• Proceedings of the National Institute of Ecology of the Republic of Korea
• /
• v.4 no.1
• /
• pp.49-62
• /
• 2023

Phthalates are animal carcinogens. Potassium hydrogen phthalate (KHP), which has the least complicated structure among phthalates, is used for the analysis of total organic carbon and formaldehyde. However, its toxicity has not been confirmed. A 24-hour acute toxicity test was performed using Daphnia magna, a water flea used to evaluate aquatic toxicity owing to its high sensitivity. The lowest observed effect concentration of KHP was found to be 240 mg/L. The effects of phosphorus, nitrogen, and Cr(6+), which are able to be discharged along with KHP, were also confirmed using tests. At 240 mg/L KHP, toxicity increased as phosphorus, nitrogen, and Cr(6+) increased. In addition, tests were performed to confirm the half maximal effective concentration of KHP. Through 10 test repetitions, the average ecotoxicity value was found to be 0.3, the average half maximal effective concentration was 327.75 mg/L, and the coefficient of variation (%) was 3.16%; because the latter value is lower than 25%, which is what is generally suggested for the water pollution standard method, the reproducibility of the tests is sufficient to replace the existing standard reference toxicity test that uses potassium dichromate. In addition, the half maximum effective concentration of potassium hydrogen phthalate is approximately 218 times more than that of potassium dichromate; therefore, toxicity is relatively low. In conclusion, KHP is a feasible alternative to the highly toxic potassium dichromate for performing the standard reference toxicity test.

• Environmental Engineering Research
• /
• v.23 no.2
• /
• pp.129-135
• /
• 2018

The aim of this study is to assess the applicability of ferrate(VI) in the efficient treatment of aqueous waste contaminated with potassium hydrogen phthalate (KHP) which is known to be a potent endocrine disrupting chemicals. Simulated batch reactor operations were conducted at a wide range of pH (7.0 to 12.0) and molar ratios of KHP to ferrate(VI). Kinetic studies were performed in the degradation process and overall rate constant was found to be 83.40 L/mol/min at pH 8.0. The stoichiometry of ferrate(VI) and KHP was found to be 1:1. Further, lower pH values and higher KHP concentrations were favoured greatly the degradation of KHP by ferrate(VI). Total organic carbon analysis showed that partial mineralization of KHP was achieved. The presence of several background electrolytes were studied in the degradation of KHP by ferrate(VI).

• Journal of Environmental Science International
• /
• v.7 no.2
• /
• pp.203-208
• /
• 1998

A simple on-line measurement system consisting of a conventional peristaltic pump, a HPLC-type heater, and a flow-through spectrophotometer is introduced for the determination of chemical oxygen demand(CODI. The system was configured such that the reaction mixture in the highly concentrated surffuric acrid medium flowing through the PTFE reaction tubing was heated at 150℃ and the absorbance of dichromate was continuously moutored at 445 m. The same addation principle as in the standard procedure was employed akcept the use of CoSO4 as a new effective catalyst. To test the system, potassium hydrogen phthalate was selected as a COD standard material. With suitably optimized reaction condition, the applicable concentration range depends on the concentration of potassium dichromate in the oxidizing reagent. With 2.0×10-3 M and 5.0×10-4M dichromate, the linear dynamic range was observed up to 400 ppm and 100 ppm, respectively. The standards in the Unear ranges were shown to be completely oxidized, which was confirmed with sodium oxalate or Mohr's salt. In all cases, the typical reproduclbility for betweenruns was 2% or less. The proposed measurement system provides the valuable in- formation for the further development of automated analysis system based on the present standard procedure.

• Journal of the Korean Chemical Society
• /
• v.20 no.4
• /
• pp.277-279
• /
• 1976

A potentiometric titration method has been developed for the titration of copper with 2,5-dimercapo-1,3,4-thiadizole in aqueous solution using a silver electrode as an indicator electrode vs. the standard calomel electrode as a reference electrode. The 2,5-dimercapto-1,3,4-thiadiazole is very sensitive reagent for copper, which has been found to be highly selective for potentiometric determination of copper. Direct titration of trace amount of copper (0.02${\sim}$0.1 mg) is possible in the presence of a number of foreign ions in aqueous solution containing potassium hydrogen phthalate and sodium fluoride as masking agent under atmosphere.

• Current Optics and Photonics
• /
• v.3 no.4
• /
• pp.336-341
• /
• 2019

This paper proposes an optical system where the organic compound content in water is determined by using an ultraviolet (UV) LED (280 nm) and photodetector. The results obtained by the proposed prototype LED spectroscopy system, which includes a single photodetector and two parallel sample holders, are calculated by applying partial least square regression; the values are highly correlated with the actual concentrations of potassium hydrogen phthalate solutions, with an adjusted coefficient of determination about 0.996. Moreover, the total organic carbon values derived from the UV-Vis spectrometer of real samples (lake, river and sea water) differed little from those obtained by the LED spectroscopy. We confirm that the fast, sensitive, and compact LED sensor system can be readily configured for real-time monitoring of organic compounds in water.

• Membrane and Water Treatment
• /
• v.4 no.4
• /
• pp.277-291
• /
• 2013

The transport and recovery of Levafix brilliant red E-4BA and Levafix brilliant red E-6BA were investigated using polytetrafluoroethylene (PTFE) fiber based supported liquid membrane containing tetra butyl ammonium bromide (TBAB) in coconut oil as a carrier. The influencing parameters studied are: pH of the feed solution, concentration of dye in the feed solution, extractant concentration, and various kind of stripping agent, rate of stirring, time of transport, reusability of membrane and stability of membrane. Increase in TBAB concentration inside the membrane enhances the flux with its maximum value at $1.553{\times}10^{-4}$ M TBAB. Further increase in the concentration of TBAB leads to decreased rate of transport due to increase in viscosity of membrane liquid. The optimum conditions for dye transport are: pH of feed ($7{\pm}0.1$), $1.553{\times}10^{-4}$ M extractant concentration, 350 rpm for stirring, $4.9{\times}10^{-1}$ M potassium hydrogen phthalate as a stripping solution, the time of transport 6 h. It was noticed that flux values were increased with increasing dye concentration in the feed phase. Applying this study to textile wastewater, dyes were transported up to 98% in 6 h. This recovery technique is rewarding to environment and economic.