• 한국통신학회논문지
• /
• 제39C권5호
• /
• pp.447-455
• /
• 2014

본 논문에서는 무안경식 3차원 영상처리 기법 중 대표적인 집적 영상 기법을 고려하여 전송 에러를 극복하여 영상 품질을 향상시키는 우선순위 전송 기법을 제안한다. 집적 영상의 각 복셀을 구성하고 있는 픽셀들의 유사성에 기반하여 전송 우선순위를 다르게 설정하고 이에 따라 변조 방식을 다르게 적용한다. 즉, 복셀을 구성하는 해당 픽셀들의 분산값이 작은 경우에는 높은 우선순위를 부여하여 에러에 강인한 특성을 갖는 변조 레벨을 사용하여 전송하고, 복셀을 구성하는 해당 픽셀의 분산값이 큰 경우에는 낮은 우선순위를 부여하여 에러율은 높아지지만 빠른 전송률을 제공하는 변조 기법을 사용하여 전송한다. 우선순위의 구분 없이 동일한 변조 레벨을 사용하는 기존 방식 대비, 우선순위가 높은 중요한 영상 데이터 비트열에 에러에 강인한 변조 레벨을 적용한 제안 방식의 경우에 수신 영상의 peak to sidelobe ratio (PSR)이 개선됨을 확인할 수 있다.

• 대한물리치료과학회지
• /
• 제3권2호
• /
• pp.951-961
• /
• 1996

Isokinetic exercise is dynamic, but the spped of movement must be regulated so that the resistance is in ratio to the force applied at each point throughout the full range of motion. The purpose of this study is to comparise with trunk flexors & extensors of isokinetic evaluation of pre-exercise and post-exercise in operated laminectomy & disectomy patients. 7 subjects were examined at $120^{\circ}$/sec and $60^{\circ}$/sec each 15 days. The results were as follows; 1. Peak torque of extensors on $60^{\circ}$/sec showed significant difference statistically(p<0.05), but peak torque of flexors on $60^{\circ}$/sec showed no significant difference statistically. 2. Trunk flexors/extensors ratio of peak torque of $60^{\circ}$/sec showed no significant difference ststistically. 3. Peak torque % B.W of extensors on $60^{\circ}$/sec showed significant difference statistically(p<0.05), but peak torque % B.W of flexors on $60^{\circ}$/sec showed no significant difference statistically. 4. TAE of extensors on $60^{\circ}$/sec showed significant difference statistically (p<0.05), but TAE of flexors on $60^{\circ}$/sec showed no significant difference. 5. Total work of flexors & extensors on $60^{\circ}$/sec showed significant difference statistically (p<0.05). 6. Average power of flexors & extensors on $120^{\circ}$/sec showed significant difference statistically(p<0.05). 7. Endurance ratio of flexors & extensors on $120^{\circ}$/sec showed no significant difference statistically. 8. Set total work of flexors & extensors on $120^{\circ}$/sec showed significant difference statistically(p<0.05). 9. TAE of extensors on $120^{\circ}$/sec showed significant difference statistically(p<0.05), TAE of flexors on $120^{\circ}$/sec showed no significant difference statistically. 10. Total work of flexors & extensors on $120^{\circ}$/sec showed significant difference statistically (p<0.05).

• 한국ITS학회 논문지
• /
• 제8권1호
• /
• pp.110-118
• /
• 2009

PB/MC-CDMA(Partial Block Multi Carrier Code Division Multilple Access) 시스템은 사용자간의 코드 간 간섭을 줄임으로써 성능을 향상 시키는 시스템이다. 또한, 이 시스템은 심볼 간 간섭을 피하면서 주파수 다이버시티 이득을 얻을 수 있어 MC-CDMA(Multi Carrier Code Division Multiple Access) 시스템보다 향상된 성능을 보여준다. 그러나, 다중캐리어를 사용함으로써 PAPR 문제가 발생하여 시스템의 성능을 저하 시킨다. 이 논문에서는, PB/MC-CDMA 시스템에서 추가적인 정보 없이 여분의 확산 코드를 이용하여 최적화된 확산코드를 선택함으로써, 피크전력을 줄이는 방법을 제안한다. PB/MC-CDMA 시스템은 각 블록 단위로 확산 코드를 재사용함으로써, 여분의 코드가 남게 된다. 이러한 여분의 코드를 여러 개의 그룹으로 나누어 PAPR(Peak to Average Power Ratio)을 계산하고, 피크전력이 최소가 되는 코드를 선택하여 전송함으로써 PAPR 문제를 해결할 수 있는 방법이다.

• 한국해양공학회지
• /
• 제29권5호
• /
• pp.342-350
• /
• 2015

A seismic reliability analysis of the jacket-type support structure for an offshore wind turbine was performed. When defining the limit state function using the dynamic response of the support structure, numerous dynamic calculations should be performedin an approach like the FORM (first-order reliability method). This causes a substantial increase in the analysis cost. Therefore, in this paper, a new reliability analysis approach using the static response is used. The dynamic effect of the response is considered by introducing a new parameter called the peak response factor (PRF). The probability distribution of the PRF could be estimated using the peak value of the dynamic response. The probability distribution of the PRF was obtained for a set of ground motions. A numerical example is considered to compare the proposed approach with the conventional static-response-based approach.

• 한국대기환경학회지
• /
• 제20권3호
• /
• pp.411-419
• /
• 2004

Titania particles are widely used as a photocatalyst to treat various contaminants in air and water. Titania particles were formed by vapor-phase oxidation of titanium tetraisopropoxide (TTIP) in a tube furnace between 773 and 1,273 K. The effect of process variables such as furnace temperature, flow rate of carrier air, and flow rate of sheath air on powder size and phase characteristics was investigated using a scanning mobility particle sizer (SMPS), transmission electron microscopy (TEM) and X-ray diffraction (XRD). The size distribution of synthesized titania particles was characterized with mode diameter and peak concentration. The mode diameter ranging from 20 to 80 nm decreased with increasing flow rates of sheath air and carrier air, and increased with increasing furnace temperature. The peak concentration increased with increasing flow rates of sheath air and carrier air The best synthetic condition for high production rate can be derived from the experimental data set represented by mode diameter and peak concentration. The crystal structure of synthesized titania particles was found to be anatase phase, ensuring high photocatalytic potential.

• Steel and Composite Structures
• /
• 제33권5호
• /
• pp.641-652
• /
• 2019

This paper investigates the effect of aftershocks on the seismic performance of self-centering (SC) prestressed concrete frames using the probabilistic seismic demand analysis methodology. For this purpose, a 4-story SC concrete frame and a conventional reinforced concrete (RC) frame are designed and numerically analyzed through nonlinear dynamic analyses based on a set of as-recorded mainshock-aftershock seismic sequences. The peak and residual story drifts are selected as the demand parameters. The probabilistic seismic demand models of the SC and RC frames are compared, and the SC frame is found to have less dispersion of peak and residual story drifts. The results of drift demand hazard analyses reveal that the SC frame experiences lower peak story drift hazards and significantly reduced residual story drift hazards than the RC frame when subjected to the mainshocks only or the mainshock-aftershock sequences, which demonstrates the advantages of the SC frame over the RC frame. For both the SC and RC frames, the influence of as-recorded aftershocks on the drift demand hazards is small. It is shown that artificial aftershocks can produce notably increased drift demand hazards of the RC frame, while the incremental effect of artificial aftershocks on the drift demand hazards of the SC frame is much smaller. It is also found that aftershock polarity does not influence the drift demand hazards of both the SC and RC frames.

• Current Optics and Photonics
• /
• 제4권6호
• /
• pp.472-476
• /
• 2020

We have investigated the impact of optical filter bandwidth on the performance of all-optical automatic gain-controlled (AGC) erbium-doped fiber amplifiers (EDFAs). In principle, an optical bandpass filter (OBPF) should be placed within the feedback gain-clamping loop to set the lasing wavelength as well as the passband of the feedback amplified spontaneous emission (ASE) in all-optical AGC EDFA. From our measurement results, we found that the power level of feedback ASE with 0.1 nm passband of the optical filter was smaller than the ones with >0.2 nm passband cases. Therefore, the peak-to-peak power variation of the surviving channel with 0.1 nm passband was much larger than the ones with >0.2 nm passband. In addition, no significant difference in the power level of the feedback ASE was observed when the passband of the optical filter was ranging from 0.2 nm to 4.5 nm in our measurements. From these results, we have concluded that the passband of the optical filter should be slightly larger than 0.2 nm by taking into account the effect of feedback ASE power and the efficient use of the EDFA gain spectrum for the lasing ASE peak.

• 대한임베디드공학회논문지
• /
• 제17권1호
• /
• pp.25-32
• /
• 2022

IR-UWB radar has been regarded as the most promising technology for non-contact respiration and heartbeat monitoring because of its ability of detecting slight motion even in submillimeter range. Measuring heart rate is most challenging since the chest movement by heartbeat is quite subtle and easily interfered with by a random body motion or background noise. Additionally, periodic sampling can be limited by the performance of computer that handles the radar signals. In this paper, we deploy Lomb-Scargle periodogram method that estimates heart rate even with irregularly sampled data and uneven signal amplitude. Lomb-Scargle periodogram is known as a method for finding periodicity in irregularly-sampled and noisy data set. We also implement a motion detection scheme in order to make the heart rate estimation pause when a random motion is detected. Our scheme is implemented using Novelda's X4M03 radar development kit and its corresponding drivers and Python packages. Experimental results show that the estimation with Lomb-Scargle periodogram yield more accurate heart rate than the method of measuring peak-to-peak distance.

• Structural Monitoring and Maintenance
• /
• 제9권2호
• /
• pp.201-220
• /
• 2022

Lateral vibrations of footbridges may induce synchronization between pedestrians and structure itself, resulting in amplification of such vibrations, a phenomenon identified by lock-in. However, investigations about accelerations and frequencies of the structural movement that are related to the occurrence of synchronization are still incipient. The aim of this paper is to investigate conditions that could lead to avoidance of synchronization among pedestrians themselves and footbridge, expressed in terms of peak acceleration. The focus is on the low acceleration range, employed in some guidelines as a criterion to avoid synchronization. An experimental campaign was carried out, employing a prototype footbridge that was set into oscillatory motion through a pneumatic exciter controlled by a fuzzy system, with controlled frequency and amplitude. Test subjects were then asked to cross the oscillating structure, and accelerations were simultaneously recorded at the structure and at the subject's waist. Pattern and phase differences between these signals were analysed. The results showed that test subjects tended to keep their walking patterns without synchronization induced by the vibration of the structure, for structural peak acceleration values up to 0.18 m/s², when frequencies of oscillation were around 0.8 to 0.9 Hz. On the other hand, for frequencies of oscillation below 0.7 Hz, structural peak accelerations up to 0.30 m/s² did not induce synchronization.

• Geomechanics and Engineering
• /
• 제31권2호
• /
• pp.183-195
• /
• 2022

Under the effects of the near-field earthquakes, the incident angle of the incoming wave could be different. In this study, the influences of some parameters such as incident angle, basin edge, peak ground acceleration level of the bedrock motion as well as different clay types with different consistency on the amplification behavior of the shallow basins are investigated. To attain this goal, the numerical analyses of the basins filled with three different clay types are performed using a fully nonlinear method. The two dimensional models of the basins are subjected to a set of strong ground motions with different peak ground acceleration levels and three different incident angles of 30◦, 45◦ and 90◦ with respect to the horizontal axes. The results show the dominant effect of the obliquely subjected waves at most cases. The higher effect of the 45◦ incident angle on the basin response was concluded. In the other part of this study, the spectral amplification curves of the surface points were compared. It was seen that the maximum spectral amplification of different surface points occurs at different periods. Also, it is affected by the increase in the peak acceleration level of the incoming motions.