• International Journal of Industrial Entomology and Biomaterials
• /
• v.33 no.2
• /
• pp.108-112
• /
• 2016

Silk has been used extensively in textile applications because of its good luster and feel. However, the low elongation and elastic recovery of silk has limited its use in a wider variety of textile applications. In this study, silk textile samples were made with a highly twisted silk/polyurethane core-spun yarn. They were immersed in water and dried at different temperatures, and the effect of treatment temperature on the mechanical properties of the silk textile was examined. It was found that the water temperature strongly affected the morphology and mechanical properties of the silk textile, whereas the drying temperature did not. As the water temperature was increased, the weft silk yarn became tangled and the interval between warp yarns decreased, resulting in shrinkage of the silk textile. When the silk textile was immersed in water at high temperature (i.e., $100^{\circ}C$), the elongation of the textile increased eight-fold as compared to an untreated silk textile. The maximum elastic recovery ratio of the silk textile was 96.7%.

• Korean Journal of Weed Science
• /
• v.16 no.3
• /
• pp.200-209
• /
• 1996

It is assumed to be an efficient method for keeping a germinability of weed seeds as long as possible, if a secondary dormancy is not induced by transferring the seeds of which dormancy was broken in wetting condition into drying condition. To investigate its validity, two experiments were carried out on seeds of 9 weed species ; to find out the most effective storage condition in breaking the dormancy of each weed species and to know whether there is a decrease in the germinability by transferring into drying storage condition. The dormancy of Chenopodium album and Stellaria aquatica was released well under the drying condition, but that of Echinochloa crus-galli var. oryzicola by soaking in water. Other weed species were released from dormancy by storage in wetting condition. When the seeds stored in the wetting or soaking condition, are air-dried and then restored at room or low temperature, a decreasing tendency of germinability which might cause a trouble in using them practically, was not observed except on the seeds of Persicaria vulgaris. In the case of Persicaria vulgaris, the low germination since 3 month-storage seemed not to be caused by drying, because a decrease of its germinability was observed with increasing storage period in all of the storage conditions. In contrast, high germination was induced as the seeds of Echinochloa crusgalli var. oryzicola, which were not germinated during the storage in low temperature and wetting condition, were transferred into the room temperature and drying condition. These results suggest that this approach can be one of the efficient methods for keeping a good germinability as long as possible in most weed seeds.

• Journal of the Korean Ceramic Society
• /
• v.31 no.6
• /
• pp.660-670
• /
• 1994

Transparent, crack-free dried gel monoliths with a composition of LiZr1.5Si2P2O12.5 have been synthesized by the low temperature polymerization of the Sol-Gel technique using metal alkoxides as starting materials. After initial reaction (20~40 min), each metal alkoxide closely paralleled each other during the hydrolysis reactions. The safe drying conditions of gels with no creaks the control of the shrinkage rate. The gels converted into the glass by heat treatment at 75$0^{\circ}C$. FTIR data indicated that the gels were phase separated into silicarich and phosphate-rich regions with the lithium. XRD results showed the formation of crystalline LiH2PO4. The gels dried at 15$0^{\circ}C$ or fired at 75$0^{\circ}C$ contained the residual water. The high ionic conductivity at room temperature for these gels was attributed to the motion of protons.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2006.11a
• /
• pp.253-256
• /
• 2006

This paper shows the study on application of the law temperature energy in the deep seawater. Deep, cold seawater has long been recognized as a valuable ocean energy resource. Recently, research and experimentation has been conducted on energy systems using deep seawater: deep seawater air conditioning system, ice-making device, salt and fresh-water manufacturing system and the Spray freeze drying system for extracting valuable material of the deep seawater. They are technically and economically feasible today: once installed, the energy is inexhaustible and there are no adverse environmental impacts. Because of the economy of scale in the air conditioning system, the seawater A/C system is most appropriate for supplying multiple buildings or hotels in a coastal area.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.28 no.1
• /
• pp.153-160
• /
• 1999

Storage stability of boiled and freeze dried loach and antioxidative effect of Zanthoxylum schinifolium were studied to confirm the possibility in development of instant choo o tang(Korean traditional loach soup). Packaging and storage temperature did not cause a measurable change in in vitro protein digestibility and trypsin indigestible substrate within 45 days of storage but remarkable quality changes were occurred in all samples stored after 60 days. Vacuum packaging and low temperature storage(4 oC) had some effect in retarding protein quality deterioration due to delaying polyunsaturated fatty acid oxidation. Maximum peroxide value and TBA value were reached in 15 days, and there were a slow(TBA value) and rapid reduction(POV) after peaks were reached. In contrast, increasing brown pigment development and fluorescence intensity continued until 90 days of storage. Treatment of ethanolic extracts from Zanthoxylum schinifolium prior to freeze drying could protect against lipid oxidation of freeze dried loach products.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.16 no.1
• /
• pp.3293-3301
• /
• 1974

An experimental work was conducted by using a laboratory-made model dryer to investigate the effect of the rate of natural forced-air on the drying rate of rough rice which was deposited in the deep-bed. The dryer consisted of 8 cylinderical containers with grain holding screen at their bottoms, each of which having 30cm in diameter and 15cm in height. The containers were sacked vertically with keeping them air-tight by using paper tape during dryer operation. Two separate layers of containers were operated in the same time to have two replications. The moisture contents of grains within each bins after predetermined period of dryer operation were determined indirectly by measuring the weight of the individual containers. The air-rates were maintained at 6 levels, or 5, 8, 10, 15, 18 and 20 millimenters of static head of water. The roomair conditions during dryer operation were maintained in the range of 10-l5$^{\circ}C$ in temperature and 40-60% in relative humidity. The results of the study are summarized as follows: 1. Drying characteristics of the grains in the bottom layers were approximately the same regardless of airdelivery rates, giving the average drying rate as about 0.35 percent per hour after 40-hour drying period, during which moisture content (w. b.) reduced from 24 percent to about 10 percent. 2. After about 40-hour drying period, the mean drying rates increased from 0.163 percent per hour to 0.263 percent per hour as air-flow rates increased from 5mm to 87.16mm of static head of water. In the same time, the moisture differences of grains between lower and upper layers varied from 12.7 percent at the air rate of 5mm of water head to 7.5 percent at the air-flow rate of 20mn of water head. Thus, the greater the air-flow rate was, the more overall improvement in drying performance was. Additionally, from the result of ineffectiveness of drying grain positioned at 70cm depth or above by the air rate of 5mm of static head of water it may be suggested in practical application that the height of grain deposit would be maintained adequately within the limits of air-rates that may be actually delivered. 3. Drying after layer-turning operation was continued for about 30 hours to test the effectiveness of reducing moisture differences in the thick layers. As a result of this layer-turning operation, moisture distribution through layers approached to narrow ranges, giving the moisture range as about 7 percent at air-flow rate of 5mm head of water, about 3 percent at 10mm head about 2 percent at 15mm head, and less than 1 percent at 20mm head. In addition, from the desirable results that drying rate was rapid in the lower layers and dully in the upper layers, layer-turning operation may be very effective in natural air drying with deep-layer grain deposit, especially when the forced air was kept in low rate. 4. Even though the high rate of air delivery is very desirable for deep-layer natural-air drying of rough rice, it can be happened that the required air delivery rate could not be attained because of limitation of power source available on farms. To give a guide line for the practical application, the power required to perform the drying with the specified air rate was analyzed for different sizes of drying bin and is given in Table (5). If a farmer selects a motor of which size is 1 or {{{{1 { 1} over {2 } }}}} H.P. and air-delivery rate which ranges from 8~10mm of head, the diameter of grain bin may be suggested to choose about 2.4m, also power tiller or other moderate size of prime motor may be recommended when the diameter of grain bin is about 5.0m or more for about 120cm grain deposit.

• Korean Journal of Weed Science
• /
• v.16 no.3
• /
• pp.187-193
• /
• 1996

To supply seeds with a good quality as plant materials for herbicide screening and to know whether the germination characteristics could be associated with a differential response to herbicides, germination characteristics and differential responses to herbicides were investigated with 3 species of a genus Setaria ; Yellow foxtail(Setaria glauca P. Beauv, SETGL), Giant foxtail(Setaria faberi Hetrm, SETFA), and Green foxtail(Setaria viridis P. Beauv, SETVI). Degree of dormancy was high in the order of SETGL, SETVI and SETFA. The dormancy of SETGL seed was relatively well removed by room temperature and drying storage, but SETFA and SETVI by low temperature and wetting storage(stratification). For breaking dormancy of SETGL, SETVI and SETFA, it was necessary for being kept under the above storage conditions for at least 2, 4 and 4-5 months, respectively. When the dormancy-breaked seeds were transfered to low temperature($4^{\circ}C$) and drying condition, SETGL showed germination rate of 96% even after 2 month storage. However, SETVI and SETFA showed a decreased germination of 54% and 69%, respectively, with a decreased velocity of germination, indicating that secondary dormancy might be induced. On the other hand, a significant change in germination rate was not observed as the seeds were transfered to room temperature($25^{\circ}C$) and drying condition. The germinability of SETGL seed began to decline from 6th year after storage in room temperature and drying condition. All of 3 species showed relatively high germination rate at alternating temperature of $30^{\circ}C$/$20^{\circ}C$(14hr/10hr) and their germination were not increased by light. All of 3 species exhibited similar responses to cycloxydim, sethoxydim and primisulfuron in greenhouse experiment. In contrast, SETVI and SETFA were relatively susceptible to fenoxapropethyl, SETFA to fluazifop-butyl, SETGL and SETFA to clorimuron-ethyl, and SETGL to EK-2612. The difference in herbicidal response among 3 species was the highest in the treatment of EK-2612. These results suggest that there is no a consistent tendency in responses of 3 species to herbicides which have the same target site. And the relationship between germination characteristics and differential responses to herbicides was not found.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.18 no.1
• /
• pp.13-24
• /
• 2000

UV-curable resin has the properties of quick-drying, high productivity at low temperature, energy, space saving, solventless, non-polluting and low-stinking, and thus, UV-curing system has been widely used in the fields of printing inks, adhesives, paints and coating agents. This study has been executed to develop a new functionnal material by the polymerization induced phase separation. The results obtained were as follows. As for the curing properties of the monomer/prepolymer/alkyd resin blends, it was found out that there was a peak by the polymerization induced phase separation when measuring the changes of viscosity and elasticity. It was also found out that such polymerization phase separation occurred in case that the alkyd resin contents were 20wt% and 30wt% and not found at the contents of 40wt%. Therefore, it would be desirable to maintain the contents of alkyd resin at less than 30wt% in order to use the polymerization induced phase separation.

• Journal of Hydrogen and New Energy
• /
• v.26 no.6
• /
• pp.547-553
• /
• 2015

For commercialization of fuel cell electric vehicles, one of the key objectives is to reduce cost of full stack assembly. Regarding Membrane Electrode Assembly, the major issue is to improve fuel cell activation process in the initial Hydrogen Oxidation Reaction and Oxygen Reduction Reaction. In this research, the VD (Vacuum Drying) process has been developed for improvement of activation process. The VD condition is developed by controlling the temperature and degree of vacuum to remove the remaining solvent of electrode. Consequently, the electrode applied to VD process showed the low characteristics such as 3.5% of remaining solvent content and the improved efficiency such as 15% of activation process speed.

• Korean Journal of Materials Research
• /
• v.16 no.9
• /
• pp.533-537
• /
• 2006

The effects of binary solvent mixtures with various ratios of toluene and ethanol on the properties of slurries and green sheets were investigated. Viscosity of slurry was changed by varying the ratio of solvent mixture which affected the solubility of binder. The relative solvency behavior of a solvent mixture could be predicted with the Hildebrand solubility parameter(${\delta}$) and hydrogen bonding index( ${\gamma}$). The minimum viscosity, the best dispersion of binder, was reached at the composition of toluene:ethanol=4:6, which corresponded to our forecast. The mechanical properties of green sheets related to evaporation of solvents were influenced by the composition of the solvent mixture. At the azeotrope the skin was formed on a drying cast during the drying process because of fast evaporation. At a range of concentrations over 50wt% toluene, green sheets could not be fully dried at low temperature due to excessive toluene. The mechanical properties of green sheets were excellent at the azeotrope-like composition of toluene:ethanol=4:6 which has a little excess of toluene over the azeotrope.