• 한국환경과학회:학술대회논문집
• /
• 한국환경과학회 2008년도 추계학술발표회 발표논문집
• /
• pp.282-285
• /
• 2008

At least 15% of the C polykrikoides cells that precipitated to the bottom layer either by the addition of loess or no addition survived for 1 week at all growth phases, rather than disappearing immediately after precipitating. However, no live cells were observed after 20 days, regardless of phase or loess addition. In the exponential phase, the number of C polykrikoides cells increased to >2886 cells/ml after loess was added. However, in the stationary phase, the number of cells did not increase until 18 days. In the exponential phase, those C polykrikoides that survived precipitation caused by scattering loess on cultures did not appear to have the ability to cause red tides again because of the short red tide periods in the field, long lag time after loess addition, and low survival rate after loess addition.

• 대한기계학회논문집A
• /
• 제33권11호
• /
• pp.1347-1352
• /
• 2009

Magnetic force driven six degree-of-freedom active vibration isolation system is developed. The velocity sensor using an electromagnetic principle that is commonly used in the vibration control is investigated since its phase lead characteristic causes an instability problem for a low frequency vibration. A lag-type compensator is adopted to reduce the phase lead and the stability test is performed by using a Bode analysis. The performance of the AVIS is validated by comparing with the passive isolation system by using the frequency responses.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2021년도 봄 학술논문 발표대회
• /
• pp.203-204
• /
• 2021

Bacteria used in self-healing concrete, which arrest the crack, helps increasing the durability is well known. However, the survival and activity of the bacteria are precisely unknown. In this research, to know the bacteria's survival curve on the surface of the cement composite, bacteria's survival curve has been measured by CFU at different curing days. The survival curve of 3 days and 7 days curing does not show the significant differences in their survival tendency. However, the slope of death phase of 7 days curing was steeper than the 3 days of curing. This research was focused on the death phase but for further research, set of interval time will be reduced and observe the lag phase and exponential phase.

• 드라이브 ㆍ 컨트롤
• /
• 제15권1호
• /
• pp.1-9
• /
• 2018

The spool displacement of directional control valve can be considered as the standard signal to measure the bandwidth frequency of a directional control valve. When the spool displacement is not available, the metering-orifice system is implemented in this research as an alternative way of measuring the 90 degrees phase bandwidth frequency of the hydraulic directional control valve. The inertia effect on the transmission line oil induces the phase lead of the valve load pressure when compared with the phase of spool displacement. The capacitance effect of the oil induces the phase lag of the valve load pressure. The phase of the load pressure can be adjusted to be the same as that of the spool displacement by controlling the opening area of the metering orifice. A series of experiments were conducted to verify the effectiveness of the metering orifice. The 90 degrees phase bandwidth frequency measured from the valve load pressure was significantly deviated in some cases from the frequency of the spool displacement. The metering orifice was hard to be applied to measure the -90 degrees phase bandwidth frequency of the high precision.

• Journal of Astronomy and Space Sciences
• /
• 제28권2호
• /
• pp.123-132
• /
• 2011

It is generally believed that the occurrence of a magnetic storm depends upon the solar wind conditions, particularly the southward interplanetary magnetic field (IMF) component. To understand the relationship between solar wind parameters and magnetic storms, variations in magnetic field polarity and solar wind parameters during magnetic storms are examined. A total of 156 storms during the period of 1997~2003 are used. According to the interplanetary driver, magnetic storms are divided into three types, which are coronal mass ejection (CME)-driven storms, co-rotating interaction region (CIR)-driven storms, and complicated type storms. Complicated types were not included in this study. For this purpose, the manner in which the direction change of IMF $B_y$ and $B_z$ components (in geocentric solar magnetospheric coordinate system coordinate) during the main phase is related with the development of the storm is examined. The time-integrated solar wind parameters are compared with the time-integrated disturbance storm time (Dst) index during the main phase of each magnetic storm. The time lag with the storm size is also investigated. Some results are worth noting: CME-driven storms, under steady conditions of $B_z$ < 0, represent more than half of the storms in number. That is, it is found that the average number of storms for negative sign of IMF $B_z$ (T1~T4) is high, at 56.4%, 53.0%, and 63.7% in each storm category, respectively. However, for the CIR-driven storms, the percentage of moderate storms is only 29.2%, while the number of intense storms is more than half (60.0%) under the $B_z$ < 0 condition. It is found that the correlation is highest between the time-integrated IMF $B_z$ and the time-integrated Dst index for the CME-driven storms. On the other hand, for the CIR-driven storms, a high correlation is found, with the correlation coefficient being 0.93, between time-integrated Dst index and time-integrated solar wind speed, while a low correlation, 0.51, is found between timeintegrated $B_z$ and time-integrated Dst index. The relationship between storm size and time lag in terms of hours from $B_z$ minimum to Dst minimum values is investigated. For the CME-driven storms, time lag of 26% of moderate storms is one hour, whereas time lag of 33% of moderate storms is two hours for the CIR-driven storms. The average values of solar wind parameters for the CME and CIR-driven storms are also examined. The average values of ${\mid}Dst_{min}{\mid}$ and ${\mid}B_{zmin}{\mid}$ for the CME-driven storms are higher than those of CIR-driven storms, while the average value of temperature is lower.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 춘계학술대회논문집
• /
• pp.843-846
• /
• 2004

Cavity tone is generated due to the feedback between flow and acoustic wave. It is recognized that the period is determined by the time required for the flow convection in one direction, the time required for the acoustic propagation in the other direction and the time for phase shift depending on the flows and mode. Most of the phenomena have been investigated by experiments and a simple but fundamental theory. But the cause of the phase shift and the correctness of the theory have not been clearly explained so far. In this paper, the phenomena are calculated numerically to obtain detail information of flow and acoustic wave to explain the mechanism including the phase. High order high resolution scheme of optimized high order compact is used to resolve the small acoustic quantities and large flow quantities at the same time. The data are reduced using cross correlation function in space and time and cross spectral density function which has phase information. Abrupt change in pressure near corner in cavity is observed and is relate to phase variation. The time required for the feedback between the flow and acoustic wave is calculated after the numerical simulation f3r various modes. The periods based on the time calculated using the above method and direct observation from the acoustic waves generated and propagated in the numerical simulation are compared. It is found that no phase shift is required if we examine the time required carefully. Rossiter's formula for the cavity tone used for quick estimation needs to be modified far some modes.

• 한국광물학회지
• /
• 제24권3호
• /
• pp.235-244
• /
• 2011

애씨디싸이오바실러스 페로악시댄스(Acidithiobacillus ferrooxidans; Af)에 의한 황철석의 산화 기작을 이해하기 위해 황철석-용액간 접종 배취실험 (batch experiment)을 수행하고, 주기적으로 용액의 화학 조성과 함께 반응 황철석의 표면을 주사전자현미경 (scanning electron microscope; SEM)으로 관찰하였다. 반응 용액의 Fe 농도 분석 결과는 Af가 뚜렷이 구분되는 성장 적응기와 증식기를 거침을 나타내었다. Af 성장 적응기 동안에 황철석 표변에 부착된 개체가 관찰됨으로써 이 기간 동안의 황철석이 Af에 의해 직접용탈 산화됨이 확인되었다. 하지만 부착된 개체가 많이 발견되지 않는 점과 Fe가 주로 Fe(III)로 존재한다는 점 등으로 인해 적응기간 동안 Af가 황철석을 주로 직접용탈을 통해 용해 시켰다고 확신하기는 어렵다. Af 성장 적응기의 중반 이후부터 증식기 직전까지 Fe 함량이 크기 증가 하지 않고 정체되는데, 이는 이 시기에 Af에 의한 황철석의 산화가 직접 또는 간접 용탈식 산화든, Af가 산화 기작의 전환을 위해 적응 기간을 분명히 필요로 하는 것으로 보인다. SEM 관찰 결과 황철석의 표면에서 Af의 세포 분열이 관찰되었다. 이 세포분열 외형을 따라 황철식이 그대로 용식된 모습을 보여주는데, 이는 Af에 의한 산화 속도가 매우 불균등하며 산화가 진행되는 동안에는 농도의 변화로 부터 계산되는 속도보다 훨씬 빠르게 진행됨을 나타낸다. Af의 접종이 이루어진 황철석의 표면에 훨씬 많은 부식홈이 관찰되어 이 미생물에 의한 산화가 무기적인 산화보다 훨씬 빨리 진행됨을 지시한다. Af에 의한 부식 홈은 좁고 깊어, 이것이 적응기-증식기 전이에 영향을 끼쳤을 가능성이 있다.

• 전기학회논문지
• /
• 제64권2호
• /
• pp.268-275
• /
• 2015

This paper proposes a method of switching to improve power loss for the single-phase three-level NPC inverter. The conventional switching methods, which are called as the bipolar and unipolar switching methods, are used for single phase inverters using three-level topology. However, these switching method have disadvantage in the power loss. Because all of the switch are operated. To reduce the power loss of the three-level NPC inverter, clamp switching method is introduced in this paper. This way, one of the lag is fixed that switching loss is reduced. This paper analyzes and compares power losses of unipolar method and clamp method. The validity of the power loss analysis is verified through the simulation and experimental results.

• 한국수산과학회지
• /
• 제51권1호
• /
• pp.64-71
• /
• 2018

This study was conducted to investigate the effects of light intensity and wavelength on the growth of Tetraselmis suecica and Tetraselmis tetrathele. These species were exposed to a blue light-emitting diode (LED; max=450 nm), a yellow LED (max=590 nm), a red LED (max=630 nm) and a fluorescent lamp (three wavelengths). The maximum growth rates (${\mu}_{max}$) of T. suecica and T. tetrathele under a red LED were 1.12/day and 0.95/day, respectively. Under a yellow LED, growth rates were 70% of the values for red wavelength, with low half-saturation constants (Ks). The optimum light source to ensure economically effective and productive growth in a Tetraselmis culture system (Photo-Bioreactor) would thus appear to be a three-phase culture, wherein a yellow LED is used during the lag phase and initial exponential phase to increase growth rate, followed by a red LED during the middle exponential phase to maximize growth rate, and finally a yellow LED again during the late exponential phase and stationary phase to achieve increased yield of useful bioactive substances.

• 한국토양환경학회지
• /
• 제5권1호
• /
• pp.3-12
• /
• 2000

다영역 모델은 Preferential 흐름에 대한 해석을 위하여 토양을 여러개의 공극군으로 나누고 각 토양의 수리학적 특성을 이용하여 토양내의 흐름을 표현한 방정식이다. 이 모델을 유한차분법을 이용하여 수치적으로 풀이할 때 해의 정확도와 일관성을 분석하기위해 수정등가편미분방정식(MEPDE)을 구하고, 안정성을 분석하기위해 Von Neumann법을 이용한다. 수정등가편미분방정식을 이용하여 얻은 유한차분계에 대한 평가는 모델방정식에 대하여 일관성이 있는 것으로 나타났고 모델방정식에 대한 유한차분법은 2차의 정확도를 얻었다. 모델방정식의 안정성 해석은 Von Neumann방법을 이용하여 진폭도와 위상지연을 구하고 이를 분석하였다. 유한차분계의 진폭비는 Peclet수의 변화에 관계없이 비분산적이었으며 Peclet수가 1.0일때 가장 큰 값을 나타냈고, 위상지연은 참값에 대한 빈도요소보다 더 느리게 파동함을 나타냈다. 모델방정식의 안정성 해석 결과, 모델의 영역분해는 보다 정확한 결과를 얻기 위해서 Peclet수는 1.0보다 작고 Courant수는 3.0보다 작은 범위 안에서 분해하는 것이 좋은 것으로 분석된다.