• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.17 no.3
• /
• pp.980-998
• /
• 2023

In Low Earth Orbit (LEO) satellite networks, satellites operate fast and the inter-satellite link change period is short. In order to sense the spectrum state in LEO satellite networks in real-time, a space-based satellite network intelligent spectrum sensing algorithm based on artificial neural network (ANN) is proposed, while Geosynchronous Earth Orbit (GEO) satellites are introduced to make fast and effective judgments on the spectrum state of LEO satellites by using their stronger arithmetic power. Firstly, the visibility constraints between LEO satellites and GEO satellites are analyzed to derive the inter-satellite link building matrix and complete the inter-satellite link situational awareness. Secondly, an ANN-based energy detection (ANN-ED) algorithm is proposed based on the traditional energy detection algorithm and artificial neural network. The ANN module is used to determine the spectrum state and optimize the traditional energy detection algorithm. GEO satellites are used to fuse the information sensed by LEO satellites and then give the spectrum decision, thereby realizing the inter-satellite spectrum state sensing. Finally, the sensing quality is evaluated by the analysis of sensing delay and sensing energy consumption. The simulation results show that our proposed algorithm has lower complexity, the sensing delay and sensing energy consumption compared with the traditional energy detection method.

• Journal of Positioning, Navigation, and Timing
• /
• v.9 no.4
• /
• pp.357-366
• /
• 2020

This paper addressed a relative navigation method for autonomous rendezvous and docking of cube-satellites using single frequency Differential GPS (DGPS) under the intermittent communication between satellites. Since the ionospheric error of GPS measurement is variable depending on the visible satellites, a few meters error of relative navigation is occurred in the Low-Earth Orbit (LEO) environment. Therefore, it is essential to remove the ionospheric error to perform relative navigation. Besides, an intermittent communication period for receiving GPS measurements of the target satellite is limited for getting information every sampling time. To solve this problem, a method combining range domain DGPS and orbit propagation is proposed in this paper. The proposed method improves the performance of DGPS by using Hatch filter and solves an intermittent communication problem by estimating the relative position and velocity using Hill-Clohessy-Wiltshire Equation. Through the simulation, it is verified that the suggested algorithm provides the relative position error within RMS 0.5 m and the relative velocity error within RMS 3 cm/s. Furthermore, it has the advantage that it is suitable for real-time implementation using single-frequency GPS measurements and is computationally efficient.

• Bulletin of the Korean Space Science Society
• /
• 2011.04a
• /
• pp.26.2-26.2
• /
• 2011

Flyby anomaly (unexpected energy increase during Earth Gravity Assists) indicates existence of an unknown non-conservative perturbation which affects hyperbolic trajectories. This presentation focuses on first order position and velocity perturbation formulas derived in terms of classical orbital element variations for hyperbolic orbit. By using both the perturbation formulas and numerical approach, we analyze effects of hypothetical acceleration models proposed by Hasse (2009), Lewis (2009), Gerrad and Sumner (2008), and Busack (2007). Based on analysis of perturbation effect on low earth orbit, we find that typical position perturbation is about 10m which is much larger than current orbit determination accuracy. From this, we deduce that anomalous acceleration only affects hyperbolic orbit or behaves differently in bound orbit. On the other hand, based on analysis of perturbation effects on hyperbolic trajectories, we find that position and velocity perturbations are highly different from acceleration models, and all of proposed models fail to explain observed range and Doppler data. Thus, it can be concluded that not only energy variations but also kinematics gives us crucial clues on the flyby anomaly, and kinematical characteristic should be considered in modeling flyby anomaly.

• The Bulletin of The Korean Astronomical Society
• /
• v.34 no.1
• /
• pp.179.2-179.2
• /
• 2009

• Aerospace Engineering and Technology
• /
• v.13 no.2
• /
• pp.142-149
• /
• 2014

After launch of Low Earth Orbit(LEO) satellite, Initial Activation Checkout(IAC) and Calibration and Validation(Cal & Val) procedure are performed prior to enter normal operation phase. During normal operation phase, most of the time is allocated for mission operation except following up measures to anomaly and orbit maintenance. Since mission operation capability is key indicator for success of LEO satellite program and consistent with promotion purpose of LEO satellite program, reliability should be ensured by conducting through test. In order to ensure reliability by examining the role of LEO satellite and ground station during ground test phase, realistic test scenario that is similar to actual operation conditions should be created, and test that aims to verify full mission cycle should be performed by transmitting created command and receiving image and telemetry data. This paper describes the test design and result. Consideration items for test design are described in detail and result of designed test items are summarized.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.7
• /
• pp.616-621
• /
• 2014

Consumption of the fuel on the satellite operating in low earth orbit, is increased due to the air resistance and the amount of increase makes the satellite lifetime decrease or the satellite mass risen. Therefore the prediction of drag force of the satellite is important. In the paper, drag force and drag coefficient analysis of the parabolic antenna satellite in low earth orbit using direct simulation monte carlo method (DSMC) is conducted according to the mission altitude and angle of attack. To verify the DSMC simulated rarefied air movement, Starshine satellite drag coefficient according to the altitude and gas-surface interaction are compared with the flight data. Finally, from the analysis results, it leads to appropriate satellite drag coefficient for orbit lifetime calculation.

• International journal of advanced smart convergence
• /
• v.13 no.2
• /
• pp.7-15
• /
• 2024

6G network technology represents the next generation of communications, supporting high-speed connectivity, ultra-low latency, and integration with cutting-edge technologies, such as the Internet of Things (IoT), virtual reality, and autonomous vehicles. These advancements promise to drive transformative changes in digital society. However, as technology progresses, the demand for efficient data transmission and energy management between smart devices and network equipment also intensifies. A significant challenge within 6G networks is the optimization of interactions between satellites and smart devices. This study addresses this issue by introducing a new game theory-based technique aimed at minimizing system-wide energy consumption and latency. The proposed technique reduces the processing load on smart devices and optimizes the offloading decision ratio to effectively utilize the resources of Low-Earth Orbit (LEO) satellites. Simulation results demonstrate that the proposed technique achieves a 30% reduction in energy consumption and a 40% improvement in latency compared to existing methods, thereby significantly enhancing performance.

• International Journal of Aeronautical and Space Sciences
• /
• v.6 no.1
• /
• pp.71-76
• /
• 2005

The KOMPSAT-1 satellite, launched into a circular sun synchronous orbit on Dec. 21, 1999, entered its$6^{th}$year of successful operation this year. The purposes of the mission are to collect earth images (6.6 m resolution), multi-spectral images of the ocean, and to collect information on the particle environment of the low earth orbit. For normal operation, KOMPSAT-1 orbits are determined using GPS navigation solutions. However, at the start of the life of KOMPSAT-1, the 11-year solar activity cycle was at a maximum. Solar flux was maintained at this level until 2002, and thereafter reduced to a moderate level by 2004. Thus, the OD (Orbit Determination) accuracy has varied according to the solar activity. This paper presents the degree to which the OD accuracy could be degraded during a high solar activity period compared with that of a (relatively) low solar activity period. We investigated the effect of the use of solve-for parameters such as a drag coefficient ($C_D$), solar radiation coefficient ($C_R$), and the general accelerations ($G_A$) on OD accuracy with solar activity. For the evaluation of orbit determination accuracy, orbit overlap comparison is used since no independent orbits of comparable accuracy are available for comparison. The effect of the use of a box-wing model instead of a constant cross-sectional area is also investigated.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.9
• /
• pp.760-766
• /
• 2018

Due to external disturbances on the satellite, unwanted momentum is accumulated on reaction wheels. To remove this momentum, three magnetic torquers which are installed along the satellite's axes are used. The magnetic torquers generated torque indirectly by interactions with the earth's magnetic field. Thus, during momentum dumping, we should consider both the magnetic torquer and the earth's magnetic field generated on the magnetic torquers at the same time. When low earth orbit satellite with high inclination angle holds nadir pointing attitude, weak earth's magnetic field is generated along the satellite's pitch axis. In this case, one magnetic torquer is overloaded and momentum dumping performance is degraded. This research will review the method to improve the momentum dumping performance by adjusting magnetic torquers arrangement.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.12
• /
• pp.1028-1036
• /
• 2018

KARI plans to launch Korea Pathfinder Lunar Orbiter (KPLO) to the Moon by December 2020 for the first step of the Korea Lunar Exploration Project. This orbiter will be launched to obtain lunar exploration technologies and science data in advance before launching a main orbiter and a lunar probe. This paper describes the verification of thermal design for the orbiter. It is exposed to more extreme thermal environment than that of low Earth orbit satellite due to the heavy infrared emission of the Moon. Accordingly, a thermal design considering this environment is needed to maintain the temperature of payloads and components equipped in the orbiter within operating temperature range in all orbits. We performed the thermal analysis for Earth-Moon transfer orbit, lunar mission orbit and lunar eclipse required for thermal design verification of the lunar orbiter. As a result, this thermal design met the design requirements.