• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2004년도 제28회 KOSCO SYMPOSIUM 논문집
• /
• pp.227-234
• /
• 2004

For gaseous fuel combustion with inherent $CO_2$ capture and low NOx emission, chemical-looping combustion(CLC) may yield great advantages of savings of energy to $CO_2$ separation and suppressing the effect on environment. In chemical-looping combustor, fuel is oxidized by metal oxide medium (oxygen carrier particle) in a reduction reactor. Reduced particles are transported to oxidation reactor and oxidized by air and recycled to reduction reactor. The fuel and the air are never mixed, and the gases from reduction reactor, $CO_2$ and $H_2O$, leave the system as separate stream. The $H_2O$ can be easily separated by condensation and pure $CO_2$ is obtained without any loss of energy for separation. The purpose of this study is to demonstrate inherent $CO_2$ separation and no NOx emission and to confirm high $CO_2$ selectivity, no side reaction (i.e., carbon deposition, hydrogen generation) by continuous reduction and oxidation experiment in a 50kWtb chemical-looping combustor. NiO/bentonite particle was used as a bed material and $CH_4$ and air were used as reacting gases for reduction and oxidation respectively.

• 한국응용과학기술학회지
• /
• 제30권3호
• /
• pp.371-379
• /
• 2013

In order to improve the selective oxidation reaction of gaseous ammonia at a low temperature, various types of metal-impregnated activated alumina were prepared, and also physical and chemical properties of the conversion of ammonia were determined. Both types of metal (Cu, Ag) impregnated activated alumina show high conversion rate of ammonia at high temperature (over $300^{\circ}C$). However, at lower temperature ($200^{\circ}C$), Ag-impregnated catalyst shows the highest conversion rate (93%). In addition, the effects of lattice oxygen of the developed catalyst was studied. Ce-impregnated catalyst showed higher conversion rate than commercial alumina, but also showed lower conversion rate than Ag-impregnated sample. Moreover, 5 vol.% of Ag activation under hydrogen shows the highest conversion rate result. Finally, through high conversion at low temperature, it was considered that the production of NO and $NO_2$, toxic by-products, were effectively inhibited.

• International Journal of Oral Biology
• /
• 제39권1호
• /
• pp.35-40
• /
• 2014

Halitosis is caused by consumption of certain foods or drinks and production of volatile sulfur compounds (VSCs) by periodontopathogens. VSCs-related halitosis is not easily removed using mechanical or chemical therapies such as dental floss, plaque control and mouth rinse. Lactobacillus are known to be probiotics and stimulate immune systems of human. Furthermore, L. casei ATCC 334 and L. rhamnosus GG have an effect on protection of dental caries in vitro studies. The aim of this study was to investigate effect of Lactobacillus on halitosis by Fusobacterium nucleatum- and Porphyromonas gingivalis-producing VSCs and to analyze inhibitory mechanism. The periodontopathogens were cultivated in the presence or the absence Lactobacillus, and the level of VSCs was measured by gas chromatograph. For analysis of inhibitory mechanisms, the susceptibility assay of the spent culture medium of Lactobacillus against F. nucleatum and P. gingivalis was investigated. Also, the spent culture medium of Lactobacillus and periodontopathogens were mixed, and the emission of VSCs from the spent culture medium was measured by gas chromatograph. L. casei and L. rhamnosus significantly reduced production of VSCs. L. casei and L. rhamnosus exhibited strong antibacterial activity against F. nucleatum and P. gingivalis. The spent culture medium of L. casei inhibited to emit gaseous hydrogen sulfide, methyl mercaptan and dimethyl sulfide from the spent culture medium of periodontopathogens. However, the spent medium of L. rhamnosus repressed only dimethyl sulfide. L. casei ATCC 334 may improve halitosis by growth inhibition of periodontopathogens and reduction of VSCs emission.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1989년도 하계종합학술대회 논문집
• /
• pp.390-393
• /
• 1989

Diamond is synthesized from the gaseous mixture of carbon monoxide and hydrogen by microwave PECVD. $10{\times}10mm^2$ silicon wafers are used as the substrate,and it can be raised more than $900^{\circ}C$ by microwave absorption, radiation by plasma and bombardment of ions. The changes of the morphology and the growth rates of the deposits with the experimental conditions are examined by Scanning Electron Microscopy. The d values of all the deposited films concide with those of powder diffraction data in XRD. In Raman spectra, the peak of the deposit coincides with that of the natural diamond which has a value of 1332.5 $cm^{-1}$, and the broad peak from 1360 $cm^{-1}$to 1600 $cm^{-1}$which represents the amorphous graphite was observed in the higher concentration of carbon monoxide.

• 한국환경과학회지
• /
• 제13권1호
• /
• pp.47-53
• /
• 2004

A biofiltration system using activated carbon/polyurethane composite as solid support inoculated with Bacillus sp. was developed for treating a gaseous stream containing high concentrations of H$_2$S. The effects of operating condition such as the influent H$_2$S concentration and the empty bed contact time (EBCT) on the removal efficiency of H$_2$S were investigated. The biofilter showed the stable removal efficiencies of over 99 ％ under the EBCT range from 15 to 60 sec at the 300 ppmv of H$_2$S inlet concentration. When the inlet concentration of H$_2$S was increased, the removal efficiencies decreased, reaching 95 and 74％, at EBCTs of 10 and 7.5 sec, respectively. The maximum elimination capacity in the biofilter packed with activated carbon/polyurethane composite media was 157 g/m$^3$/hr.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1720-1723
• /
• 2000

Boron doped conducting diamond thin film were grown on Si substrate by microwave plasma chemical vapor deposition from a gaseous feed of hydrogen, acetone/methanol and solid boron. The doping level of boron was controlled from 0ppm to $10^4$ppm (B/C). The Si substrate was tilted ca. 10$^{\circ}$ to make Si substrate have different height and temperature. Experimental results show that same condition but different temperature of Si substrate by height made different crystalline of diamond thin film. There were appeared 3$\sim$4 step of different crystalline morphology of diamond. To characterize the boron-doped diamond thin film, Raman spectroscopy was used for identification of crystallinity. To survey surface morphology, microscope was used. Grain size was changed gradually by different temperature due to different height. The Raman spectrum of film exhibited a sharp peak at 1334$cm^{-1}$, which is characteristic of crystalline diamond. The lower position of diamond film position, the more non-diamond component peak appeared near 1550$cm^{-1}$.

• Transactions on Electrical and Electronic Materials
• /
• 제1권2호
• /
• pp.12-17
• /
• 2000

Helicon waves were excited by a Nagoya type III antenna in magnetized plasma, and hydrogen and methane are fed through a Mass Flow Controller(MFC). We made a diagnosis of properties of helicon plasma by H$_2$gaseous discharge, and fabricated the diamond thin film. The maximum measured electron density was 1${\times}$10$\^$10/ cm$\^$-3/. Diamond films have been growo on (100) silicon substrate using the helicon plasma chemical vapor deposition. Diamond films were deposited at a pressure of 0.1 Torr, deposition time of 40~80 h, a substrate temperature of 700$^{\circ}C$ and methane concentrations of 0.5~2.5%. The growth characteristics were investigated by means of X-ray Photoelectron (XPS) and X-ray Diffraction(XRD), XRD and XPS analysis revealed that SiC was formed, and finally diamond particles were definitely deposited on it. With increasing deposition time, the thickness and crystallization of the daimond thin film increased, For this system the optimum condition of methane concentration was estimated to near to 1.5%.

• 한국안전학회지
• /
• 제11권3호
• /
• pp.126-136
• /
• 1996

Synthesis of perfluoromethanesulfonyl fluoride(PFMSF) which is a valuable precursor of perfluoro-chemicals such as surface modifier and fine chemicals was studied by electrochemical fluorination (ECF). In order to determine the termination of preelectrolysis, it was carried to monitor the variation of current during preelectrolysis by means of constant cell voltage operation. In a batch cell, chronopotentiometric electrolysis and various chemical analysis such as GC, GC/MS and If were used to understand the potential change of electrode and synthesis and control of hazardous gases products. Termination of preelectrolysis was determinated by measurement the current and/or detection of $F_2$ gas generation. And during the preelectrolysis, an amount of generated $OF_2$ was shown that a lot of moisture was absorbed from air when a cell was filled with anhydrous hydrogen fluoride( AHF ). Above 4V cell voltage, $F_2$ gas was generated and acted on any form of fluorinating agents. In the ECF of MSC (methane sulfonyl chloride) by constant current operation, the potential of anode was intimately relation with generation of $SO_2F_2$. Exchange of Cl to F was dominatly occured in a initial stage. There were various gaseous products including PFMSF as main product and $C_4$ compounds.

• 한국환경과학회지
• /
• 제28권1호
• /
• pp.137-145
• /
• 2019

The purpose of this study was to evaluate the effect of implementing a Liquid Manure Circulation System (LMCS) on the environmental improvement of swine farms. Bacterial counts at different circulation phases of the LMCS were measured. Air in the swine facility and the liquid manure in each step of LMCS were sampled and gaseous composition detected in swine farms both with and without LMCS to compare the environmental conditions in either case. There were no differences in the total bacteria count at any circulation phase in the LMCS. Escherichia coli were detected at a very low abundance only at the outlet of the slurry pit ($1.5{\times}10^2CFU/m{\ell}$). Salmonella were not detected at any phase. The LMCS clearly affected the odor strength of the swine farm and improved the air quality in the swine facility. On-site odor strength - inside, at the exhaust, and at the border of the swine facility - were clearly lowered in farms applying LMCS. Furthermore, the levels of ammonia, hydrogen sulfide, and carbon dioxide were improved in swine facilities applying LMCS.

• Bulletin of the Korean Chemical Society
• /
• 제22권2호
• /
• pp.154-158
• /
• 2001

The steps for the generation of very thin GaN films on ultrathin AlN/6H-SiC surface by alternating a pulsative supply (APS) of trimethyl gallium and NH3 gases have been examined by ASED-MO calculations. We postulate that the gallium cul ster was formed with the evaporation of CH4 gases via the decomposition of trimethyl gallium (TMG), dimethyl gallium (DMG), and monomethyl galluim (MMG). During the injection of NH3 gas into the reactor, the atomic hydrogens were produced from the thermal decomposition of NH3 molecule. These hydrogen gases activated the Ga-C bond cleavage. An energetically stable GaN nucleation site was formed via nitrogen incorporation into the layer of gallium cluster. The nitrogen atoms produced from the thermal degradation of NH3 were expected to incorporate into the edge of the gallium cluster since the galliums bind weakly to each other (0.19 eV). The structure was stabilized by 2.08 eV, as an adsorbed N atom incorporated into a tetrahedral site of the Ga cluster. This suggests that the adhesion of the initial layer can be reinforced by the incorporation of nitrogen atom through the formation of large grain boundary GaN crystals at the early stage of GaN film growth.