• Journal of The Korean Astronomical Society
• /
• v.39 no.2
• /
• pp.41-50
• /
• 2006

We present the results of new multi-color CCD photometry for the contact binary XZ Leo, together with reasonable explanations for the period and light variations. Six new times of minimum light have been determined. A period study with all available timings confirms Qian's (2001) finding that the O-C residuals have varied secularly according to $dP/dt\;=\;+8.20{\times}10^{-8}\;d\;yr^{-l}$. This trend could be interpreted as a conservative mass transfer from the less massive cool secondary to the more massive hot primary in the system with a mass flow rate of about $5.37{\times}10^{-8}\;M_{\odot}\;yr^{-l}$. By simultaneous analysis of our light curves and the previously published radial-velocity data, a consistent set of light and velocity parameters for XZ Leo is obtained. The small differences between the observed and theoretical light curves are modelled by a blue third light and by a hot spot near the neck of the primary component. Our period study does not support the tertiary light but the hot region which may be formed by gas streams from the cool secondary. The solution indicates that XZ Leo is a deep contact binary with the values of q=0.343, $i=78^{\circ}.8$, ${\Delta}(T_1-T_2)=126\;K$, and f=33.6 %, differing much from those of Niarchos et al. (1994). Absolute parameters of XZ Leo are determined as follows: $M_1=1.84\;M_{\odot},\;M_2=0.63\;M_{\odot},\;R_1=1.75\;R_{\odot},\;R_2=1.10\;R_{\odot},\;L_1=7.19\;L_{\odot},\;and\;L_2=2.66\;L_{\odot}$.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.2
• /
• pp.152.1-152.1
• /
• 2011

We report preliminary results of long-slit near-infrared (NIR) spectroscopy of Luminous Blue Variables (LBVs) with moderate resolution of R ~ 2400. We obtained Jshort (1.04-1.26 micron) and Ks (2.02-2.31 micron) band spectra of 4 LBVs and 3 LBV candidates in Southern hemisphere using IRIS2, infrared imager and spectrograph, mounted on the 4-m Anglo-Australian Telescope. All targets are fairly bright in NIR so that we can obtain high signal-to-noise ratio for clear line detection and modeling. They are also widely distributed in the HR diagram so that we can compare the spectral properties of LBVs in different temperature and luminosity ranges. Among them, we present the results of two well-known LBVs AG Car and HR Car. Their spectra show similar properties with hydrogen, He I, and metallic lines such as Fe II and Mg II, most of them in emission. We discuss, in particular, the He I 1.083 micron lines formed in stellar wind because these two LBVs show large variation in their He I line intensities, compared to previous studies. Since the He I 1.083 line is known to be anticorrelated with the photometric variation of LBVs, strong line intensities with P-Cygni profiles in both stars indicate that they are now near the visual minimum phase. We model the obtained spectra using non-LTE atmosphere code CMFGEN of Hillier (1998) to derive stellar parameters such as wind velocity and mass loss rate, and discuss the long-term variability of stellar parameters of these LBVs. deduced from our otometric solution.

• Journal of Astronomy and Space Sciences
• /
• v.10 no.2
• /
• pp.123-145
• /
• 1993

UBVRi photometry of Algol was carried out from December of 1988 to March of 1991 at Chungbuk National University Observatory and a total of 3465 observations in U, B, V, R, I were obtained. Three times of primary minimum light of JDH el 2447898.0938, JEH el 2448265.1205 and JDH el 2448288.0598, and two secondary minimum light of JDH el 2447808.1014 and JDH el 2448275.146 were determined from our observations. We analyzed simultaneously the UBVRI light curves of the Algol system with the Wilson-Devinney method for the determination of the photometric parameters. Indivisual masses for the 3 components of Algol are derived as $m_1$=3.36, $m_2$=0.76, $m_3$=1.6 in solar mass and radii as $R_1$=2.97, $R_2$=0.76 in solar radinus using i=$82.{\circ}47$, q=0.227, $r_1$=0.2102, $r_2$=0.2512 of our solution and some parameters of the spectroscopic solution of Hill et al. (1971). Our results is simiar to those reported by Kim (1989). The temperature of Algol C, $T_3$=8800 was obtained by means of fitting $l_1$, $l_2$, and $l_3$ of five colors to Planckian curve, and $R_3$=$1.6R_\odot$ is derived from its result. It is believed that its semidetached configuration of Algol A and B is the consequence of case B mass transfer. According to its location in a mass-radius diagram. Algol b may have evolved significantly in its Hburnning phase.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.3
• /
• pp.203-207
• /
• 2009

The concern of seriousness and harmful effects of environmental pollution is rising by the various water pollutions, appearances of new micro-noxious substances and increase of sustainable pollutants. The method is suggested that can effectively increase the removal of organic substances and several pollutants using a coagulation process. The experiment for characteristics of $ZrSiO_4$ (zirconium silicate) as a coagulation-aid was carried out for application to coagulation process with domestic wastewater and lake water, and the removal rate of the organic substances depending on a dosage was evaluated by PDA (Photometric Dispersion Analyzer) in this study. Zeta-potential of zirconium silicate solution was -32.22 mv at pH 7 and the lower negative(-) charge was detected in the more acidic conditions. Absorbance on $UV_{254}$ presented higher when zirconium silicate was added than in a domestic wastewater itself. Besides, the results by PDA experiment represented that injection of zirconium silicate could promote growing of floc. Tests for coagulation process were conducted by three ways which are pre-injection, co-injection and post-injection of zirconium silicate with alum. Accordingly, removal efficiency of organic substances increased over 15% in co-injection than in using of alum as a sole reagent. When a 20 mg/L of alum was used with a 10 mg/L of zirconium silicate, the removal efficiency was high up to 90%. Removal efficiency of $COD_{Cr}$ was improved more than 15% in case of dosage of coagulant either PAC (Poly aluminium chloride) or PACS (Poly aluminium chloride Silicate) together with zirconium silicate. As a result, the removal efficiency of $COD_{Cr}$ were 5~10% higher in a co-injection of zirconium silicate with a coagulant than a pre-injection and a post-injection but it of soluble substances was lower in a co-injection.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.16 no.2
• /
• pp.136-146
• /
• 1987

Flavor components were trapped by stimultaneous steam distillation-extraction method for investigating it in the bellflower roots and fractionated into four groups such as a neutral, a basic, a phenolic and an acidic fraction. An acidic fraction methylated with diazomethane solution and three others were analysed by GC and GC-MS equipping a fused silica capillary column, and S-containing compounds in these were detected with a flame photometric detector (FPD). The total of one hundred and three compounds from the bellflower roots were identified: they were 6 aliphatic hydrocarbons, 10 aromatic hydrocarbons, 2 terpene hydrocarbons, 12 alcohols, 8 terpene alcohols, 17 aldehydes, 3 terpene aldehydes, 5 ketones, 5 esters, 3 furans, 2 thiazoles, 2 lactones, 2 sulfides, 9 phenols, l2 carboxylic acids and 5 others. The greater part of the others except carboxylic acids were identified from a neutral fraction of which was assumed to be indispensable for the reproduction of bellflower root odor in a sensory evaluation. As a result of a sensory evaluation, 1-hexanal, trans-2-hexenal, 1-hexanol, cis-3-hexenol, trans-2-hexenol, 1-octen-3-ol and so forth identified in a neutral fraction were considered to be the key compounds of grass-like odor in the bellflower roots.

• Journal of Astronomy and Space Sciences
• /
• v.21 no.2
• /
• pp.73-82
• /
• 2004

New photometric and spectroscopic solutions of W-type overcontact binary V 417 Aql were obtained by solving the UBV light curves of Samec et al. (1997) and radial-velocity ones of Lu ＆ Rucinski (1999) with the 2003 version of the Wilson-Devinney binary code. In the light curve synthesis the light of a third-body, which Qian (2003) proposed, was considered and obtained about 2.7%, 2.2%, and 0.4% for U, B, and V bandpasses, respectively. The model with third-light is better fitted to eclipse parts than that with no third-light. Absolute dimensions of V417 Aql are determined from our solution as $M_1$= 0.53 $M_{*}$, $M_2$= 1.45 $M_{*}$, $R_1$= 0.84 $R_{*}$, and $R_2$= 1.31 $M_{*}$, and the distance to it is deduced as about 216pc. Our distance is well consistent with that (204pc) derived from Rucinski ＆ Duerbeck's (1997) relation, $M_{v}$ = $M_{v}$(log P, B-V), but is more distant than that (131$\pm$40pc) determined by the Hipparcos trigonometric parallax. The difference may result from the relatively large error of Hipparcos parallax for V 417 Aql.l.

• Journal of Astronomy and Space Sciences
• /
• v.19 no.3
• /
• pp.187-196
• /
• 2002

We performed CCD photometric observations of the eclipsing binary Y Cam with a pulsating component, for 16 nights from November 2000 to May 2001 using a V filter attached to the 61-cm reflector at Sobaeksan Optical Astronomy Observatory. Our V light curve and Broglia & Marin's (1974) BV ones were analyzed with Mode 2 for a detached Roche model as well as Model 5 for a semi-detached one in the Wilson-Devinney code. From the analysis, we found the following results: 1) It is hardly discernible from only light curve synthesis which model between the detached and semi-detached ones is a real Roche model of Y Cam. 2) There exist the third light of about 2% and 3% in B and V light curves of Y Cam, respectively. 3) The light curve solution is immune from the light variation due to the pulsation of the primary component of Y cam. However, the detached model rather than the semi-detached one has slightly better fitted to the observations which were get rid of the pulsation effect. 4) The absolute dimensions of Y Cam were calculated for two Roche models.