• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.5 no.4
• /
• pp.47-63
• /
• 1994

An important parameter in characterizing mobile communication channel is delay spread. This paper presents the results of measured delay profiles and calculated distribution funcations of delay spread for typical cellular service environments at Taejon and vicinities. The measurement system uses 1023 chip length, 5 Mbps PN code and sliding correlation method. It has been evaluated by using commercial hardware channel simulator for reliability of out data. As results the value of mean delay spread is 2.08 $\mu\textrm{s}$for suburban area. 2.12 $\mu\textrm{s}$ for urban area and 1.3 $\mu\textrm{s}$ for national/local road. Delay spread is less then 3.4$\mu\textrm{s}$, 2.8$\mu\textrm{s}$ and 1.5 $\mu\textrm{s}$ for probability of 50% and 4.5$\mu\textrm{s}$, 4.2$\mu\textrm{s}$ and 2.9$\mu\textrm{s}$ for probability of 90% at each tested site. The difference of delay spread is within 7% between going and returning status along same street. In this experiment, we found delay spread for suburban area is larger than reported foreign test results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.2
• /
• pp.220-227
• /
• 2011

With the rapid development of mobile communication technology, the technologies based on the diverse digital modulation schemes have been used for the frequency range of over 800 MHz. The only radiation immunity has been tested using only AM signal based on IEC 61000-4-3 without any consideration of the influence of electromagnetic radiation in Korea. However, it has not been tested by wideband digital modulation signals such as cdmaone(IS-95), WCDMA and PM signal. The purpose of this study was to review the standards. In addition, the input signals were analyzed and tested considering the environments in Korea. The results showed that the devices were influenced by digital modulation signal or PM signal more than by AM signal.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.3
• /
• pp.597-604
• /
• 2011

The various Smartphone platforms that are used currently make difficult to build efficient applications("apps") for Smartphone. Introduction of middleware in the Smartphone environment is being studied to solve this problem. By enhancing interoperability between server systems and Smartphone platforms as introducing this middleware supports efficiently for Smartphone apps to be developed and managed. Thus, the development of this middleware for Smartphone has become essential for the purpose of responding actively to the rapidly expanding Smartphone market. In this research, we designed and implemented Smartphone middleware which optimizes the cost and time for developing new application service and maintaining it. In order to test this implemented middleware's performance and its capabilities, we also developed university Smartphone apps and activated campus twitter.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.6
• /
• pp.1481-1487
• /
• 2014

Recently, with the popularization of smartphones, augmented reality has become even more familiar to the public as an application that can provide realistic images as a tool for location-based services. Therefore, as a location-based application for smartphones that is appropriate for the application of augmented reality technology, the study develops a golf information system. Golf is the sport for which we should exactly know the accurate shape or distance to the destinations or obstacles, so the sport is suitable for applying the augmented reality technology. Even though the sport of golf has constantly increasing population to play it with the popularization of it, presently released golf-related smartphone apps are established as 2D images or in GPS basis; thus, they lack a sense of realism unfortunately. Thereupon, this study develops a golf information system by modifying and complementing usefully Mixare, the open source for augmented reality, for the sport of golf into an augmented reality-based system that can provide various information according to the actual environment of the golf course and describes how to apply it actually to the golf course.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.10
• /
• pp.1994-2000
• /
• 2016

Technology that can determine the location of individuals is required in a variety of applications such as location based control, a personalized advertising. Missing-child prevention and support for field trips, and applications such as push events based on the user's location is endless. In particular, the technology that can determine the location without interruption in the indoor and outdoor spaces have been studied a lot recently. Because emphasizing on accuracy of the positioning, many conventional research have constraints such as using of additional sensing devices or special mounting devices. The algorithm proposed in this paper has the purpose of performing the positioning only with standard equipment of the smart phone that has the most users. In this paper, sensor Fusion with GPS, WiFi Radio Map, Accelerometer sensor and Particle Filter algorithm is designed and implemented. Experimental results of this algorithm shows superior performance than the other compared algorithm. This could confirm the possibility of using proposed algorithm on actual environment.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.10
• /
• pp.1903-1911
• /
• 2016

As interest in MANET is increasing nowadays, research upon an efficient MANET routing protocol is actively under way. A LQA(Link Qualty Aware)-AODV routing protocol to deal with frequent changes of topology and wireless link variations under tactical operating conditions is proposed in this paper. The suggested LQA-AODV takes into account the channel capacity of each hop during the route request process of the traditional AODV protocol. In detail, LQA-AODV adds a channel capacity cost value to the RREQ message format that occurs during the routing process of the existing AODV Routing Protocol causing the accumulated channel capacity cost values of each sections to be compared before establishing a route. To verify the performance of LQA-AODV, NS2.35 was utilized and the Link-Quality Model was applied in order to reflect the tactical wireless environment. The simulation compares and analyzes LQA-AODV and the existing AODV, showing a large improvement over the traditional AODV in regards to the Packet Delivery Ratio, and End-to-End Delay.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.10a
• /
• pp.207-210
• /
• 2013

Recently, rapid innovation of Smartphone is changing the paradigm of our daily life. Smartphone users, opinion experts more than 99 percent of the economically active population is using, it has reached the saturation past the early stages of formation. Smartphone is equipped with a general purpose OS possible the implementation of high performance environment similar level as a personal computer. Also, it is a mobile communication terminal scalable which can be removed or installed various applications. Such extensibility, it is possible to use different applications through the Apps store. In addition, it is also possible various services which are location based service. However, these services also benefit many but it also has a disadvantage of invasion of privacy and disclosure of personal information. In this research, we aim to analyze factors influencing on perceived value and risk in location based service of Smartphone. In addition, we aim to analyze the causal relationship with perceived value and risk in satisfaction and recommendation intention. This study suggests practical and theoretical implications based on the results.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.46 no.5
• /
• pp.101-110
• /
• 2009

The unconscious and non-intrusive measurements of activity signals or physiological signals represent important enabling technologies for realizing a ubiquitous healthcare environment as well as a related UI. Particularly, non-intrusive measurements should be used in activity monitoring system for long-term monitoring. This paper is based on activity estimation by measuring the activity signals of a user using a handhold device with an accelerometer. The user activity estimation system (UAES) presented in this paper makes non-intrusive measurements of activity signals to minimize inconveniencing a user and to create a more practical implementation in real life. Thus, a variety of positions in which the handhold device can be carried by a user for daily use is considered, such as in the front/hip/shirt pockets, a backpack, on the waist, and in the hand.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.1
• /
• pp.97-108
• /
• 2013

Recently, mobile devices were increased and there was a sharp rise in demand. To exploit the location information of each device, many researcher was studying locating systems. The favorite locating or positioning systems were a GPS using satellites and a RTLS using wireless communication between devices. If some obstacle existed nearby the target device, The system have difference of performance. The obstacles near targets were caused signal disconnection and reflection because of NLOS condition. As the result, the NLOS condition degrade the locating performance. In this paper, we propose a locating system which is cooperated two systems using information reliability estimates from LOS/NLOS condition. We developed proposed system. In addition, we performed fields test and simulation tests at various environment for performance evaluation. As the result, the test showed 97% success rate to estimate NLOS condition. Furthermore, the simulation result of our locating system was increased to 89% compared with a single system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.7
• /
• pp.694-700
• /
• 2013

Urban area is a representative environment of wireless channels in the mobile communication, building density has a different distribution depending on the location. Building density has affect to propagation prediction For this reason, building density is expected to affect to the channel characteristics, we need to analyze it. We measured channel characteristics in urban areas of Jeju island by channel sounder and $4{\times}4$ antenna. Channel characteristics considering the building density were derived based on the measured data in the urban area. In this paper, the measurement data is analyzed and channel characteristics are derived through MIMO Channel measurements at 700 MHz considering the building density in the urban area.