• Proceedings of the Korea Water Resources Association Conference
• /
• 2009.05a
• /
• pp.1112-1116
• /
• 2009

The importance of securing water resources and their efficient management has attracted more attention recently due to water deficit. In water budget analysis, however, evapotranspiration (${\lambda}E$) has been approximated as the residual in the water balance equation or estimated from empirical equations and assumptions. To minimize the uncertainties in these estimates, it is necessary to directly measure ${\lambda}E$. In this study, using the eddy covariance technique, we have measured ${\lambda}E$ in a mixed forest in the Seolmacheon catchment in Korea from September 2007 to December 2008. During the growing season (May - July), ${\lambda}E$ in this mixed forest averaged about 2.2 mm $d^{-1}$, whereas it was on average 0.5 mm $d^{-1}$ during the non-growing season in winter. The annual total ${\lambda}E$ in 2008 was 581 mm $y^{-1}$, which is about 1/3 of the annual precipitation of 1997 mm. Despite the differences in the amount and frequency of precipitation, the accumulated ${\lambda}E$ during the overlapping period (i.e., September to December) for 2007 and 2008 was both ${\sim}$ 110 mm, showing virtually no difference. The omega factor, which is a measure of decoupling between forest and the atmosphere, was on average 0.5, indicating that the contributions of equilibrium ${\lambda}E$ and imposed ${\lambda}E$ to the total ${\lambda}E$ were about the same. The results suggest that ${\lambda}E$in this mixed forest was controlled by various factors such as net radiation, vapor pressure deficit, and canopy conductance. In this study, based on the direct measurements of ${\lambda}E$, we have quantified the relative contribution of ${\lambda}E$in the water balance of a mixed forest in the Seolmacheon catchment. In combination with runoff data, the information on ${\lambda}E$ would greatly enhance the reliability of water budget analysis in this catchment.

• The Korean Journal of Petroleum Geology
• /
• v.11 no.1 s.12
• /
• pp.9-17
• /
• 2005

In the main target area of the block II, Targe-scale faults occur below the unconformity developed around 1 km in depth. The contrast of seismic velocity around the unconformity is generally so large that the strong multiples and the radical velocity variation would deteriorate the quality of migrated section due to serious distortion. More than 15 kinds of data processing techniques have been applied to improve the image resolution for the structures farmed from this active crustal activity. The bad and noisy traces were edited on the common shot gathers in the first step to get rid of acquisition problems which could take place from unfavorable conditions such as climatic change during data acquisition. Correction of amplitude attenuation caused from spherical divergence and inelastic attenuation has been also applied. Mild F/K filter was used to attenuate coherent noise such as guided waves and side scatters. Predictive deconvolution has been applied before stacking to remove peg-leg multiples and water reverberations. The velocity analysis process was conducted at every 2 km interval to analyze migration velocity, and it was iterated to get the high fidelity image. The strum noise caused from streamer was completely removed by applying predictive deconvolution in time space and ${\tau}-P$ domain. Residual multiples caused from thin layer or water bottom were eliminated through parabolic radon transform demultiple process. The migration using curved ray Kirchhoff-style algorithm has been applied to stack data. The velocity obtained after several iteration approach for MVA (migration velocity analysis) was used instead or DMO for the migration velocity. Using various testing methods, optimum seismic processing parameter can be obtained for structural and stratigraphic interpretation in the Block II, Yellow Sea Basin.

• Asian-Australasian Journal of Animal Sciences
• /
• v.30 no.4
• /
• pp.514-522
• /
• 2017

Objective: The study aimed to assess the N use efficiency (NUE) of pig slurry (in comparison with chemical fertilizer) for each regrowth yield and annual herbage production and their nutritive value. Methods: Consecutive field experiments were separately performed using a single application with a full dose of N (200 kg N/ha) in 2014 and by four split applications in 2015 in different sites. The experiment consisted of three treatments: i) control plots that received no additional N, ii) chemical fertilizer-N as urea, and iii) pig-slurry-N with five replicates. Results: The effect of N fertilization on herbage yield, N recovery in herbage, residual inorganic N in soil, and crude protein were significantly positive. When comparing the NUE between the two N sources (urea and pig slurry), pig slurry was significantly less effective for the earlier two regrowth periods, as shown by lower regrowth dry matter (DM) yield, N amount recovered in herbage, and inorganic N availability in soil at the 1st and 2nd cut compared to those of urea-applied plots. However, the effect of split application of the two N sources was significantly positive at the last two regrowth periods (at the 3rd and 4th cut). The two N sources and/or split application had little or no influence on neutral detergent fiber (NDF) content, acid detergent fiber (ADF) content, and in vitro DM digestibility, whereas cutting date was a large source of variation for these variables, resulting in a significant increase in in vitro DM digestibility for the last two regrowth periods when an increase in NDF and ADF content occurred. Split application of N reduced the N loss via nitrate leaching by 36% on average for the two N sources compared to a single application. Conclusion: The pig slurry-N was utilized as efficiently as urea-N for annual herbage yield, with a significant increase in NUE especially for the latter regrowth periods.

• The Korean Journal of Physiology
• /
• v.2 no.1
• /
• pp.31-38
• /
• 1968

Total body fat measurement by means of skinfold thickness was performed in 94 secondary school boys. Hydrostatic weighing was made on the same subject and corrected for residual volume in lung. Skinfold thicknesses at four sites, namely, back, waist, arm and abdomen, were compared with total body fat calculated from the equation given by Keys and Brozek and regression equation were computated. In 48 middle school boys aged between 13 and 16 years and 46 high school boys aged between 16 and 19 years, skinfold thicknesses increased at all 4 sites as age increased. The body density, however, showed different pattern. In middle school ages, body density showed little variation. Density in 13-14 years was 1.0608, in 14-15 years 1.0578 and in 15-16 years 1.0546. In high school ages density in-creased abruptly to 1.0703 (16 yr.), 1.0730 (17 yr.) and 1.0740 (18 yr.). Subsequently 15 years was a boundary for density change and total body fat change. In middle school boys as a group of 48 the observed values were: density: 1.0562, total body fat: 15.9%, mean skinfold thickness at four sites: 6.02 mm. The coefficient of correlation between mean skinfold thickness and density were r=-0.759 and r=0.781 with %fat. The regression equations were : Body $density=-0.00527{\times}Mean$ skinfold thickness (mm)+1.0879, %Fat=$1.933{\times}Mean$ skinfold thickness (mm)+4.26 In high school boys the values were: density: 1.0723, body fat: 10.4%, and mean skinfold thickness: 7.89 mm. Coefficients of correlation between mean skinfold thickness and density were r=-0.868 and r=0.855 with % fat. Thus, Body density=$-0.00365{\times}Mean$ skinfold thickness (mm)+1.1008, and %Fat=$1.326{\times}Mean$ skinfold thickness (mm)-0.064, were obtained. Although skinfold thicknesses at 4 sites showed a continuous increase in absolute value as age increased, relative growth of skinfold at specific site differed. On arm the growth of skinfold showed a decrease and on waist it showed an increase as compared to the mean thickness.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.12
• /
• pp.2215-2226
• /
• 2000

Adsorption characteristics for homologous xanthates on quartz surface has been investigated by FT-IR spectroscopy to understand the adsorption mechanism in relation with verification of the influence of surfactants on the stability of hydrophilic suspended solids in aqueous system. Contact angle measurement for water droplets on quartz surface treated with xanthate was also conducted as a supplementary study for spectroscopic investigation to grant a reliability to the interpretation of experimental results. It has been observed that monolayer of ethyl xanthate was formed on quartz surface as the adsorption progressed and double layer of ethyl xanthate was formed eventually through the reverse oriented adsorption of xanthate molecules on the monolayer. Similar trend of adsorption to the case of ethyl xanthate was found for propyl and butyl xanthates and adsorption was observed to occur more rapidly as the number of carbon atom in alkyl group of xanthate homologs increased. Thermodynamic aspect of adsorption was discussed using Young's equation and the variation in adsorption rate was examined according to the concentration of ethyl xanthate. Based on the result, it has been concluded that the adsorption features of surfactant on substrate in aquatic system is governed by molecular structure and concentration of surfactant and its residual time in aqueous environment as dissolved state also influences greatly the stability of hydrophilic suspended particles.

• Journal of radiological science and technology
• /
• v.39 no.2
• /
• pp.143-148
• /
• 2016

The purpose of this study was examined the measurement error factor on AMARES of jMRUI method for magnetic resonance spectroscopy (MRS) quantitative analysis by skilled and unskilled observer method and identified the reason of independent observers. The Point-resolved spectroscopy sequence was used to acquired magnetic resonance spectroscopy data of 10 weeks male Sprague-Dawley rat liver. The methylene protons ($(-CH_{2-})n$) of 1.3 ppm and water proton ($H_2O$) of 4.7 ppm ratio was calculated by LCModel software for using the reference data. The seven unskilled observers were calculated total lipid (methylene/water) using the jMRUI AMARES technique twice every 1 week, and we conducted interclass correlation coefficient (ICC) statistical analysis by SPSS software. The inter-observer reliability (ICC) of Cronbach's alpha value was less than 0.1. The average value of seven observer's total lipid ($0.096{\pm}0.038$) was 50% higher than LCModel reference value. The jMRUI AMARES analysis method is need to minimize the presence of the residual metabolite by identified metabolite MRS profile in order to obtain the same results as the LCModel.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.8
• /
• pp.1015-1021
• /
• 2010

In this study, the effect of the C/SiC composition ratio on the impact damage of a reaction sintered SiC (RS-SiC) plates was evaluated. An impact test was conducted by using an air gun. The impacter used was a steel ball with a diameter of 2 mm, and the impact velocities were 113, 122, and 180 m/s. The RS-SiC plates were $20\times20\times3$ mm with different C/SiC composition ratios. The ring crack diameters damaged by a steel ball were determined using SEM images. It was observed that the maximum diameter increased with increasing impact velocity, and it rapidly changed with increasing C/SiC composition ratio because of the effect of residual Si and the variation flexural strength. Cone cracks were formed in the case of C/SiC composition ratios of 0.4~0.5, this indicated that the impact damage changed from a ring crack to a cone crack in this critical range of C/SiC composition ratios. The C/SiC composition ratio of 0.3 was determined to be the optimal ratio for the RS-SiC manufacturing process.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.4
• /
• pp.7-13
• /
• 2012

The performance of blind equalization algorithm ISCA was compared with MSCA that is used for the minimization of the inter symbol interference which occurs in the time dispersive communication channel for digital transmission. Because of the non-linearities of a magnitude and phase transfer characteristics of a communication channel, the transmitting signal will be received that band limited and time dispersived. Therefore the distortion was compensated by using the self adaptive equalizer at the receiving side, then passing through the detector for the decision of "1" or "0". At this time the Constellation Dependent Constant is played an important role in the adaptive equalizer used on the receiver. In order to calculation of this constant, the ISCA and MSCA was used the second order statistics. The ISCA and MSCA which are possible to compensation of mensioned transfer function simulataneously, are improved the performance of original SCA algorithm and then was compared the performance by computer simulation. For this, the recovered constellation, residual isi and MSE was used, and a result of performance comparison, the ISCA algorithm has better than the MSCA in every performance index. But on the steady state of equalizer, the variation of performance due to the CME terms in the MSCA equalization algorithm was less than the ISCA, so MSCA has better stability.

• The Journal of Engineering Geology
• /
• v.22 no.3
• /
• pp.331-341
• /
• 2012

Granitoid rocks are generally high-quality rock from a geotechnical perspective, because they rarely contain systematic joints or fragmented fault zones. Although the rock type at the Sanhak site is granite, a collapsed slope has a deep soil layer and shows no residual structures such as discontinuities or faults; surface avalanches from this slope can be observed in several places. To study the stability of this slope, we investigated rainfall duration, variation in pore-water pressure, and the factor of safety considering three cases (current cross-section, initial planning cross-section, revised planning cross-section). With increasing duration of rainfall, the groundwater level rises, up to 20 m in height from ground surface. In the initial planning cross-section, safety was secure for rainfall of 2 days duration, but inadequate for rainfall of 4 days duration. In the revised planning cross-section, however, safety factors were secure for rainfall of 4 days duration. Therefore, to ensure permanent stability at the Sanhak site, a slope degree of 1:1.8 should be maintained during cutting.

• Journal of the Korean institute of surface engineering
• /
• v.38 no.4
• /
• pp.144-149
• /
• 2005

ZnO films were produced on the Si(100) and sapphire(0001) wafers by RF magnetron sputtering in terms of processing variables such as substrate temperature and RF power. The stress in films was obtained from the Stoney's formula using a laser scanning device. The stress levels in the films showed the range from $\~40$ MPa to $\~-1100$MPa depending on processing variables. The specimens were thermally cycled from R.T. to $250^{\circ}C$ to investigate the stress variation as a function of temperature. SEM was employed to characterize the microstructure of te films. As the substrate temperature increased, the film surface became rougher and the films showed coarser grains. The optical property o the films was studied by PL measurements. At the highest substrate temperature $800^{\circ}C$ the film exhibited sharper UV peaks unlike other conditions.