• Bulletin of the Korean Chemical Society
• /
• v.8 no.5
• /
• pp.414-418
• /
• 1987

Electrochemical reduction of dibenzoylmethane was studied on mercury electrode by means of cyclic voltammetry, polarography and potentiostatic measurements in ethanol-water system. In acidic solutions monomeric pinacol was produced by irreversible two-electron process while monomeric and dimeric pinacol were competitively produced by the same process in neutral solution. However, in basic solution the dimeric pinacol was mostly produced through radical by irreversible one-electron transfer process. Mechanisms of the reduction of dibenzoylmethane are deduced from Tafel slope, pH dependance and reaction order with respect to the concentration of dibenzoylmethane in the solution of various pH.

• Korean Journal of Environmental Biology
• /
• v.23 no.4
• /
• pp.390-397
• /
• 2005

The inhibition of cell recovery might be proceeded via either the damage of the mechanism of the recovery itself or via the formation of irreversible damage which could not be repaired at all. Both these processes may take place at the same time. Any of these possibilities would result in a decrease in both the rate and extent of cell recovery. To distinguish them, a quantitative approach describing the process of recovery as a decrease in the effective radiation dose was applied to experimental data on the recovery from potentially lethal damage in Chinese hamster cells exposed to X-rays alone or combined with various chemicals (pyruvate, novobiocin, lactate, nalidixic acid, 3-aminobenzamide). For these particular cases, it is concluded that the recovery process itself is not damaged and the inhibition of the recovery is entirely due to the enhanced yield of the irreversibly damaged cells.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 1999.05a
• /
• pp.151-157
• /
• 1999

In this study, tile characteristics of three dimensional flow fields in centrifugal flump impeller are investigated by numerically. Detailed analysis and understanding of flow field in centrifugal pump are very important to predict performance of components. The three dimensional viscous fluid flow in centrifugal pump is distingushed isentropic process region from irreversible process region by wall shear effect, secondary flow, centrifugal and Coriolis forces, variation of boudary layers. Development of low momentum region by viscous fluid flow in the centrifugal impeller causes stall and blockage which is irreversible process region, and resulting in decrease of the performance and efficiency of centrifugal pump. Especially, the result is that Coriolis and centrifugal forces are most powerful factors which are increasing the irreversible region.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.266-266
• /
• 2013

We show a set-up of poly (4,4'-aminotriphenylene hexafluoroisopropylidenediphthalimide) (6F-TPA PI)/Al sample in which holes are injected by photoelectron emission process instead of direct charge carrier injection via metal electrode. In this process, an irreversible electrical phase transition of 6F-TPA PI is found in contrast to the Al/6F-TPA PI/Al structure, leading to a write-once-readmany behavior. The photoelectron spectroscopy results measured before and after the switching process revealed that the irreversible electrical phase transition of 6F-TPA PI is attributed to the chemical modification of the carbonyl group in phthalimide moiety.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.244-244
• /
• 2012

Polymer memory devices have attracted considerable attention because of their advantages such as low cost potential, good scalability, flexibility, simplicity in structure, and large capacity for data storage. Metal/poly (4,4'-aminotriphenylene hexafluoroisopropylidenediphthalimide) (6F-TPA PI)/metal system has been found to show an electrical bi-stable behavior. Here, we show a novel set-up of 6F-TPA PI/Al sample in which holes are injected by photoelectron emission process instead of direct charge carrier injection via metal electrode. In this process, an irreversible electrical phase transition of 6F-TPA PI is found, leading to a write-once-read-many (WORM) behavior. The photoelectron spectroscopy results measured before and after the switching process revealed that the irreversible electrical phase transition of 6F-TPA PI is attributed to the chemical modification of the carbonyl group in phthalimide moiety.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.1
• /
• pp.38-46
• /
• 2005

In this research, we tried to combine the coagulation/sedimentation process as pre-treatment with UF membrane filtration to reduce the membrane fouling and to improve the permeate water quality. We used the Jet Mixed Separator (JMS) as coagulation/sedimentation process. We observed that the HPC and E.Coli can't be removed through the direct UF memebrane filtation of surface water. The removal efficiency of dissolved organic substances, indicated by E260 and DOC, was 40% and 15%, respectively. However, the removal efficiency of it increased two time as a result of combination of JMS process as coagulation/sedimentation pre-treatment. This was resulted from the formation of high molecular humic micro-floc through JMS process. The accumulation amount of irreversible cake layer which was not removed by backwashing was less than direct UF membrane filtration of surface water. Moreover, the loading rate of fouling induced substances, such as humic substances and suspended substances, on membrane surface decreased drastically through JMS process. As a result, the accumulation amount of irreversible cake on membrane surface was decreased.

• Korean Chemical Engineering Research
• /
• v.60 no.2
• /
• pp.217-222
• /
• 2022

It is very important to analyze the OCV change behavior during the open circuit potential holding (OCV holding) process, which accelerates the evaluation of the electrochemical durability of the PEMFC membrane. In this study, an empirical formula using the experimental data of three MEAs with different durability was created and compared. The durability evaluation time of the reinforced membrane MEA without radical scavenger inside the membrane was 383 h, and the durability evaluation time of the reinforced membrane MEA with radical scavenger inside the membrane was 1,000 and 1,650 h, respectively. The degradation of the membrane was divided into the reversible degradation that can be recovered by activation and the irreversible degradation that is not recovered. The irreversible degradation of the membrane was indicated by an increase in hydrogen permeability, and the change in hydrogen permeability was similar to the irreversible degradation constant c of all three MEAs. The initiation of irreversible deterioration without recovery is indicated by an increase in hydrogen permeability, and the OCV is not recovered due to an increase in hydrogen permeability, so the slope of the OCV recovery line (ORL) decreases, which can be confirmed by an increase in the constant c value of the empirical formula.

• Bulletin of the Korean Chemical Society
• /
• v.10 no.6
• /
• pp.600-604
• /
• 1989

In order to find the rational methods for improving the thermal stability of subtilisin Carlsberg, the mechanisms of irreversible thermoinactivation of the enzyme were studied at $90^{\circ}C.$ At pH 4, the main process was hydrolysis of peptide bond. This process followed first order kinetics, yielding a rate constant of $1.26\;{\times}\;10^{-1}h^{-1}$. Hydrolysis of peptide bond of PMS-subtilisin occurred at various sites, which produced new distinct fragments of molecular weights of 27.2 KD, 25.9 KD, 25.0 KD, 22.3 KD, 19.0 KD, 17.6 KD, 16.5 KD, 15.7 KD, 15.0 KD, 13.7 KD, and 12.7 KD. Most of the new fragments originated from the acidic hydrolysis at the C-side of aspartic acid residues. However 25.0 KD, 15.7 KD, and 13.7 KD which could not be removed in purification steps stemmed from the autolytic cleavage of subtilisin. The minor process at pH 4 was deamidation at asparagine and/or glutamine residues and some extend of aggregation was also observed. However, the aggregation was main process at pH 7 with a first order kinetic constant of $16 h^{-1}.$ At pH 9, the main process seemed to be combination of deamidation and cleavage of peptide bond.

• Korean Management Science Review
• /
• v.11 no.1
• /
• pp.39-50
• /
• 1994

Carousel systems can be classified into unidirectional and bidirectional carousel, depending on the hardware structure. Bidirectional carousels again can be classified into reversible and irreversible carousel, depending on whether the reversal of direction is allowed or not during the process of an order. In this study, single carousel served by one operator is considered. Analytical models for the rotation distance to process an order of size are developed for unidirectional and irreversible bidirectional cases. For reversible bidirectional and Nearest Neighbor Heuristic cases, simulation results of the average rotation distance are presented. Since the throughput capacity of carousel systems also depends upon the picking time of the operator; order size; and the rotation speed of carousel, the model considers the above three factors to express the throughput capacity of single carousel systems.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.16 no.3
• /
• pp.305-314
• /
• 1987

Thermodynamic analysis of a mixed refrigerant refrigeration cycle has been performed by computing thermodynamic properties of various refrigerants. The analyses are carried cut to identify the sources and distribution of the energy degradation by irreversible processes. Heat exchange process with the surroundings produces the entropy and the irreversible loss can be reduced by the mixed refrigerant whose phase change temperature varies during the phase change processes in the evaporator and the condenser. The concept has been applied to find the minimum compression work and thus the minimum energy loss in the overall system, specifically in the case of the mixed refrigerant of R12 and R114. Parametric studies have been added to recognize the various factors affecting the system performance.