• Macromolecular Research
• /
• v.12 no.1
• /
• pp.141-143
• /
• 2004

We have investigated the dynamic mechanical behavior of ultra-high molecular weight polyethylene (UHMWPE) irradiated with varying doses of gamma rays. A relaxation peak in the loss factor curve, which has not been reported previously in the literature, is observed at a temperature above the crystal melting temperature. The peak is unique to UHMWPE and appears to be related to the high degree of entanglement. Because the temperature and intensity of the peak are reduced by irradiation-induced chain scission and crosslinking, respectively, we believe that the peak is associated with disentanglement relaxation. The behavior of the storage modulus in the melt state agrees with the classical theory of rubber elasticity.

• Journal of Sericultural and Entomological Science
• /
• v.45 no.1
• /
• pp.46-57
• /
• 2003

This study was carried out to investigate the characteristics of the soluble sericins after degumming and after hydrolysis of insoluble sericin with various enzymes. Especially, the hydrolysis characteristics were examined in terms of molecular weight of the soluble sericin. Amino acid composition and molecular weight characteristics of the soluble sericins were also studied. When the insoluble sericin was hydrolyzed with kojizyme and flavourzyme, the solubility was highest at pH 7 and 50$^{\circ}C$. On the other hand, in the cases of protamex and alcalase, the highest solubility was obtained at 60$^{\circ}C$. In these cases, solubility increased with pH. In enzymatic hydrolysis, the solubility was increased with concentration of enzymes until 4 hours. After then, a slight difference was found along with treatment times. In enzymatic hydrolysis, the absorbance of the soluble sericin was increased with concentration of enzymes and treatment times. Average degree of polymerization was decreased with treatment time and concentration. The amino acid compositions were similar in low(low molecular weight by degumming) and high (high molecular weight by degumming). Those of PK (soluble sericin hydrolyzed with kojizyme), PP (soluble sericin hydrolyzed with protamex), and PA(soluble sericin hydrolyzed with alcalase) were similar to each other. Serine and tyrosine compositions were higher in low and high than those of PK, PP, and PA. However proline was absent in low and high. Molecular weights of the various sericins became higher as KP>high>PP>low>PA and those of KP and PA were 9,800 and 905 respectively.

• Korean Journal of Food Science and Technology
• /
• v.31 no.3
• /
• pp.586-592
• /
• 1999

The objective of this study was to investigate the fundamental characteristics of proteins effecting on Korean wheat flour quality. Mixing properties and protein contents of Eunpa, Allgreu, and Woori showed soft wheat characteristics. Tapdong had strong dough stability and high protein content like hard wheat flour. However, even though Greu had a high protein content, the dough strength was very weak like soft wheat flour. No major difference was observed in protein solubility with water, 0.1N NaCl, 70% ethyl alcohol, 0.1 N acetic acid solution and in sulfur and disulfide contents between Korean wheat flours and imported flours. However, DNS (Dark Norther Spring) had more contents of acid insoluble and SDS insoluble proteins compared with Korean wheat varieties. PAGE pattern of Tapdong was very similar to imported wheat flours at the high molecular weight regions and characteristic high molecular weight glutenin subunits were observed over 116 kD protein molecular weight region from 4 Korean wheat flours such as Eunpa, Woori, Allgreu, and Greu.

• Macromolecular Research
• /
• v.14 no.4
• /
• pp.430-437
• /
• 2006

The ultra-drawing process of an ultra high molecular weight polyethylene (UHMWPE) gel film was examined by incorporating linear low-density polyethylene (LLDPE) and $BaTiO_3$ nanoparticles. The effects of LLDPE and the draw ratios on the morphological development and mechanical properties of the nanocomposite membrane systems were investigated. By incorporating $BaTiO_3$ nanoparticles in the UHMWPE/LLDPE blend systems, the ultra-drawing process provided a highly extended, fibril structure of UHMWPE chains to form highly porous, composite membranes with well-dispersed nanoparticles. The ultra-drawing process of UHMWPE/LLDPE dry-gel films desirably dispersed the highly loaded $BaTiO_3$ nanoparticles in the porous membrane, which could be used to form multi-layered structures for electronic applications in various embedded, printed circuit board (PCB) systems.

• Food Science and Preservation
• /
• v.15 no.6
• /
• pp.903-908
• /
• 2008

This study investigated protein changes in soymilk and whole soymilk due to enzymatic hydrolysis. The total free amino acid contents of low molecular weight soymilk (LSM) and low molecular weight whole soymilk (LWSM) were higher than soymilk (SM) and whole soymilk (WSM). The essential amino acid content was similar in SM and LSM, but was higher in LWSM than WSM. In SDS-PAGE performed to tendency of becoming low molecules, the soy protein molecular weights were 3372 kDa for SM and WSM, but 17 kDa or less for LSM and LWSM. Also, high molecular weight protein spots were evident in 2-D electrophoresis of SM and LSM, but only low molecular weight protein spots of various sizes were evident in WSM and LWSM. This suggests that the high molecular weight protein in SM and WSM is changed to low molecular weight protein by enzymatic hydrolysis. Further investigations of the separation and qualities of these proteins are required.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.41 no.2
• /
• pp.13-19
• /
• 2009

In order to produce high quality paper at the lowest cost in high speed, typically various polyelectrolytes as retention aids were used. Retention systems such as single polymer system, dual polymer system, and microparticle system were used. The objective of this study was to analyze the changes of retention, drainage, formation and fracture toughness depending on types of retention system, molecular weight of C-PAM and dosage sequences of agents. When single polymer system was applied, retention was increased with poor formation and drainage. When common microparticle system(C-PAM/bentonite) was used, high molecular weight PAM gave high retention and fast drainage, but poor formation. When the microparticle system with reverse dosage sequence(bentonite/C-PAM) was used, low molecular weight PAM gave high retention, fast drainage and good formation. When various retention agents were applied, fracture toughness was increased than that of blank. When using high molecular weight PAM and consequently causing excessive flocculation, fracture toughness was decreased.

• BMB Reports
• /
• v.35 no.2
• /
• pp.220-227
• /
• 2002

Two aspartate aminoransferase (EC 2.6.1.1) isoenzymes (AAT-1 and AAT-2) from Lupinus albus L. cv Estoril were separated, purified, and characterized. The molecular weight, pI value, optimum pH, optimum temperature, and thermodynamic parameters for thermal inactivation of both isoenzymes were obtained. Studies of the kinetic mechanism, and the kinetics of product inhibition and high substrate concentration inhibition, were performed. The effect of some divalent ions and irreversible inhibitors on both AAT isoenzymes was also studied. Native PAGE showed a higher molecular weight for AAT-2 compared with AAT-1. AAT-1 appears to be more anionic than AAT-2, which was suggested by the anion exchange chromatography. SDS-PAGE showed a similar sub-unit molecular weight for both isoenzymes. The optimum pH (between 8,0 and 9.0) and temperature ($60-65^{\circ}C$) were similar for both isoenzymes. In the temperature range of $45-65^{\circ}C$, AAT-2 has higher thermostability than AAT-1. Both isoenzymes showed a high affinity for keto-acid substrates, as well as a higher affinity to aspartate than glutamate. Manganese ions induced an increase in both AAT isoenzymes activities, but no cooperative effect was detected. Among the inhibitors tested, hydroxylamine affected both isoenzymes activity by an irreversible inhibition mechanism.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05b
• /
• pp.77-80
• /
• 2006

Graft copolymerized polycarboxylate(PC)-type superplasticizers(PCs) which have carboxylic acid with $\pi$ bond among the molecular structure and polyethyleneglycol methyl ether methacrylate(PMEM) were synthesized by free radical reaction and investigated the chemical structure, polymerization condition, and physical and chemical properties. Also, the effects of PCs in the dispersion, adsorption and hydration of cement were evaluated. As the molecular weight of graft chain decreases, the adsorption amount on cement particles increased. It was advantageous for the flow to reduce molar ratio, the lower the side bone molecular weight, and increase the molar ratio, the larger the side bone molecular weight. The hydration reaction speed was highly delayed at day 1, due to increase in molar ratio and reduction in side bone molecular weight, but it was recovered in the days after.

• Korean Journal of Microbiology
• /
• v.20 no.4
• /
• pp.201-209
• /
• 1982

An enzyme, named GTP cyclohydorlase, that catalizes the hydrolytic removal of carbon No.S of GTP has been partially purified from extracts of Pseudomonas putida (IAM 1506). The enzyme exists in two molecuar weight forms : a high molecular weight form (150,000) and a low molecular weight from (40,000). The high molecular weight form has been purified 25-fold. Some of the properties of the enzyme are as follows : It functions optimally at pH8.0, and at $52^{\circ}C$. The Km value for GTP is $20{\mu}M$. Divalent cations $(Cd^{2+}\;and\;Hg^{2+})$ 2+/) at a concentration of 5mM inhibit completely the enzyme activity. No metal ion including $Mg^{2+}$ is needed for the catalysis. The enzyme is heat labile ; its half at $57^{\circ}C$ is 1.5 min. Of a number of nucleotides tested, only GDP was used to any extent as substrbte in place of GTP. One of the products of the enzyme is determined to be a dihydro-neopterin compound.

• Journal of Microbiology
• /
• v.40 no.1
• /
• pp.70-76
• /
• 2002

Proviral DNAs from HIV-1-infected CD4+ T cells (Molt/LAV cells) were amplified and detected in infected individual cells using polymerase chain reaction and in rifu hybridization. In this in situ PCR, three parameters were considered to achieve effective amplification and retention of amplificants inside the cells by making high molecular weight PCR products intracellularly, forming agarose matrix against the cells, and maintaining the appropriate PCR temperature profile. Over the cycles of ampliHcationl tailed primers with complementary overhanging sequences at their 5' sides manufactured high molecular weight products by using short primary products as a repeating unit. Agarose matrix could prevent the diffusion of the amplificants from the cells. Use of Thermanox coverslip inside the PCR tube offered target cells a similar temperature profile to that of conventional PCR in solution.