• 한국세라믹학회지
• /
• 제28권11호
• /
• pp.851-858
• /
• 1991

Spherical fine BaTiO3 powders with an average diameter of 0.3${\mu}{\textrm}{m}$ to 0.9${\mu}{\textrm}{m}$ are prepared at 100$0^{\circ}C$ by the ultrasonic spray pyrolysis of solutions containing Ba(NO3)2 and TiCl4. Experimental variables are adjusted to produce BaTiO3 powders and its effect on the phase, the size and the morphology of the particles are investigated by XRD, SEM, TEM. Each particle consists of small primary particles and has a hollow around its center. The dependence of particle diameters on the concentrations of source solutions indicates that metal salt precursors are dried to precipitate solid particles and decompose to form BaTiO3 phase without gas phase reactions.

• 대한기계학회논문집
• /
• 제8권3호
• /
• pp.217-223
• /
• 1984

본 논문에서는 이온질화 처리강의 미끄름 마멸현상에 대하여 이론 및 실험적 으로 규명하고 종래의 질화법과 비교하였다. 또한 미끄럼 마멸을 나타내는 일반식 V/L=C*(P/H)를 이용하여 이온질화, 염욕질화 및 가스질화에서의 C 값을 구하였으며 여기에서 V는 마멸체적, L은 마멸길이, P는 마멸하중, H는 경도이며 C는 마멸상수이다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1994년도 추계학술대회 논문집
• /
• pp.198-201
• /
• 1994

Stability improvement of fragile LB films was attempted by polyion complexation of monolayers at the air-water interface and crosslinking of the resulting LB films. The spreading polymers were synthesized by radical copolymerization of monoalkyl itaconate with oligoethyleneglycol methyl vinylether, and poly(allylamine) was employed as the subphase polymer. Formation and characteristic of the monolayers were comfirmed by surface pressure-area($\pi$-A) isotherms. The two different polymers formed polyion-complexed monolayer through the formation of carboxylate/ammonium salt at the air-water interface. Y-type deposition occurred on solid substrates, and the transfer ratio was over 0.7. Pores (diameter, 0.1$\mu\textrm{m}$) of a membrane filter could be covered by polyion-complexed 6 layers. Interactions of the polymers with metal ions were investigated of the air-water interface and in the LB films. The structure change and macroscope morphology of the LB films were confirmed by FT-lR and SEM, respective1y.

• 열처리공학회지
• /
• 제5권1호
• /
• pp.23-31
• /
• 1992

It is investigated that Fe-C-N compound layer, defusion layer, and induction hardened layer produced by nitrocarburizing blend heat treatment in austenitic temperature with high frequency induction heating of mild steel specimen sprayed sursulf salt-bath. As the temperature of blend-heat treatment got increased, the thickness and hardness of compound layer and diffusion layer were increased. Compound layer(max. $35{\mu}m$), diffusion layer (max. 2.5mm) and induction hardened layer were gained in the shortest time 10 sec and in the case of $1000^{\circ}C$ total hardness depth of those was about 3.5mm. When the blend-heat treated specimen was reheated, maximum hardness of compound layer was dropped more than that of the reheated compound layer after sursulf treated, whereas hardness of diffusion layer was increased.

• 분석과학
• /
• 제13권6호
• /
• pp.810-814
• /
• 2000

The open-chain hexadentate $N_4$, $O_2$ ligands 1, 15-bis(2-hydroxybenzyl)-2, 6, 10, 14-tetraazapentadecane (BSATPD. 4HCl) has been synthesized as its tetrahydro-chloride salt and characterized by EA, IR, NMR, and Mass spectrum. Its protonation constants ($logK_n{^H}$) and stability constants ($logK_{ML}$) for $Cu^{2+}$, $Ni^{2+}$, $Co^{2+}$ and $Zn^{2+}$ ions were determined in aqueous solution by potentiometry and compared with those of analogous $N_4$, $O_2$ ligands contain ethtylenic spacers or propylenic spacers, which make six-membered chelate rings between the aliphatic nitrogen atoms.

• 한국대기환경학회지
• /
• 제15권5호
• /
• pp.677-685
• /
• 1999

Aerosol mass size distributions were measured at Kosan, Cheju Island in April 1998 and their compositions were analyzed. Microorifice Uniform Deposit Impactor(MOUDI) was used to collect aerosols. Sulfate and ammonium ions were predominatly present at fine mode of the aerosols while nitrate, chloride, and metal ions were mostly at coarse mode. Based on the size distribution of nitrate, it is suggested that most nitrate were from gas to particle conversion on coarse particles. Non-sea salt(nss) fraction of sulfate accounted for more than 90% of total sulfate mass concentration. In general, ion concentrations in this study are lower than those measured at the same site from the previous studies. Ion balance and chloride ion levels indicates that there had been anthropogenic chloride emission sources near to the site during the measurements.

• 대한화학회지
• /
• 제13권4호
• /
• pp.303-307
• /
• 1969

酸性溶液中에서 重金屬 이온의 沈澱劑로 널리 使用되는 Nitrosophenyhydroxylamine(Cupferron)의 非可逆電極反應의 電流電壓曲線과 酸性 및 알카리性에서의 還元反應機構 및 反應速度 그리고 pH變化에 따른 관여전자수, 活性化 energy를 Delahay 方法을 利用하여 구하였다.

• 약학회지
• /
• 제35권5호
• /
• pp.444-455
• /
• 1991

Two kinds of new lectin fractions (LOA-I, LOA-II) were obtained from loach (Misgurnus spp.) meat by 0.15 M NaCl extraction, salt fractionation, ion exchange and hydroxyapatite column chromatographies. On polyacrylamide gel electrophoresis, LOA-I exhibited one major and a few minor bands, but LOA-II exhibited three minor bands. The partially purified loach lectins agglutinated not only erythrocytes of human B and AB type, rabbit, dog, but also murine splenic lymphocytes. Agglutinability was relatively labile at various pH and stable at increasing temperature, but was not affected by tested several metal ions. By the sugar specificity test, D-glucosamine and metyl-$\beta$-galactopyranose inhibited agglutinating activity at a final concentration of 3 mM. The lectins contained relatively high amounts of aspartic acid, valine and leucine, but sulfur containing amino acids, cystein, methionine and isoleucine were not determined. LOA-I, LOA-II lectins were nonmitogenic toward murine lymphocytes.

• 한국분말재료학회지
• /
• 제11권3호
• /
• pp.242-246
• /
• 2004

FePt nanoparticles for high-density magnetic recording media were synthesized by the simultaneous chemical reduction of Fe(acac) $_2$ and Pt(acac) $_2$ with 1,2-hexadecanediol as the reducing reagent. TEM images showed that the shape of as-synthesized FePt nanoparticle was spherical and average particle size was 3 nm. Also, SAD pattern showed that crystal structure was disordered FCC (face centered cubic). These FCC structured nanoparticles were transformed FCT (face centered tetragonal) structure by annealing at 55$0^{\circ}C$ for 30 min in Ar atmosphere. XRD analysis revealed that as-synthesized FePt nanoparticles were transformed from disordered FCC to ordered FCT. Finally, the coercivity of 2 kOe for FePt nanoparticles with FCT structure was obtained by VSM measurement.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 추계학술대회 논문집
• /
• pp.629-632
• /
• 1999

For replacing Li metal ai Lithium ton Bakery(LIB) system. we used carbon powder material which prepared by pyrolysis of phenol resin as starting material. It became amorphous carbon by pyrolysis through it\`s self condensation by thermal treatment. Amorphous carbon can be doped with Li intercalation and deintercalation because it has wide interlayer. however it has a problem with structural destroy causing weak carbon-carbon bond. So. we used ZnCl$_2$ as the pore-forming agent. This inorganic salt used together with the resin serves not only as the pore-forming agent to form open pores, which grow Into a three-dimensional network structure in the cured material, foul also as the microstructure-controlling agent to form a loose structure dope with bulky dopants. We analyzed SEM in order to find to different of structure. and can calculate distance of interlayer. CV test showed oxidation and reduction