• Water Engineering Research
• /
• v.3 no.1
• /
• pp.31-44
• /
• 2002

The effect of diurnal cycle, intermittent visit of observation satellite, sensor installation, partial coverage of remote sensing, heterogeneity of soil properties and precipitation to the soil moisture estimation error were analyzed to present the global sampling strategy of soil moisture. Three models, the theoretical soil moisture model, WGR model proposed Waymire of at. (1984) to generate rainfall, and Turning Band Method to generate two dimensional soil porosity, active soil depth and loss coefficient field were used to construct sufficient two-dimensional soil moisture data based on different scenarios. The sampling error is dominated by sampling interval and design scheme. The effect of heterogeneity of soil properties and rainfall to sampling error is smaller than that of temporal gap and spatial gap. Selecting a small sampling interval can dramatically reduce the sampling error generated by other factors such as heterogeneity of rainfall, soil properties, topography, and climatic conditions. If the annual mean of coverage portion is about 90%, the effect of partial coverage to sampling error can be disregarded. The water retention capacity of fields is very important in the sampling error. The smaller the water retention capacity of the field (small soil porosity and thin active soil depth), the greater the sampling error. These results indicate that the sampling error is very sensitive to water retention capacity. Block random installation gets more accurate data than random installation of soil moisture gages. The Walnut Gulch soil moisture data show that the diurnal variation of soil moisture causes sampling error between 1 and 4 % in daily estimation.

• Journal of Ginseng Research
• /
• v.6 no.2
• /
• pp.168-203
• /
• 1982

Effects of soil moisture on growth of Panax ginseng, of various factors on soil moisture, and of moisture on nutrition, quality, physiological disorder, diseases and insect damage were reviewed. Optimum soil moisture was 32% of field capacity with sand during seed dehiscence, and 55-65% for plant growth in the fields. Optimum soil moisture content for growth was higher for aerial part than for root and higher for width than for length. Soil factors for high yield in ginseng fields appeared to be organic matter, silt, clay, agreggation, and porosity that contributed more to water holding capacity than rain fall did, and to drainage. Most practices for field preparation aimed to control soil moisture rather than nutrients and pathogens. Light intensity was a primary factor affecting soil moisture content through evaporation. Straw mulching was best for the increase of soil moisture especially in rear side of bed. Translocation to aerial part was inhibited by water stress in order of Mg, p, Ca, N an Mn while accelerated in order of Fe, Zn and K. Most physiological disorders(leaf yellowing, early leaf fall, papery leaf spot, root reddening, root scab, root cracking, root dormancy) and quality factors were mainly related to water stress. Most critical diseases were due to stress, excess and variation of soil water, and heavy rain fall. The role of water should be studied in multidiciplinary, especially in physiology and pathology.

• YAKHAK HOEJI
• /
• v.47 no.3
• /
• pp.148-153
• /
• 2003

Skin moisture is an important factor in skin health. Measurement of moisture content can provide diagnostic information on the condition of skin. In this study, a portable near-infrared (NIR) system was newly integrated with a photo diode array detector that has no moving parts, and this system has been successfully applied for the evaluation of human skin moisture. Diffuse reflectance spectra were collected and transformed to absorbance using 1 nm step size over the wavelength range of 1100 nm to 2200 nm. Partial least squares regression (PLSR) was applied to develop a calibration model. For practical use for the evaluation of human skin moisture, the PLS model for human skin moisture was developed in vivo using the portable NIR system on the basis of the relative water content values of stratum corneum from the conventional capacitance method. The PLS model showed a good correlation. The calibration with the use of PLS model predicted human moisture with a standard error of prediction (SEP) of 3.5 at 1120∼1730 nm range. This study showed the possibility of skin moisture measurement using portable NIR system.

• Journal of the Korean Wood Science and Technology
• /
• v.15 no.2
• /
• pp.113-119
• /
• 1987

A study was conducted to determine the kiln drying schedule for hydrid aspen, This kiln drying schedule was found by oven drying method and developed by pilot testing of 2.0cm, 2.5cm, 3.0cm-thick green lumber. The results of this study were as follows: 1. Kiln drying schedule developed by oven-drying method was $T_{12}-E_5$ for 2.5cm-thick green lumber. 2. Drying times for 2.0cm-thick green lumber(127.0 percent moisture content) to 7.3 percent moisture content, for 2.5cm-thick green lumber(95.0 percent moisture content) to 9.7 percent moisture content, and for 3.0cm-thick green lumber(118.5 percent moisture content) to 10.0 percent moisture content were 45 hours, 45 hours, and 54 hours, respectively. 3. Drying rate from 90 to 10 percent moisture content of 2.5cm-thick lumber was about 0.7 times faster than that of 2.0cm-thick lumber and about 1.1 times faster than that of 3.0em-thick lumber. 4. End checks for 2.0cm-, 2.5cm-, and 3.0cm-thick green lumber occurred 95, 74 and 100 percent moisture content, respectively and reached maximum amount in 53, 41, and 60 percent moisture content, respectively. 5. No surface check and no honeycomb occurred. 6. Cupping and collapse slightly occurred and the quality of dry lumber was first.

• Journal of the Korean Wood Science and Technology
• /
• v.36 no.2
• /
• pp.20-28
• /
• 2008

This study was carried out to provide the so-called circumferential slicing method for investigating radial distributions of the tangential strains and of moisture contents within the log cross section (LC) of Kalopanax pictus during indoor drying it. While the heartwood showed an almost uniform moisture content distribution in the range of about 50~55% in case of the green wood, it has gradually decreased toward the outer side, showing about 19% of moisture content difference from the innermost slice. Although the moisture gradient along the radial direction has gradually become gentle as drying progresses, the sapwood of the outer side represented the moisture contents below the fiber saturation point after 24 hours of drying while the heartwood in the inner part showed the moisture contents higher than the fiber saturation point. The pith side was laid under the tensile stress after 24 hours of drying, and then gradually decreasing toward the bark side, and showed the distribution being switched again to the tensile stress on the bark side. As the drying has progressed, this trend got more intensified, and finally showed the U-shaped distribution model after 48 hours of drying. The circumferential slice test is considered to be suitable in quantitatively determining the tangential strains and moisture content within a LC.

• Journal of Korean Society of Forest Science
• /
• v.59 no.1
• /
• pp.63-66
• /
• 1983

Sectional equilibrium moisture contents of Larix leptolepis and Populus euramericana I-476 were determined, their correlations and significances were investigated. Among the ovendry moisture contents. electric moisture meter determining values and the estimative values through chemical equilibria formula, there were significant correlations, 1-5% level, at whole sections in Larix leptolepis. However, in Populus euramericana there was only significant correlation between ovendry moisture content values and electric moisture meter determining values.

• Advanced Composite Materials
• /
• v.17 no.4
• /
• pp.359-372
• /
• 2008

The moisture absorption behavior of carbon fiber-reinforced plastic (CFRP) and its effect on dimensional stability were examined. Moisture diffusivity in CFRP was determined by measuring a specimen's weight during the moisture absorption test. Three types of CFRP specimens were prepared: a unidirectionally reinforced laminate, a quasi-isotropic laminate and woven fabric. Each CFRP was processed into two geometries - a thin plate for determination of diffusivity and a rod with a square cross-section for the discussion of two-dimensional diffusion behavior. By solving Fick's law expanded to 3 dimensions, the diffusivities in the three orthogonal directions were obtained and analyzed in terms of the anisotropy of CFRP moisture diffusion. Coefficients of moisture expansion (CMEs) were also obtained from specimen deformation caused by moisture absorption. During moisture absorption, the specimen surfaces showed larger deformation near the edges due to the distribution of moisture contents. This deformation was reasonably predicted by the finite element analysis using experimentally determined diffusivities and CMEs. For unidirectional CFRP, the effect of the fiber alignment on CME was analyzed by micromechanical finite element analysis (FEA) and discussed.

• Journal of Fashion Business
• /
• v.15 no.6
• /
• pp.40-55
• /
• 2011

The purpose of this research is to review testing principle, testing design and experimental results of the four dynamic moisture movement testers. The research analyzes Moisture Manager Tester (MMT), Alambeta Instrument, Dynamic Surface Moisture Movement Tester, and Gravimetric Absorbent Testing Method based on American Society for Testing and Material (ASTM) E 96 which is an international standard testing method. Although many of researches use ASTM E 96 to measure moisture movement on a fabric, it has several weaknesses, such as long experimental time and a physical change of sample by a holder of the frame. Hence, lots of researchers have studied and developed the new measurement systems measuring moisture management on a fabric or garment and ultimately mimic heat energy and perspiration created by the human body. These moisture management systems use a variety of parameters, such as electricity, color, and sensor to measure their movement in the fabric. Through comparison with the existing tester (ASTM E 96), the research recognizes the strength and weakness in the dynamic moisture movement testers.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.6
• /
• pp.658-665
• /
• 2015

Temporal and spatial variation of soil moisture is important for understanding patterns of climate change, for developing and evaluating land surface models, for designing surface soil moisture observation networks, and for determining the appropriate resolution for satellite-based remote sensing instruments for soil moisture. In this study, we measured several soil moistures in upland soil using Advanced Microwave Scanning Radiometer 2 (AMSR2) Soil Moisture Content (SMC) during eight-month period in Chungbuk province. The upland soil moisture properties were expressed by simple statistical methods (average, standard deviation and coefficient of variation) from the monthly context. Supplementary studies were also performed about the effect of top soil texture on the soil moisture responses. If the results from this study were utilized well in specific cities and counties in Korea, it would be helpful to establish the countermeasures and action plans for preventing disasters because it was possible to compare with the relationship between soil moisture and top soil texture of each region. And it would be the fundamental data for estimating the effect of future agricultural plan.

• Korean Journal of Plant Resources
• /
• v.34 no.6
• /
• pp.608-615
• /
• 2021

Soil moisture control system including soil sensing and automatic water supply chain was constructed on open farmland and pot conditions. Soil moisture was controlled by the system showing over the soil moisture contents except 40% treatment. EC was gradually decreased by increasing cultivation days. On applying this system to control soil moisture, the growth and development characters of the bellflower were improved compared with control, cultivation without the automatic irrigation. Of the growth and development characters, plant height with water treatments was higher than that of control in 1st-year plants. Moreover, numbers of branch were increased by the increased soil moisture on farmland and pot condition. Capsule numbers for seed were best at 20%, 30% soil moisture treatment in 1st-year plants, and 20% to 50% treatment in 2nd-year plants. The construction of automatic soil moisture control system provide fundamental data for plant growth and development on open farmland soil condition.