• Journal of Korean Port Research
• /
• v.13 no.2
• /
• pp.333-350
• /
• 1999

Today freeway is thought to be a very important transportation facility carrying tremendous traffic flow as the main corridor within the area of between the areas. However freeway is experiencing severe congestion and accidents by increased entrance ramp flow especially at peak time period. Ramp meters on the freeway entrance ramps that supply traffic to the freeway in a measured or appropriately regulated amount are needed for alleviating freeway congestion. Because ramp meters can be operated to discharge traffic at a measured or regulated rate thus maintaining more uniform speed on the mainline section maximizing the throughput to the freeway within the capacity of a downstream bottleneck and reducing the congestion related accidents. Thus the objectives in this study were to analyze the traffic characteristics on the freeway I-94 with ramp metering system before/after ITS technology in Detroit (Michigan) area compare shifts of the traffic characteristics on the freeway I-94 before/after ITS technology and finally suggest a better ramp metering strategy for the freeway system The following results were obtained: i)Flow occupancies and speeds on the mainline merge section of freeway were shown to be a big difference depending on the peak periods areas and directions based on the distribution of traffic flow characteristics on the freeway. ii)Reduced speed was shown to be more than 5 mph and ramp flow was also shown to be more than 240 vph at peak periods if there was the ramp metering system constructed on the freeway. iii)Ramp metering system was shown to be optimally operated on the freeway if ramp flow could be maximized within the range of over 900 vph and reduced occupancy could be also maximized by no more than 2 percent at peak periods. iv)The average flows on the freeway after the ITS technology were shown to be a decrease of over 20% depending on the peak periods areas and directions when compared with those flow on the freeway before the ITS technology. over 20% depending on the peak periods areas and directions when compared with those speeds on the freeway before the ITS technology. vi)The average metering rates on the freeway after the ITS technology were shown to be an increase of over 10% depending on the peak periods areas and directions when compared with those metering rates on the freeway before the ITS technology.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.2 no.4
• /
• pp.473-477
• /
• 2013

The railway developed countries in Europe, Japan such as ERTMS Regional, FFB, COMBAT, it is the stage of development or testing the train control system for the signal system of branch interval of low density. Similar to the signal system used by the mainline and branch sections of low density domestic portions not suitable in terms of maintenance operational efficiency in accordance with the installation and operation in many cases. Therefore these low-density branch railway lines required that oriented train control system of wireless communication to improve the operation efficiency and line side equipment controlled on board the train. In this paper, We was published a route on setting is the operation of the new on-board oriented train control system for controlling a line converter of the train so that it is possible to improve the operational efficiency of the branch of the low density.

• Journal of Korean Society of Transportation
• /
• v.19 no.3
• /
• pp.89-100
• /
• 2001

내부순환로의 진출램프 중 성산, 홍은, 홍제, 길음, 마장 진출램프에서는 램프의 지체가 심각하여, 진출차량의 대기행렬이 내부순환로 본선에까지 이르는 대기행렬 역류현상이 발생하고 있다. 이러한 본선으로의 대기행렬 역류는 본선의 혼잡을 가중시키고 교통사고의 위험도 증가시킨다. 본 논문에서는 이러한 도시고속도로의 진출램프 혼잡을 개선하기 위해 진출램프 제어전략을 개발하였다. 진출램프 제어전략의 목표는 진출램프의 대기차량이 본선으로 역류하지 않도록 하는 것이다. 대기행렬의 역류를 막기 위해서는 진출램프의 차량이 인접한 간선도로로 원활하게 진행하도록 해야 하며, 간선도로와 진출램프의 대기행렬을 제어정책에 따라 관리할 수 있어야 한다. 이를 위해서 진출램프 진출부에 신호를 설치하여 간선도로차량의 흐름을 제어하고, 진출부 하류부 교차로와 연동제어를 하여 진출공간을 확보하였다. 또한, 대기행렬의 관리를 위해서는 대기행렬 관리계수를 정의하고 이 값에 따라 현시를 결정할 수 있는 제어식을 유도하였다. 진출램프 제어전략은 과포화 신호제어 기법을 응용하여 개발하였으며, 그 중 Equity offset과 내부미터링 기법을 연동제어에 응용하였고, Imbalanced split 기법은 대기행렬 관리계수에 따라 현시가 결정되는 제어식의 개발에 응용하였다. 진출램프 제어전략을 평가하기 위하여 진출램프의 혼잡으로 인해 본선으로 대기행렬 역류가 발생하는 내부순환로의 홍은, 홍제 진출램프를 선정하였으며, NETSIM을 통해 진출램프 제어전략의 효과를 분석하였다. 분석결과 진출램프의 혼잡이 크게 개선되며, 운영자의 관리목적에 따라 대기행렬의 관리가 이루어지는 것을 볼 수 있었다. 진출램프 제어전략은 내부순환 도시고속도로뿐만 아니라 진출램프 제어가 필요한 타도시고속도로에서도 적용을 하면 좋은 효과를 얻을 수 있을 것으로 예상된다.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.12
• /
• pp.2046-2052
• /
• 2016

Ramp metering is one of the most efficient and widely used control methods for an intelligent transportation management system on a freeway. Its objective is to control and upgrade freeway traffic by regulating the number of vehicles entering the freeway entrance ramp, in such a way that not only the alleviation of the congestion but also the smoothing of the traffic flow around the desired density level can be achieved for the maintenance of the maximum mainline throughput. When the cycle of the signal detection is larger than that of the system process, the density tracking problem needs to be considered in the form of the discrete-time system. Therefore, a discrete-time sliding mode control method is proposed for the ramp metering problem in the presence of both input constraint in the on-ramp and exogenous disturbance in the off-ramp considering the random behavior of the driver. Simulations were performed using a validated second-order macroscopic traffic flow model in Matlab environment and the simulation results indicate that proposed control method can achieve better performance than previously well-known ALINEA strategy in the sense that mainstream flow throughput is maximized and congestion is alleviated even in the presence of input constraint and exogenous disturbance.

• Journal of Korean Port Research
• /
• v.14 no.4
• /
• pp.419-427
• /
• 2000

Today travel demand continues to increase with spread of economic zones. Also, urban freeway plays an important role in intra-zone transportations as a major corridor in a big city. However, most of urban freeways experience a severe congestion with the excess of inflowing or outflowing traffic through freeway ramps. The purpose of this study is to identify the traffic characteristics, analyze the relationships between the traffic characteristics and finally construct the speed predictive models on the ramp junctions of urban freeway under the intelligent transportation system(ITS) settings. From the analyses of traffic characteristics following results were obtained: ⅰ) 24 hours average traffic characteristics flow, occupancy, speed under the ITS settings showed about 40%, 38%, 8.8% increase each on urban freeway junctions period when compared with that under the non-ITS settings each other. Free flow speed and traffic flow on the mainline sections of urban freeway under the ITS settings also showed about 20% and 17% increase when compared with that under the non-ITS, respectively. ⅱ) The upstream when compared speed( $S_{u}$)and downstream occupancy( $O_{d}$) were especially shown to have higher explanatory powers on the stable flow ramp junctions, but the upstream speed( $S_{u}$) and downstream flow( $V_{d}$) were especially shown on the unstable flow ramp junctions of urban freeway under the ITS settings.ngs.ngs.

• International Journal of Highway Engineering
• /
• v.18 no.1
• /
• pp.85-90
• /
• 2016

PURPOSES : The objective of this paper is to understand the deterioration phenomenon and causes in the pavement of a ramp area. METHODS : Ramp areas need to be sloped because of the centrifugal force, which depends on the vehicle speed and grade of the ramp area. As a result, vertical and horizontal forces are applied on the pavement surface of the ramp area. Furthermore, the horizontal force depends on the vehicle speed and grade of the ramp area. In order to analyze the pavement structure of a ramp area, a multi-layered elastic analysis program was used to evaluate the weakest link of fatigue cracking deterioration, according to the simultaneously applied vertical and horizontal forces. RESULTS : From case studies related to the bonding conditions between the surface and base layer in a ramp area, it was found that the partially bonded cases resulted in a critical potential of fatigue cracking deterioration, in a comparison of 50%, 70%, and fully bonded cases. CONCLUSIONS : According to the results of the case studies, the pavement structure system should be reinforced by upgrading the material or increasing the thickness compared to the general pavement areas, in order to provide a performance life similar to the mainline pavements in the ramp areas.

• Journal of Korea Port Economic Association
• /
• v.18 no.2
• /
• pp.27-45
• /
• 2002

The continuing pace of technological change and the trend toward larger and faster ships is evident as shipping lines compete in seeking economies of scale in the global market and ports. become increasingly reliant on sophisticated equipment. Across the Asia and Pacific region some of the worlds most modern container ships are calling at an extensive network of mainline and feeder ports. This paper shows that during the period from 1999 to 2011, Asian container trade is expected to continue to increase more rapidly than the world average, i.e., 7.2 per cent per annum compared with the world average of 6.3 per cent. It is forecast that the total volumes of international containers handled at the ports in Asia and the Pacific will increase at an average growth rate of 7,2 per cent per annum. In order to handle the anticipated port container traffic in 2011, new container berths are required in nearly every country in the Asia and the Pacific region. This will entail very significant capital investment requirements. If countries in the UNESCAP region are to position their ports to meet the challenges of the next decade, there is an urgent need to implement more robust strategies to address important issues including prioritisation of port development projects, promotion of private sector participation in ports, emphasis on productivity and preparation for intermodal integration and logistics growth.

• Journal of Korean Port Research
• /
• v.13 no.1
• /
• pp.113-122
• /
• 1999

Congestion and traffic accidents occur on the merge and diverge sections in the interchange of the freeway. Studies have been conducted to reduce the traffic delay and accidents on the merge section in the freeway since 1960s. but a study was not conducted to estimate the speed variation on the merge section construct models estimated for the speed variation and suggest the appropriate measures. The purpose of this study was to identify the traffic flow characteristics on the merge section in the freeway construct the models estimated for the speed variation on the merge section in the freeway and finally establish the appropriate measure for reduction of traffic delay and accidents on the merge section in the freeway. The following results were obtained: I) Speed variations in the urban freeway appeared to be about 3.2mph, 6.5mph and 7.4mph based on the morning peak period, afternoon peak period and 24-hours period but those in the suburban freeway appeared to be about 8.0mph, 11.1mph and 10.1mph based on the same periods respectively. So different speed reduction signs need be installed to reduce delay and accidents on the merge section in the freeway based on the areas and periods as the freeway traffic management system(FTMS). ii) These models estimated for speed variation need to be studied with the changeable message sign(CMS) technique based on the real-time data so that the traffic flow could be maximized and the traffic delay and accidents be on the merge section in the freeway as more efficient freeway traffic management system(FTMS) in the near future.

• Journal of Korean Society of Transportation
• /
• v.31 no.6
• /
• pp.22-33
• /
• 2013

Currently average daily traffic using Hi-pass has increased over 3 times that of 2008 and more than half of highway traffic now uses High-pass. At this juncture, reassessment on the overall operation of Hi-pass is required to improve the safety aspect of toll booths and the flow of traffic. Although existing Hi-pass operation manual presents the methods of alignment, they do not reflect actual forms of vehicles and do not properly take the safety of toll booth and flow of the traffic into consideration. In order to compensate these problems, this study classifies highway tollbooths into two categories of mainline type and interchange type, and establishes the standard of lane alignment by traffic conflict analysis based on the types divided according to geometric structure or environment around the tollbooths. In addition, traffic flows around the tollbooths were reflected with the stage to arrange Hi-pass lanes according to the volume of traffic on the lanes for Hi-pass.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.5
• /
• pp.2031-2042
• /
• 2017

In this paper, a novel traffic flow control method based-on ramp metering and speed regulation using an adaptive sliding mode control (ASMC) method along with a deadzoned parameter adaptation law is proposed at a stochastic macroscopic level traffic environment, where the influence of the density and speed disturbances is accounted for in the traffic dynamic equations. The goal of this paper is to design a local traffic flow controller using both ramp metering and speed regulation based on ASMC, in order to achieve the desired density and speed for the maintenance of the maximum mainline throughput against disturbances in practice. The proposed method is advantageous in that it can improve the traffic flow performance compared to the traditional methods using only ramp metering, even in the presence of ramp storage limitation and disturbances. Moreover, a prior knowledge of disturbance magnitude is not required in the process of designing the controller unlike the conventional sliding mode controller. A stability analysis is presented to show that the traffic system under the proposed traffic flow control method is guaranteed to be uniformly bounded and its ultimate bound can be adjusted to be sufficiently small in terms of deadzone. The validity of the proposed method is demonstrated under different traffic situations (i.e., different initial traffic status), in the sense that the proposed control method is capable of stabilizing traffic flow better than the previously well-known Asservissement Lineaire d'Entree Autoroutiere (ALINEA) strategy and also feedback linearization control (FLC) method.