• Journal of the Mineralogical Society of Korea
• /
• v.9 no.2
• /
• pp.71-81
• /
• 1996

Dissolution experiments were conducted to understand chemical nature of weathering of anorthosite from the Hadong area. Anorthosite and plagioclase from it were reacted with HCl or KOH solutions under various conditions concerning such as grain size, initial pH of solutions, and shaking Average composition of plagioclase used in the experiment was Na0.32Ca0.71Al1.71Si2.28O8.Under acidic conditions, solution pH increases rapidly in the initial stage and then gradually to reach palteau. Shaking agitates the reaction rate in the initial stage but does not affect after the system reached steady state. Ca and si concentrations show rapid increase and then gradual increase. Al concentration increases rapidly in the early stage and then decreases. Later decrease was interpreted as the precipitation of an Al-bearing material. Different dissolution rates of different constituents of plagioclase together the with precipitation of al-bearing material might be responsible for the non-stoichiometric dissolution of plagioclase.X-ray diffraction analyses on anorthosite before and after dissolution experiment show dissolution rates differ with different lattice planes of plagioclase. It suggests the crystallographic control on dissolution reaction. X-ray photoelectron spectroscopic result shows that the average composition of plagioclase surface reacted with HCL of initial pH 1.97 for 2000 hours is Na0.20Ca0.26Al1.7Si2.3O8. It means that Na- and Ca-depleted H-feldspar is developed without Al-depleted layer on the surface of plagioclase by reaction with HCl and that dissolution reaction takes place sparsely on the surface of plagioclase. Al and Si are dissolved preferentially over Ca from anorthosite powder in KHO solution. Reaction of acid-reacted anorthosite with KOH solution shows the same Si dissolution behavior as in the fresh anorthosite. This indicates that the Al-depleted and Si-enriched layer does not build up on the acid-reacted surface.

• Preventive Nutrition and Food Science
• /
• v.9 no.3
• /
• pp.218-221
• /
• 2004

Irradiated red pepper powder (IRPP) was tested for its ability to retard fermentation and to maintain a high quality of Kimchi by the reduction of the initial microbial load. Kimchi containing IRPP at the doses of 0, 5, 10, 15, or 20 kGy was prepared. Quality indices for Kimchi in this study were pH, titratable acidity, reducing sugar content, total microbial count, lactic acid bacterial load, and sensory evaluation. Based on the pH and titratable acidity, the Kimchi with IRPP showed a retarded fermentation until 15 days. The number of the total aerobes and lactic acid bacteria of the Kimchi with IRPP were lower by about 1 log CFU/mL compared to control at day 0, however, the counts increased to 8.5 log CFU/mL after 10 days, which was similar to the control group. Kimchi that was fermented with 5 kGy IRPP was better than control and other treatments in odor and color, whereas the control scored highest in taste. Addition of IRPP showed a limited retardation of Kimchi fermentation without other quality deterioration.

• Journal of Hydrogen and New Energy
• /
• v.22 no.3
• /
• pp.326-332
• /
• 2011

The authors examined the effects of operating parameters on the $H_2$ production by dark fermentation of the wastewater generated from food waste recycling facilities, in short "food waste wastewater (FWW)". Central composite design based response surface methodology was applied to analyze the effect of initial pH (5.5-8.5) and substrate concentration (2-20 g Carbo. COD/L) on $H_2$ production. The experiment was conducted under mesophilic ($35^{\circ}C$) condition and a heat-treated ($90^{\circ}C$ for 20min)anaerobic digester sludge was used as a seeding source. Although there was a little difference in carbohydrate removal, $H_2$ yield was largely affected by the experimental conditions, from 0.38 to 1.77 mol $H_2$/mol $hexose_{added}$. By applying regression analysis, $H_2$ yield was well fitted based on the coded value to a second order polynomial equation (p = 0.0243): Y = $1.78-0.17X_1+0.30X_2+0.37X_1X_2-0.29X_1{^2}-0.35X_2{^2}$, where $X_1$, $X_2$, and Y are pH, substrate concentration (g Carbo. COD/L), and hydrogen yield (mol $H_2$/mol $hexose_{added}$), respectively. The 2-D response surface clearly showed a high inter-dependency between initial pH and substrate concentration, and the role of these two factors was to control the pH during fermentation. According to the statistical optimization, the optimum condition of initial pH and substrate concentration were 7.0 and 13.4 g Carbo. COD/L, respectively, under which predicted $H_2$ yield was 1.84 mol $H_2$/mol $hexose_{added}$. Microbial analysis using 16S rRNA PCR-DGGE showed that $Clostridium$ sp. such as $Clostridium$ $perfringens$, $Clostridium$ $sticklandii$, and $Clostridium$ $bifermentans$ were main $H_2$-producers.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.193-193
• /
• 2012

In thin film silicon solar cells, p-i-n structure is adopted instead of p/n junction structure as in wafer-based Si solar cells. PECVD is the most widely used thin film deposition process for a-Si:H or ${\mu}c$-Si:H solar cells. Single-chamber PECVD system for a-Si:H solar cell manufacturing has the advantage of lower initial investment and maintenance cost for the equipment. However, in single-chamber PECVD system, doped and intrinsic layers are deposited in one plasma chamber, which inevitably impedes sharp dopant profiles at the interfaces due to the contamination from previous deposition process. The cross-contamination between layers is a serious drawback of single-chamber PECVD system. In this study, a new plasma process to solve the cross-contamination problem in a single-chamber PECVD system was suggested. In order to remove the deposited B inside of the plasma chamber during p-layer deposition, a high RF power was applied right after p-layer deposition with SiH4 gas off, which is then followed by i-layer, n-layer, and Ag top-electrode deposition without vacuum break. In addition to the p-i interface control, various interface control techniques such as FTO-glass pre-annealing in O2 environment to further reduce sheet resistance of FTO-glass, thin layer of TiO2 deposition to prevent H2 plasma reduction of FTO layer, and hydrogen plasma treatment prior to n-layer deposition, etc. were developed. The best initial solar cell efficiency using single-chamber PECVD system of 10.5% for test cell area of 0.2 $cm^2$ could be achieved by adopting various interface control methods.

• Journal of Korean society of Dental Hygiene
• /
• v.22 no.5
• /
• pp.461-468
• /
• 2022

Objectives: To investigate the effect of several elder-friendly foods on oral health and suggest guidelines for proper food intake. Methods: Six elderly-friendly foods (liquid type) and two control groups (mineral water and mixed coffee) were selected for this study. The pH of the food was measured using a calibrated pH meter, and the titratable acidity was determined using 1 M NaOH until 7.0 (TA 7.0). The screening method suggested by the International Organization for Standards was performed using an undersaturated hydroxyapatite solution to determine the difference between the initial and final pH of the screening solution (△pH). In addition, the sugar content was measured and expressed as Brix (%). Results: All the elder-friendly foods tested in this study showed a neutral pH (6.68-7.35), similar to mineral water (pH 7.84). The range of TA 7.0 values was 0.00-0.54 ㎖. The changes in pH determined using the screening solution confirmed that the largest change in pH was found in Careon (△pH 1.14±0.02), which has no erosive potential. Nevertheless, all elder-friendly foods had higher sugar content than the negative control group. Conclusions: Low tooth erosive potential was found in elder-friendly foods, but these foods showed high sugar content.

• Journal of Life Science
• /
• v.19 no.8
• /
• pp.1033-1038
• /
• 2009

Maximal productions of gellan by Sphingomnas paucibilis NK2000 from 20 g/l glucose and 10 g/l soybean pomace were 7.46 g/l in a flask and 7.35 g/l in a 7 l bioreactor, when the initial pH of media was 6.8. Maximal production of gellan in a 7 l bioreactor under pH control by sodium hydroxide was 8.42 g/l, whereas that under control by potassium phosphate was 8.50 g/l. The optimal concentration of potassium phosphate in a medium for production of gellan by S. paucibilis NK2000 was found to be 5.0 g/l. Maximal production of gellan in a medium containing 5.0 g/l potassium phosphate without pH control was 8.93 g/l in a 7 l bioreactor. In this study, a simple process without pH control was developed to enhance the production of gellan, with optimized concentration of potassium phosphate in the medium.

• Journal of Environmental Health Sciences
• /
• v.16 no.2
• /
• pp.75-82
• /
• 1990

Carbaryl was degradaded to monomethylamine(MA) by bacterium. which isolated from lake sediment. Its carbaryl degradation was maximized when grown on mineral salt medium conditioning 20 $\mu$M of carbaryl as a sole carbon source at 26${\circ}$C and initial pH 7.0-9.0 Its degradation ability was minimized at initial pH 3.0 and 5.0 The percent conversions { (moles of MA in excess of control / mole of carbaryl added) $\times$ 100} for 10. 20. 40 and 80 $\mu$M of carbaryl were 18.6. 16.1. 18.1 and 11.6 respectively. It suggests that increasing amount of carbaryl added above 80 $\mu$M. the percent conversion should be decreased. The MA production by the bacterium was lineary related to the cultural time. After 7days culture. its percent conversion was 46.2. and this result suggests that a half amount of carbaryl would be hydrolyzed to MA by the bacterium within 8 days.

• Journal of Korean Society on Water Environment
• /
• v.25 no.4
• /
• pp.568-572
• /
• 2009

The adsorption characteristics of tartrazine by granular activated carbon were experimentaly investigated in the batch adsorber and the packed column. The adsorptivity of activated carbon for tartrazine was largely improved by pH control, and 98 percent of initial concentration could be removed at pH 3. It was estabilished that the adsorption equilibrium of tartrazine on granular activated carbon was sucessfully fitted by Freundlich isotherm equation in the concentration range from 50 mg/L to 1,000 mg/L. The characteristics of breakthrough curve of activated carbon packed column, which depend on the design variables such as initial concentration, bed height, and flow rate, were studied.

• Journal of the Korean Society of Safety
• /
• v.24 no.4
• /
• pp.34-39
• /
• 2009

The adsorption characteristics of amatanth by granular activated carbon were experimently investigated in the batch adsorber and the packed column. The adsorptivity of activated carbon for amaranth were largely improved by pH control, and 94 percent of initial concentration(100mg/L) could be removed at pH 9. It was estabilished that the adsorption equilibrium of amaranth on granular activated carbon was sucessfully fitted by Freundlich isotherm equation in the concentration range from 1mg/L to 100mg/L. The characteristics of breakthrough curve of activated carbon packed column, which depend on the design variables such as initial concentration, bed height, and flow rate, were studied.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.3
• /
• pp.406-411
• /
• 2006

The objective of this study was to investigate the effects of feeding probiotic (Enterococcus faecium SF68, EF) on growth performance, nutrient digestibility, blood characteristics and faecal noxious gas content in finishing pigs. A total of eighty [($Landrace{\times}Yorkshire$)${\times}Duroc$] pigs with an initial BW of $50.47{\pm}2.13kg$ were used in this 8-week experiment. Pigs were allotted to four treatments (4 replicates per treatment and 5 pigs per pen) according to a randomized complete block design. Dietary treatments were: 1) CON (control; basal diet), 2) CTC (control diet+0.1% antibiotic, chlortetracycline), 3) EF1 (control diet+0.1% probiotic, EF) and 4) EF2 (control diet+0.2% probiotic, EF). During weeks 0-4, ADG was not affected by the addition of antibiotic or EF (p>0.05). In weeks 4-8, ADG tended to increase in CTC and EF treatments compared to CON treatment (p<0.10). ADFI and gain/feed were not affected in each 4-week period and the entire experimental period (p>0.05). Digestibilities of DM and N were higher in EF supplemented treatments than in CON and CTC treatments (p<0.05). Blood characteristics of WBC, RBC and lymphocyte were not affected in pigs given diets containing EF (p>0.05). Supplementation of EF in the diet decreased faecal ammonia nitrogen ($NH_3$-N) and hydrogen sulphide ($H_2S$) concentrations (p<0.05). Faecal acetic acid concentration tended to decrease (p<0.10) while propionic acid and butyric acid concentrations were significantly lower on diets with EF supplementation than on the diet containing antibiotic (p<0.05). In conclusion, dietary supplementation of EF can increase nutrient digestibility and decrease faecal $NH_3$-N, $H_2S$ and volatile fatty acid (VFA) concentrations in finishing pigs.