• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.791-794
• /
• 2003

The increasing computational capability of processors is driving the need for high bandwidth links to communicate and store the information that is processed. Such links are often an important part of multi processor interconnection, processor-to-memory interfaces and Serial-network interfaces. This paper describes a 0.11-${\mu}{\textrm}{m}$ CMOS 4 Gbp s/pin 3-Level transceiver using RSL/(Rambus Signaling Logic) for high bandwidth. This system which uses a high-gain windowed integrating receiver with wide common-mode range which was designed in order to improve SNR when operating with the smaller input overdrive of 3-Level. For multi-gigabit/second application, the data rate is limited by Inter-Symbol Interference (ISI) caused by low pass effects of channel, process-limited on-chip clock frequency, and serial link distance. In order to detect the transmited 4Gbps/pin with 3-Level data sucessfully ,the receiver is designed using 3-stage sense amplifier. The proposed transceiver employes multi-level signaling (3-Level Pulse Amplitude Modulation) using clock multi phase, double data rate and Prbs patten generator. The transceiver shows data rate of 3.2 ~ 4.0 Gbps/pin with a 1GHz internal clock.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.7
• /
• pp.791-798
• /
• 1988

Films of Cr, Cu, and Al were deposited by the evaporation technique at the high vacuum level-high evaporation rate and the low vacuum level-low evaporation rate. We measured sheet resistance and light transmittance, and observed microstructure and diffraction pattern by TEM, and investigated oxygen content in thin film by AES. We discussed the relations among microstructure, sheet resistance, and light transmittance with AES data. We found that the films deposited at the high vacuum level-high evaporation rate have small oxygen content in thin film comparing to the films deposited at the low vacuum level-low vacuum level-low evaporation rate, and that the films having crystalline structure and larger grain size were formed in the case of the high vacuum level-high evaporation rate and they showed lower sheet resistance and lower light transmittance.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1260-1263
• /
• 2005

Data storage related with writing and retrieving requires high storage capacity, fast transfer rate and less access time. Today any data storage system cannot satisfy these conditions, however holographic data storage system can perform faster data transfer rate because it is a page oriented memory system using volume hologram in writing and retrieving data. System can be constructed without mechanical actuating part therefore fast data transfer rate and high storage capacity about 1Tb/cm3 can be realized. In this research, to reduce errors of binary data stored in holographic data storage system, a new method for bit error reduction is suggested. First, find fuzzy rule using experimental system for Element of Holographic Digital Data System. Second, make fuzzy rule table using Genetic algorithm. Third, reduce prior error element and recording Digital Data. Recording ratio and reconstruction ratio will be very good performance

• 정보저장시스템학회:학술대회논문집
• /
• 2005.10a
• /
• pp.44-46
• /
• 2005

Data storage related with writing and retrieving requires high storage capacity, fast transfer rate and less access time. Today any data storage system cannot satisfy these conditions, however holographic data storage system can perform faster data transfer rate because it is a page oriented memory system using volume hologram in writing and retrieving data. System can be constructed without mechanical actuating part therefore fast data transfer rate and high storage capacity about $1Tb/cm^3$ can be realized. In this paper, to reduce errors of binary data stored in holographic data storage system, a new method for bit error reduction is suggested. We proposal Algorithm use The Extended Kalman filter. The Kalman filter reduce measurement noise. Therefore, By using this error reduction method following results are obtained; the effect of measurement nois of Pixel is decreased and the intensity profile of data page becomes uniform therefore the better data storage system can be constructed.

• 정보저장시스템학회:학술대회논문집
• /
• 2005.10a
• /
• pp.129-133
• /
• 2005

Data storage related with writing and retrieving requires high storage capacity, fast transfer rate and less access time. Today any data storage system cannot satisfy these conditions, however holographic data storage system can perform faster data transfer rate because it is a page oriented memory system using volume hologram in writing and retrieving data. System can be constructed without mechanical actuating part therefore fast data transfer rate and high storage capacity about $1Tb/cm^3$ can be realized. In this paper, to reduce errors of binary data stored in holographic data storage system, a new method for bit error reduction is suggested. First, find cluster centers using subtractive clustering algorithm then reduce intensities of pixels around cluster centers and fuzzy rules. Therefore, By using this error reduction method following results are obtained ; the effect of Inter Pixel Interference noise is decreased and the intensity profile of data page becomes uniform therefore the better data storage system can be constructed.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.6 s.324
• /
• pp.25-31
• /
• 2004

fireless LAN can offer high data rate communication between wireless terminals. In IEEE 802.11 wireless LAN, a basic service unit is called a Basic Service Set (BSS), which consists of one AP and more than one wireless terminals. Terminals far from the AP may not communicate with high data rate because signal strength is weakened as they move away from the AP. In this paper we propose a method to permit high speed data transmission by grouping terminals and by using part of wireless terminals as repeaters. We analyze the proposed and algorithm via simulations. Our proposed grouping mechanism is shown to be an effective way to increase the distance for high rate transmission.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.2
• /
• pp.86-91
• /
• 2014

Holographic data storage (HDS) has a number of advantages, including a high transmission rate through the use of a charge coupled device array for reading two-dimensional (2D) pixel image data, and a high density capacity. HDS also has disadvantages, including 2d intersymbol interference by neighboring pixels and interpage interference by multiple pages stored in the same holographic volume. These problems can be eliminated by modulation codes. We propose a 7/9 error-correcting modulation code that exploits a Viterbi-trellis algorithm and has a code rate larger (about 0.778) than that of the conventional 6/8 balanced modulation code. We show improved performance of the bit error rate with the proposed scheme compared to that of the simple 7/9 code without the trellis scheme and the 6/8 balanced modulation code.

• Nuclear Engineering and Technology
• /
• v.54 no.10
• /
• pp.3587-3594
• /
• 2022

A distributed high-speed data acquisition and monitoring system for the RF negative ion source at Huazhong University of Science and Technology (HUST) is developed, which consists of data acquisition, data forwarding and data processing. Firstly, the data acquisition modules sample physical signals at high speed and upload the sampling data with corresponding absolute-time labels over UDP, which builds the time correlation among different signals. And a special data packet format is proposed for the data upload, which is convenient for packing or parsing a fixed-length packet, especially when the span of the time labels in a packet crosses an absolute second. The data forwarding modules then receive the UDP messages and distribute their data packets to the real-time display module and the data storage modules by PUB/SUB-pattern message queue of ZeroMQ. As for the data storage, a scheme combining the file server and MySQL database is adopted to increase the storage rate and facilitate the data query. The test results show that the loss rate of the data packets is within the range of 0-5% and the storage rate is higher than 20 Mbps, both acceptable for the HUST RF negative ion source.

• Journal of Astronomy and Space Sciences
• /
• v.32 no.3
• /
• pp.209-219
• /
• 2015

The Accurate Ranging System for Geodetic Observation - Mobile (ARGO-M) was successfully developed as the first Korean mobile Satellite Laser Ranging (SLR) system in 2012, and has joined in the International Laser Ranging Service (ILRS) tracking network, DAEdeoK (DAEK) station. The DAEK SLR station was approved as a validated station in April 2014, through the ILRS station "data validation" process. The ARGO-M system is designed to enable 2 kHz laser ranging with millimeter-level precision for geodetic, remote sensing, navigation, and experimental satellites equipped with Laser Retro-reflector Arrays (LRAs). In this paper, we present the design and development of a next generation high-repetition-rate SLR system for ARGO-M. The laser ranging rate up to 10 kHz is becoming an important issue in the SLR community to improve ranging precision. To implement high-repetition-rate SLR system, the High-repetition-rate SLR operation system (HSLR-10) was designed and developed using ARGO-M Range Gate Generator (A-RGG), so as to enable laser ranging from 50 Hz to 10 kHz. HSLR-10 includes both hardware controlling software and data post-processing software. This paper shows the design and development of key technologies of high-repetition-rate SLR system. The developed system was tested successfully at DAEK station and then moved to Sejong station, a new Korean SLR station, on July 1, 2015. HSLR-10 will begin normal operations at Sejong station in the near future.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.5
• /
• pp.832-842
• /
• 2006

Wireless Personal Area Networks(WAPANs) are designed for short-range ad hoc connectivity among portable devices. They have gained much attention in the industry recently. One of them, High-rate WPAN, is designed to support multimedia traffic that requires high data rates. But, High-rate WPAN standards don't specify the time slot assignment scheduling method of CAT(Channel Time Allocation). So, there has been many studies regarding time slot assignment scheduling of CAT. However, present studies involve demerits about not applying various types of errors in air interlace or having a starvation of a specific DEV(data device). In this paper, we propose algorithms about supplying the intermediate channel assignment in order to avoid these demerits. This method will help other methods that use time slot assignment scheduling of CTA.