• Journal of the Korean Society of Clothing and Textiles
• /
• v.32 no.1
• /
• pp.157-165
• /
• 2008

Transient thermal response of five types of underwear(cotton jersey, wool jersey, nylon jersey, cotton mesh and polyester mesh) for a protective coverall is evaluated using a sweating thermal manikin. Experimental protocol for transient thermal response of the sweating thermal manikin was also proposed. As results, it was found that steady state thermal response from sweating thermal manikin was not sensitive enough to evaluate thermal comfort of the experimental garments. However, when half time is used as an index of the heat flux change in transient thermal response, difference was found among underwear materials. Half time of cotton was the shortest and heat transfer of cotton was the fastest followed by polyester mesh, cotton jersey, nylon jersey and wool jersey. Dynamic thermal response of wool underwear was quite different from that of cotton underwear. Wool shows quite less heat flow at the initial stage, however, moisture permeability of wool was higher than cotton at the later stage. It was difficult to distinguish surface temperature difference visually using thermogram taken right before the completion of dry and wet test in steady state thermal response.

• Korean Journal of Rural Living Science
• /
• v.6 no.1
• /
• pp.1-10
• /
• 1995

To lead rural clothing management in the rural household, we assessed in terms of the wearing of pesticide protective clothing and care methods of contaminated clothing, consumer consciousness, the discard method of clothing et al. in rural areas of Gyonggi-Do by sampling 122 households. The results are as following ; 1. The behavior for laundering management didn't appropriate in view of certification of label about laundry method, frequency of laundry and quantitative use of detergent. Also family's cooperative attitude wasn't insufficient. 2. Reasons of dissatisfaction about retained clothing were decreased in order of discoloration, shrink or breakage after laundry, breakage of seam or cloth, unlabel, allergy from cloth. The solution of trouble was acted passively. 3. Reasons of hoarding of clothing were high because of change on size, fashion, and low because of wornout. Still-wearable garments were discarded in proportion of one to one. 4. The ratio of putting on the fatigue cap which the Once of Rural Development has propagated was under 10 percent. 5. Protective clothes against agricultural chemicals had not been prepared and contaminated clothing was often washed with regular family wash.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.23 no.3
• /
• pp.294-301
• /
• 2020

Man-In-Simulant Test(MIST) provides a test method to evaluate chemical protective equipments such as protective garments, gloves, footwear and gas mask. The MIST chamber is built to control concentration of chemical vapor that has a activity space for two persons. Non-toxic methyl-salicylate(MeS) is used to simulate chemical agent vapor. We carried out to measure inward leakage MeS vapors by using passive adsorbent dosimeter(PAD) which are placed on the skin at specific locations of the body while man is activity according to the standard procedure in MIST chamber. But more time is required for PADs and there is concern of contamination in PADs by recovering after experiment. Therefore detector for measuring in real time is necessary. In order to analyze in real time the contamination of the personal protective equipment inside the chemical environment, we have developed a wireless real-time gas detector. The detector consists of 8 gas-sensors and 1 control-board. The control-board includes a CPU for processing a signal, a power supply unit for biasing the sensor and Bluetooth-chipset for transmission of signals to external PC. All signals from gas-sensors are converted into digital signals simultaneously in the control-board. These digital signals are stored in external PC via Bluetooth wireless communication. The experiment is performed by using protective equipment worn on manikin. The detector is mounted inside protective equipment which is capable of providing a real-time monitoring inward leakage MeS vapor. Developed detector is demonstrated the feasibility as real-time detector for MIST.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.42 no.1
• /
• pp.172-182
• /
• 2018

The purpose of the present study was to quantify the thermal insulation of garments by item and examine factors influencing clothing insulation. A total of 769 garments in clo unit were collected and classified into 12 categories: blouses/shirts (95 items, BS), T-shirts/sweaters (62 items, TS), vest (23 items, VT), cardigans (23 items, CD), jackets/coats (75 items, JC), sport outerwear (including padding jackets)(48 items, SO), trousers (23 items, TR), skirts (56 items, SK), dresses (28 items, DS), underwear (150 items, UW), sleepwear (50 items, SW), and personal protective clothing (59 items, PPC). The results showed that clothing insulation was $0.21{\pm}0.01clo$ for the BS, $0.22{\pm}0.01clo$ for TS, $0.12{\pm}0.00clo$ for VT, $0.23{\pm}0.02clo$ for CD, $0.40{\pm}0.02clo$ for JC, $0.49{\pm}0.03clo$ for SO, $0.21{\pm}0.01clo$ for TR, $0.18{\pm}0.01clo$ for SK, $0.34{\pm}0.03clo$ for DS, $0.09{\pm}0.01clo$ for UW, $0.42{\pm}0.03clo$ for SW, and $0.56{\pm}0.03clo$ for PPC (p<.001). The most influential factors among the seven factors for thermal insulation of garments were clothing weight and covering area; however, the explanatory powers of two factors differed according to clothing categories. The covering area had more significant impact on clothing insulation in cardigans, jackets/coats, trousers, and dresses than clothing weight. Covering areas and clothing weight were the most influential factors in the following categories: blouses/shirt, T-shirts/sweaters, skirts, sleepwear and personal protective clothing. The garment weight was the most important factor for thermal insulation for the sport outerwear.

• Journal of Sensor Science and Technology
• /
• v.24 no.5
• /
• pp.319-325
• /
• 2015

While the conventional personal protective equipments (PPEs) covers a variety of devices and garments such as respirators, turnout gear, gloves, blankets and gas masks, several electronic devices such as personal alert safety system (PASS) and heads-up displays in the facepiece have become a part of firefighters personal protective equipments through past several years. Furthermore, more advanced electronic sensors including location traking sensor, thermal imaging caerma, toxic gas detectors, and even physiological monitoring sensors are being integrated into ensemble elements for better protection of firefighters from fire sites. Despite any electronic equipment placed on the firefighter must withstand environmental extremes and continue to properly function under any thermal conditions that firefighters routinely face, there are no specific criteria for these electronics to define functionability of these devices under given thermal conditions. Although manufacturers provide the specifications and performance guidelines for their products, their operation guidelines hardly match the real thermal conditions. Present study overviews firefighter's fatalities and thermal conditions that firefighters and their equipments face. Lastly, thermal packaging methods that we have developed and tested are introduced.

• Science of Emotion and Sensibility
• /
• v.17 no.4
• /
• pp.71-78
• /
• 2014

Composite draw textured yarns(DTY) and air jet textured yarns(ATY) with hollow PET filament have been used for making high emotional fabrics including light weight sports wear garments. This study investigated effect of hollow composite yarns and fabric structural parameters to the comfort properties related to the moisture and thermal transport phenomena for the composite fabrics made of DTY and ATY with hollow PET filament. Wicking property of hollow composite fabric was superior at the high pore size fabric and was not influenced by fabric cover factor. Wicking property of the fabric with ATY was better than that of the fabric with DTY. On the other hand, drying rate of fine pore sized fabric was shorter than that of large pore sized fabric and drying rate of high multi yarn fabric with low cover factor and small pore size was superior than that of hollow composite fabric. The pore size of the fabric was dominant factor in the air permeability and thermal conductivity of hollow composite fabric. High pore sized fabric showed high air permeability and thermal conductivity of hollow composite fabric was nonlinearly inversely proportional to pore size of the fabric.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.35 no.2
• /
• pp.192-205
• /
• 2011

This study analyzed the registration of patent and utility models by fashion firms in Korea. A total of 2,291 registration cases of IPC A41B-H from the period of 1996 to 2009 were collected by KIPRIS of the Korean Intellectual Property Organization (KIPO). All cases were analyzed by year to review the longitudinal trend and 481 cases of IPC A41B (shirts, underwear, baby linen, and handkerchiefs) and 1088 cases of IPC A41D (outerwear, protective garments, and accessories) were analyzed by content (provided benefit type and developing method), by detailed product items and the characteristics of the applicant. The results of this study were as follows: 1) Registration of IPC 41 increased steeply by the year (especially since 2006) and the patent registrations increased more than those in the utility model. 2) Analyzing the application content of A41B on the basis of benefit showed that 75% were to provide new functions and the rest were for health. In terms of the developing method, 83% of benefit provided by the application were by design development, 11.2% were by material, and the rest was by process, In the cases of IPC A41D, 23.6% were for safety and protection. In terms of the developing method, the process and material development were more frequently adopted than in the cases of A41B. 3) The major product types of A41B were socks, underwear, and infant wear, whereas gloves and parts of clothing were major items in A41D. 4) In terms of the characteristics of the applicant, registration by firms was greater for patents than for utility models and registration by foreigners increased in 2006 due to the complete opening of the retail market. 5) Fifteen universities registered for a total 57 cases and major applications were for IT related clothing or high-tech protective items.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.2
• /
• pp.101-108
• /
• 2008

This study attempted to develop the technology by gaseous ozone for decontaminating building affected by a model of biological weapon agent(Bacillus subtilis spores) instead of Bacillus anthracis spore. The use of ozone is attractive method from a practical point of view of decontamination procedure since it has strong oxidation power but no residue after application. We examined the disinfection efficiency of gaseous ozone to Bacillus subtilis spores which suspension was sprayed on different material surfaces and dried. Three different types of gaseous ozone was applied : dry ozone, dry ozone with humidified air, and water bubbled wet ozone. Dry ozone(1500ppm) failed to achieve any significant inactivation for 2hrs. However, six log reduction of B. subtilis spore was achieved within 30min by 1500ppm of water bubbled wet ozone. This result shows the noticeable inactivation efficiency by gaseous ozone compared with previous studies. Good performance by wet ozone was also found for military material surface.(i.e. : gas mask hood, protective garments, army peinted metal surface).

• Journal of the Korean Society of Safety
• /
• v.23 no.4
• /
• pp.53-58
• /
• 2008

This paper presents the findings obtained from the investigation of fatal disasters occurred by small-sized construction firms which have been accepted as to provide lower safety performance other than large-sized construction enterprises and cause more than half of the safety accidents in average. The study identifies the current status of safety performance provided by the small-sized construction contractors in details, find the issues involved with lack of safety performance, and suggest the improvement measures derived from the findings. A survey questionnaire was administered to the construction contractors, which are listed in the database of Construction Association of Korea as to fall into rank between 501st and 1000th in construction capacity. Safety issues such as the performance of safety management system, safety control structure, safety cost relative to safety control, education devoted to safety improvement, usage of safety garments or individual protective tools, and activities to maintain safety performance on site, etc were investigated from the study.

• The Korean Journal of Pain
• /
• v.30 no.2
• /
• pp.104-115
• /
• 2017

Background: C-arm fluoroscopy equipment is important for interventional pain management and can cause radiation injury to physicians and patients. We compared radiation safety education and efforts to reduce the radiation exposure of pain specialists. Methods: A survey of 49 pain specialists was conducted anonymously in 2016. The questionnaire had 16 questions. That questionnaire was about radiation safety knowledge and efforts to reduce exposure. We investigated the correlation between radiation safety education and efforts of radiation protection. We compared the results from 2016 and a published survey from 2011. Results: According to the 2016 survey, all respondents used C-arm fluoroscopy in pain interventions. Nineteen respondents (39%) had received radiation safety education. Physicians had insufficient knowledge about radiation safety. When the radiation safety education group and the non-education group are compared, there was no significant difference in efforts to reduce radiation exposure and radiation safety knowledge. When the 2011 and 2016 surveys were compared, the use of low dose mode (P = 0.000) and pulsed mode had increased significantly (P = 0.001). The number checking for damage to radiation protective garments (P = 0.000) and use of the dosimeter had also increased significantly (P = 0.009). But there was no significant difference in other efforts to reduce radiation exposure. Conclusions: Pain physicians seem to lack knowledge of radiation safety and the number of physicians receiving radiation safety education is low. According to this study, education does not lead to practice. Therefore, pain physicians should receive regular radiation safety education and the education should be mandatory.