• Journal of the Korean Geotechnical Society
• /
• v.20 no.8
• /
• pp.15-27
• /
• 2004

Sliding aspects of rock slope, where large-scaled tension cracks are induced during preliminary excavation, have been analyzed. Structure of rock mass is investigated by performing the electrical resistivity survey and the orientations and positions of discontinuities are measured from DOM-drilled core log. Geological evidence far primary failure movement has been detected and clay minerals which possess swelling properties are identified through XRD analysis. Slope stability is examined by considering the orientations of discontinuities and their trace distributions on the cut-face and neighboring natural slope surface. Both orientations and positions of failure-invoking discontinuity planes, traces of which are exposed within the anticipated sliding region, are concerned fur analyzing the preferred sliding directions. Regional sliding vectors are assessed based on the relative positions of potential sliding planes in the boreholes and the general trend of anticipated failure movement of rock slope is also investigated.

• Journal of the Korean Society of Industry Convergence
• /
• v.8 no.3
• /
• pp.161-168
• /
• 2005

This study is analysis for adjacent structures and ground movement by deep excavation work. Underground Inclinometer has shown that deformation of increment is minor within to allowable limit. According to the measurements result of slope and crack for adjacent structures, a detached house showed bigger than hospital structure to deformation of increment. Variation of underground water level didn't effect so much to ground and adjacent structures movement because underground water flows in rock and didn't give the water press to propped walls. Measurement data of strut variation is within tolerance limit. Because excavation site's wall was strengthened suitably. This study will contribute in establishment of measurement standard and information-oriented construction during deep excavation in multi-layered ground including rock masses.

• Economic and Environmental Geology
• /
• v.26 no.1
• /
• pp.83-96
• /
• 1993

Kwangju granite body located in vicinity of Kwangju city consist of three rock bodies-Kwangju rock body, Jangsung rock body and Youngkwang rock body. Petrochemistry of Kwangju granite is as follows: Kwangju granite body is igneous complex which compose of a series of differential products of a magma. Kwangju granites are divided into four rock facies based on the geologic age, mineralogical and chemical constituents and texture: Triassic hornblende-biotite granodiorite and biotite granite, and Jurassic porphyritic granite and two mica granite. Harker and other variation diagrams of Kwangju granites plot on trend of calc-alkali rock series and range of peraluminous granite. Parental magma type of Kwangju granites correspond to I-type, Syn-Collision type in compressive stress field by collision movement between both rock block. In chondrite normalized REE patterns of Kwangju grnites, LREE enriched than HREE in REE amount and have more steep negative slope with slightly (-) Eu anormaly.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.16 no.4
• /
• pp.369-376
• /
• 2003

In this paper, a nonlinear structural analysis for the composite structure composed of the spent nuclear fuel disposal canister and the 50㎝ thick bentonite buffer is carried out to predict the collapse of the canister while the horizontal symmetric sudden rock movement of 10㎝ is applied on the composite structure. This sudden rock movement is anticipated by the earthquake etc. at a deep underground. Elastoplastic material model is adopted. Drucket-Prager yield criterion is used for the material yield prediction of the bentonite buffer and von-Mises yield criterion is used for the material yield prediction of the canister(cast iron, copper). Analysis results show that even though very large deformations occur beyond the yield point in the bentonite buffet, the canister structure still endures elastic small strains and stresses below the yield strength. Hence, the 50㎝ thick bentonite buffet can protect the canister safely against the 10㎝ sudden rock movement by earthquake etc.. Analysis results also show that bending deformations occur in the canister structure due to the shear deformation of the bentonite buffer.

• Tunnel and Underground Space
• /
• v.16 no.6 s.65
• /
• pp.451-466
• /
• 2006

Analysis of slope behavior concerning the structural characteristics of field rock mass can be processed by virtue of borehole information of joint orientation and position acquired from DOM drilled core. Anticipated sliding potential of pre-failed rock slope is analyzed and the regional slope instability is investigated by inspecting the hazardous joints and blocks the traces of which is projected on the cut-face. Cross section has been set at the center of rock slope and the traces of both joints and tetrahedral blocks, which potentially can induce the slope failure, are drawn to investigate the failure modes and the triggering mechanism. Automated monitoring system has been established to measure the slope movement and especially, inclinometer has been installed inside DOM borehole to analyze the slope movement by considering the internal rock structure. Algorithms for predicting the slope failure time have been reviewed and the significance of heavy rainfall on the slope behavior has been investigated.

• The Research Journal of the Costume Culture
• /
• v.21 no.2
• /
• pp.261-271
• /
• 2013

This study aimed to identify professional climbers'demand for movement functionality in pants worn for rock climbing and ice climbing. Data were collected through in-depth interviews with 12 professional climbers using a semi-constructed questionnaire. The respondents were instructor-level experts whose climbing ability ranged from 5.9 to 5.14 on the Yosemite Decimal System rating scale. The research findings were as follows. Experts wore different climbing pants depending on the type of climbing. For example, they mostly wore high-stretch, second layer pants for rock climbing, while layering first layer, second layer, and third layer pants for ice climbing. There were gender differences regarding the parts of the body in which climbers reported the most discomfort when wearing climbing pants; male climbers most commonly responded 'knees', 'inner thighs' and 'hips' while their female counterparts most commonly responded 'inner thighs', 'exposed back and waist' and 'hips' in that order. Differences were found between rock climbing and ice climbing in terms of wear and tear on pants, preferred fabric properties, and length of pants. Wear and tear was found mainly on the hips and knees of rock climbing pants and on the inner lower hem of ice climbing pants. Listed in the order of preference, the most preferred fabric properties were elasticity, light weight, and durability for rock climbing pants and elasticity, insulation, and protection against water and wind for ice climbing pants. Regarding the length of rock climbing pants, respondents preferred ankle-length pants and cropped pants that did not cover the feet. For ice climbing pants, respondents favored heel-length pants that prevented pieces of ice from entering the clothing. Men showed a high level of preference for ergonomically cut climbing pants. Respondents said the waistband on climbing pants should be simplified so as not to adversely affect climbing maneuvers.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.53 no.3
• /
• pp.240-245
• /
• 2017

In order to study for the growth of fish in the aquaculture industry, the behavior analysis of rock bream (Oplegnathus fasciatus) depending on the temperature and LED lights was conducted. In this study, water temperatures from 10 to 30 degrees were used. One red light (wave length: 622 nm; light power: 811 mW) and one green light (wave length: 518 nm; light power: 648 mW) were used. Behavior of the rock bream was analyzed at an average moving distance for one minutes (AMD) and a rate of movement. The mean AMD were respectively 5.3 m, 7.3 m and 3.0 m in the red LED light, green LED light and control condition. The mean rates of movement were 77%, 88% and 61% respectively in the red LED light, green LED light and control condition. The mean AMD during 24 hours were 3.1 m, 3.1 m and 3.3 m respectively in the red LED light, green LED light and control condition.

• Geomechanics and Engineering
• /
• v.18 no.4
• /
• pp.417-426
• /
• 2019

Gangue filling in the goaf is an effective measure to control the surface subsidence. However, due to the obvious deformation of gangue compression, the filling effect deserves to be further studied. To this end, the deformation of coal gangue filling in the goaf is analyzed by theoretical analysis, large-scale crushed rock compression test, and field investigation. Through the compression test of crushed rock, the deformation behaviour characteristics and energy dissipation characteristics is obtained and analysed. The influencing factors of gangue filling and predicted amount of main deformation are summarized. Besides, the predicted equation and filling subsidence coefficients of gangue are obtained. The gangue filling effect was monitored by the movement observation of surface rock. Gangue filling can support the roof of the goaf, effectively control the surface subsidence with little influence on the ground villages. The premeter and equations of the main deformation in the gangue filling are verified, and the subsidence coefficient is further reduced by adding cemented material or fine sand. This paper provides a practical and theoretical reference for further development of gangue filling.

• Journal of The Geomorphological Association of Korea
• /
• v.21 no.4
• /
• pp.1-17
• /
• 2014

This study analyzed characteristics of landform relieves on 12 bedrock whole(W) areas and 24 mountain(M) and valley(V) areas. Based on this result, characteristics and relations between bedrocks and landform relief were classified as follows. 1) gneiss-height M and granite-height W, M, V areas show active stream incision for uplift. However these areas have relatively low relief and grade compared to high altitude, because effect of denudation don't pass on whole slope. 2) gneiss-height W, V, gneiss-mid M, schist M, granite-mid M, volcanic rock W, M, sedimentary rock-height(conglomerate) W, M, V, sedimentary rock-mid (sandstone and shale) M, limestone W, M areas have active stream erosion and mass movement, but landform relieves are on the high side, because these have resistant bedrock and geological structure against weathering and erosion. 3) gneiss-mid W, V, schist W, V, granite-mid W, V, volcanic rock V, sedimentary rock-mid W, V, sedimentary rock-low(shale) M, limestone V areas landform relieves are on the low side, because these have weak resistance and active weathering, mass movement, erosion, transportation and deposit. 4) gneiss-low W, M, V, granite-low W, M, V, sedimentary rock-low W, V areas landform relieves are very low, because these don't have active erosion and mass movement as costal area with low altitude.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.15 no.1
• /
• pp.9-16
• /
• 1987

In Seoul metropolitan area, rockily denuded fores lands are widely distributed. Out of the rock-exposed hillslopes, Kwanak-Samsung mountains and Bookhan-Dobong mountains areas are the most severely eroded land at present To develope the rehabilitation measures for the rock-exposed hillslopes, it is essentially required that mechanisms of rock debris production and movement from the rock-exposed hillslopes should be studied. And also, suitable experiments for planting techniques should be practised at the field level. In this context, some experiments for the on-site fixation of the unstable stone-debris including plantation establishments on the rock-exposed hillslopes, have been carried out for 4 years from 1983 to 1986 at Kwanak mountain hillslopes. The results may be summarized as follows : 1) The soil environment-tolerable tree species for plantation extablishment on rock-exposed hillslopes include Buxus microphylla var. koreana, Forsythia koreana, Juniperus chinensis var. sargentii, Alnus hirsuta and Pinus rigida. These trees have, however, been showed fairly good growth performence at the places having more than about 30cm of soul layer depth above rock-bed. 2) In raising of seedlings to plant on the rock-exposed hillslopes, containerized seedling practices knave been appeared as the most adoptable measures. 3) In fixation of the unstable stole debris-and-sands on the on-site of rock. exposed hillslopes, the stone-lined barrier measures are more effective at comparatively large-sized places of rock-exposed hillslopes while the stone-bowed barrier measures are more effective at small-sifted isolated sold-debris places. The stone-buttressed terraces measures are more effective at the soil-composed hillslopes rather than rock-exposed hillslopes.