• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.792-793
• /
• 2005

Circuit testing process is very important in IC Manufacturing there are two ways in research for circuit testing improvement. These are ATPG Tool Design and Test simulation application. We are interested in how to use parallel technique such as one-side communication, parallel IO and dynamic Process with data partition for circuit testing improvement and we use one-side communication technique in this paper. The parallel ATPG Tool can reduce the test pattern sets of the circuit that is designed in laboratory for make sure that the fault is not occur. After that, we use result for parallel circuit test simulation to find fault between designed circuit and tested circuit. From the experiment, We use less execution time than non-parallel Process. And we can set more parameter for less test size. Previous experiment we can't do it because some parameter will affect much waste time. But in the research, if we use the best ATPG Tool can optimize to least test sets and parallel circuit testing application will not work. Because there are too little test set for circuit testing application. In this paper we use a standard sequential circuit of ISCAS89.

• Journal of Periodontal and Implant Science
• /
• v.42 no.2
• /
• pp.45-49
• /
• 2012

Purpose: The aim of the present clinical trial was to compare pain during injection of anterior middle superior alveolar (AMSA) technique with that of infiltration injection technique in the maxilla in periodontal flap surgeries of patients referring to the Department of Periodontics, Faculty of Dentistry, Tabriz University of Medical Sciences. Methods: Twenty subjects with an age range of 20 to 40 years were selected for the present study. One side of the maxilla was randomly selected as the test side and the other as the control side using a flip of a coin. AMSA technique was used on the test side and infiltration technique was used on the control side for anesthesia. On both sides 2% lidocaine containing 1:80,000 epinephrine was used for anesthesia. The operator obtained the visual analogue scale for each patient immediately after the injection and immediately after surgery. Data was analyzed using descriptive statistical methods (frequency percentages, means and standard deviations) and Wilcoxon's test using SPSS ver. 13 (SPSS Inc.). Statistical significance was defined at P<0.05. Results: There were no statistically significant differences in pain during injection between the two techniques (P=0.856). There were statistically significant differences in postoperative pain between the two injection techniques (P=0.024). Conclusions: Postoperative pain in AMSA injection technique was less than that in the infiltration technique. Therefore, the AMSA technique is preferable in the periodontal surgeries for the anesthesia of palatal tissues given the fact that it has other advantages, too.

• Archives of Plastic Surgery
• /
• v.36 no.5
• /
• pp.642-648
• /
• 2009

Purpose: Hexadactyly without thumb is a rare congenital anomaly of the hand where six triphalangeal digits are symmetrically distributed without thumb. Contrary to mirror hands, triphalangeal six digits are symmetrically distributed on each side at the midline with well - differentiated carpal bones, extensor tendons, one ulnar and one radius. The authors developed a new surgical technique based on a three - dimensional concept to correct the hexadactyly and applied to 2 cases of hexadactyly with good functional and aesthetic results. Here we document the surgical technique and its result. Methods: A 16 month old male patient visited our clinic with chief complaints of bilateral hexadactyly deformity. On physical examination most radial first and second digits showed no opposition and adduction motion on both side hands. Radiography showed 6 triphalangeal digits with normal development of carpal, radial and ulnar bone. Right side abnormality was corrected by removal of most radial side extra - digit, rotation and migration of 2nd ray to thumb position and creation of 1st web by transposing a mid - palm based rectangular palmar flap as in Snow & Littler procedure which has been being applied for correction of 1st web syndactyly in cleft hand deformity. Seven months later, left side abnormality was also corrected with the same procedure. Results: Postoperative appearances of the both hands were satisfactory. Flexion, extension, opposition and grasping were possible with the pollicized 2nd ray. Pinching power was 3.0 kg 15 months after surgery and 2.5 kg 22 months after in right hand respectively. Conclusion: In correction of hexadactyly deformity, satisfactory aesthetic and relevant functional results can be expected with authors' newly developed technique: removal of most radial digit, rotation and migration of 2nd digit to thumb position as well as creation of the 1st web space by transposition of mid - palm based rectangular flap.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.5
• /
• pp.1762-1773
• /
• 2014

In this paper, a distributed image coding scheme for multi-view video through an efficient generation of side information is proposed. A distributed video coding technique corrects the errors in the side information, which is generated with the original image, by using the channel coding technique at the decoder. Therefore, the more correct the generated side information is, the better the performance of distributed video coding. The proposed technique is to apply the distributed video coding schemes to the image coding for multi-view video. It generates side information by selectively and efficiently using both 3-dimensional warping based on the depth map with spatially adjacent frames and motion-compensated temporal interpolation with temporally adjacent frames. In this scheme the difference between the adjacent frames, the sizes of the motion vectors for the adjacent blocks, and the edge information are used as the selection criteria. From the experiments, it was observed that the quality of the side information generated by the proposed technique was improved by the average peak signal-to-noise ratio of 0.97dB than the one by motion-compensated temporal interpolation or 3-dimensional warping. The result from analyzing the rate-distortion curves revealed that the proposed scheme could reduce the bit-rate by 8.01% on average at the same peak signal-to-noise ratio value, compared to previous work.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.467-472
• /
• 2008

One of the maindisadvantages of Orthogonal Frequency Division Multiplexing (OFDM) is the Peak to Average Power Ratio (PAPR) problem. To reduce PAPR and improve the error performance of the OFDM signal over a fading channel, an OFDM system combining an Adaptive Symbol Selection Scheme (ASSS) and channel estimation can be used. Because of the side information of ASSS, however, the data rate decreases in the conventional ASSS OFDM system. In this letter, to overcome this impairment, we propose a technique to transmit side information by using pilot tones, and demonstrate that the proposed technique can give reasonable bit error rate (BER) performance.

• Journal of the Korean Academy of Esthetic Dentistry
• /
• v.9 no.1
• /
• pp.48-57
• /
• 2000

Direct bonded restoration with composite resin is one of the few areas which the achievement and result are available in chair side. Especially free-hand bonding technique and incremental technique give us challengeable opportunity for restoring severely damaged anterior teeth. If clinicians have keen sense of observation to evaluate polychromatic characteristics of natural teeth, hue, chroma, value, translucency, opacity and correlate the observation result with various kinds of composite resins, they will have privilege to share joy from restoring damaged anterior teeth in chair side immediately.

• Archives of Reconstructive Microsurgery
• /
• v.8 no.1
• /
• pp.92-96
• /
• 1999

Neuroma is formed by abnormal, incomplete nerve regeneration after nerve injury. A painful neuroma in the hand can be psychologically and physically disabling. The goal of treating painful neuroma is to relieve pain and to restore nerve function. A numerous treatment modality was reported for alleviating the problem. These treatments include crushing the neuroma, ligating it, burying in soft tissue, bone, and muscle, injecting it with alcohol, phenol, and steroid, capping it with silicone cuff. But, none of these methods has been uniformly successful, although each has its advocates. No one technique reliably prevents formation of a painful neuroma. However, the principles of treatment is resection of neuroma and proximal stump of the nerve is transposed to appropriate adjacent tissue. Our current technique was resection of neuroma with partial normal neural tissue, and then the nerve ending was transposed and sutured to the side of the proximal stump with 10-0 nylon, so end-to-side neurorrhaphy was made. The nerve ending had to be placed and fixed into the proximal nerve epineurium like as a figure of a loop. We believe this technique is another useful method for the treatment of painful neuroma.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.19 no.2
• /
• pp.3-9
• /
• 2009

In this paper we introduce a new side-channel attack using block cipher cryptanalysis named meet-in-the middle attack. Using our new side-channel technique we introduce side-channel attacks on AES with reduced masked rounds. That is, we show that AES with reduced 10 masked rounds is vulnerable to side channel attacks based on an existing 4-round function. This shows that one has to mask the entire rounds of the 12-round 192-bit key AES to prevent our attacks. Our results are the first ones to analyze AES with reduced 10 masked rounds.

• ETRI Journal
• /
• v.38 no.6
• /
• pp.1135-1144
• /
• 2016

Fractal antenna arrays are geometry-based thinned arrays having multiband applications. The major challenge of these arrays is their large number of elements at higher expansion factors. This article presents the thinning of fractal antenna arrays while maintaining an appropriate balance between the side lobe level and beam width by using various quantized fractal distribution functions. A 2D square fractal antenna array and 3DSierpinski gasket antenna array are considered in this article to validate the proposed distribution functions. Nearly one third of the antenna elements are thinned in each successive iteration except in the case of a one-count distribution function. The proposed technique can simplify practical implementation and exhibits better performance for various parameters such as the side lobe level, side lobe angle, and half power beam width than fully populated fractal antenna arrays.

• Proceedings of the KSME Conference
• /
• 2004.04a
• /
• pp.420-425
• /
• 2004

Lee and Kang measured side-necking deformation near a crack-tip for CT specimen using Stereoscopic Digital Speckle Photography and Digital Image Correlation. In this work the same technique was applied to SENB specimen. We happened to find that the deformation shape of the side-necking is similar to the one of plastic region estimated by McClictock using slip line theory. Based on volume constancy of plastic deformation as well as this finding, it is expected that a linear relationship holds between the volume of plastic deformation region and the one of side-necking upon the lateral surface of a specimen. To prove the idea, a preliminary study has been performed using 3-D finite element method on a model with modified boundary layer formulation. As the result, it is shown that the idea works well with acceptable error.