• 전기전자학회논문지
• /
• 제11권1호통권20호
• /
• pp.46-53
• /
• 2007

Design characteristics of PMLSM(Permanent Magnet Linear Synchronous Motor) considering the dynamic running condition under the limited input voltage and current for short reciprocating trajectory are presented. Particularly, the dynamic constraints resulted from the dynamic capability of PMLSM and the required motional performance of the repeated short stroke are applied to determine the design specification of PMLSM. In addition, optimal design flow based on the dynamic constraints is specified with the design parameters, such as coil resistances, the EMF constants, inductances, pole-pitch. Furthermore, proposed methods and results are validated by the experimental ones measured with the purpose-built prototype.

• 전자공학회논문지S
• /
• 제34S권1호
• /
• pp.72-79
• /
• 1997

Most open magnetic resonance imaging systems have used the planar gradient coils whose inductances were minimized through the magnetic energy minimization procedure in the spatial frequency domain. Though the planar gradient coils have smaller inductance than conventional gradient coils, the planar gradient coils often suffer from their poor magnetic field linearity. Scaling the spatial frequencies of the current density function designed by the magnetic energy minimization, magnetic field linearity of the planar gradient coils can be greatly improved with small sacrifice of gradient coil inductance. We have found that the figure of merit of the planar gradient coils, defined by the gradient strength divided by the linearity error and the inductance, can be improved by proposed technique.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제54권1호
• /
• pp.22-26
• /
• 2005

This paper proposes the calculation method of magnetic coupling coefficient of the contactless energy transmission system by 3D finite element method with a variation of the secondary core positions. The primary, secondary self and leakage inductances and the capacitances of a resonant circuit are calculated by the finite element analysis results. From these values, the magnetic coupling coefficients are obtained. The secondary voltages and currents according to the secondary core positions are calculated by using the resonant circuit and compared.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 F
• /
• pp.2761-2763
• /
• 1999

In this paper, we analyzed the characteristics of the detected EMF signals used to detect the rotor position in the IPM(Interior Permanent Magnet) BLDC motor and SPM (Surface Permanent Magnet) BLDC motor. The position sensing signal, in the IPM BLDC motors, advances the real rotor position due to the variation of the rotor inductances. This fact was verified by the simulation and experiment.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 정기총회 및 추계학술대회 논문집 학회본부
• /
• pp.103-105
• /
• 1993

This paper proposed a new direct vector control scheme using high frequency current injection. This scheme has some attractive features such as using no flux sensor or speed sensor, robustness of parameter variation, capability of accurate vector control at very low speed. Compared to other direct vector control scheme, this scheme doesn't depends on phase delay and difference of magnitude of estimated flux, rotor resistance and all inductances except stator resistance. These features are proved by computer simulation and experimental results.

• 전기학회논문지
• /
• 제65권1호
• /
• pp.81-87
• /
• 2016

An LCL-type Isolated dc-dc converter operating for constant output voltage is analyzed, including the effect of a high frequency transformer using ac complex circuit approximation. Its solution is derived and is used to obtain the characteristics of the proposed converter. The analyses show through converter modeling, phasor diagram and gain comparison that inclusion of a high frequency transformer results in introduction of magnetizing inductance and leakage inductances at conventional LCL dc-dc converter with ideal transformer. The theoretical and simulation results are presented in case of the wide variations in input voltage and load current in detail. Analysis and simulation results observed that introduction of a transformer in the dc-dc converter had considerable effect on the performance, especially in the case of low output voltage and large load.

• 전자공학회논문지A
• /
• 제33A권2호
• /
• pp.148-162
• /
• 1996

Bonding wires for high frequency device packaging have dominant parasitic inductances which limit the performance of semiconductor lasers. In this paper, the inductance sof bonding wires are claculated by the method of moments with incorporation of ohmic loss, and the wideband modulation characteristics are analyzed for ddifferent wire lengths and structures. We observed the modulation bandwidth for 1mm-length bonding wire lengths and structures. We observed the modulation bandwidth for 1mm-length bonding wire is 7 GHz wider than that for 2mm-length bonding wire. We also observed th estatic inductance calculation results in dispersive deviation of the parasitic inductance and the modulation characteristics from the wideband moment methods calculations. The angled bonding wire has much less parasitic inductance and improves the modulation bandwidth more than 6 GHz. This calculation resutls an be widely used for designing and packaging of high-speed semiconductor device.

• 전기전자학회논문지
• /
• 제24권2호
• /
• pp.586-591
• /
• 2020

본 논문에서는 인터리브된 전류 주입형 고승압 DC-DC 컨버터가 제안된다. 높은 전압 이득 외에도 인터리빙 방식을 채택하여 낮은 리플 입력 전류가 달성된다. 또한 제안 된 컨버터의 소프트 스위칭 특성은 전력 스위치의 스위칭 손실을 줄이고 변환 효율을 높인다. 변압기의 누설 인덕턴스를 활용하여 다이오드의 전류 변화율을 제어함으로써 출력 정류기의 역 회복 문제도 완화된다. 200W 프로토 타입에서 얻은 실험 결과에 대해 설명한다.

• 제어로봇시스템학회논문지
• /
• 제12권7호
• /
• pp.658-665
• /
• 2006

RVDT is a transducer that presents rotary phase angle according to the displacement of eccentric rotor such as press machine. However a study on the phase error of RVDT that affects precision is not enough. This paper analyzes RVDT phase error and obtains compensation curves with serial or parallel resistance through simulation. First, error compensation procedure that analyses errors due to the unbalance of reference inductances of each pole and uses parallel resistance as a compensation is proposed. Second, error compensation procedure due to the amplitude unbalance of the sensor driving currents is examined by serial compensation resistance. Experimentally, we got stable RVDT with phase error under $1^{\circ}$ by the proposed method.

• 전자공학회논문지D
• /
• 제34D권12호
• /
• pp.54-61
• /
• 1997

An accurate extraction technique is developed to determine full euqivalent circuit parameters of Si MOSFETs using 1 set of measured S-parametes without complicated optimization process. This technique is based on the use of anlytic Z-parameters experessions for resistances and inductances and the Y-parameter ones for ntrinsic parameters. This accuracy is proved over the wide range of gate voltage by observing good agreement between measured and fitted Z-parameter equations and frequency-independent response of the extracted intrinsic parameters. Using this technique, gate voltage-dependencies of model parameters are obained in the saturation region and these results show the similar behavior to the short-channel effects expected from the device theory.