• Proceedings of the KIEE Conference
• /
• 2000.07a
• /
• pp.31-33
• /
• 2000

This paper discusses the operational characteristic analysis of distance relay depending on the power system parameters in transmission line including FACTS devices. Distance relay requires protective coordination because the FACTS devices change power system parameters to increase power transmission capacity. In this paper, the dynamic operational characteristics of distance relay are analyed for the effect of fault resistance and operation mode of FACTS devices according to the installed points of these devices.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.219-220
• /
• 2008

We proposes an adaptive relay selection scheme for a regenerative (OFDMA) relay network with fairness constrains. The proposed scheme selects the best relays out of a set of potential relays to maximize system capacity. Among these selected relays, subcarriers are reallocated to satisfy fairness constraints as well as to minimize the decrease of the system capacity. The simulation results show that the proposed scheme achieves significant performance improvement over direct transmission and opportunistic relaying with OFDM (OR-OFDM).

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.969-974
• /
• 2003

A simple and cost-effective method for the electrostatic suspension of thin plates like silicon wafers is proposed which is based on a switched voltage control scheme. It operates according to a relay feedback control and deploys only a single high-voltage power supply that can deliver a dc voltage of positive and/or negative polarity. This method possesses the unique feature that no high-voltage amplifiers are needed which leads to a remarkable system simplification relative to conventional methods. It is shown that despite the inherent limit cycle property of the relay feedback based control, an excellent performance in vibration suppression is attained due to the presence of a relatively large squeeze film damping origination from the air between the electrodes and levitated object. Using this scheme, a 4-inch silicon wafer was levitated stably with airgap variation decreasing down to 1 $\mu\textrm{m}$ at an airgap of 100 $\mu\textrm{m}$

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.178-178
• /
• 2000

In this paper, intelligent methods using digital protection relay in power management and control system is developed in order to protect power systems by means of timely fault detection during operation and control at starting for induction motor which have various load environments and capacities in power systems. The digital protective relay was designed with DSP CPU(TMS320C31) to Protect and measure more quickly and precisely. The test result on the basis of KEMCl120 and IEC60255, show that the operation time error of the digital motor protection relay is improved within $\pm$5%. Also, we can control motors at starting according to starting types with simple method as programmable sequence editor. So we can improve the demerits of high cost and much manhour for rework.

• Journal of the Korean Society for Precision Engineering
• /
• v.22 no.10 s.175
• /
• pp.56-64
• /
• 2005

A simple and cost-effective method for the electrostatic suspension of thin plates like silicon wafers is proposed which is based on a switched voltage control scheme. It operates according to a relay feedback control and deploys only a single high-voltage power supply that can deliver a DC voltage of positive and/or negative polarity. This method possesses the unique feature that no high-voltage amplifiers are needed which leads to a remarkable system simplification relative to conventional methods. It is shown that despite the inherent limit cycle property of the relay feedback based control, an excellent performance in vibration suppression is attained due to the presence of a relatively large squeeze film damping origination from the air between the electrodes and levitated object. Using this scheme, a 4-inch silicon wafer was levitated stably with airgap variation decreasing down to $1 {\mu}m$ at an airgap of $100{\mu}m$.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.5
• /
• pp.1638-1653
• /
• 2014

A sequential optimization algorithm (SOA) for resource allocation in a cyclic-prefixed single-carrier cognitive relay system is proposed in this study. Both subcarrier pairing (SP) and power allocation are performed subject to a primary user interference constraint to minimize the mean squared error of frequency-domain equalization at the secondary destination receiver. Under uniform power allocation at the secondary source and optimal power allocation at the secondary relay, the ordered SP is proven to be asymptotically optimal in maximizing the matched filter bound on the signal-to-interference-plus-noise ratio. SOA implements the ordered SP before power allocation optimization by decoupling the ordered SP from the power allocation. Simulation results show that SOA can optimize resource allocation efficiently by significantly reducing complexity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.4A
• /
• pp.345-355
• /
• 2011

This paper introduces the coded cooperation protocol in wireless relay network. We propose a two relay based coded cooperation protocol with RCPC codes for wireless networks. The proposed two-relay based system can achieve a diversity of order 4 under slow fading environment. Under fast fading, the diversity order is 2 times of the free distance of the convolutional code. We develop upper bounds on BER and FER for the system under both slow and fast fading with Rayleigh distribution. The effect of various channel conditions on the cooperation is also examined in this work.

• Journal of the Korea Society of Computer and Information
• /
• v.12 no.3
• /
• pp.267-275
• /
• 2007

In this paper, we designed and implemented DCS terminal remote monitoring middleware for real-time auditor and management terminal status signal with relay and fuse status at power management room. The middleware consist of four component as event analyzer, event manager, service manager and user interface. We expected economic effects extend relay life-time that pre-detected errors and prevented relay fault.

• Proceedings of the KIEE Conference
• /
• 1998.07c
• /
• pp.946-948
• /
• 1998

The distance relay is very important for transmission line protection. A quadrilateral zone shape is used mainly for a modern digital distance relay. The shape of quadrilateral is vendor specific. At the stage of design, the shape is determined considering all possible types of faults and diverse configurations of system. Also this type relay must be designed to avoid the operation by a sound phase at single-Phase-to-ground fault, by a sound phase at two-phase-to-ground fault. The effect of a source impedance and a load impedance is another important factor to design. In this paper, a reliable zone shape which is appropriate for the KEPCO's transmission system is provided.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.97-98
• /
• 2007

In this paper, we investigate the throughput capacity of a multi-hop relay network with cognitive radio (CR) enabled relay stations (RS). We suggested a TDMA/FDMA based frame structure where RSs dynamically select unused channels to communicate with the base station (BS) using CR techniques to analyze the throughput capacity. We developed the throughput capacity model for the proposed system based on utilization factor. The analytical results based on those equations show significant improvement in throughput capacity for CR enabled multi-hop relay system.