• 산업기술연구
• /
• 제22권B호
• /
• pp.211-218
• /
• 2002

The paper is to show the behavior of composit ground which is installed with sheet pile in soft soil improved by sand compaction pile. The results of load-settlement relationship, earth pressure, stress concentration characteristics, and final water content were obtained by centrifuge model test. Two cases of tests, installation of sheet pile on the corner and both side of the loading plate for the improved SCP ground which was designed twice of the footing width, were performed for the tests under the vertical and horizontal loading and both side of corner. Finite element program(CRISP) for sand compaction pile using elasto-plastic model and numerical analysis for soft soil using modified cam-clay constitutive equation were compared and analized with the results of model tests. The result of analysis show the increased bearing capacity of soil after, SCP and sheet pile was installed.

• 한국건설순환자원학회논문집
• /
• 제6권1호
• /
• pp.1-7
• /
• 2018

본 연구에서는 산업부산물을 다량 활용한 소일콘크리트의 유동성 및 강도발현에 대한 결합재-흙의 비(B/S) 및 물-결합재비(W/B)의 영향을 평가하였다. 보통 포틀랜드 시멘트의 부분 치환재로서 바이패스 더스트 10%, 고로슬래그미분말 40%, 순환유동층 플라이애시 25%가 사용되었다. 저시멘트 결합재와 함께 사질토 또는 점성토를 사용하여 18 소일콘크리트 배합이 실험되었다. 실험결과 소일콘크리트의 유동성은 대상토(점성토 또는 사질토)의 종류에 관계없이 동일한 W/B에서 B/S가 클수록 증가하였다. 압축강도는 점성토 콘크리트보다 동일 배합조건을 갖는 사질토 콘크리트에서 컸다. 산업부산물 다량 활용 소일콘크리트의 배합은 압축강도 및 고유동성을 고려하면 대상토에 관계없이 B/S가 0.35 그리고 W/B는 175%가 추천될 수 있었다.

• 산업기술연구
• /
• 제25권B호
• /
• pp.55-62
• /
• 2005

This paper is the results of experimental and numerical works on analyzing the geotechnical engineering behavior and characteristics of excavated clay slope formed by the method of excavated replacement which is one of treatments in soft soil ground. For the centrifuge model tests, models of excavated clay slope were prepared by remolding the marine clayey soil sampled from the field. Tests were performed with changing the slope to investigate the behavior of them. On the other hand, numerical analyses were carried out to analyze the change of safety factor against instability of slope with time. Changes of pore water pressure, shear strength and displacement were also investigated. As results of centrifuge model tests with slopes of 1:1.5 and 1:3 using the confining body of simulating the effect of excavation, for the case of 1:1.5, slope failure occurred right after remove the confining body whereas relatively small displacements within the range of 3.2mm, implying to maintain the stability of slope, were observed for the case of 1:3 slope. From the results of numerical analyses using the software of PLAXIS to investigate the stability of slope after excavation, the minimum safety factor against slope failure was 1.28 for the case of 1:3 slope. The further researches in the future are required with considerations of build up of static pore water pressures during acceleration of centrifuge, depth of excavation influencing the behavior of the slope and permeability of the slope since excavation of the slope was not simulated well resulted from the limitations of apparatus at the stage of excavation during the centrifuge tests.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2000년도 봄 학술발표회 논문집
• /
• pp.481-488
• /
• 2000

The mechanism of soil-geotextile system has been studied among researchers since the application of geotextile as a replacement of graded granular filters is rapidly growing. The interaction of soils with geotextile is rather complicated so that its design criteria are mostly based on empiricism. Hence, it is essential to study the characteristics of fine particles transport into geotextile induced by the groundwater flow In this study, the permeability reduction in the soil-filter system due to clogging phenomenon is evaluated. An extensive research program is performed using two typical weathered residual soils which are sampled at Shinnae-dong and Poi-dong area in Seoul. Two separate simulation tests with weathered residual soil are peformed: the one is the filtration test(cross-plane flow test): and the other is the drainage test(in-plane flow test). Needle punched non-woven geotextiles are selected since it is often used as a drainage material in the field. The compatibility of the soil-filter system is investigated with emphasis on the clogging phenomenon. The hydraulic behaviour of the soil-filter system is evaluated by changing several testing conditions.

• Geomechanics and Engineering
• /
• 제12권1호
• /
• pp.85-109
• /
• 2017

The paper presents the laboratory study of clayey soil stabilized with Pond ash (PA), Rice husk ash (RHA), cement and their combination used as stabilizers to develop and evaluate the performance of clayey soil. The effect of stabilizer types and dosage on fresh and mechanical properties is evaluated through compaction tests, unconfined compressive strength tests (UCS) and Split tensile strength tests (STS) performed on raw and stabilized soil. In addition SEM (scanning electron microscopy) and XRD (X-ray diffraction) tests were carried out on certain samples in order to study the surface morphological characteristics and hydraulic compounds, which were formed. Specimens were cured for 7, 14 and 28 days after which they were tested for unconfined compression tests and split tensile strength tests. The moisture and density curves indicate that addition of RHA and pond ash results in an increase in optimum moisture content (OMC) and decrease in maximum dry density (MDD). The replacement of clay with 40% PA, 10% RHA and 4% cement increased the strength (UCS and STS) of overall mix in comparison to the mixes where PA and RHA were used individually with cement. The improvement of 336% and 303% in UCS and STS respectively has been achieved with reference to clay only. Developed stabilized soil mixtures have shown satisfactory strength and can be used for low-cost construction to build road infrastructures.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 춘계 학술발표회 논문집
• /
• pp.705-712
• /
• 2005

Among soft ground treatment methods with granular soil used in domestic, the sand compaction pile method has been utilized greatly, but, as a result of exhaustion of sand and increase of unit cost, a necessity of an alternative method is suggested. In this study, the static load tests for group crushed-stone compaction piles which were constructed at in-situ site were performed. Pile diameter was 700mm and area of loading plates were changed. The static load tests of single and group piles were performed for area replacement ratio of 20, 30 and 40%. Based on test results, bearing capacity of group crushed-stone compaction pile were estimated. The more both single pile and group pile increase, the more yield bearing capacity tended to increase. Also, the yield bearing capacity of a group pile is about 50% less than the yield bearing capacity of a single pile. If the ground reinforced with the crushed-stone compaction pile is replacement ratio of $20{\sim}40%$, RIYB of both single pile and group pile increases qualitative tendency of linear more than original ground

• 한국습지학회지
• /
• 제24권3호
• /
• pp.204-212
• /
• 2022

국내의 경우 LID 기술은 2009년 이후에 적용하기 시작하여 환경부, 국토부, LH공사 등의 사업지구와 공공기관, 상업용지, 주택, 공원, 학교 등에서 빗물 관리를 위해 LID 시설을 설치하고 운영 중이다. 그러나 국내의 사례를 살펴보면 국외에 비해 적용사례나 운영 기간 등이 충분하지 못하여 적절한 설계기준과 운영 및 유지관리에 대한 방안 제시가 미흡한 실정이다. 특히, LID 기술을 활용하여 시공되는 LID 시설은 고유의 물순환 기능으로 발현하는 물질순환과 에너지 흐름으로 수문학적 및 환경적 효과가 발현되기에 LID 시설 내부의 지속적인 환경 유지가 필요하다. LID 시설은 물순환 목표량에 계획된 처리용량으로 설계가 되며 적절한 유지관리와 식생 및 토양의 상태를 주기적으로 파악하여 최초에 설치된 상태를 최대한 유지해야 그 효율을 얻을 수 있다. 즉, LID 시설은 물순환 구축을 통한 물의 저류와 침투능을 증대시키면서 수질오염저감, 홍수저감, 수자원확보, 온도저감 등의 효과를 기대하는 시설이기에 LID 시설에 조성되는 토양은 매우 중요한 설계 요소이다. 정확한 LID 시설의 기능 유지와 관리를 위해서는 토양오염, 제설제 영향, 식생 기준 등의 다양한 정량적 데이터를 통해 시설의 현재 상태와 교체 및 유지관리의 주기를 정확하게 알아야 한다. 본 연구에서는 2009년부터-2020년까지 국내에 설치된 LID 시설의 현황을 조사하고, 그 중 식생형 시설인 빗물화단, 식생수로, 식생체류지 등을 대상으로 하여 토양층에서 토양시료를 채취한 후 지난 10년 간 적용된 LID 시설의 지속성과 현재 상태를 통해 토양의 변화를 분석하고자 수행되었다. 토성, 유기물, 경도, 함수량, pH, 전기전도도, 염분 등의 분석을 통해서 시공후 5년~7년 이상된 일부 식생형 LID 시설에서 조경설계기준 하급치에 해당하는 결과를 나타냈다. 하급치 이하의 시설은 토양의 투수율 저하와 식생 생육에 문제가 될 수 있는 상태로 유지관리가 필요한 시점으로 인식할 수 있다. 이에 따른 토양치환과 교체를 통해 LID 시설을 관리해야 함을 알 수 있었다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2004년도 춘계학술발표회
• /
• pp.525-532
• /
• 2004

Among soft ground treatment methods with granular soil used in domestic, the sand compaction pile method has been utilized greatly, but, as a result of exhaustion of sand and increase of unit cost, a necessity of an alternative method is suggested. In this study, the static load tests for crushed-stone compaction piles which were constructed on test field were performed. Based on test results, stress concentration ratios between the crushed-stone compaction pile and the soft ground were investigated and estimated. The stress concentration ratio was the range of 1.7 to 3.0 and the higher it was the more replacement rate was increased.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2017년도 추계 학술논문 발표대회
• /
• pp.28-29
• /
• 2017

For this study, alkali-activated slag red-mud pavement is manufactured to examine the usability of red-mud as a recycling material in the construction industry. In the compaction curve in terms of the replacement ratio of red mud by binder type, the dry density changed gradually depending on the water content, which implies that there is no distinct difference in compaction according to the replacement ratio of red mud. The compressive strength at 28 days was observed to be 18.9~27.0MPa in ASS, and 18.4~28.8MPa in OPC, showing a similar level between the specimens.

• Corrosion Science and Technology
• /
• 제11권6호
• /
• pp.225-231
• /
• 2012

Fitness-for-Service is a useful technology to determine replacement timing, next inspection timing or in-service when nuclear power plant's buried pipes are damaged. If is possible for buried pipes to be aged by material loss, cracks and occlusion as operating time goes by. Therefore Fitness-for-Service technology for buried pipe is useful for plant industry to perform replacement and repair. Fitness-for-Service for buried pipe is studied in terms of existing code and standard for Fitness-for-Service and a current developing code case. Fitness-for-Service for buried pipe was performed according to Code Case N-806 developed by ASME (American Society of Mechanical Engineers).