• Advances in concrete construction
• /
• v.14 no.2
• /
• pp.131-137
• /
• 2022

Based on the design of reinforced concrete columns in Chinese design codes, the failure function of reinforced concrete (RC) columns cannot be expressed as a linear function. This makes it difficult to reveal the level of reliability control in Chinese design code. Therefore, the failure function of dimensionless form is established in this paper, and the typical components (Industrial plant columns) are selected for analysis. At last, numerical simulation proves that the proposed model can be used to analysis reliability of columns. The results based on this model indicate that there is a strong difference in the reliability of RC columns designed with different design parameters, and the reliability would be lower when the eccentricity produced by crane load is smaller.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.27 no.5
• /
• pp.437-450
• /
• 2014

In this study, we developed a methodology to determine the reference parameter for an aircraft impact induced risk assessment of nuclear power plant (NPP) using finite element impact analysis of containment building. The target structure used to develop the method of reference parameter selection is one of the typical Korean PWR type containment buildings. We composed a three-dimensional finite element model of the containment building. The concrete damaged plasticity model was used for the concrete material model. The steels in the tendon, rebar, and liner were modeled using the piecewise-linear stress-strain curves. To evaluate the correlations between structural response and each candidate parameter, we developed Riera's aircraft impact force-time history function with respect to the variation of the loading parameters, i.e., impact velocity and mass of the remaining fuel. For each force-time history, the type of aircraft is assumed to be a Boeing 767 model. The variation ranges of the impact velocity and remaining fuel percentage are 50 to 200m/s, and 30 to 90%, respectively. Four parameters, i.e., kinetic energy, total impulse, maximum impulse, and maximum force are proposed for candidates of the reference parameter. The wellness of the correlation between the reference parameter and structural responses was formulated using the coefficient of determination ($R^2$). From the results, we found that the maximum force showed the highest $R^2$ value in most responses in the materials. The simplicity and intuitiveness of the maximum force parameter are also remarkable compared to the other candidate parameters. Therefore, it can be concluded that the maximum force is the most proper candidate for the reference parameter to assess the aircraft impact induced risk of NPPs.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.196-196
• /
• 2017

Oilseed crop Camelina (Camelina sativa L.) is a suitable for biodiesel production that has high adaptability under low-nutrient condition like marginal land and requires low-input cost for cultivation. Enhanced abiotic stress tolerance of Camelina is very important for oil production under the wide range of different climate. CsRCI2s (Rare Cold Inducible 2) are related proteins in various abiotic stresses that predicted to localized at plasma membrane (PM) and endoplasmic reticulum (ER). These proteins are consist of eight-family that can be divided into tail (CsRCI2D/E/F/G) and no-tail (CsRCI2A/B/E/H) type of C-terminal. However, it is still less understood the function of C-terminal tail. In this study, CsRCI2D/H genes were cloned through gateway cloning system that used pCB302-3 as destination vector. And we used agrobacterium-mediated transformation system for generation of overexpression (OX) transformants. Overexpression of target gene was confirmed using RT-PCR and segregation ratio on selection media. We analyzed physiological response in media and soil under abiotic stresses using CsRCI2D and CsRCI2H overexpression plant. To compare abiotic stresses tolerance, wild type and CsRCI2D/H OX line seeds were sown on agar plate treated with various NaCl and mannitol concentration for 7 days. In the test of growth rate under abiotic stress on media, CsRCI2H OX line showed similar to NaCl and mannitol stress. In the other hand, CsRCI2D OX line showed to be improved stress tolerance that especially increased in 200mM NaCl but was similar on mannitol media. In greenhouse, WT and CsRCI2D/H OX lines for physiological analysis and productivity under abiotic stresses were treated 100, 150, 200mM NaCl. Then it was measured various parameters such as leaf width and length, plant height, total seed weight, flower number, seed number. CsRCI2H OX line in greenhouse did not show any changes in physiological parameters but CsRCI2D OX line was improved both physiological response and productivity under NaCl stress. Among physiological parameters of CsRCI2D OX line under NaCl stress, leaf length and width were observed shorter than WT but it were slightly longer than WT in 200mM NaCl stress. Furthermore, total seed weight of CsRCI2D OX line under stress displayed to decrease than WT in normal condition, but it was gradually raised with increasing NaCl stress then more than WT relatively. These results suggested CsRCI2D might be contribute to improve abiotic stress tolerance. However, function of CsRCI2H is need to more detail study. In conclusion, overexpression of CsRCI2s family can generate various environmental stress tolerance plant and may improve crop productivity for bio-energy production.

• Korean Journal of Environmental Biology
• /
• v.34 no.4
• /
• pp.264-271
• /
• 2016

The objective of this study was to determine the growth and light utilization efficiency of garden plants in shade area through chlorophyll fluorescence reaction analysis. Ten garden plants was grown for 75 days under 50% and 80% shading conditions. Under shading, $ET2_O/RC$, the fluorescence parameter related to electron-transport in photosystem II, was effectively enhanced. However, the electron transport flux until PSI acceptors per reaction center ($RE1_O/RC$) was reduced. These changes in photochemical parameters evoked a decrease in performance index (PI) and driving force (DF) of electron transport flux. In addition, some photochemical parameters such as $F_V$, $FV/F_O$, $RE1_O/RC$, $ET2_O/RC$, $PI_{TOTAL\;ABS}$, and $DF_{TOTAL\;ABS}$ were found to be important for shade tolerance. Three species (Pachysandra terminalis Siebold & Zucc, Physostegia virginiana L., and Carex maculata Bott) were found to be shade tolerant. Based on these results, shading factor index (SFI) deduced from photochemical parameters is useful for evaluating of shading stress of garden plants.

• Korean Journal of Environmental Agriculture
• /
• v.20 no.2
• /
• pp.93-98
• /
• 2001

A chilling-tolerant japonica-type and a chilling-susceptible indica-type of rice (Oryza sativa L.) plants were compared with respect to various physiological parameters during chilling and subsequent recovery. The japonica-type and the indica-type of rice cultivars used were Ilpumbyeo and Taebaekbyeo, respectively. The two rice cultivars exhibited little or no differences in the changes of leaf fresh weight and chlorophyll content during chilling at $5^{\circ}C$ for 3 days. During subsequent recovery at $25^{\circ}C$, however, Ilpumbyeo restored its growth more rapidly than Taebaekbyeo. Since the changes of relative water content, malondialdehyde production, an estimate of lipid peroxidation, and chlorophyll fluorescence were significantly different in the two rice cultivars during the chilling and subsequent recovery, they were found to be more sensitive physiological parameters than fresh weight and chlorophyll content. However, the differences in relation to water content, malondialdehyde production, and chlorophyll fluorescence between the two rice cultivars were smaller during chilling than those during subsequent recovery. These results suggest that relative water content, malondialdehyde production, and chlorophyll fluorescence could widely be used as important physiological parameters for screening chilling-tolerant plants.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.1
• /
• pp.121-132
• /
• 2000

This study is to investigate the performance of a new BNR process using predenitrification scheme focusing on nitrogen removal and the possibility of adapting a computer simulation scheme in BNR process development. By using a pre-denitrification basin, higher $COD/NO_3-N$ ratio could be sustained in this BNR process. The results of the investigation showed a SDNR value of 9.04mg/gMv/hr. In the anoxic tank, the average value of SPRR of 6.25mgP/gMv/hr was observed to be very sensitive to SCOD load of influents. By calibrating internal parameters (stoichiometric and kinetic parameters) of the simulation model, the results of simulation for various BNR processes gave good agreement with observed data. The major adjustment was given with three parameters, maximum specific growth rate of heterotrophic biomass, short chain fatty acid (SCFA) limit, and phosphorous release rate. With the series of simulations on varying operational conditions, the simulation by computer program can be a useful tool for process selection, and design and operation of municipal wastewater treatment plant.

• Proceedings of the Plant Resources Society of Korea Conference
• /
• 2020.08a
• /
• pp.67-67
• /
• 2020

Though there is an on-going need for the diversity of ornamental plants for in-door environment, their growth and stress adaptability in comparatively low light intensity condition require further studies for implementation. Here investigates the growth and chlorophyll fluorescence parameters of Farfugium japonicum (L.) Kitam, Liriope muscari (Decne.) L.H.Bailey and Acorus gramineus Aiton under several light intensities which were based on common in-door environment. The growth measurement of the plants included the quantity, length, width and SPAD value of the leaves. Calculated values of Fm/Fo, Fv/Fm, Pi_Abs, ETo/RC and DIo/RC were used as the parameters of the chlorophyll fluorescence under 10, 50, 100 and 200 PPFD (μmol·m^-2·s^-1) light intensities. In-door plants group was put in a closed room allowing no other light sources for 10 weeks and the control group was put in glass-greenhouse for the same period. The overall in-door growth of L. muscari was not significantly different in all light intensities compared to the control group and even showed the higher SPAD values. Also, an increasing tendency of Pi_Abs value under 10 to 100 PPFD was observed implying that L.muscari could adapt well to in-door environment. Measurement of A. gramineus growth mostly showed the highest values in the control group especially in the number of the leaves. Nevertheless, chlorophyll fluorescence parameters showed no significant value difference between in-door and the control groups and thus, A. gramineus might have possibility of successful adaptation to in-door environment. F. japonicum showed deficient growth in plant height and leaf length compared to the control but, it seemed to be able to sustain ornamental value under in-door light intensities. Furthermore, Pi_Abs and DIo/RC values were increased under in-door light conditions suggesting potential adaptability of F. japonicum.

• Journal of Plant Biotechnology
• /
• v.6 no.1
• /
• pp.9-13
• /
• 2004

Transient uidA expression was used to optimize parameters required for biolistic transformation of suspension cells of Easter lily, Lilium longiflourm. Maximum uidA expression occurred following bombardment with gold particles as compared to tungsten. A 3hr pre-treatment of suspension cells with 0.125M osmoticum resulted in a 1.5X increase in uidA expression. A helium pressure of 1550 psi combined with a particle travelling distance of 6cm resulted in maximum uidA expression as compared to either 1100, 1200, or 1800 psi. Transient transformation resulted in up to 493 uidA expressing cells/Petri plate. For stable transformation suspension cells of Lilium longiflorum, were co-bombarded with plasmid DNA containing cucumber mosaic virus (CMV) replicase under the rice actin (Act1) promoter and either the bar or PAT genes under the cauliflower mosaic virus (CaMV 355) promoter. Ten regenerated plants contained the transgene as analyzed by PCR, and two of the ten plants were confirmed to contain the transgene by Southern hybridization. The two transgenic plants were independent transformants, one containing the bar gene and the other both the CMV replicase and bar genes. Plants were sprayed at the rosette stage and found to be resistant to 1000 mg/L of phosphinothricin (Trade name-Ignite) indicating expression of the bar gene throughout the leaves when bar was under control of the CaMV 35S promoter.

• Asian-Australasian Journal of Animal Sciences
• /
• v.4 no.3
• /
• pp.263-274
• /
• 1991

Digestibilities of nutrients and energy are among the most important parameters to be determined in feed evaluation research. The apparent digestibility coefficients (ADC) of protein, total carbohydrate (TCHO), fat, energy and amino acids were determined for 14 common feed ingredients using chromic oxide as external indicator with Israeli carp (Cyprinus carpio). The ingredients tested were; corn, corn starch, gelatinized starch, wheat middling, wheat grade inferior, corn gluten meal, rapeseed meal (solvent extracted), soybean meal (solvent extracted), blood meal (drum dried), feather meal(hydrolyzed), file fish meal (flame dried), sardine fish meal (steam dried), sardine fish meal (flame dried) and brewers yeast (dehydrated). The overall ADC values were high in Israeli carp showing high capacity to digest their feed ingredients irrespective of plant or animal sources. In addition the ADC of plant protein was high enough to support the successful supplementation of fish meal with other plant proteins.

• Membrane and Water Treatment
• /
• v.9 no.6
• /
• pp.455-462
• /
• 2018

The measurement and monitoring of the biochemical oxygen demand (BOD) play an important role in the planning and operation of wastewater treatment plants. The most basic method for determining biochemical oxygen demand is direct measurement. However, this method is both expensive and takes a long time. A five-day period is required to determine the biochemical oxygen demand. This study has been carried out in a wastewater treatment plant in Turkey (Hurma WWTP) in order to estimate the biochemical oxygen demand a shorter time and with a lower cost. Estimation was performed using artificial neural network (ANN) method. There are three different methods in the training of artificial neural networks, respectively, multi-layered (ML-ANN), teaching learning based algorithm (TLBO-ANN) and artificial bee colony algorithm (ABC-ANN). The input flow (Q), wastewater temperature (t), pH, chemical oxygen demand (COD), suspended sediment (SS), total phosphorus (tP), total nitrogen (tN), and electrical conductivity of wastewater (EC) are used as the input parameters to estimate the BOD. The root mean squared error (RMSE) and the mean absolute error (MAE) values were used in evaluating performance criteria for each model. As a result of the general evaluation, the ML-ANN method provided the best estimation results both training and test series with 0.8924 and 0.8442 determination coefficient, respectively.