• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2008년도 추계학술발표대회 논문집
• /
• pp.245-250
• /
• 2008

This study is on the availability of solar thermal energy in Korean high-rise apartment complex depending on the installation type of solar collectors to roof or facade of building. Firstly, solar access evaluation on the roof and the facade of apartment buildings was carried out. The total thermal load of each apartment unit and building was investigated and matched with the energy which was produced by solar thermal systems on the facade. The considered layout patterns of apartment buildings were '一type', 'alternative 一type', 'ㄱtype' and 'ㅁtype' and that was analyzed in prior studies. Extensive dynamic hourly energy simulations with the solar thermal system were Performed with the TRNSYS of SEL. We assumed that the apartment complex is composed of 9 buildings and located in Daejeon. The collectors are the heat-pip evacuated tube collectors and the number of collectors are 45 tubes We assumed that the collectors are installed on the balcony of each unit and the angle of incilnation is $90^{\circ}$. As a result, the supply amount of solar thermal systems is about 4,850,086kJ/hr and the solar fraction is about 66%. The solar fraction according to each azimuth is about 66% on the south, 62% on the south-east $30^{\circ}$ and 56% on the south-east $60^{\circ}$. So, we quantitatively got a line on the optimal azimuth for installing the solar thermal systems. The solar fraction has differences from 5% to 15% of each floor, 6th, 12th and 20th and those tendencies are same in analyzed each 4 types of the apartment complexes.

• 한국의류산업학회지
• /
• 제4권3호
• /
• pp.248-253
• /
• 2002

The purpose of this study was to improve consumer sleeping life in quality and to suggest producers meet new consumer needs and demands, by examining the nationwide use of bedding, analyzing consumer sleeping life by category and age group, comparing the results with the findings of the nationwide studies by Sung Su-kwang (1992) and Lee Song ja (1995), and identifying the major trend of consumer sleeping life. Results and Discussion The findings of this study were as below: 1. The General Characteristics of the Subjects : Most of the housewives investigated were in their 30s and 40s, with 41.7% and 50.8% respectively. 2. Bedroom : When it comes to bedroom style, 47.8% put beds in their rooms with the Korean under-floor heating system, and 45.4% didn't place beds in their rooms with the same heating system. 3. The Purchase of Bedding : 49.0%, approximately half the homemakers, bought their current bed-clothes at bedding shops, and just 3.2% made them on their own at home. 4. The Use of Bedclothes : In summer, yam (flax, ramie fabric) and a single-layer bed sheet (41.9%) were in use most, followed by a single-layer quilt (34.5%). 5. Bedding Management The most common frequency of bedding disinfection by sunning was once a month (29.4%), followed by once per two weeks (23.9%) and once a week (19.0%) in the order named.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2009년도 춘계학술대회 논문집
• /
• pp.1109-1116
• /
• 2009

건축기술의 발달로 유리가 벽의 구조로 일반화도어 건축되고 있으며, 기존 벽의 역할인 수직 하중을 지탱하는 역할이 없어지게 되었다. 기능과 아름다운 면을 강조하게 되어 벽이 커튼의 역할만 하게 되어, 객차 실내 유리창에 접근시 차가운 느낌으로 불쾌감을 유발 한다. 그리고 유리창 아래에 바닥 난방을 했음에도 유리창에 외풍 발생으로 결로 현상이 발생하며, 즉 유리창 주변에 물방울이 발생(곰팡이 발생 원인)하여 겨울철 난방 에너지와 여름철 외부 온열이 유리를 통해 이동 하게 된다. 그러므로 에너지효율 감소에 절대적으로 영향을 준다. 객차에 발열 유리시스템을 적용하면 유리창 표면에는 냉기의 확산이 방생 하지 않으며, 객차의 실내 냉 난방시 에너지 절감 효과가 있다.

• 대한안전경영과학회지
• /
• 제10권4호
• /
• pp.105-109
• /
• 2008

The purpose of this study is to distinguish the causes of broken glass on doors or windows when it is originally kept among the remains on the floor in fire site - whether it was broken due to heating or outer power-through test and characteristics of the broken plane including the pattern on the plane. Addition to it, the study tries to find characteristics to judge the point and direction of breakdown through the analysis of glass broken by outer power. With two assumed causes - a) breakdown due to heating and b) breakdown due to outer power-3 pieces of glass plates ($30cm{\times}30cm{\times}5mm$) were tested for each case, getting the results as following: First, for the glass broken due to the change of temperature, the broken plane is of slow and smooth curve without any pattern. Second, for the glass broken due to outer power, with the impact point as the center, the glass shows breakdown of radial type and the side shows breakdown of near-perpendicular type. The far the broken piece is from the impact point, the bigger the size is. The broken piece at the impact point is of long triangle type and the two long planes of the triangle shows semi-arc with the center of breakdown point and the other plane shows opposite pattern. Third, when glass that is damaged by outer power is heated, damaged forms and side patterns of the glass that is damaged by outer power are heated and disappeared.

• 한국화재조사학회지
• /
• 제3권1호
• /
• pp.12-15
• /
• 2003

The purpose of this study is to distinguish the causes of broken glass from doors or windows when it is found being originally kept among the remains on the floor in fire site - whether it was broken due to heating or by outer power through test and the properties of the broken plane including the pattern on the plane. Addition to it, the study tries to find characteristics for judging the point and direction of breakdown through the analysis of glass broken by outer power. With two causes assumed - a. breakdown due to heating and b. breakdown due to outer power - 3 pieces of glass plates $(30cm{\times}30cm{\times}5mm)$ for each case were tested, getting the results as following: 1. For the glass broken due to the change of temperature The broken plane is of slow curve and smooth without any pattern. 2. For the broken due to outer power With the impact point as the center, the shows breakdown of radial type and the side shows breakdown of near-perpendicular type. The far the broken piece is from the impact point, the bigger the size is. The broken piece at the impact point is of long triangle type and the two long planes of the triangle shows semi-arc with the center of breakdown point and the other plane shows opposite pattern 3. Change of the pattern and type of the glass due to outer power The pattern and type of the glass due to outer power shows change due to heatihg.

• 대한건축학회논문집:계획계
• /
• 제33권12호
• /
• pp.53-63
• /
• 2017

The purpose of this study is to present an integrated analysis for energy use and its patterns as vertical locations of the dwelling units in apartment buildings which are located in an urban area and constructed by a renowned contractor. In order to enhance the effectiveness of the method, the original data of electricity, water, and gas bills which directly reflect the energy use are sorted and analyzed into several groups as vertical locations in each building. And also, by use of comparing and contrasting the data on a monthly and yearly basis, the accuracy of analyses for seasonal energy use and its patterns is strengthened. Comparative analyses used in this study describe the results that vertical locations of dwelling units do not have much influence on electricity and water usage, but are closely related with gas usage for a heating season. According to the analysis of gas usage, the units on the ground and right above pilotis need enhancement in the insulations for heating to mitigate energy loss. Also, the analysis for the middle floor units in each group describe the fact that the gas usage of the units on the ground is consumes 1.5 times greater than that of the typical floors. Therefore, enhanced insulation strategies need to be considered against the adverse condition that the heat loss increases as the wall facing the outside air increases or as the wind velocity increases through the pilotis.

• 건축역사연구
• /
• 제32권1호
• /
• pp.61-72
• /
• 2023

Korean architecture classifies Banja (the decorated flat of the ceiling visible from the inside) of Royal Palaces into two types: Woomul(water-well, 井) banja, which inserts rectangular wooden board into lattice frame, and paper banja, which applies paper to the flat ceiling. Such classification was established in the 19th century. Before that, Banja was classified according to what was inserted into the lattice frame, either wooden or paper board. At first, the banja that used paper board was widely installed regardless of the purpose or nobility of the building. However, since the 17th century, the use of paper board banja became mostly restricted to Ondol (Korean floor heating system) rooms which are characterized by private usage and the importance of heating, and it was considered inferior to wooden board banja in terms of rank or grace. The contemporary paper banja was mainly installed in low-rank ondol rooms until the late 19th century to early 20th century, when roll-type wallpaper was introduced from the West and the paper banja came to decorate the King's and Queen's bedrooms. The traditional paper board banja benefits heat reservation, reduces the weight of the ceiling, and allows the adjustment of the lattice frame size. Furthermore, it can feature unique artistry if covered with blue, white, or red Neung-hwa-ji (traditional flower pattered paper).

• 한국지열·수열에너지학회논문집
• /
• 제19권4호
• /
• pp.27-38
• /
• 2023

The Government the Republic of Korea is showing a lot of interest in net zero-energy buildings (NZEBs) to reduce energy consumption of buildings and to promote green growth policy in construction sector. The application of building passive technologies and renewable energies is essential to achieving NZEBs. Green remodeling reinforced the insulation of the exterior walls and roofs of the buildings and replaced high-efficiency windows and doors. In this study, the energy performance before and after green remodeling applied in a detached house was comparatively analyzed for baseline scenario and three different ones, ALT 1, ALT 2 and ALT 3. A building modeling and simulation software (DesignBuilder V7.0) with EnergyPlus (V9.4) calculation engine was used to calculate the energy demand and energy consumption for each scenario. Based on the calculation results of the building's energy demand for baseline, it was determined that the target building required more heating energy than cooling energy. The simulation results also showed that the implementation of building envelope performance improvement technologies (ALT 1) could notably decrease the heating energy consumption of the building. After the remodeling (ALT 1), the source energy consumption per unit floor area was assessed to be reduced by 65.2%, compared to prior remodeling of 338.7 kWh/m² -y. Meanwhile, ALT 2 can achieve energy savings of 67.7% and ALT 3 can achieve savings of 73.1%. Following completion of the remodeling project, actual construction costs, and on-site measurements and verification results will be gathered and compared with the simulation results. Additionally, economic analysis including construction costs and payback period will be conducted using actual site data.

• 한국실내디자인학회논문집
• /
• 제25권1호
• /
• pp.132-141
• /
• 2016

For those with disabilities, the residential area is the primary place to adapt the disabilities. Since the quality of the area gives a critical impact on their quality of life, it is essential to finding the measures to create the residential environment that supports their independence. In this regard, this study aimed to compare and analyze the interior elements of the houses that hinder the independence of the physically handicapped in the rural and urban areas, and conducted a survey on a total of 80 physically challenged in Seoul and Yeongwol (40 for each area). As a result, the respondents answered that the houses where they are currently living are hindering their independence regardless of area, and there were regional differences in the level of inconvenience with the size of living room, size of utility room, location of room, lighting and heating environment, ventilation system, deteriorated wallpapers and finishing materials, threshold and floor level difference and humidity control. This study has significance by providing the realistic measures to improve the housing environment of the physically challenged living in the rural and urban areas to be customized to them to increase their quality of life.

• 한국축산시설환경학회지
• /
• 제4권1호
• /
• pp.1-8
• /
• 1998

The objective of this study was conducted to develope a mobile pig nursery(MPN) for segregation of early weaned piglet. The units of MPN was consisted of 4 rectangle-type pens, 1 workroom, 2 doors, 3 windows, 1 air-inlet, 1 exhaust fan, and 1 cooling and heating system. Total of 40 piglet were weaned at 7 days of age. The period of the feeding test was 63 days. The results obtained are as follows: 1. The insulation thickness was 70, 70 and 50 mm of roof, floor and wall, respectively. R-value was 15.32 and 10.32 of roof and wall, respectively. 2. Exhaust fan( 30.48) was installed near back door 40cm from the bottom. When exhaust fan speeds were 15, 20, 30 and 35%, Air ventilation was required 9.75, 7.07, 1.72, 1.45 minutes of respectively. 3. Average temperature in the MPN was able to maintain 27∼28$^{\circ}C$ from 7∼28 days of age, 24∼25$^{\circ}C$ from 35∼56 days of age and 20∼21.5$^{\circ}C$ from 56∼70 days of age. 4. Average daily gain, feed intake and feed conversion were 420.6g, 761.5g, 1.81 respectively.