• 센서학회지
• /
• 제16권2호
• /
• pp.97-103
• /
• 2007

Crystallized carbon nitride film that has many stable physical and/or chemical properties has been expected potentially by a new electrical material. However, one of the most significant problems degrading the quality of carbon nitride films is an existence of N-H and C-H bonds from the deposition environment. The possibility of these reactions with hydroxyl group in carbon nitride films, caused by a hydrogen attack, was suggested and proved in our previous reports that this undesired effect could be applied for fabricating micro-humidity sensors. In this study, MIS capacitor and MIM capacitor with $5{\mu}m{\times}5{\mu}m$ meshes were fabricated. As an insulator, carbon nitride film was deposited on a $Si_{3}N_{4}/SiO_{2}/Si$ substrate using reactive magnetron sputtering system, and its dielectric constant, C-V characteristics and humidity sensing properties were investigated. The fabricated humidity sensors showed a linearity in the humidity range of 0 %RH to 80 %RH. These results reveal that MIS and MIM $CN_{X}$ capacitive humidity sensors can be used for Si based micro-humidity sensors.

• 한국조경학회지
• /
• 제27권1호
• /
• pp.122-131
• /
• 1999

Indoor environments are usually less than optimal for the growth of ferns, especially in regards to the water condition. These studies were performed to investigate responses involved in causing growth of ferns and presume management plan against the water deficit under indoor conditions. The effect of air humidity and soil moisture on the ferns was examined in Adiantume raddianum and Selaginella kraussiana. Results of experiments are as follows; 1. Under a low humidity condition, having a 25-50% RH. ornamental value of ferns decreased much more than under a 90% RH. Under a low soil moisture, such as sand treatment, ornamental value of ferns also decreased. 2. Leaf chlorophyll content, water content and stomata situations increased as air humidity and soil moisture went up. 3. Even if air humidity and soil water were not enough for ferns growth, the extending of irrigation cycle was helpful. 4. Under extremely low air humidity conditions, some water management, namely, using water holding soil or extending of irrigation cycle was desirable. Other methods of increasing air humidity, including water instruments such as ornamental pools, waterfalls, or fountains, grouping plants together were also helpful. But spraying water on leaves increased injury to ferns growth because of excess evaporation from the leaves. Though these studies, we learn that ferns are susceptible to water condition such as air humidity, soil water and water management. If other environmental factos are maintained with optimal conditions, water condition plays an important role in ferns growth in indoor environments.

• 한국재료학회지
• /
• 제13권12호
• /
• pp.796-800
• /
• 2003

The polypyrrole prepared with pyrrole monomer, APS and DBSA was synthesized by chemical Polymerization at $V^{\circ}C$ under atmosphere conditions. After dissolving polypyrrole powder to the chloroform including DBSA, polypyrrole film was prepared on the alumina substrate with an interdigitated electrode by using the dip-coating method. This film was soaked in methanol solvent for 1 h at room temperature and heated to $70^{\circ}C$ for 4 h in $N_2$. Initial resistance was increased with the increasing humidity and decreasing temperature. The sensitivity was increased with lower humidity and decreasing temperature. The best linearity was achieved at $25^{\circ}C$ and low humidity of 0%.

• 한국안전학회지
• /
• 제19권3호
• /
• pp.65-69
• /
• 2004

This study was performed with Hartmann type dust explosion apparatus and Godbert-Greenwald furnace apparatus in order to research the effect of temperature and humidity affecting LEL, minimum ignition temperature of Hydroxy Propyl Methyl Cellulose. The experimental determinations in the range between $20^{\circ}C\;and\;60^{\circ}C$ of temperature was not affected $LEL(180g/m^3)$ but LEL showed $200g/m^3\;and\;250g/m^3\;at\;80^{|circ}C\;and\;100^{\circ}C$. As the change of humidity LEL was $180g/m^3\;for\;50\%,\;200g/m^3\;for\;60\%\;and\;250g/m^3\;for\;70\%$ but dust explosion didn't occur over $80\%$. The ignition temperature of HPMC dust clouds was increased as increasing of humidity. So, the minimum ignition temperatures at $50\%,\;60\%,\;70\%\;80\%$ of humidity was $363^{\circ}C,\;375^{\circ}C,\;397^{\circ}C,\;405^{\circ}C$.

• 센서학회지
• /
• 제14권5호
• /
• pp.331-336
• /
• 2005

The influence of water molecule on the electrical properties of single-walled carbon nanotube field effect transistors (SWNT-FETs) was reported. Conductance suppression was observed with the increase of the humidity. This can be explained by doping of the SWNT-FETs, which has p-type semiconductor characteristic, with the water molecules acting as an electron donor. However, after 65 % of humidity, conductance of the SWNT-FETs started to increase again, due to the opening of electron channels. Upon annealing at $400^{\circ}C$ in Ar atmosphere, conductance increases more than 500 %, and the threshold voltage shifts toward further positive gate voltages. The results of this experiment support possible application of single-walled carbon nanotubes for humidity sensing material.

• 한국연초학회지
• /
• 제3권1호
• /
• pp.30-40
• /
• 1981

The moisture sorption and desorption isotherms of various tobaccos were obtained over a relative humidity range from 0 to 90% at $20^{\circ}C$ and $30^{\circ}C$. The hysteresis effect, constant and rate of moisture sorption and desorption, monomolecular-layer moisture content, and specific surface area were analyzed from the obtained data. The moisture sorption and desorption isotherms showed a different characteristics for different tobacco varieties. At a lower humidity range below 50% RH, Burley tobacco had higher moisture sorption and desorption figures than Hicks and Basma, while, at a higher humidity range above 50% RH, Hicks had higher values than the others. The hysteresis effect of tobacco were greater in an intermediate humidity range (40-70% RN), and Basma showed a greater effect than the others. The sorption and desorption constant (K) increased with temperature, but decreased with RH, and Burley tobacco had larger K values, while Hicks had smaller K values than others. The sorption and desorption rate of Burley tobacco were greater than the other tobaccos. The monomolecular-layer moisture was 27.8 and 51.4mg/g, and the specific surface was 101 and $186m^2/g$, for Basma and Burley, respectively.

• 수산해양교육연구
• /
• 제18권1호
• /
• pp.58-64
• /
• 2006

In order to examine the effect of humidity on hydrogen embrittlement of STS 444 weld zone for boiler with dry and wet welding conditions, this paper was carried out the accelerated hydrogen osmosis test and the electrochemical Tafel polarization test. In 0.5M $H_2SO_4$ + 0.01M $As_20_3$ solution, this test is added to load of $1400kg/cm^2$ together with hydrogen osmosis by current of $50 {mA/cm^2}$ for 60 min.. The electrochemical Tafel polarization test was carried out in 0.5M $H_2SO_4$ + 0.01M $As_20_3$ solution. Therefore, the effect of humidity on hydrogen embrittlement of STS 444 was considered. The main results are as following: On the basis of hydrogen embrittlement mechanism, that is, integrated electrochemical polarization characteristics with the established mechanism of hydrogen embrittlement, the reduction rate of corrosion current density of weld zone in the wet weld condition is larger than in the dry condition. We can nondestructively predict the degree of hydrogen embrittlement of STS 444 weld zone for boiler through the reduction rate of electrochemical corrosion current density.

• 대한한의학회지
• /
• 제28권4호
• /
• pp.18-26
• /
• 2007

Objective : To study the effect of the Insamyangyoung-tang(ISYT) extract on the skin barrier function, the skin pH, skin humidity and transepidermal water loss(TEWL) were measured and histological changes were observed in DNCB(2,4-dinitrochloro-benzen)-induced contact dermatitis(CD) hairless mice. Methods : The male hairless mice were divided into three groups. Each group consisted of 15 mice. The normal group which had acetone- olive oil applied. The control group which had intentionally induced CD by DNCB and it was fed normal saline orally. The ISYT group which had intentionally induced CD by DNCB and it was fed ISYT extract orally for 7 days. The three groups were checked 24h, 48h and 72h later after inducing CD, and the skin pH, skin humidity and TEWL were observed. Tissue samples were taken, and damage to the epithelial cell was observed. Statistical analysis was performed by using one way-ANOVA: significance was set at p values less than 5% (p<0.05). Results : ISYTextract efficiently maintained the pH balance, it kept the skin humidity at a normal level, and it inhibited TEWL of the DNCB-induced CD hairless mouse. The damage to the epithelium was decreased and the regeneration power of the skin was increased in the ISYT group. Conclusion : Insamyangyoung-tang has a good effect on the skin barrier function of DNCB induced contact dermatitis hairless mice.

• 한국세라믹학회지
• /
• 제32권11호
• /
• pp.1283-1291
• /
• 1995

The electrical conductivity, flammable gas response and their humidity effect of porous ZnO, added with 5wt% corn starch as the fugitive phase, were examined. Porous ZnO showed different conductivity curves during increasing and decreasing temperature, and its electrical conductivity decreased rapidly by desorption of OH- between 20$0^{\circ}C$ and 35$0^{\circ}C$ when the temperature increased in dry air. The CO gas sensitivity of starchadded ZnO samples was higher than that of ZnO without starch addition. The sensitivity of porous, starchadded ZnO to 200ppm CO gas was much less in humid atmosphere than in dry atmosphere since water vapor increased the conductivity of porous ZnO in air, but decreased the conductivity in CO. Maximum sensitivity to 200 ppm CO gas balanced by air was about 100 in dry atmosphere and about 15 in RH 23% atmosphere.

• 한국태양에너지학회 논문집
• /
• 제25권2호
• /
• pp.45-51
• /
• 2005

The solar shading height for the cultivation of plants is a very important factor because it has an effect on the variations of the solar energy. In this study, the solar shadings were built in Daegu region to investigate the optimum thermal conditions for the cultivation of plants and to provide the basic data. The thermal environment factors (dry bulb temperature, relative humidity, air velocity) were then measured and analyzed. It is found that the heights of the solar shadings have an uniform effect on the thermal environment for the cultivation of plants: the higher the heights of the solar shadings the higher temperature was obtained. But surprisingly this trend was not found for the relative humidity and the air velocity.