• Journal of Magnetics
• /
• 제18권2호
• /
• pp.173-177
• /
• 2013

Cantilever-detected high-frequency electron spin resonance (ESR) is a powerful method of sub-terahertz and terahertz ESR spectroscopy for a tiny magnetic sample at low temperature. In this technique, a small magnetization change associated with ESR transition is detected as deflection of a sample-mounted cantilever. So far, we have succeeded in ESR detection at 370 GHz using a commercial piezoresistive microcantilever. The spin sensitivity was estimated to ${\sim}10^{12}$ spins/gauss. In order to further increase the sensitivity, we adopt a fiber-optic-based detection system using a Fabry-Perot interferometer in place of piezoresistive system. Fabry-Perot cavity is formed between an optical-fiber end and microcantilever surface, and a change in the interference signal, corresponding to the cantilever deflection, is sensitively detected. This system is suitable for low-temperature and high-magnetic-field experiments because of its compact setup and less heat dissipation. In this study, performance of Fabry-Perot interferometer is evaluated, and its application to cantilever-detected ESR measurement is described.

• 한국구조물진단유지관리공학회 논문집
• /
• 제4권4호
• /
• pp.109-119
• /
• 2000

PVDF film sensor was applied to measure the stress concentration for monitoring the structural integrity. The strain calibration of this film sensor was performed by the bending test of aluminum beam. The PVDF sensor and the electrical strain gage were bonded on the beam. When the beam was loaded, the output of electrical strain gage was compared with the output of the PVDF sensor. The waveform of PVDF sensor output was shown as the same form of the output of electrical strain gage. The gain was determined as 1.7 by comparing these two signals to determine the exact value of the strain. In order to experiment the stress concentration, the stress field was analyzed by finite element analysis. The tensile test of notched steel specimens was conducted to develop the measurement technique of stress concentration. The output voltage ratio between the PVDF sensor near the notch and the PVDF sensor far from the notch could give the information about the load bearing capacity of steel specimen.

• 대한기계학회논문집B
• /
• 제21권5호
• /
• pp.700-712
• /
• 1997

The flowfield generated by a 2-D rotating cylinder on a plane moving at freestream velocity was experimentally investigated in a wind tunnel to simulate aerodynamic characteristics of rotating wheels of an automobile. In the flowfield around a rotating cylinder at 3*10$^{3}$ < Re$_{d}$<8*10$^{3}$, unique mean flow and turbulence characteristics were confirmed by hot-wire measurements as well as frequency analysis, which was supported by flow visualization. In the vicinity of a rotating cylinder, a unique turbulence structure on .root.over bar u'$^{2}$ profiles was formed in hump-like shape at 1 < y/d < 3. A peak frequency which characterized the effect of a rotating cylinder had the same value of the rotation rate of a cylinder. In case of cylinder rotation, the depths of mean velocity -defect and turbulent-shear regions were thickened by 20-40% at 0 < x/d < 10 compared with the case of cylinder stationary. Far downstream beyond x/d > 10, the flowfield generated by a rotating cylinder showed self-similarity in the profiles of mean velocity and turbulence quantities. The effect of a rotating cylinder was independent of its rotation rate and Reynolds number in the measurement range.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2002년도 하계학술발표회
• /
• pp.218-219
• /
• 2002

일반적인 칼라 디스플레이의 화질은 시·공간 분해능과 색재현성에 크게 의존한다. 고분해능의 영상을 재생하기 위해서는 작은 크기의 화점과 높은 신호대 잡음비가 필요하고 우수한 색재현성을 위해서는 높은 휘도, 넓은 색재현 영역을 만족시켜야 한다. 따라서 이러한 분해능과 색재현성을 종합적으로 측정하기 위한 방법이 필요하다. 표 1은 ISO (the International Organization for Standardization) 규격에서 정하고 있는 디스플레이의 색재현에 영향을 미치는 요인들이다. (중략)

• ETRI Journal
• /
• 제17권3호
• /
• pp.45-63
• /
• 1995

This paper proposes an algorithm to improve the correlation between giga-hertz transverse electromagnetic (GTEM) cell and open area test site (OATS). It is based on the dipole modeling process of an unknown source object in a GTEM cell and on the evaluation of the approximate far field equations correlated with measured GTEM powers at output port of the GTEM cell. In this algorithm, the relative phase differences between dipole moments play an important part in modeling the test object as a set of dipoles and offer stable calculation of emission values. The radiated emission test using this algorithm requires fifteen orientations of equipment under test, but the increased orientations as compared with the previous method have little effect on the time needed for testing. Radiation from a notebook computer has been tested for statistical analysis of the correlation between GTEM data and OATS data. The emission test results of the notebook computer show that the mean, the standard deviation, and the correlation coefficient are -0.62, 1.99, and +0.85, respectively. These figures indicate that this algorithm provides improved accuracy in the measurement of electromagnetic emissions over the previous method.

• 전자공학회논문지D
• /
• 제35D권4호
• /
• pp.24-31
• /
• 1998

The far-zone magnetic field patterns of a E-plane horn antenna with various edge structures are analyzed using UTD. The ray tracing method is used to lacate the shadow boundaries, and then GO and UTD are utilized to evaluate the incident, reflected, diffracted, surface diffaracted, and the second order diffracted, diffracted-reflected, and diffracted-reflected-diffracted waves existing in each region of interest. By doing this, we analyzed the effects of flanges or caps connected on the edge of a horn antenna on the side lobe and back lobe levels. Also, the validity of this paper is proved by comparing the analytical results with those of measurement and method of moment presented in the reference.

• 항공우주시스템공학회지
• /
• 제10권1호
• /
• pp.8-14
• /
• 2016

The optimal estimation of a bearing only target tracking problem be achieved through the solution of the Fokker-Planck equation and the Bayesian update. Recently, a nonlinear filtering algorithm using a direct quadrature method of moments in which the associated Fokker-Planck equation can be propagated efficiently and accurately was proposed. Although this approach has demonstrated its promising in the field of nonlinear filtering in several examples, the "degeneracy" phenomenon, similar to that which exists in a typical particle filter, occasionally appears because only the weights are updated in the modified Bayesian rule in this algorithm. Therefore, in this paper to enhance the performance, a more stable measurement update process based upon the update equation in the Extended Kalman filters and a more accurate initialization and re-sampling strategy for weight and abscissas are proposed. Simulations are used to show the effectiveness of the proposed filter and the obtained results are promising.

• 한국가시화정보학회지
• /
• 제8권4호
• /
• pp.31-37
• /
• 2010

In this study, a novel hybrid micro/nano PIV system combining defocusing and TIRFM technique has been developed for the multiscale flow measurement. With the developed system, both far and near field velocity fields have been measured simultaneously in a 2D straight microchannel and the particle trajectories were extracted by the nearest tracking algorithm. The shear rate values taken from experimental results have been estimated by comparing with the analytical solution of 2D Poiseuille flow and it is confirmed that the result shows good agreement with the theoretical value.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2014년도 추계학술대회 논문집
• /
• pp.236-239
• /
• 2014

Most naval underwater weapon system can be simplified to a circular cylindrical structure which has vibrating machineries inside. In order to predict efficiently the total acoustic radiation power of cylindrical structure, surface velocity is measured and radiation efficiency of surface element is calculated. Then, they are substituted to the surface pressure in the simplified Helmholtz integral equation which assumes acoustic far-field and plane-wave approximation at the surface. Surface velocity and total acoustic radiation power for a submerged cylinder are measured in water-tank. In this example, it is found that total acoustic power output obtained from the prediction is in good agreement with that of measurement in mid-high frequency range.

• ETRI Journal
• /
• 제29권1호
• /
• pp.95-98
• /
• 2007

A low-profile phased array antenna with a low sidelobe was designed and fabricated using a genetic algorithm (GA). The subarray distances were optimized by GA with chromosomes of 78 bits, a population of 100, a crossover probability of 0.9, and a mutation probability of 0.005. The array antenna has 24 subarrays in 14 rows, and is designed as a mobile terminal for Ku-band satellite communication. The sidelobe level was suppressed by 6.5 dB after optimization, compared to the equal spacing between subarrays. The sidelobe level was verified from the far-field pattern measurement by using the fabricated array antenna with optimized distance.