• 약학회지
• /
• 제34권5호
• /
• pp.302-310
• /
• 1990

A study has been made of the Korean bentonite aqueous suspension contrast with American bentonite by means of XRD IR swelling, gel formation and rheogram at various conditions such as concentration, temperature and pH. The Korean bentonite was identified as montmorillonite clay containig a small proprotion of crystoballite and mordenite, and its swelling power were acceptable for requirements of Korean pharmacopeia regulations though its values were not satisfied. Korean bentonite swelled to 10 times and American one did to 15 times compared to its bulkiness of powder. The rheogram of Korean bentonite suspension reveals bulged pseudoplatic flow with yield value at higher concentration and pseudoplastic flow without yield value at lower concentration. The higher the concentration, the greater were the apparent viscosity and hysteresis loop. Korean bentonite suspension showed insignificant temperature dependence on both apparent viscosity and hysteresis loop and it was more temperature dependent on viscosity but less on hysteresis loop than those of American sample. The pH dependence was so high on viscosity that apparent minimum value was near pH 7 and maximum value at pH 3 or 7. The hysteresis loop appeared minimum over the pH range 5-7 and maximum near pH 3 or 11. The Korean bentonite was inferior to the American bentonite in swelling volume, gel formation, thioxotropy, however, it would be possible to improve the quality of Korean bentonite by developing the method of purification for bentonite clay.

• Journal of Pharmaceutical Investigation
• /
• 제18권1호
• /
• pp.9-13
• /
• 1988

Physicochemical properties of oil in water microemulsions containing soybean oil and egg phosphatide were observed for 3 weeks under the storage condition of $4^{\circ}C$ refrigerator. Changes in major fatty acid content, particle size distribution, rheogram, acid value and pH value were measured by gas chromatograph, laser particle sizer, Coulter counter and rheometer. From above experiments following conclusions were obtained; 1) Mean particle diameter was shifted from 240 to 266mm. 2) No significant changes were observed in the content of major fatty acids of soybean oil, rheogram, acid value and pH value.

• 대한화장품학회지
• /
• 제10권1호
• /
• pp.49-74
• /
• 1984

Rheology of gels prepared with stearyl dimethyl benzyl ammonium hectorite (SDBAH) and various polar additives in n-butyl acetate was investigated by measuring the viscosity and rheogram. Including generally recognized polar additives, additional studies on the rheogram and viscosity were made with ether-type methyl cellosolve and carbitol, with dimethyl sulfoxide (DMSO) having sulfonyl group, and furthermore with above-mentioned polar additives containing small quantity of water, It was observed that molecular size, dipole moments and dielectric constants of polar additives had a great influence on viscosity increase and rheology of SDBAH gel, and the increase of SDBAH interlayer spacing was important factor in gel formation and viscosity change. It was also shown that thixotropy effect was increased with the increase of polar additive concentration, finally changed to rheopexy from thixotropy as the concentration of polar additives was increased more than about 40% of SDBAH weight. In addition thixotropy changed to rheopexy as the increase of shear rate. It was further found that the aqueous solutions of polar additives (water content, 5-25%) had more effects on rheology than additives without water, and particularly 95clo DMSO solution was the most effective. And the optimum concentration of polar additives showing maximum viscosity in the same SDBAH concentration system was examined.

• 대한치과의사협회지
• /
• 제13권9호
• /
• pp.833-839
• /
• 1975

• The Korean Journal of Physiology
• /
• 제5권1호
• /
• pp.59-69
• /
• 1971

Studies were undertaken on the changes in the renal blood flow by relating them with the alterations in the amplitudes in the rheogram of rabbits. The changing pattern of the electrical conductivity was recorded by means of the needle electrodes inserted into the kidney and the surrounding aluminium foil which was grounded. The Impedance Rheograph manufactured by the Narco Company was used. The small artifact which persisted after ligation of the renal vessels was subtracted from the value obtained in each pulsatile wave in the rheogram. The animals were nembutalized intravenously, 30 mg/kg. A plastic canule was inserted into the carotid artery and the arterial blood pressure was monitored continuously with the pressure transducer connected to the physiograph. Stepwise bleedings were performed on the animal. The first bleeding was between 13 to 18 ml in the amount, and it was folowed by consecutive hemorrhages, 5 or 10 ml each time. The total amount of bleeding was summed as much as 1.5-2% of the body weight. Two minutes fter each bleeding th arterial blood pressure, ECG and the rheogram were taken. That was the necessary time to obtain the stabilized picture of each parameter. After closing the bleeding process, the shed blood was retransfused into the animal and the response in the renal blood flow was observed as well as the arterial blood pressure. Particularly the presence or absence of the autoregulatory mechanism in the situation of the hemorrhage was also studied. The results obtained were as follows: 1. In 7 cases out of 22, that was about one third of the total number of experiments, the autoregulatory mechanism of the renal blood flow persisted even in acute hemorrhage, and the decreases in the renal blood flow were less than 10% of the control values even when the arterial blood pressure dropped to 66-87% of the original value obtained before the bleeding. 2. Because of the stepwise bleeding the exact blood pressure at which the renal blood flow reduced as much as one third of the control value could not be obtained. However, the results revealed that the approximate pressure, expressed as percentage of the control value, was 50-60% in 3 cases, 61-70% in 4 cases and 71-80% in 8 cases. In one case the decrease in the renal blood flow exceeded one third of the control value before the pressure dropped to 80% of the control. 3. In 19 cases the decreases in the renal blood flow exceeded one half of the control values by hemorrhage. Then the arterial blood pressure revealed less than 40% of the control value in 6-cases. In 2 cases the pressure was 51-60% of the control pressure. In 5 cases the range of bleed pressure was 61-70%, and in e remaining 6 cases the pressure ranged from 71 to 80% of e control value. 4. Out of 15 cases of retransfusion after definite decreases in the renal blood flow loller·ing the hemorrhage, 9 cases restored their renal blood flow. On the contrary 6 cases showed low values even when the shed blood was retransfused. 5. Theories concerning the mechanism of the autoregulation of the renal blood flow were reviewed for the purpose of explanation of the results obtained. However, there are much to be done before greater satisfaction

• Journal of Periodontal and Implant Science
• /
• 제5권1호
• /
• pp.15.1-15.1
• /
• 1975

• 약학회지
• /
• 제37권1호
• /
• pp.66-75
• /
• 1993

Dental abrasive, dicalcium phosphate dehydrate (DCPD) was prepared and the several important factors affecting on the quality of toothpaste were investigated by means of set test, glycerine absorption, Coulter counter test, color difference, BET adsorption, mercury porosimetery, and rheogram comparing with two foreign DCPDs, MFO4 and Dentphos K. Sample DCPD was prepared by reaction between 85% H$_{3}$PO$_{4}$ and 15% milk of lime at $39^{\circ}C$ (pH6.5), and stabilized with TSPP and TMP. The physicochemical properties of Sample DCPD were obtained as follows: whiteness (98.99), average particle size (15.5 $\mu\textrm{m}$), pH (7.9), remainder particle weight (0.49w/w%), glycerine absorption value (64 ml), and set test (passed). N$_{2}$ adsorption curves (BET) of three kinds of DCPD showed non-porous type III isotherm. BET adsorption parameters of sample DCPD showed that surface area was 24.9 m$^{2}$/g, total pore volume 0.09 cm$^{3}$/g and average pore radius 72.0 $\AA$. The rheogram of the toothpaste containing each DCPD showed bulged plastic flow with yield vlaue and thixotropic behavior. These results meet standard requirements as abrasive standard, and suggested that synthesized sample DCPD could be used a dental abrasive such as a high quality grade in practice as foreign DCPDs.

• 대한화장품학회지
• /
• 제20권1호
• /
• pp.52-63
• /
• 1994

4성분계 o/w 형 microemulsion의 안정성과 유동특성에 비이온 계면활성제와 보조계면 활성제의 혼합비가 미치는 영향을 연구하였다. 비이온 계면활성제와 보조계면 활성제의 혼합비에서 계면활성제의 양이 증가함에 따라 입자의 크기가 작아졌고, 경시안정성이 양호하였으며, 이 때의 혼합비는 20/40 - 30/30으로 나타났다. Rheogram을 통하여 시료에는 일정한 내부구조가 형성됨을 의미하는 항복점이 존재함을 알 수 있었으며, 전단속도 증감 시 전단응력이 일치하지 않는 hysteresis를 나타내었다. hysteresis의 면적은 혼합비에서 계면활성제의 양이 많아짐에 따라 커졌으며 제조된 microemulsion은 rheopetic한 특성을 보였다.

• Archives of Pharmacal Research
• /
• 제19권3호
• /
• pp.183-190
• /
• 1996

There are a wide variety of semi-solid ointments used for healing the skin diseases, whose therapeutic and skin penetration abililties may greatly differ from one another depending on the compositions of ointment vehicles. A computer optimization technique was applied to obtain the optimum formula of o/w type ointment giving the in vitro maximum absorption rate through hairless rat skin membrane. Some of the formulations were selected to find out a relationship between skin penetration of ointment and its Theological characteristics. The experimental value of absorption rate obtained from the ointment by optimum formula agreed well with the theoretical value obtained from a polynomial regression analysis, Three kinds of ointments selected among 15 formulations were obtained with a concentric cylinder type rheometer (Model; Rheolab SM-HM Physica, Germany) at 20, 30, 40 and $50^{\circ}C$ for rheograms of rhelolgical properties of o/w type ointments. As the temperature was raised, all products showed a decrease in both shear stress and yield values. The higher skin penetration, the lower shear stress showed.

• 한국터널지하공간학회 논문집
• /
• 제24권5호
• /
• pp.355-374
• /
• 2022

쏘일 컨디셔닝(soil conditioning)은 굴착토의 전단강도를 감소시키고 작업성(workability)을 확보하여, EPB 쉴드 TBM의 굴진면 전방을 지지하며 TBM의 굴진 성능을 향상시키는 기술이다. 다양한 지반 조건에 대한 최적의 첨가제 주입 조건을 결정하기 위해서는 첨가제를 혼합한 굴착토의 역학적 유동학적 거동을 평가해야 한다. 따라서, 본 연구에서는 TBM 챔버 내 압력 상태를 모사하고 시료의 유동학적 특성을 평가할 수 있는 실내 가압 베인시험 장비를 개발하였다. 인공 사질토 시료에 대하여 폼(foam)과 폴리머(polymer)의 주입변수인 FIR (foam injection ratio)과 PIR (polymer injection ratio)을 변화시켜가며 일련의 실내 가압 베인시험을 수행하였다. 또한, 슬럼프 시험을 통해 컨디셔닝된 흙의 작업성을 평가하였다. 실내 가압 베인시험 장비를 통해 베인 전단시험을 수행함으로써 측정된 토크 데이터로부터 컨디셔닝된 흙의 유동곡선(rheogram)을 도출하여 주입변수에 따른 첨두응력과 항복응력의 경향을 분석하였다. 시험 결과, FIR이 커지거나 PIR이 작아질수록 작업성이 증가하는 경향을 나타냈으며, 최대 토크, 첨두응력과 항복응력은 모두 감소하였다. 실내 가압 베인시험으로 측정된 시료의 첨두응력과 항복응력이 슬럼프 시험을 통해 측정된 작업성과 상응하는 결과는 제안된 시험이 굴착토 물성 평가에 활용될 수 있음을 보여준다.