• 한국연초학회지
• /
• 제6권1호
• /
• pp.39-49
• /
• 1984

In the tobacco industry, it is important to study the change of mechanical property occurring the expansion process. The purpose of this study is to attain basic data for development of a tobacco expansion method. 1 . Freon gas was adsorbed to tobacco under various conditions of temperature, relative humidity and pressure, and then the amount of freon gas adsorbed was analyzed by GC. Freon adsorption rate of Burley 21 was more than that of By104 at the same condition and about 17 $\pm$ 1% moisture content produced better adsorption rate. 2. Freon adsorbed sample were heated to about $150^{circ}C\;to\;230^{\circ}C$ in a drying oven and recycle duct form about 2 to 30 seconds, and then the change of mechanical property were measured. Heated leaf was damaged when the tissue was pressed by the force of above $0.5x10^8dyn/cm^2$. The optimum condition of no damage of the sample was below the temperature of 15$0^{\circ}C$ and heating time of 10 seconds. It was more economically advantages to treated sample in a recycle duct than to be in a drying oven. By this process, the specific volume of the heated sample was increased from 80 to 110 percent in comparison to that of untreated sample.

• 천문학회보
• /
• 제46권2호
• /
• pp.47.1-47.1
• /
• 2021

Transverse magnetohydrodynamic waves often called Alfvénic (or kink) waves have been often theoretically put forward to solve the outstanding problems of the solar corona like coronal heating, solar wind acceleration, and chemical abundance enhancement. Here we report the first spectroscopic detection of Alfvénic waves around a sunspot at chromospheric heights. By analyzing the spectra of the Hα line and Ca II 854.2 nm line, we determined line-of-sight velocity and temperature as functions of position and time. As a result, we identified transverse magnetohydrodynamic waves pervading the superpenumbral fibrils. These waves are characterized by the periods of 2.5 to 4.5 minutes, and the propagation direction parallel to the fibrils, the supersonic propagation speeds of 45 to 145 km s-1, and the close association with umbral oscillations and running penumbral waves in sunspots. Our results support the notion that the chromosphere around sunspots abounds with Alfvénic waves excited by the mode conversion of the upward-propagating slow magnetoacoustic waves.

• 한국분말재료학회지
• /
• 제21권4호
• /
• pp.256-259
• /
• 2014

A magnetic powder, M-type barium hexaferrite (BaFe12O19), was consolidated with the spark plasma sintering process. Three different holding temperatures, $850^{\circ}C$, $875^{\circ}C$ and $900^{\circ}C$ were applied to the spark plasma sintering process with the same holding times, heating rates and compaction pressure of 30 MPa. The relative density was measured simultaneously with spark plasma sintering and the convergent relative density after cooling was found to be proportional to the holding temperature. The full relative density was obtained at $900^{\circ}C$ and the total sintering time was only 33.3 min, which was much less than the conventional furnace sintering method. The higher holding temperature also led to the higher saturation magnetic moment (${\sigma}_s$) and the higher coercivity ($H_c$) in the vibrating sample magnetometer measurement. The saturation magnetic moment (${\sigma}_s$) and the coercivity ($H_c$) obtained at $900^{\circ}C$ were 56.3 emu/g and 541.5 Oe for each.

• 생명과학회지
• /
• 제11권3호
• /
• pp.203-210
• /
• 2001

To produce the instant marsh calm(Corbicula elatior) soup with abundant taste and flavor. optimum conditions of heating temperature and time for extraction were investigated. Excretion rate in a pre-treatment for excretion of estuary was 82% at 15% salt concentration for 6 hr and 95% at pH 7.5 for 10 hr. The contents of glycogen and amino-nitrogen were the most high levels in the treatments extracted at 9$0^{\circ}C$ for 3 hr, at 10$0^{\circ}C$ for 1.5 hr and at 11$0^{\circ}C$for 1 hr. The contents of total free amino acids in the extracts treated at 9$0^{\circ}C$, 10$0^{\circ}C$ and 11$0^{\circ}C$ were 367.05mg/100g, 472.23 mg/100g and 463.54 mg/100g, respectively and optimal temperature was above 10$0^{\circ}C$. The mineral contents was the most high level for the extract treated at 10$0^{\circ}C$ for 1.5hr. The results of sensory evaluation showed that tastes for the marsh calm extracts had no significant discrimination, while external appearances and flavors for the extract done at 10$0^{\circ}C$ for 1.5 hr were excellent. The extracts at 10$0^{\circ}C$ showed a little dark color and those at 9$0^{\circ}C$ smell a little fish flavor.

• Journal of Ginseng Research
• /
• 제6권1호
• /
• pp.25-29
• /
• 1982

This investigation was carried out to study the influence of pH and heat treatment on the ginsenosides in the white ginseng extract. Changes in ginsenosides (Rb1, Rb2, ,Rc, Rd) and free sugar were measured by the peak area variation of HPLC chromatogram during 25 hours heat treatment at the various level of pH. It was found that :(1) The peak areas of Rb1. Rb2, Rc and Rd on the HPLC chromatogram were decreased remarkably below pH 4.0 and more decrease was found as the temperature and heating time increased. (2) Those of glucose and arabinose were increased remarkably. It is considrered that the increase of glucose and the formation of arabinose result from the hydrolysis of ginsenoside( Rb1, Rb2, Rc, Rd) linked with sugars.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2003년도 학술대회논문집
• /
• pp.161-163
• /
• 2003

Ring-shaped electrodeless fluorescent lamp is removed the internal electrodes and heating filaments that are a light-limiting factor of conventional fluorescent lamps. The ring-shaped electrodeless lamp is intended as a high efficacy replacement for the incandescent reflector lamp in many applications. In this paper, maxwell 3D finite element analysis program (Ansoft) was used to obtain electromagnetic properties associated with the coil and nearby structures. The electromagnetic emitting properties were presented by 3D simulation software operated at 250[㎑]and some specific conditions. The optical measurement measured luminance and a temperature and an optical spectrum distribution for 10 minutes in a one minute interval at the same time.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2010년도 춘계학술대회 초록집
• /
• pp.94.2-94.2
• /
• 2010

Indium tin oxide (ITO) Thin films were grown on Non-alkarai glass Substrates by PVD method and Subsequently Subjected to ($100^{\circ}C-350^{\circ}C$) Thermal Annealing (TA) In Nitr Oxygen ambinent. Most of all, The effect of TA treatment on the structural properties were studied by using X-Ray diffraction and atomic force microscopy, while optical properties were studied by UV-Transmittance measurements. After TA treatment, the XRD spectra have shown an effective relaxation of the residual compressive stress, As a result, XRD peaks increase of the intensity and narrowing of full width at half-maximun (FWHM). In addtion The microstructure, The surface morphology, the optical transmittance changed and improved, and we investigated The effects of temperature, Time and atmosphere during the TA on the structural and electrical properties of the ITO/glass on TA at $300^{\circ}C$. As a results, the films are highly transparent (80%～89%) in visible region. AFM analysis shows that the films are very smooth with root mean square surface roughness 0.58nm -2.75nm thickness film. It is observed that resistivity of the films drcreases T0 $1.05{\times}10^{-4}{\Omega}cmt$ $6.06{\times}10^{-4}{\Omega}cm$, while mobility increases from $152cm^2/vs$ to $275cm^2/vs$.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제53권12호
• /
• pp.601-605
• /
• 2004

In this paper, we investigated ionic impurities and physical properties by change of carbon black content, which is asemiconductive material for underground power transmission. Specimens were made into sheet form with three existing resins and nine specimens for measurement. The ionic impurities of the specimens were measured using anICP-AES (Inductively Coupled Plasma Atomic Emission Spectrometer), and the density of specimens was measured by a density meter. Specific heat (Cp) was then measured using aDSC (Differential Scanning Calorimetry). The ranges of measurement temperature were from 0[$^{\circ}C$] to 200[$^{\circ}C$], and heating temperature was 4[$^{\circ}C$/min]. Ionic impurities were measured to be high according to increases in the content of carbon black from this experimental result and density was also increased according to these properties. In particular, the impurity content values of A1 and A2, and existing resins, were measured at more than 4000[ppm]. Specific heat from the DSC results was lowered according to augmentation in the content of carbon black. The ionic impurities of carbon black containing Fe, Co, Mn, Al and Zn are forms of rapidly passed kinetic energy that increase the number of times breaking occurs during unit time with the near particles according to an increase in the vibration of particles by the applied heat energy.

• Steel and Composite Structures
• /
• 제19권3호
• /
• pp.661-678
• /
• 2015

Buckling Restrained Braces (BRB) have been widely used in the construction industry as they utilize the most desirable properties of both constituent materials, i.e., steel and concrete. They present excellent structural qualities such as high load bearing capacity, ductility, energy-absorption capability and good structural fire behaviour. The effects of size and type of filler material in the existed gap at the steel core-concrete interface as well as the element's cross sectional shape, on BRB's fire resistance capacity was investigated in this paper. A nonlinear sequentially-coupled thermal-stress three-dimensional model was presented and validated by experimental results. Variation of the samples was described by three groups containing, the steel cores with the same cross section areas and equal yield strength but different materials (metal and concrete) and sizes for the gap. Responses in terms of temperature distribution, critical temperature, heating elapsed time and contraction level of BRB element were examined. The study showed that the superior fire performance of BRB was obtained by altering the filler material in the gap from metal to concrete as well as by increasing the size of the gap. Also, cylindrical BRB performed better under fire conditions compared to the rectangular cross section.

• 토지주택연구
• /
• 제1권1호
• /
• pp.19-25
• /
• 2010

최근 에너지 절약을 화두로 건물에서의 에너지 절약기술들이 크게 요구되어 지는 반면 재실자의 온열쾌적환경은 비교적 비중 있게 다루어지지 않고 있다. 실내공간의 쾌적성은 재실자의 만족감과 더불어 생산성을 향상시키는 등의 역할을 하며, 최근 삶의 질 향상 등에 따라 그 필요성이 크게 요구되고 있는 실정이다. 따라서 본 연구에서는 공동주택을 대상으로 겨울철 난방 시 쾌적지표를 통한 실내 온열환경 제어의 타당성을 검토하고자 시뮬레이션을 수행하였으며, 주거건물에서의 일상적인 실내온도와 에너지 절약 설계기준에서 제시한 실내 설정온도, 그리고 쾌적지표를 설정으로 한 각 제어조건의 온열환경과 에너지 소비량을 비교 분석 및 검토하였다. 본 연구결과에 따르면, 쾌적지표인 PMV로 실내환경을 제어했을 때 에너지 절약설계 기준인 $22^{\circ}C$로 실내온도를 설정하였을 때보다 에너지 소비량은 29% 증가하지만 주거용 건물에서 일반적으로 유지되는 실내온도인 $24^{\circ}C$ 보다는 에너지소비량은 11% 정도 감소하며, 온열쾌적감도 각 제어조건 중 가장 우수하게 나타났다. 따라서 여러 가지 제어변수들을 통한 연구가 지속된다면 주거용 건물에서도 쾌적지표를 활용한 실내 공간의 제어방법은 건물의 에너지를 절약하고 실내 환경의 쾌적성을 증대시키는 주요기술이 될 수 있을 것으로 기대된다.