• International Journal of Highway Engineering
• /
• v.18 no.6
• /
• pp.105-113
• /
• 2016

OBJECTIVES : This study is to develop the optimum mixing proportions for cement concrete pavement with using recycled aggregates. METHODS : The mixture varied recycled coarse aggregates content from 50 % to 100 % to replace the natural coarse aggregates by weight. Tests for fundamental properties as a cement concrete pavement were conducted before and after hardening of the concrete. RESULTS : It was found that the variation in the amount of the recycled aggregate affected the compressive and flexural strength development, as well as the chloride ion penetration resistance. As the amount of the recycled aggregate content increased the compressive and flexural strength and the resistance to chloride ion penetration decreased. However, the resistance to freeze-thaw reaction was affected significantly. In addition, the gradation of the aggregate became worse and hence so did the coarseness factor as the recycled aggregate amount increased. CONCLUSIONS : The fundamental properties of the concrete with recycled aggregate does not seem to be appropriate when the recycled aggregate quality is not guaranteed up to a some level and its replacement ratio is over 50%. The optimized gradation of the aggregates should also be sought when the recycled aggregate is used for the cement concrete pavement materials.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.27 no.4
• /
• pp.53-60
• /
• 1985

The plaster mixed to loam and sandy soil from 4 to 12 percent by dry soil weight, and the compaction, permeability, CBR, unconfined compressive strength and freezingthawing test were performed The results obtained are summarized as follows; 1.The coefficient of permeability reduced sharply at the plaster content of 4 percent, and in the CBR test, the swelling ratio reduced by the increment of plaster content. 2.The addition of plaster increased the unconfined compressive strength by the cementing effect, and it was found that the optimum plaster content, existed with the soil type, which showed the maximum strength 3.It was possible to enhance the unconfined compressive strength of the gypsum-lime-soil mixtures when the optimum content of plaster was mixed to the hydrated lime. 4.In case of sandy soil, the relative frost heave decreased with the mixture of plaster, however in loam soil, the relative frost heave began to increase at the plaster content of 12 percent than non-treated soil. Therefore the optimum plaster content existed for protecting frost heave by the different soil type. 5.The above summarized results make it possible to expect the effects such as improvement of soil properties, decrement of permeability, increment of unconfined compressive strength, and protection of frost heave, etc, therefore, it is considered that it is possible to it is plaster as sub-base materials of road.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.3 no.4
• /
• pp.38-43
• /
• 1999

An experimental study was carried out, in order to set up the procedure for evaluation of hot fire test, to investigate the effect of mixture on combustion performance and combustion stability , and to determine the optimum design condition for designing the liquid rocket engine. $HNO_3$/Kerosene uni-element liquid rocket engine(thrust 24 $\iota{b}_f$, chamber pressure 200 psia) using impinging streams doublet injector was designed, and ground hot-fire test was carried out. To prevent or reduce the hard start during ignition period, two step ignition method was used. This was accomplished by maintaining about 25% of the designed operating pressure doting transient period, then chamber pressure was built up to the designed operating pressure. Maximum combustion efficiency was at O/F ratio 3.6, and combustion efficiency is decreased with increasing momentum ratio.

• Textile Coloration and Finishing
• /
• v.28 no.3
• /
• pp.125-133
• /
• 2016

In this study, efforts were made to enhance the mechanical properties of the poly(vinyl alcohol) (PVA) fibers of medium molecular weight(number-average degree of polymerization=1735) varying the ratio in $DMSO/H_2O$ mixed solvent and spinning/drawing conditions. The gel fibers prepared from pure DMSO were opaquely frozen in the coagulating bath of $-20^{\circ}C$. However, transparent gel fibers were formed without freezing for the mixture to contain water less than 80wt%. As the amount of water in the mixture increased the residual solvent in the coagulated gel fibers decreased ranging from 85 to 42wt%. The complex viscosity increased with increasing PVA concentration in 80/20 $DMSO/H_2O$ exhibiting remarkable shear thinning at 18wt%. In the Cole-Cole plot, the 18wt% PVA solutions gave a deviated curve from 12 and 15wt% ones. Thus the optimum PVA concentration for the spinning processing of medium MW PVA solutions in 80/20 $DMSO/H_2O$ was determined to 18wt% with rheological concept. Low degree of drawing during hot drawing process in the dry state was available for high bath draft in the coagulation bath. The most improved mechanical properties were observed by applying the highest possible draw ratio attained by reducing bath draft over multi-step drawing process. In the given bath draft, linear relationship was observed between both tensile strength and modulus and draw ratio showing the inflection points at the draw ratio of 19.5 and 18.0 for tensile strength and modulus, respectively.

• Korean Journal of Soil Science and Fertilizer
• /
• v.47 no.6
• /
• pp.480-485
• /
• 2014

In satsuma mandarin (C. unshiu Marc. cv. Miyagawa), alternate bearing is frequently occurred. It is very difficult to control and maintain the optimum production because satsuma mandarin is a very sensitive citrus cultivar. We carried out the experiment to find out the effects of foliar application of gibberellic acid ($GA_3$) and machine oil emulsion mixture on flowering and fruit quality of satsuma mandarin grown on open field. The treatments were composed of control (no application), $GA_3$ (25, 50 and $100mg{\cdot}L^{-1}$), machine oil emulsion 100 times and mixture of $GA_3$ (25 and $50mg{\cdot}L^{-1}$) with machine oil emulsion 100 times on 16 year-old 'Miyagawa' satsuma mandarin on December 30, 2012. Foliar application of $GA_3$ during winter season led to a reduction of the flowering in the following year. $GA_3$ decreased flowering in dose dependant manner. However, application of $GA_3$ and machine oil emulsion (100 times-diluted mixture) inhibited effectively the flowering compared to $GA_3$ only. Also, flower-leaf ratio was significantly decreased by the application of $GA_3$ 25 (0.54) and $50(0.41)mg{\cdot}L^{-1}$ with machine oil emulsion mixture in comparison to $GA_3$ 25 (0.86) and $50(0.60)mg{\cdot}L^{-1}$ only. The number of leaves per fruit increased in application of $GA_3$ and machine oil emulsion mixture as concentration of $GA_3$ increased. Fruit weight and sugar-acid ratio also increased in comparison to the control whereas fruit size, soluble solid content and acidity remained unchanged. From the results, it was suggested that $GA_3$ application can reduce the number of flowers on the alternate bearing of satsuma mandarin. Moreover, application of $GA_3$ (25 and $50mg{\cdot}L^{-1}$) with machine oil emulsion 100 times mixture can reduce the flowering effectively without altering fruit maturity and soluble solid contents. Therefore, it can be concluded that the application of $GA_3$ 25 and $50mg{\cdot}L^{-1}$ with machine oil emulsion 100 times might be useful in controlling alternate bearing in satsuma mandarin.

• Journal of Environmental Science International
• /
• v.27 no.9
• /
• pp.737-742
• /
• 2018

Livestock manure treatments have become a more serious problem because massive environmental pollutions such as green and red tides caused by non-point pollution sources from livestock manures have emerged as a serious social issue. In addition, more food wastes are being produced due to population growth and increased income level. Since the London Convention has banned the ocean dumping of wastes, some other waste treatment methods for land disposal had to be developed and applied. At the same time, researches have been conducted to develop alternative energy sources from various types of wastes. As a result, anaerobic digestion as a waste treatment method has become an attractive solution. In this study has three objectives: first, to identify the physical properties of the mixture of livestock wastewater and food waste when combining food waste treatment with the conventional livestock manure treatment based on anaerobic mesophilic digestion; second, to find the ideal ratio of waste mixture that could maximize the collection efficiency of methane ($CH_4$) from the anaerobic digestion process; and third, to promote $CH_4$ production by comparing the biodegradability. As a result of comparing the reactors R1, R2, and R3, each containing a mixture of food waste and livestock manure at the ratio of 5:5, 7:3, and 3:7, respectively, R2 showed the optimum treatment efficiencies for the removal of Total Solids (TS) and Volatile Solids (VS), $CH_4$ production, and biodegradability.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.33 no.4
• /
• pp.15-20
• /
• 2001

The function of the moisture-proof paper is to prevent moisture from adsorbing into the packed goods. Water-vapor transmission rate of the moisture-proof paper should be less than 100g/$m^2$.24hr and the optimum rate would be less than 50g/$m^2$.24hr. In general the moisture-proof paper has been made by laminating polyethylene or polypropylene on top of the base paper. However this kind of moisture-proof paper has a problem in recycling so that it brings about environmental pollution. In general the moisture-proof paper has been made by laminating polyethylene or polypropylene on top of the base paper. However this kind of moisture-proof paper has a problem in recycling so that it brings about environmental pollution. The purpose of this paper was to make moisture-proof paper using the mixture of SB latex and wax emulsion which was recyclable and environmentally friendly. Water vapor transmission rate showed less than 50g/$m^2$.24hr in mixture ratio of 85:15, 87:13, 90:10. Especially the mixture ratio of 87:13 showed the most favorable water-vapor transmission rate. However, the moisture-proof layer was destroyed slightly by folding in packing. It has been observed that there was no close relationship between water-vapor transmission rate of the moisture-proof paper and grammage of the base paper, but the density of base paper had influenced on water vapor transmission rate. It was also observed that the moisture-proof paper could be recycled. The moisture-proof paper was similar to base paper in degree of the pulping, and there was no significant difference in dispersion between moisture-proof paper and base paper. Most of wax particles which caused the spots during drying process could be removed by flotation process. Tensile strength and tear strength of both moisture-proof paper and base paper after pulping were measured to examine the fiber bonding, and no significant difference in physical properties was observed.

• Resources Recycling
• /
• v.17 no.1
• /
• pp.29-37
• /
• 2008

Recently, domestically and internationally, the occurrences of Waste Glass are on the increase. Most of scrap glass are either reused of recycled. However, glass not recycled is buriedand is causing secondary environmental problem. With 5% mixture of Waste Glass, the average paste viscosity (rheology) decreased by 22.3% and 28-day compressive strength of mortar's flow and aging decreased by 1.5% and 6% respectively. Also, as Waste Glass mixture ratio of un-hardened elf-compacting concrete increased, fluidity increased and compressive strength decreased. In consideration of adequate compressive strength and fluidity that meets the 2nd class JSCE regulations; optimum mixture ratio of Waste Glass can be concluded as 20%.

• Fisheries and Aquatic Sciences
• /
• v.22 no.5
• /
• pp.11.1-11.8
• /
• 2019

Background: In the present study, the skin-whitening effects of a marine-sourced mixture that includes a fucoidanrich extract of Undaria pinnatifida (UPEF), a phlorotannin-rich extract of Ecklonia cava (ECE), and glycosaminoglycans (GAGs) from sea squirt skin were investigated. Methods: The whitening effects of the mixture and its components were evaluated by measuring the inhibition of mushroom tyrosinase and melanin synthesis in alpha-melanocyte-stimulating hormone (${\alpha}$-MSH)-stimulated B16F10 melanoma cells. Results: Each component alone markedly inhibited mushroom tyrosinase in a dose-dependent manner, and in ${\alpha}$-MSH-stimulated B16F10 cells, they inhibited melanin synthesis and were cytotoxic. However, the whitening effects of UPEF, ECE, and GAGs in combination were greater than those of each component alone. A mixture in the ratio of 4:5:1 (UEG-451) showed the strongest activity without cytotoxicity. Further study suggested that UEG-451 inhibits ${\alpha}$-MSH-stimulated melanogenesis in B16F10 cells by downregulating tyrosinase and tyrosinase-related proteins, such as TRP-1 and TRP-2, via the inhibition of MITF expression. Conclusions: These results suggest that mixing the different components at optimum ratios might be an effective way to improve their bioactivities and reduce toxicity and that UEG-451 possesses strong whitening effects that could be used in the cosmetic industry.

• Journal of the Korean GEO-environmental Society
• /
• v.6 no.4
• /
• pp.5-12
• /
• 2005

In this study, the geotechnical applicability of permeable barriers that could filter the leachate from a landfill was evaluated. Specimens were cast from sand, loess and bentonite according to the specific weight ratios of them. A series of experiments are performed to determine the unconfined compressive strength and permeability of various mixing ratio of bentonite, loess, and sand. From the laboratory test, optimum mixing ratio that satisfied the regulations of unconfined compressive strength($5kgf/cm^2$) and coefficient of permeability ($10^{-3}{\sim}10^{-4}cm/sec$) in landfill was found when the weight ratio of sand and loess was 8:2 with 2% of bentonite. Using the laboratory test data and in situ test results, the applicability of the wall will be tested for various conditions.