• Tribology and Lubricants
• /
• v.26 no.1
• /
• pp.73-77
• /
• 2010

One of the important trends for condition monitoring in the 21st century is the development of smart sensors that will permit the cost-effective continuous monitoring of key machine equipments. In this study, an integrated in-line oil monitoring sensor assigned for continuous in situ monitoring multiple parameters of oil performance is presented. The sensor estimates oil deterioration based on the information about chemical degradation, total contamination, water content of oil and oil temperature. The oil oxidation is estimated by "chromatic ratio", total contamination is measured by the changes in optical density of oil in three optical wave-bands ('Red', 'Green' and 'Blue') and water content is evaluated as relative saturation of oil by water. In order to evaluate the sensor's effectiveness, the sensor was applied to several used oil samples in steel making industry and the results were compared with those measured by standard test methods.

• Tribology and Lubricants
• /
• v.19 no.5
• /
• pp.251-258
• /
• 2003

New method and device for the on-line measurement of soot concentration in a diesel engine oil are proposed, where the measurement principle is based mainly on attenuated internal total reflection. The detector were evaluated in various ranges of contaminated oils by carbon black particles. It was found that the proposed detector could be well used to monitor the oil deterioration due to soot contamination. Operational range of the detector was found from 0 to 5 mass percentage of soot content. Test results with water and fuel dilution showed that these effects were not remarkable. However, adsorption of carbon black particles onto the measurement surface was considered to be a critical problem of the detector. Effects of particle deposition on the interface was experimentally evaluated with the oil temperature and flow turbulence and discussed throughout this work.

• Journal of the Korean Society of Safety
• /
• v.7 no.3
• /
• pp.22-29
• /
• 1992

Emulsion-type cometics contain many kinds of carbon and energy source i.e., vegetable oil, mineral oil and carbohydrate etc., those can be used as nutrients and caused contamination by microbials. Thereby we have to keep cosmetics from the possibility of contamination by microbials. From this viewpoint, the purpose of this study is to get the data necessary not only to prevent dermatopathia occurred by microbials but also to sustain the quality. In this experiment, we observed how many Staphylococcus aureus were grown in the prepared cosmetics with or without antiseptics so as to prevent contamination. When the contamination proceed, the stability of phase was disturbed and creaming phenomina was happened with some discoloration and bad smell. About 40 days after, the pH was changed from 7.6 to 6.5 and the refractive index of cosmetic raw materials were changed from 1.4415 to 1.4490(water : oil=70:30). By adding antiseptics Into prepared cosmetics, the number of Staphylococcus aureus with challenge test method were decreased to 7$\times$103 cell/ml. For the antibacterial effect against Staphylococcus aureus, p-hydroxy benzoic acid propyl ester in phosphoric acid buffer solution was the best.

• The Korean Journal of Malacology
• /
• v.27 no.1
• /
• pp.77-86
• /
• 2011

The unwanted artificial oil-spill has severely contaminated the coastal environment in the world. Level of contamination has so far been monitered by various indicator species including mussel, oysters, flounder, and cockle. In this study, we decided to use the oyster as a model organism to observe the morphological changes being exposed to the artificial oil-spill in the coastal areas in Taean, Korea. The oysters were collected from four local sites (Sindu-ri, Uiwang-ri, Jonghyeon-dong, Ansan and Uihang-ri) exposed to various levels of pollution after an oil spill in Taean. Microscopic analysis of the hepatopancreatic microstructure in the digestive gland from the collected oysters show that the swelling, whorl, and destruction phenomenon of the nuclear membrane, a well-known microstructure induced by heavy metal exposure, was observed. Nuclear body (Nb), another typical characteristic of contamination or infection were also observed in some samples. Necrosis was observed in tissue samples collected from the area with a high degree of oil pollution. In addition, parasite-like particles (virus, perkinsus) were observed in most samples. Taken together, these results suggest that oil contamination in the oyster habitats influences the cytopathological changes in Crassostrea gigas.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.1
• /
• pp.46-51
• /
• 2006

This paper reports on the effects of silicone oils, used as processing agents, on the recovery of hydrophobicity of silicone rubber. The recovery of hydrophobicity was evaluated by the measuring the contact angle, the surface electrical resistance and SEM. Here, we formed artificial contamination on the surface of samples, which scratched by sand papers and alumina powders. There was small recovery of hydrophobicity on the surface of SIR-A that silicone oil was not added. In both oil-added samples, SIR-B and SIR-C, recovery of hydrophobicity was achieved greatly. The surface of SIR-C showed that a lot of silicone oil was observed due to migration of oil, relatively in comparison with SIR-B. The tendency of recovery of hydrophobicity expressed by contact angle was in a good agreement with electrical property as determined by surface resistivity.

• Journal of the Korean Society of Safety
• /
• v.32 no.1
• /
• pp.15-20
• /
• 2017

A large amount of research has been performed on the rolling contact fatigue(RCF) life of bearings, since it directly affects the safety and reliability of mechanical systems. It is well known that rolling contact fatigue life is influenced by several parameters including contact pressure, oil contamination by water or metal particles, and the surface conditions of bearings. However, the detailed damage mechanisms involved in rolling contact fatigue have not been clearly identified yet. In this paper the effects of water contamination of the lubricant and surface roughness of bearing steel on the rolling contact fatigue life were investigated. Two types of specimens with different surface roughness values were prepared through turning and lapping operations. They were tested under two different lubrication conditions, i.e. oil lubricant with 100% of oil and the water contaminated condition with 80% of oil and 20% of water using the rolling contact fatigue testing machine. The surface damage induced by the rolling contact fatigue was observed by using atomic force microscope(AFM). Experimental results show that the rolling contact fatigue life, $L_{10}$ was reduced by 24 to 33% depending on the lubrication condition. The reduction of fatigue life in the range of 53 to 57% was also observed at different surface roughness conditions.

• Journal of Soil and Groundwater Environment
• /
• v.15 no.1
• /
• pp.19-28
• /
• 2010

Considering six screen matrix to select an optimum remediation method for the Kunsan military base contaminated with petroleum oil, the following order was obtained: landfarming > biopile > soil washing > thermal desorption = incineration. When the landfarming method was applied for the remediation of 2,250 $m^3$ soil contaminated with petroleum oil ranging from 500 to 2,404 mg/kg as TPH, contamination level decreased below target concentration 450 mg/kg after 20~42 days depending on the initial contamination. From the evaluation of case studies of landfarming, it is suggested that ratty-truss or single-arch structure is suitable in the landfarming plant for the treatment of large-scale contaminated soil requiring long period of remediation. But, vinyl-house structure is suitable in the landfarming plant for the treatment of small-scale contaminated soil requiring short period of remediation. Therefore vinyl-house structure is recommended in the remediation of contaminated soil less than 5,000 $m^3$ requiring within 1 year of remediation period but ratty-truss or single-arch structure is recommended for the remediation of contaminated soil more than 5,000 $m^3$.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2006.04a
• /
• pp.424-427
• /
• 2006

Soil contamination with petroleum oil around a military army was investigated. It showed that soils of a riverside highland, an entrance of the military army, and nearby roads were contaminated with total petroleum hydrocarbons (TPH) released from the military army to the depth of approximately 2 m. The measured concentrations were as high as 15,277 mg/kg. A wide range of soil in the riverside highland was contaminated by the movement of oil to the surface soil, which occurred with the vertical movement of groundwater table caused by the change of river water level and groundwater level. Spilled petroleum oil components were released into Wonju Stream by the increase of hydraulic conductivity and the groundwater flow.

• Journal of Soil and Groundwater Environment
• /
• v.10 no.2
• /
• pp.28-34
• /
• 2005

The aim of this article is to assess the application characteristics of the site by remediating oil-contaminated area using DSB (Deep-site Biopile) system. In the contaminated area, the soil was composed of penetrable sand and the leaked oil was spread widely (total 7,201 cubic meters) through 2.5 meter deep underground water flow. DSB system was operated for 30 minutes intervals for 24 hours in a day (30 minutes opεration and 30 minutes stop). To check contamination level change in the contaminated area after DSB system was operated, samples were taken. The result from the site shows that BTEX/TPH contamination level was dropped 50% after 30-day operation of DSB system, and that contamination level was dropped below contamination level check standard after 165 days and the remediation was completed. Unlike traditional biological remediation methods DSB system could efficiently process soil and water which were contaminated by high levels of oil compounds.

• Applied Chemistry for Engineering
• /
• v.27 no.6
• /
• pp.664-668
• /
• 2016

The contamination in soil, underground water and river environment became serious due to illegal waste dumping. In this study, our research group analyzed the oil species of illegally disposed oils from J City. After pretreating the mixture of oil, water and solid phases to obtain homogeneous phase components, the physical property analysis, atom analysis, and gas chromatography were performed. From the results showing 11.8% of oxygen content, $-6^{\circ}C$ of pour point and chromatogram pattern. the contaminated oil was identified as a vegetable one. High performance liquid chromatography (HPLC) analysis was also performed in order to know what kind of vegetable oil was, and the ratio of LLO, OOL and POL was found to be high indicating that the disposed oil is majorly the used soybean oil with some vegetable oil mixtures. This study can be used for identifying contaminators for oils from the illegal waste dumping.