• Journal of Energy Engineering
• /
• v.4 no.3
• /
• pp.394-401
• /
• 1995

본 연구는 중심부에 액체, 외주부에 산화제가 흐르는 기액 동축분류의 유동장에 대한 것이다. 기액 동축 분사기는 연료의 분사량이 적은 소형 연소시스템을 고려하여, 실험은 연공비(W1/Wa)가 0.6 이하를 대상으로, 물과 공기를 사용하여 분사조건에 따른 분무특성과 기액 2상 분무류의 기본구조를 조사하여 액적의 확산, 기액혼합특성에 대하여 검토하여 다음과 같은 결론을 얻었다. 반경방향 기상속도분포 및 액적유속분포는 분구직경 및 분사조건에 관계없이 정규분포에 가까운 형태를 취하고 있으며, 각각 식 (2) 및 (3)으로 나타낼 수 있다. 기상속도는 반치폭은 축방향에 따라 일정한 구배 (≒4.6)로서 증가하며, 기상만의 단상분류의 구배(≒6)에 비해서 완만하다. 액적유속 반치폭은 축방향에 따라 더욱 완만한 구배(≒3.1)로서 증가한다. 무차원 액적유속분포는 축방향에 따라 일정한 구배(n≒1.5)로서 감소한다. 액적의 확산은 상대적으로 기액유량비가 클수록 효과적으라고는 말할 수 없고, 최대 확산을 이루는 최적의 기액유량비가 존재한다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.04a
• /
• pp.63-64
• /
• 2009

Optical bounce during switching in the fringe field switching (FFS) mode using a liquid crystal (LC) with positive dielectric anisotropy has been observed. According to the analysis, it occurs at two positions which are center and edge of the pixel electrode, which decreases decaying response time. The former is major and mainly associated with increase in twist angle instantaneously during switching off resulted from decrease in tilt angle near by LC molecules at center. This paper discusses the origin of such optical bounces.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.808-812
• /
• 2010

A great deal of attention is focused on coupled Thermo-Hydro-Mechanical (THM) behavior of multiphase porous media in diverse geo-mechanical and geo-environmental areas. This paper presents general governing equations for coupled THM processes in unsaturated porous media. Coupled partial differential equations are derived from 3 mass balances equations (solid, water, and air), energy balance equation, and force equilibrium equation. Finite element code is developed from the Galerkin formulation and time integration of these governing equations for 4 main variables (displacement $\underline{u}$, gas pressure $P_g$, liquid pressure $P_l$), and temperature T). The code is validated with theoretical solutions for linear material with simple boundary conditions.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.1521-1522
• /
• 2011

뇌임펄스에 의한 절연유체 내 절연파괴 현상은 스트리머 채널에서의 유체유동과 기체유동이 동시에 발생한다. 스트리머 개시와 동시에 발생하는 기포들은 절연파괴에 직접적인 영향을 미치며 이를 모의해석하기위해서 2상유동이 고려되어야한다. 2상유동이 고려된 뇌임펄스 응답 유한요소해석은 전계에 의한 푸아송 방정식과 전자, 양이온, 음이온에 대한 전하연속방정식으로 구성되며 전계 방출과 열전자 방출효과를 경계조건으로 부여하였다. 기체 전리현상은 타운젠트 이론을 도입하였으며, 유체 전리현상은 제너 이온화 모델을 도입하여 수학적 모델링을 통한 2상유동으로 결합하였다. IEC standard #60897의 표준규격에 따라 침-구형 전극을 설계하였고 2차원 축대칭 간략화모델에 적용하여 실험적 결과와 비교분석함으로써 신뢰할 수 있는 수치해석기법이 제시되었다.

• Journal of the Korean Society of Combustion
• /
• v.14 no.3
• /
• pp.29-36
• /
• 2009

Simulation is performed to analyze the characteristics of turbulent spray combustion in a diesel engine condition. An extended Conditional Moment Closure (CMC) model is employed to resolve coupling between chemistry and turbulence. Relevant time and length scales and dimensionless numbers are estimated at the tip and the mid spray region during spray development and combustion. The liquid volume fractions are small enough to support validity of droplets assumed as point sources in two-phase flow. The mean scalar dissipation rates (SDR) are lower than the extinction limit to show flame stability throughout the combustion period. The Kolmogorov scales remain relatively constant, while the integral scales increase with decay of turbulence. The chemical time scale decreases abruptly to a small value as ignition occurs with subsequent heat release. The Da and Ka show opposite trends due to variation in the chemical time scale. More work is in progress to identify the spray combustion regimes.

• Carbon letters
• /
• v.4 no.2
• /
• pp.64-68
• /
• 2003

A study on the electrosorption of uranium ions onto a porous activated carbon fiber (ACF) was performed to treat uraniumcontaining lagoon sludge. The result of the continuous flow-through cell electrosorption experiments showed that the applied negative potential increased the adsorption kinetics and capacity in comparison to the open-circuit potential (OCP) adsorption for uranium ions. Effective U(VI) removal is accomplished when a negative potential is applied to the activated carbon fiber (ACF) electrode. For a feed concentration of 100 mg/L, the concentration of U(VI) in the cell effluent is reduced to less than 1 mg/L. The selective removal of uranium ions from electrolyte was possible by the electrosorption process.

• Journal of the Korean Vacuum Society
• /
• v.2 no.4
• /
• pp.480-485
• /
• 1993

Factros considered building the magnetron sputtering system for TFT LCD (thin film transistor liquid crystal display0 metallization were thin film thichnes uniformity, temperature uniformity and the pressure gradient of sputtering gas flow in vacuum chamber, base pressure, and the stability fo the carrier moving . The system was consisted of a deposition chamber, a pre-heating chamber, a RF-precleaning chamber and a load/unload lock chamber. The system was designed to handle a substrate with dimension of 400$\times$400mm. The temperautre uniformity of a heater table developed showed $250 ^{\circ}C\pm$5% accuracyon the substrate glass. A base pressure of 1.8 $\times$10-7 torr was obtained after 24 hours pumping with a cryo pump. After an aluminum target was installed in a sputtering source and the film wa sdeposited on the glass, the uniformity, reflectivity and sheet resistance of the deposited film were measured.

• Solar Energy
• /
• v.12 no.1
• /
• pp.34-39
• /
• 1992

The present study has carried out thermal performance evaluation of air systems for space heating in Daejeon by the f-chart method. The various effects with the change in air flow rate, number of glazings, storage capacity of pebble bed, and coating materials of absorber plate are analyzed with regard to the effectiveness of air systems for space heating. A comparison is also made with liquid systems under the same operating conditions.

• Journal of Environmental Science International
• /
• v.13 no.3
• /
• pp.319-325
• /
• 2004

An experimental study on the preparation of monolithic porous polymers by environmentally friend process in supercritical carbon dioxide has been carried out. Polymerization mixture composed of a cross-linking monomer, initiator and functional co-polymer was charged in the reactor with sapphire window. After the system was purged with a flow of $CO_2$ for 15 min, the reactor was pressurized with liquid $CO_2$ up to 100 bars. The reactor was isolated from and placed back to the system via quick connector for shaking until the mixture had become fully homogeneous. The reactor was then heated and pressurized to the required reaction conditions and left overnight. After cooling and $CO_2$ evacuation, the polymer was removed from the reactor as dry, white, continuous monoliths. The effect of experimental conditions on the physical properties of porous polymer was systematically examined, and it was found that monomer content had a major effect on the physical properties of the polymers.

• 한국전산유체공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.105-110
• /
• 2005

Evaluation of elliptic blending turbulence model (EBM) together with the two-layer model, shear stress transport (SST) model and elliptic relaxation model (V2-F) is performed for a better prediction of thermal stratification in an upper plenum of a liquid metal reactor by applying them to the experiment conducted at JNC. The algebraic flux model is used for treating the turbulent heat flux. There exist much differences between turbulence models in predicting the temporal variation of temperature. The V2-F model and the EBM better predict the steep gradient of temperature at the interface of thermal stratification, and the V2-F model and EBM predict properly the oscillation of temperature. The two-layer model and SST model fail to predict the temporal oscillation of temperature.