• Journal of the Korean Society for Precision Engineering
• /
• v.17 no.2
• /
• pp.89-96
• /
• 2000

This paper describes the characteristic of die finishing to obtain smooth surface using electro-chemical grinding after cutting process. Electro-chemical grinding is possible under lower load and tool wear comparing with those in the mechanical grinding. Conventionally, if the metal bonding material of the grinding wheel is directly t contacted with workpiece, the current is circulated without electrolytic phenomena. Sometimes, electrical discharge is occurred between tool and workpiece. To cope with this problem, the metal-resin bonded pellet was used in this study. This pellet is composed of optimal volume of metal and resin powders and its characteristics are changable with the each volume of powders. Finally, high efficient die finishing is realized using metal resin bonded pellet in electro-chemical grinding.

• Journal of the Korean Society for Precision Engineering
• /
• v.17 no.6
• /
• pp.96-102
• /
• 2000

The finishing process for dies and molds is an important process because it has influence on final quality of products. And it is difficult to automatize finishing process so that the process has depended on expert's skill until now. However, recently a study on development of die automatic finishing machine has been progressed, and actually this machine is applied to fabrication of die. But the research about tooling system is not enough and finishing tool must have high machining efficiency and adaptability of curved surface. So, this study investigated the application of conductive elastic tool which is composed of metal-resin bonded pellet and elastic backing material. The metal-resin bonded pellet is used to finish the surface by conventional mechanical grinding or electro-chemial grinding method. And elastic backing material is used to follow the curved surface. So conductive elastic tool has long lifetime, uniform removal rate and adaptability of curved surface.

• Journal of the Korean Society for Precision Engineering
• /
• v.16 no.3 s.96
• /
• pp.84-90
• /
• 1999

The finishing process for dies and molds is directly related to finished surface quality, but many parts of process depend on human labor which needs much time and value. So automatic finishing machine has been produced for dies and molds, and applied widely for finishing process. Conventionally finishing machine has applied resin bonded finishing pad as a tool, but the removal ability of pad decreases greatly as finishing process goes on. In the finishing mechanism for dies and molds, finishing process is affected severely by cutting process, so can be divided into removing cusp and smoothing surface process. So, this study investigated the application of cast iron bonded diamond pellet for press dies, which is considered to have better characteristics than the other metal bonded pellets. The finishing characteristics were compared the between finishing pellet and pad. And finishing performance was appraised as the several cutting surfaces.