• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.777-781
• /
• 2004

This paper presents an algorithm for multichannel slotted-ring topology medium access protocol (MAC) using in wavelength division multiplexing (WDM) networks. In multichannel ring, there are two main previously proposed architectures: Tunable Transmitter - Fixed Receiver (TTFR) and Fixed Transmitter - Tunable Receivers (FTTR). With TTFR, nodes can only receive packets on a fixed wavelength and can send packets on any wavelengths related to destination of packets. Disadvantage of this architecture is required as many wavelengths as there are nodes in the network. This is clearly a scalability limitation. In contrast, FTTR architecture has advantage that the number of nodes can be much larger than the number of wavelength. Source nodes send packet on a fixed channel (or wavelength) and destination nodes can received packets on any wavelength. If there are fewer wavelengths than there are nodes in the network, the nodes will also have to share all the wavelengths available for transmission. However the fixed wavelength approach of TTFR and FTTR bring low network utilization. Because source node with waiting data have to wait for an incoming empty slot on corresponding wavelength. Therefore this paper presents Tunable Transmitter - Tunable Receiver (TTTR) approach, in which the transmitting node can send a packet over any wavelengths and the receiving node can receive a packet from any wavelengths. Moreover, the self-similar distributed input traffic is used for evaluation of the performance of the proposed algorithm. The self-similar traffic performs better performance over long duration than short duration of the Poison distribution. In order to increase bandwidth efficiency, the Destination Stripping approach is used to mark the slot which has already reached the desired destination as an empty slot immediately at the destination node, so the slot does not need to go back to the source node to be marked as an empty slot as in the Source Stripping approach. MATLAB simulator is used to evaluate performance of FTTR, TTFR, and TTTR over 4 and 16 nodes ring network. From the simulation result, it is clear that the proposed algorithm overcomes higher network utilization and average throughput per node, and reduces the average queuing delay. With future works, mathematical analysis of those algorithms will be the main research topic.

• KDI Journal of Economic Policy
• /
• v.28 no.1
• /
• pp.117-144
• /
• 2006

This study is to analyze the existence of the real buffer effect that reflects the effect of beginning-of-period inventory stocks effect on the demand for fixed investment, and the financial buffer effect indicates the substitution effect between end-of-period inventory stock and the source of financing for fixed investment. I use panel data of 361 Korean listed non-financial firms during 1990-2003. After the crisis, it also observed whether the relationship between inventory stocks and fixed investment has altered or not. I review the theoretical connection between inventory stock and fixed investment through the paper by Bo(2004) and estimate the investment model by the method of GMM-SYS. The results show negative relation between end-of-period inventory stock and fixed investment in the whole period and each period classified, also it confirms that the relation between fixed investment and end-of-period investment is significantly negative. It can be interpreted through two aspects that firms not only use inventory stock as a buffer in response to unexpectedly high demand, but also utilize inventory stock as a source of financing for fixed investment. The results imply that firm's decision-making is much correlated with production-and-inventory stock adjustment, decision-making about fixed investment, and decision-making about financial affairs.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.4
• /
• pp.512-521
• /
• 2018

Islands that is far away from onshore have used internal-combustion engine driving alternators to secure electric power. However, with Paris convention on climate change, there is a growing interest in eco-friendly energy independent island that replaces microgrid(MG) consisting of photovoltaic, wind power, and energy storage system with alternators for internal combustion engines. And also, national emission trading has been implemented, and the price of certified emission reduction(CER) has a influence on system marginal price(SMP). Because, the low cost generation source decides SMP when CER price is low, while the more expensive generation source decides SMP when CER price is high. Therefore, the increasing of CER price has a strong influence on the annualized return of MG independent power producer. Moreover, the fixed RPS price is implemented from 2017, which the increasing of CER price under the fixed RPS price or the variable RPS price affects annualized return differently. In this paper, the annualized return according to CER price is analyzed for large, middle, and small scaled islands, the effect of CER price on the annualized return was confirmed.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.24 no.3
• /
• pp.259-267
• /
• 2004

A finite element method is used to simulate interaction of laser-based ultrasounds with surface breaking tracks in elastic media. The laser line source focused on the surface of semi-infinite medium is modeled as a shear dipole in 2-D plane strain finite elements. The shear dipole-finite clement model is found to give correct directivity patterns for generated longitudinal and shear waves. The interaction of surface waves with surface breaking cracks (2-D machined slot) is considered in two ways. Both the source and receiver are fixed with respect to the cracks in the first case, while the source is moving in another case. It is shown that the crack depth tested in the range of 0.3-5.0mm $({\lambda}_R/d=0.21{\sim}3.45)$ can be measured using the corner reflected waves produced by the fixed laser source. The moving laser source is found to cause a large amplitude change of reflected waves near crack, and the crack whose depth is one order lower than the wavelength ran be detected from this change.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.4
• /
• pp.296-299
• /
• 2008

The effects of radio frequency (RF) source power for decoupled plasma nitridation (DPN) process on the electrical properties and Fowler-Nordheim (FN) stress immunity of the oxynitride gate dielectrics for deep nano-technology devices has been investigated. With increase of RF source power, the threshold voltage (Vth) of a NMOS transistor(TR) decreased and that of a PMOS transistor increased, indicating that the increase of nitrogen incorporation in the oxynitride layer due to higher RF source power induced more positive fixed charges. The improved off-current characteristics and wafer uniformity of PMOS Vth were observed with higher RF source power. FN stress immunity, however, has been degenerated with increasing RF source power, which was attributed to the increased trap sites in the oxynitride layer. With the experimental results, we could optimize the DPN process minimizing the power consumption of a device and satisfying the gate oxide reliability.

• Journal of Communications and Networks
• /
• v.7 no.1
• /
• pp.65-75
• /
• 2005

In this paper, we consider a scenario in which the source has been offered QoS guarantees subject to token-bucket regulation. The rate of the source should be controlled such that it conforms to the token-bucket regulation, and also the distortion obtained is the minimum. We have developed an optimal scheduling algorithm for offline (like pre-recorded video) sources with convex distortion function and which can not tolerate any delay. This optimal offline algorithm has been extended for the real-time online source by predicting the number of packets that the source may send in future. The performance of the online scheduler is not substantially degraded as compared to that of the optimal offline scheduler. A sub-optimal offline algorithm has also been developed to reduce the computational complexity and it is shown to perform very well. We later consider the case where the source can tolerate a fixed amount of delay and derive optimal offline algorithm for such traffic source.

• 한국기계연구소 소보
• /
• s.14
• /
• pp.135-144
• /
• 1985

A method is described to obtain the first order force and second order steady force on the fixed two dimensional submerged or semisubmerged cylinders at infinite depth of water due to regular waves. The first order diffraction wave velocity potential which describes the flow diffracted by a body is obtained numerically using source distribution method on the mean wetted surface. And a technique to remove the irregular frequency phenomena of the source distribution method is also applied. The second order steady force is calculates by means of direct integration of the pressures on the body as derived from the first order velocity potential and is also computed by means of reflection wave height derives from momentum conservation theory. The results are compared with those of published works, and show good agreement.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.7-8
• /
• 2009

In the presence of infrared light, a CMOS Readout IC (ROIC) for a microbolometer typed infrared sensor detects the voltage or current that is caused by the changing in resistance in the bolometer sensor. A serious problem in designing the ROIC is how the value of the bolometer and reference resistors vary because of variations in manufacturing process. Since different pixel have different, resistance values, sensor operations must contend with fixed pattern noise (FPN) problems. In this paper, we propose a novel technique to compensate for the fluctuation in reference resistance by tiling into account the process variation. By using constant current source basing and correlated double sampling, we solved FPN.

• Journal of Ocean Engineering and Technology
• /
• v.9 no.1
• /
• pp.161-172
• /
• 1995

A numerical procedure is described fro predicting the motion and structural responses of tension leg platforms(TLPs) in waves. The developed numerical approach is based on a combination of a three dimensional source distribution method and the dynamic response analysis method, in which the superstructure of TLPs is assumed flexible instead of the rigid body assumption used in tow-step analysis method. Both the hydrodynamic interactions among TLP members, such as columns and pontoons, and the structural whole structure are formulated using element-fixed coordinate systems which have the origin at the node of the each hull element and move parallel to a space-fixed coordinate system. Numerical results are compared with the experimental and numerical ones, which are obtained in the literature, concerning the motion and structural responses of a TLP in waves. The results of comparison confirmed the validity of the proposed approach.

• New & Renewable Energy
• /
• v.5 no.1
• /
• pp.40-46
• /
• 2009

Optimization of a rectangular profile annular fin with variable pipe inside radius is presented. This optimum procedure is based on fixed fin height and is made by using variables separation method. The optimum heat loss, corresponding optimum fin length and optimum fin efficiency are presented as a function of pipe inside radius, fin half height, inside fluid convection characteristic number and ambient convection characteristic number. One of results shows that the optimum fin length increases linearly with increase of pipe inside radius for fixed fin height and fin base radius.