• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 춘계학술대회 논문집
• /
• pp.69-72
• /
• 2008

The local water contents and water transfer characteristics in the PEMFC system were investigated by numerical simulations and experiments. The performance of a lab-scale PEMFC is measured for fully humidified gases conditions and non-humidified ones. In order to observe the local water contents and water transfer characteristics inside PEMFC, the numerical simulation using CFD module on STAR-CD(es-pemfc) were conducted. The results show that the water content was increased as increasing current density, whereas it was decreased in high current density region. Then there was close correlation between high water content and internal temperature inside of MEA, and high current density was observed when internal temperature was dramatically increased.

• 대한기계학회논문집B
• /
• 제21권5호
• /
• pp.615-627
• /
• 1997

An experiment was performed to local heat transfer coefficient and Nusselt number in the circular duct of 180.deg. bend for Re=6*10$^{4}$, 8*10$^{4}$ and 1*10$^{5}$ at swirling flow and non-swirling flow conditions. The test tube with circular section was made by stainless which has curvature ratio 9.4. The wall of test tube was heated directly by electrical power to 3.51 kw and swirling motion of air was produced by a tangential inlet to the pipe axis at the 180 degree. Measurements of local wall temperatures and bulk mean temperature of air are made at four circumferential positions in the 16 stations. The wall temperatures show particularly reduced distribution curve at bend for non-swirling flow but this effect does not appear for swirling flow. Nusselt number distributions for swirling flow which was calculated from the measured wall and bulk temperatures were higher than that of non-swirling flow. Average Nusselt number of swirling flow increased about 90 ~ 100% than that of non-swirling flow whole through the test tube. The Nu/N $u_{DB}$ values at the station of 90.deg. for non-swirling flow and swirling flow are respectively about 2.5 and 4.8 at Re=6*10$^{4}$. Also that is good agreement with Said's result for non-swirling flow. flow.

• Structural Engineering and Mechanics
• /
• 제82권3호
• /
• pp.325-341
• /
• 2022

Previous major earthquakes indicated that the earthquake induced ground motions are typical non-stationary processes, which are non-stationary in both amplification and frequency. For the convenience of aseismic design and analysis, it usually assumes that the ground motions at structural supports are stationary processes. The development of time-frequency analysis technique makes it possible to evaluate the non-stationary responses of engineering structures subjected to non-stationary inputs, which is more general and realistic than the analysis method commonly used in engineering. In this paper, the wavelet-based stochastic vibration analysis methodology is adopted to calculate the non-stationary responses of multi-support structures. For comparison, the stationary response based on the standard random vibration method is also investigated. A frame structure and a two-span bridge are analyzed. The effects of non-stationary spatial ground motion and local site conditions are considered, and the influence of structural property on the structural responses are also considered. The analytical results demonstrate that the non-stationary spatial ground motions have significant influence on the response of multi-support structures.

• 대한수학회보
• /
• 제50권3호
• /
• pp.705-717
• /
• 2013

In this paper, we study the geometry of half lightlike submanifolds M of a semi-Riemannian manifold $\tilde{M}$ with a semi-symmetric non-metric connection subject to the conditions; (1) the characteristic vector field of $\tilde{M}$ is tangent to M, the screen distribution on M is totally umbilical in M and the co-screen distribution on M is conformal Killing, or (2) the screen distribution is integrable and the local lightlike second fundamental form of M is parallel.

• 한국컴퓨터정보학회논문지
• /
• 제22권10호
• /
• pp.189-194
• /
• 2017

The purpose of this study was to find out the necessary conditions and factors what effect as a society member through the students with disabilities to have a positive and mutual peer relationship with their classmates in the school and by them analyzed formation process and elucidate signification. The research method focused on the data summarized and enumerated through the investigation methods such as two in-depth interviews and two observation activities part, and the data which are commonly stated or observed in the data. The results of this study start that the factors of peer relationship formation between children with disabilities and their with non-disabled children are caused by lack of prejudice or lack of awareness. However, continuous cognizance improvement program, teacher's education guidance, the age have presence sense and subject about friend equating idea was mainly shown of school education or local community.

• Structural Engineering and Mechanics
• /
• 제25권1호
• /
• pp.53-73
• /
• 2007

In this study, an effective load increment method for multi modal adaptive non-linear static (pushover) analysis (NSA) for building type structures is presented. In the method, lumped plastisicity approach is adopted and geometrical non-linearties (second-order effects) are included. Non-linear yield conditions of column elements and geometrical non-linearity effects between successive plastic sections are linearized. Thus, load increment needed for formation of plastic sections can be determined directly (without applying iteration or step-by-step techniques) by using linearized yield conditions. After formation of each plastic section, the higher mode effects are considered by utilizing the essentials of traditional response spectrum analysis at linearized regions between plastic sections. Changing dynamic properties due to plastification in the system are used on the calculation of modal lateral loads. Thus, the effects of stiffness changes and local mechanism at the system on lateral load distribution are included. By using the proposed method, solution can be obtained effectively for multi-mode whereby the properties change due to plastifications in the system. In the study, a new procedure for determination of modal lateral loads is also proposed. In order to evaluate the proposed method, a 20 story RC frame building is analyzed and compared with Non-linear Dynamic Analysis (NDA) results and FEMA 356 Non-linear Static Analysis (NSA) procedures using fixed loads distributions (first mode, SRSS and uniform distribution) in terms of different parameters. Second-order effects on response quantities and periods are also investigated. When the NDA results are taken as reference, it is seen that proposed method yield generally better results than all FEMA 356 procedures for all investigated response quantities.

• 설비공학논문집
• /
• 제3권1호
• /
• pp.78-85
• /
• 1991

An experimental result for heat transfer of pulsating turbulent pipe flow was presented under the condition of fully developed dynamic regime and uniform wall heat flux. Experiments were performed at following conditions ; Inlet time-averaged Reynolds number varied from 5000 to 11000; The peak pressure fluctuation were 1.3, 2.3 and 3.5 percent of the mean pressure; Pulsating frequency ranged from 53 Hz to 320 Hz The measurements showed that the effect of pulsation on local heat transfer is greater at downstream, in which pulsating source exists, than upstream and the heat transfer rate, averaged over the pipe length, was higher or lower than in an equivalent non-pulsating flow according to the pulsating conditions. In addition, the significant change of heat transfer rate was observed in acoustically resonant conditions, when the pulsating frequency of the flow corresponded to the pipe natural frequency.

• Nuclear Engineering and Technology
• /
• 제31권1호
• /
• pp.29-48
• /
• 1999

Local two-phase flow parameters of subcooled flow boiling in inclined annulus were measured to investigate the effect of inclination on the internal flow structure. Two-conductivity probe technique was applied to measure local gas phasic parameters, including void fraction, vapor bubble frequency, chord length, vapor bubble velocity and interfacial area concentration. Local liquid velocity was measured by Pilot tube. Experiments were conducted for three angles of inclination; 0$^{\circ}$(vertical), 30$^{\circ}$, 60$^{\circ}$. The system pressure was maintained at atmospheric pressure. The range of average void fraction was up to 10% and the average liquid superficial velocities were less than 1.3 m/sec. The results of experiments showed that the distributions of two-phase How parameters were influenced by the angle of channel inclination. Especially, the void fraction and chord length distributions were strongly affected by the increase of inclination angle, and flow pattern transition to slug flow was observed depending on the How conditions. The profiles of vapor velocity, liquid velocity and interfacial area concentration were found to be affected by the non-symmetric bubble size distribution in inclined channel. Using the measured distributions of local phasic parameters, an analysis for predicting average void fraction was performed based on the drift flux model and flowing volumetric concentration. And it was demonstrated that the average void fraction can be more appropriately presented in terms of flowing volumetric concentration.

• 한국지역사회생활과학회지
• /
• 제25권3호
• /
• pp.363-372
• /
• 2014

This study was examined the quality characteristics of 20 types of non-sterilized commercial Makgeolli. These samples are classified according to firm size, enterprise Makgeolli(4 samples), prize-winning Makgeolli(6) and local Makgeolli(10). The alcohol contents of Makgeolli was determinded as follows: enterprise Makgeolli(6.18%), local Makgeolli(7.11%), and award-winning( 7.87%). Enterprise Makgeolli(0.24%) showed higher total acidity than award-winning and local Makgeolli(0.21%). In addition, pH levels were as follows: local Makgeolli(3.75), award-winning Makgeolli(3.77), and enterprise Makgeolli(4.09). Enterprise Makgeolli had the lowest sugar content. According to the sensory evaluation, three grades were identified based on balance and taste(5 points). The upper grade(more than 3 points) showed a higher pH, reducing sugar, higher aminoacidity, more soluble solids, and larger color differences than other grades. There were no significant differences in the level of acidity across the grades. The alcohol and volatile acid contents of the upper grade were lower than the middle(2.0-2.9 points) and lower(under 2.0 points) grades. Further research should provide a quality analysis of leavening agents and fermentation conditions, and a sensory evaluation.

• 한국환경과학회지
• /
• 제19권2호
• /
• pp.137-148
• /
• 2010

This paper investigates the characteristics of turbulence schemes. Turbulence closures are fundamental for modeling the atmospheric diffusion, transport and dispersion in the boundary layer. In particular, in non-homogeneous conditions, a proper description of turbulent transport in planetary boundary layer is fundamental aspect. This study is based on the Regional Atmospheric Modeling System (RAMS) and combines four different turbulence schemes to assess if the different schemes have a impact on simulation results of vertical profiles. Two of these schemes are Isotropc Deformation scheme (I.Def) and Anisotropic deformation scheme (A.Def) that are simple local scheme based on Smagorinsky scheme. The other two are Mellor-Yamada scheme (MY2.5) and Deardorff TKE scheme (D.TKE) that are more complex non-local schemes that include a prognostic equation for turbulence kinetic energy. The simulated potential temperature, wind speed and mixing ratio are compared against radiosonde observations from the study region. MY2.5 shows consistently reasonable vertical profile and closet to observation. D.TKE shows good results under relatively strong synoptic condition especially, mixing ratio simulation. Validation results show that all schemes consistently underestimated wind speed and mixing ratio but, potential temperature was somewhat overestimated.