element acts as a secondary sound source to reduce the noise. Active noise control using a ring-type smart foam is only effective locally because of the way to excite radially. To enlarge the quiet zone, the duct Is lined with additional acoustic foam between the smart foam and the error microphone. When cancellation path ks optimized by the LMS/RLS algorithm, the computation power is reduced while control performance Is maintained. The filtered-x LMS algorithm is used to minimize the error signal.

• Archives of Craniofacial Surgery
• /
• v.22 no.2
• /
• pp.85-92
• /
• 2021

Background: Patients with secondary deformities associated with unilateral cleft lip and nose might also suffer from nostril stenosis due to a lack of tissue volume in the nostril on the cleft side. Here, we used full-thickness skin grafts (FTSGs) to reduce nostril stenosis and various methods for skin volume augmentation. We compared the changes in the symmetry of both nostrils before and after surgery. Methods: From February 2016 to January 2020, 34 patients underwent secondary cheiloplasty and open rhinoplasty for secondary deformities of the unilateral cleft lip and nose with nostril stenosis. FTSG was used on the nostril floor, nasal columella, and alar inner lining. The measured nasal profile included the nostril surface, nostril circumference, width of the nostril floor, and distance from the alar-facial groove to the nasal tip. The "overlap area," which was defined as the largest overlapping area when the image of the cleft nostril was flipped to the left and right and overlaid on the image of the normal side nostril, was also calculated. The degree of symmetry was evaluated by dividing the value of the cleft side by that of the normal side of each measured profile and expressed as "ratios." Results: The results of all profile ratios, except for the nostril floor width, became significantly close to 1, which represents full symmetry. The overlap area ratio improved from 62.7% to 77.3%, meaning that the length and width of the nostril as well as the overall shape became similar (p< 0.05). Conclusion: When performing cleft rhinoplasty with nostril stenosis, FTSG is useful to achieve symmetry in the nostril size and shape. Skin grafting is simpler to perform than the other types of local flap, and the results are generally satisfactory.

• Restorative Dentistry and Endodontics
• /
• v.20 no.1
• /
• pp.303-315
• /
• 1995

An adequate and homogeneous cure of light-activated restroative material is very important for improvement of marginal adaptation and prevention of marginal leakage, secondary caries and pulpal irritation as well as expressing natural physical property of that material. The purpose of this study was to evaluate the change of surface hardness and cure uniformity of light-activated glass ionomer cements. Restorative(Fuji II LC, Vitremer) and lining(Baseline VLC, Vitrebond) light-activated glass ionomer cements were investigated for this study. The surface hardness of the top and bottom surfaces and cure uniformity of each 1mm, 1.5mm, 2mm, 2.5mm & 3mm in the thickness of specimen were measured immediately, at 1 hour, 24 hours and 1 week after light activation. The surface hardness change and cure uniformity of all the specimens were measured by Knoop hardness tester. The results were as follows. 1. The surface hardness of top and bottom surfaces in all groups increased with time(p<0.01). 2. Both top and bottom surfaces hardness of Vitrebond group measured immediately after light-activation were significantly lower than those of the other groups(p<0.01). 3. The surface hardness of top and bottom surfaces of restorative light -activated glass ionomer cements was higher than those of lining materials at 1 week(p<0.10). 4. Surface hardness of Vitremer group decreased as the specimen thickness increased, except top and bottom surfaces hardness of the specimen at 1 week(p<0.01). There was no significant difference in the surface hardness of Fuji II LC with changes in the thickness except bottom surface hardness of specimen at 24 hours and 1 week (p>0.05). 5. Surface hardness of Vitrebond group significantly decreased as the specimen thickness increased(p<0.01). There was no significant difference in the surface hardness of Baseline VLC group with changes in the thickness except bottom surface hardness of specimen measured immediately after light -activation(p>0.05). 6. The hardness ratio of top against bottom surface in all groups decreased with time(p<0.05). 7. There was no significant difference in the hardness ratio of top against bottom surface with changes of the thickness except Vitrebond group, 24 hours and 1 week of Vitremer group and 1 week of Baseline VLC group (p>0.05). These results suggest that surface hardness of restorative ligh-activated glass ionomer cements were highter than those of lining light-activated materials. In all groups, the surface hardness and cure uniformity continuously increased with time.

• Geomechanics and Engineering
• /
• v.37 no.6
• /
• pp.599-614
• /
• 2024

To evaluate the safety status of deteriorated segments in a submarine shield tunnel during its service life, a seepage model was established based on a cross-sea shield tunnel project. This model was used to study the migration patterns of erosive ions within the shield segments. Based on these laws, the degree of deterioration of the segments was determined. Using the derived analytical solution, the internal forces within the segments were calculated. Lastly, by applying the formula for calculating safety factors, the variation trends in the safety factors of segments with different degrees of deterioration were obtained. The findings demonstrate that corrosive seawater presents the evolution characteristics of continuous seepage from the outside to the inside of the tunnel. The nearby seepage field shows locally concentrated characteristics when there is leakage at the joint, which causes the seepage field's depth and scope to significantly increase. The chlorine ion content decreases gradually with the increase of the distance from the outer surface of the tunnel. The penetration of erosion ions in the segment is facilitated by the presence of water pressure. The ion content of the entire ring segment lining structure is related in the following order: vault < haunch < springing. The difference in the segment's rate of increase in chlorine ion content decreases as service time increases. Based on the analytical solution calculation, the segment's safety factor drops more when the joint leaks than when its intact, and the change rate between the two states exhibits a general downward trend. The safety factor shows a similar change rule at different water depths and continuously decreases at the same segment position as the water depth increases. The three phases of "sudden drop-rise-stability" are represented by a "spoon-shaped" change rule on the safety factor's change curve. The issue of the poor applicability of indicators in earlier studies is resolved by the analytical solution, which only requires determining the loss degree of the segment lining's effective bearing thickness to calculate the safety factor of any cross-section of the shield tunnel. The analytical solution's computation results, however, have some safety margins and are cautious. The process of establishing the evaluation model indicates that the secondary lining made of molded concrete can also have its safety status assessed using the analytical solution. It is very important for the safe operation of the tunnel and the safety of people's property and has a wide range of applications.

• Archives of Craniofacial Surgery
• /
• v.15 no.3
• /
• pp.133-137
• /
• 2014

Reconstruction of a full-thickness alar defect requires independent blood supplies to the inner and outer surfaces. Because of this, secondary operations are commonly needed for the division of skin flap from its origin. Here, we report a single-stage reconstruction of full-thickness alar defect, which was made possible by the use of a nasolabial island flap and septal mucosal hinge flap. A 49-year-old female had presented with a squamous cell carcinoma of the right ala which was invading through the mucosa. The lesion was excised with a 5-mm free margin through the full-thickness of ala. The lining and cartilage was restored using a septal mucosa hinge flap and a conchal cartilage from the ipsilateral ear. The superficial surface was covered with a nasolabial island flap based on a perforator from the angular artery. The three separate tissue layers were reconstructed as a single subunit, and no secondary operations were necessary. Single-stage reconstruction of the alar subunit was made possible by the use of a nasolabial island flap and septal mucosal hinge flap. Further studies are needed to compare long-term outcomes following single-stage and multi-stage reconstructions.

• The Korean Journal of Zoology
• /
• v.33 no.2
• /
• pp.152-157
• /
• 1990

The present study, using immunohistochemical procedure, was carried out to determine the localization of immunostainable $\beta$-endorphin cells in the mouse ovarian tissues. Mature female mice were perfused with 4% neutral buffered paraformaldehyde under anesthesia and then frozen-sections were immunostained with anti $\beta$-endorphin antiserum according to ABC technique. Immunoreactive $\beta$-endorphin was found in the luteal cells of corpus lutea, but not in the thecal cells. More strong immunostaining signak were observed in large corpus luteum, in particular, the regressing luteal cells. Primary and secondary follicles did not show any immunoreactivity of $\beta$-endorphin, but granulosa cells lining the antral cavity of large antral follicles contained immunoreactive $\beta$-endorphin.

• Journal of Korean Dental Science
• /
• v.7 no.1
• /
• pp.38-42
• /
• 2014

Bisphosphonate-related osteonecrosis of the jaw (BRONJ) is defined as exposed necrotic bone without evidence of healing for at least 8 weeks in the maxillofacial area in a patient with history of bisphosphonate use. Obtaining complete coverage of the hard tissue by soft tissue in BRONJ patients is especially important. Therefore, managing the mucosa is one of the key factors in a successful outcome, but this is especially hard to achieve in BRONJ patients. Various applications of buccal fat pad in oral reconstruction-including the closure of surgical defects following tumor excision, repair of surgical defects following the excision of leukoplakia and submucous fibrosis, closure of primary and secondary palatal clefts, coverage of maxillary and mandibular bone grafts, and lining of sinus surface of maxillary sinus bone graft in sinus lift procedures for maxillary augmentation-have been studied. Eliminating all potential sites of infection and post-operative infection control is crucial in BRONJ. We present a case using the buccal fat pad pedicle for a stage 3 BRONJ defect. Uneventful total epithelialization of the buccal fat pad regardless of size was noted. In summary, the buccal fat pad has versatile application and various recipient sites for surgical utilization. It is an easy technique, with promising overall success rates. With careful selection and handling, buccal fat graft can resolve problems with soft tissue coverage in stage 2 or 3 BRONJ patients.