• Earthquakes and Structures
• /
• v.15 no.5
• /
• pp.513-528
• /
• 2018

A typical viable technique to decrease the seismic response of liquid storage tanks is to isolate them at the base. Base-isolation systems are an efficient and feasible solution to reduce the vulnerability of structures in high seismic risk zones. Nevertheless, when liquid storage tanks are under long-period shaking, the base-isolation systems could have different impacts. These kinds of earthquakes can damage the tanks readily. Hence, the seismic behaviour and vibration of cylindrical liquid storage tanks, subjected to earthquakes, is of paramount importance, and it is investigated in this paper. The Finite Element Method is used to evaluate seismic response in addition to the reduction of excessive liquid sloshing in the tank when subjected to the long-period ground motion. The non-linear stress-strain behaviour pertaining to polymers and rubbers is implemented while non-linear contact elements are employed to describe the 3-D surface-to-surface contact. Therefore, Nonlinear Procedures are used to investigate the fluid-structure interactions (FSI) between liquid and the tank wall while there is incompressible liquid. Part I, examines the effect of the flexibility of the isolation system and the tank aspect ratio (height to radius) on the tank wall radial displacements of the tank wall and the liquid sloshing heights. Maximum stress and base shear force for various aspect ratios and different base-isolators, which are subjected to three seismic conditions, will be discussed in Part II. It is shown that the composite-base isolator is much more effective than other isolators due to its high flexibility and strength combined. Moreover, the base isolators may decrease the maximum level pertaining to radial displacement.

• KCID journal
• /
• v.18 no.1
• /
• pp.68-80
• /
• 2011

To provide a operation rule curve for reservoir with low ratio of watershed area to paddy field area, Duckyong reservoir with watershed area of $15.8km^2$ and paddy field area of 1,071ha was selected, in which 4 meters are being heightened and full water levels will be increased from EL.26.0m to EL.30.0m, total water storages from 365.6M $m^3$ to 708.0M $m^3$. There was no operation rule curve that satisfied over 90% reliability of water supply in reservoir with watershed area of 1.48 times of paddy field area. The differences between observed and simulated reservoir daily water storages were minimized to determine parameters for simulating reservoir inflow in case of paddy field area of 550ha from 1991 to 2010. A operation rule curve was drawn to have a maximum storage with total water storage, which was in paddy field area of 700ha with ratio of 2.3 between watershed area and paddy field area. This case showed that annual irrigation water supply was 668M $m^3$ and instream flow of 57M $m^3$, water supply reliability of 55.6% in normal operation, and annual irrigation water supply was 605M $m^3$ and instream flow of 38M $m^3$, water supply reliability of 95.6% in withdrawal limited operation. Water supply reliabilities showed 35.6% without flood regulation and 17.8% with flood regulation in existing reservoir before heightening.

• Journal of Hydrogen and New Energy
• /
• v.9 no.3
• /
• pp.101-110
• /
• 1998

The change of hydrogen storage characteristics by substituting zirconium for a portion of titanium in Ti-Cr-V alloys has been studied. The zirconium substitution decreased the plateau pressure and hysteresis of the PC isotherm. However, it decreased the hydrogen storage capacity and increased slopping in PC isotherm by forming $Cr_2Zr$ phase. By modifying the composition ratio of titanium to chromium, thereby suppressing the formation of $Cr_2Zr$ phase, we got an alloy having very high hydrogen storage capacity. The heat treatment of the alloys improved the flatness of plateau very much without a decrease in the maximum and the effective hydrogen storage capacities.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.31 no.2
• /
• pp.184-188
• /
• 2002

The fatty acid contents of egg yolk from various chicken eggs such as general egg, ginseng egg, gamgoal egg and docosahexaenoic acid (DHA) egg were analysed during storage at 4$^{\circ}C$ for 3 weeks. The major fatty acids of all egg yolk oils were oleic acid (18 : 1) and palmitic acid (16 : 0). The contents of both fatty acids reached maximum at the first or second week and decreased at the third week. DHA was detected from 4 kinds of eggs stored for 2 or 3 weeks. The n-6/n-3 ratio was obtained under recommended intake range in fresh gamgoal egg and in general and DHA eggs stored far 0~3 weeks. For 3 weeks, polyunsaturated fatty acid / monounsaturated fatty acid/ saturated fatty acid (P/M/S) ratio of DHA e99 did not chance, but that of ginseng e99 gradually increased. The P/M/S ratio was generally maintained under recommended intake range in general egg stored for 3 weeks, in ginseng egg stored for 2 weeks and in DHA egg during all the storage period.

• Korean Journal of Environmental Agriculture
• /
• v.15 no.4
• /
• pp.434-441
• /
• 1996

This study was conducted to clarify the degradation pattern, safety evaluation and penetration ratio of benomyl and bitertanol to apple used as postharvest fungicides during CA(controlled atmosphere) and cold storage. In CA storage, the degradation of benomyl and bitertanol in stored apple was slow at the early stage, while that in cold storage was, on the contrary, faster at the early stage. The initial concentrations of benomyl and bitertanol in apples applied at the standard application concentrations were 2.24 and 1.54mg/kg, respectively, and their residual amounts were below the maximum residue limits, 1mg/kg at 135 and 96 days in CA storage, 115 and 70 days in cold storage, respectively. The half-lives of benomyl and bitertanol in stored apples were 124 and 130 days in CA storage, 101 and 111 days in the cold storage, respectively, indicating that the degradation was faster in cold storage than in CA storage. The residual amount of benomyl and bitertanol in stored apples was retained more in peels than in pulps of apples.

• Journal of Power Electronics
• /
• v.18 no.2
• /
• pp.343-355
• /
• 2018

A wide-voltage-conversion range bidirectional DC-DC converter is proposed in this paper. The topology is comprised of one typical LC energy storage component and a special common grounded asymmetric H-bridge with four active power switches/anti-parallel diodes. The narrow output PWM voltage is generated from the voltage difference between two normal (wider) output PWM voltages from the asymmetric H-bridge with duty cycles close to 0.5. The equivalent switching frequency of the output PWM voltage is double the actual switching frequency, and a wide step-down/step-up ratio range is achieved. A 300W prototype has been constructed to validate the feasibility and effectiveness of the proposed bidirectional converter between the variable low voltage side (24V~48V) and the constant high voltage side (200V). The slave active power switches allow ZVS turn-on and turn-off without requiring any extra hardware. The maximum conversion efficiency is 94.7% in the step-down mode and 93.5% in the step-up mode. Therefore, the proposed bidirectional topology with a common ground is suitable for energy storage systems such as renewable power generation systems and electric vehicles with a hybrid energy source.

• Journal of Information Processing Systems
• /
• v.18 no.6
• /
• pp.803-812
• /
• 2022

With the increasing number of mobile device users worldwide, utilizing mobile edge computing (MEC) devices close to users for content caching can reduce transmission latency than receiving content from a server or cloud. However, because MEC has limited storage capacity, it is necessary to determine the content types and sizes to be cached. In this study, we investigate a caching strategy that increases the hit ratio from small base stations (SBSs) for mobile users in a heterogeneous network consisting of one macro base station (MBS) and multiple SBSs. If there are several SBSs that users can access, the hit ratio can be improved by reducing duplicate content and increasing the diversity of content in SBSs. We propose a Deep Q-Network (DQN)-based caching strategy that considers time-varying content popularity and content redundancy in multiple SBSs. Content is stored in the SBS in a divided form using maximum distance separable (MDS) codes to enhance the diversity of the content. Experiments in various environments show that the proposed caching strategy outperforms the other methods in terms of hit ratio.

• Solar Energy
• /
• v.15 no.3
• /
• pp.15-27
• /
• 1995

This study presents experimental and numerical results of the temperature characteristics, the heat transfer phenomema, and the heat storage quantity during the heat storage process with sodium phyrophosphate decahydrate($Na_4P_2O_7{\cdot}10H_2O$)-Phase Change Material(PCM) in a latent heat storage tank(cubic type). It was proved that heat transfer by conduction was dominant because PCM($Na_4P_2O_7{\cdot}10H_2O$) during heating processes was gel phase, not liquid phase The gap ratio(rate of air content) of PCM became smaller, the thermal capacity of PCM became larger, therefore the temperature distribution of PCM slowly increased than that of large gap ratio. There was maximum 15% difference between measured temperatures and calculated temperatures.

• Transactions of the Society of Information Storage Systems
• /
• v.10 no.1
• /
• pp.23-26
• /
• 2014

In this paper, we present a novel approach for tuning the resonant frequency of torsionally driven vertical comb actuators. The tuning unit composed of thermal actuator, scissor mechanism and V-shape shaft enables continuous and reversible resonant frequency tuning. The proposed method is based on the stiffness alteration of the V-shape shaft. It is experimentally verified that the resonant frequency of the torsional microscanner is shifted up to 1.59 kHz from 1.51 kHz showing the maximum tuning ratio of 5.29%.

• Transactions of the Society of Information Storage Systems
• /
• v.2 no.1
• /
• pp.38-42
• /
• 2006

We report the random pattern characteristics of the super resolution near field structure(Super-RENS) write once read-many(WORM) disc at a blue laser optical system(laser wavelength 405nm, numerical aperture 0.85) and the Super-RENS read only memory(ROM) disc at a blue laser optical system(laser wavelength 659nm, numerical aperture 0.65). We used the WORM disc of which carrier-to-noise ratio(CNR) of 75nm is 47dB and ROM disc of which carrier-to-noise ratio(CNR) of 173nm is 45dB. We controlled the equalization(EQ) characteristics and used advanced partial-response maximum likelihood(PRML) technique. We obtained bit error rate(bER) of 10-3 level at 50GB WORM disc and bite error rate of 10-4 level at 50GB level ROM disc. This result shows high feasibility of Super-RENS technology for practical use.