• Journal of Sensor Science and Technology
• /
• v.28 no.2
• /
• pp.106-112
• /
• 2019

Flexible impact force sensors composed of piezoelectric PZT/PDMS composite sandwiched between Al/PET films were fabricated and their voltage signal characteristics were evaluated under varying impact forces for electronic mitt applications. The piezoelectric impact force sensor on an ethylene-vinyl acetate (EVA) substrate exhibited an output voltage difference of no greater than 40 mV a periodical impact test in with the impact load was increased by as much as 240 N by a restoration time of 5 s in a five-time experiment, implying good sensing ability. Moreover, the impact force sensor embedded four electronic mitts showed a reliable sensitivity of less than 1 mV/N and good repeatability under 100 N-impact force during a cycle test executed 10,000 times. This indicated that the fabricated flexible piezoelectric impact sensor could be used in electronic mitt applications. However, the relatively low elastic limit of substrate material such as EVA or poly-urethane slightly deteriorated the sensitivity of the impact sensor embedded electronic mitt at over 200 N-impact forces.

• Korean Journal of Environmental Agriculture
• /
• v.13 no.3
• /
• pp.346-358
• /
• 1994

In this paper, the current knowledge on the formation of acid rain and its effect on vegetation are reviewed. The pollutants which were emitted into the air are oxidized by photochemical reaction and affect the vegetation by dry and wet deposition. Acid rain at pH 4.0 affected sensitive plants and when it was below pH 3.0, visible symptoms developed in most of the crops. The acid rain treatment at pH 2.0 decreased dry weight, leaf area and chlorophyll contents in soybean but it increased rate of photosynthesis and respiration rate. Rain treatment at pH 2.8 increased ethylene production, but it’s not a suitable indicator of sensitivity to acid rain. At pH 2.0 treatment, the contents of soluble Mn and Al were increased but the cultivated soil pH at upper layer(0-5cm) was significantly decreased. The pertubation of glandular trichome which is existed along the vein was developed at all treatment except the control(pH 6.0) and non-treatment. Histological pertubation of spiked trichome and disintegration of chloroplast were developed only on the leaves of sesame treated with SAR(simulated acid rain) of pH 2.0.

• Elastomers and Composites
• /
• v.42 no.2
• /
• pp.112-118
• /
• 2007

An HRP immobilized carbon paste electrode, which was bound by EPDM, was newly fabricated and its electrochemical properties were investigated for the purpose of validating the new possibility for the practical use of biosensor. In the experimental range of substrate concentration, Lineweaver-Burk plot of the signal showed a good linearity. This means that HRP was embedded effectively to preserve its identity in the bulk of composite electrode materials and EPDM is a recommendatory binder. When the electrode was run at low operating potential($0.0\sim-1.0$ V vs. Ag/AgCl), it showed a high sensitivity and a good reproducibility. Especially the mechanical stability of the dried rubber was a remarkable breakthrough to get over a difficulty in putting the carbon-paste electrode bound with silicon oil to real use.

• Proceedings of the Polymer Society of Korea Conference
• /
• 2006.10a
• /
• pp.254-254
• /
• 2006

The sensitivity of plasmid DNA (pDNA) to S1 nuclease, an enzyme to cleave a single-strand DNA, was dramatically modulated through a supramolecular assembly (polyion complex micelle) with a synthetic block copolymer, poly(ethylene glycol)-b-poly(L-lysine) (PEG-PLL). The pDNA condensed in stoichiometric charge ratio was cleaved into 7 fragments each being 10/12, 9/12, 8/12, 6/12, 4/12, 3/12, and 2/12 of the original DNA length, on the other hand, the pDNA condensed in higher charge ratios (>4), were digested into non-specific manner. Condensation of the pDNA was investigated from two viewpoints that how does the rigid DNA molecules fold and condense and how does the condensation influence their biological activity.

• Macromolecular Research
• /
• v.13 no.5
• /
• pp.373-384
• /
• 2005

Novel pH-sensitive moieties containing an s-triazine ring were synthesized with sulfonamide and secondary amino groups. The synthesized pH-sensitive moieties were used for the synthesis of a pH-sensitive amphiphilic ABA triblock copolymer. The pH-sensitive triblock copolymer was composed of diblock copolymers, methoxy poly(ethylene glycol)-poly ($\varepsilon$-caprolactone-co-D,L-lactide) (MPEG-PCLA), and pH-sensitive moiety. These copolymers could be dissolved molecularly in both acidic and basic aqueous media at room temperature due to secondary amino and sulfonamide groups. The synthesized s-triazine rings containing pH-sensitive compounds were characterized by ${^1}H-NMR,\;{^13}C-NMR$, and LC/MSD spectral data. The synthesized diblock and triblock copolymers were also characterized by ${^1}H-NMR$ and GPC analyses. The critical micelle concentrations at various pH conditions were determined by fluorescence technique using pyrene as a probe. Furthermore, the micellization and demicellization study of the triblock copolymer was done with pH-sensitive groups. The sensitivity towards pH change was further established by acid-base titration.

• Polymer(Korea)
• /
• v.32 no.3
• /
• pp.219-229
• /
• 2008

A pH sensitive ternary copolymer gel was synthesized in the presence of ethylene glycol dimethacrylate (EGDMA) as a crosslinking agent through radical polymerization of vinyl acetate (VA), acrylic acid (AA) and methyl acrylate(MA) with a weight ratio of 1 : 1.3 : 1. A number of experiments were carried out to determine the swelling behavior of the gel under a variety of pH conditions of the swelling medium. As the pH of the swelling medium was changed from 1.0 to 8.0 at $37^{\circ}C$, the gel showed a shift in the pH-dependent swelling behavior from Fickian (n=0.3447) to non-Fickian (n=0.9125). The resulting swelling parameters were analyzed using graphical and statistical methods. The results showed that the swelling of the gel was controlled by the pH of the medium, i.e. $n=n_o{\exp}(S_{C}pH)$, where n is the diffusion exponent, $n_o(=28.9645{\times}10^{-2})$ is the pre-exponential factor and $S_C$(=0.1417) is pH sensitivity coefficient. The swelling behavior of the gel was also examined in aliphatic alcohols. The results showed that the rate of swelling increased with increasing number of carbon atoms in the alcoholic molecular chain.

• The Korean Journal of Ceramics
• /
• v.5 no.2
• /
• pp.125-130
• /
• 1999

After $SnO_2$ fine powder by precipitation method, Ca as crystallization inhibitor and Pd as catalyst were added to $SnO_2$ raw material by various methods. Thick film device was fabricated on the alumina substrate by mixing ethylene glycol and such mixed powders. The sensing characteristics of the device for methane gas were investigated. The most excellent gas sensing property was shown by the thick film device fabricated by Method 3 in which Ca and Pd doped $SnO_2$ powder is prepared by mixing $SnO_2$ powder, 0.1 wt% Ca acetate and 1 wt% $PdCl_2$ in deionized water and by calcining the mixture, after $Sn(OH)_4$ is dried at $110^{\circ}C$ for 36h. The sensitivity of the sensor fabricated with $SnO_2$-0.1 wt%Ca acetate-1wt%$PdCl_2$ powder heat-treated at $700^{\circ}C$ for 1h was about 86% for 5,000 ppm methane in air at $350^{\circ}C$ of the operating temperature. Response time and recovery were also excellent.

• Journal of Korean Society of Water and Wastewater
• /
• v.35 no.2
• /
• pp.135-142
• /
• 2021

The activity of anaerobic ammonium oxidation (ANAMMOX) immobilized in synthetic media (Poly Ethylene Glycol, PEG) and granular form was evaluated comparatively to investigate the effect of influent nitrogen concentration and exposure of oxygen. In ANAMMOX granule reactor, when concentration of influent total nitrogen increased to 500mg/L, removal efficiency of ammonium, nitrite and nitrate were shown to 90.5±6.5, 96.6±4.9, and 93.2±6.1%, respectively. In the case of the PEG gel, it showed lower nitrogen removal performance, resulting in that the removal efficiency of ammonium, nitrite and nitrate were shown to 83.3±13.0, 96.4±6.1, and 90.3±7.5%, respectively. In second step, when exposed to oxygen, the nitrogen removal performance in the ANAMMOX granule reactor also remained stable, but the activity of PEG gel ANAMMOX was found to be inhibited. Consequently, the PEG gel ANAMMOX was a higher sensitivity than that of granular ANAMMOX with two variables applied in this study.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.7
• /
• pp.45-49
• /
• 2010

We have developed and demonstrated the use of a new kinetic method as an analytical tool for the measurement of $HO_2{\cdot}/O_2{\cdot}^-$. This new method is based on the reduction of $Fe^{3+}$-Ethylene Diamine Tetra Acetate, EDTA) into $Fe^{2+}$-EDTA by $HO_2{\cdot}/O_2{\cdot}^-$ and the well-known Fenton-like reaction of $H_2O_2$ and $Fe^{2+}$-EDTA to yield the hydroxyl radicals ($OH{\cdot}$). Since this method for $HO_2{\cdot}/O_2{\cdot}^-$ shows high sensitivity and allows a simple calibration system, it can contribute significantly to understanding the basic functions of $HO_2{\cdot}/O_2{\cdot}^-$ in advanced oxidation processes for water treatment. Moreover, the present technique has the advantage of using inexpensive and easily available nonenzymatic reagents and of being insensitive to the moderate concentration of possible interferences often found in aqueous phase.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1999.07a
• /
• pp.203-203
• /
• 1999

Mass spectrometry technique provides the molecular weight distribution, data on the sequence of repeat units, polymer additives, and impurities, and structural information. time-of-Flight secondary Ion Mass Spectrometry (TOF-SIMS) has been used for structural characterization of various polymers1-2. the masses of repeat units and terminal groups and molecular weight distributions of polymers have been determined from their TOF-SIMS spectra. TOF-SMIS provides good sensitivity and structural specificity for high mass ions so that intact oligomers and large polymer fragments are observed. In this study, we investigated the detailed structural information on the oligomers and fragment ions of branched poly(1,3-butylene adipate) and branched poly[di(ethylene glycol) adipate] and the transesterification products of branched polyesters with trifluoroacetic acid or chloro difluoroacetic acid. Branched polyesters were chosen because they are important polymers but difficult to characterize; thus branched polyesters provide challanging test for TOF-SIMS. TOF-SIMS spectra of polyesters are obtained from thin polymer films cast from solution on a silver substrate. A good solvent for a polumer solution disrupts intermolecular forces between polymer chains but leaves the polumer intact. Transesterification reactions are potentially useful for characterization of high molecular weight and intractable polyesters. Transesterification products of polyesters and trifluoroacetic acid or an integral number of polyester repeat units and an additional diol. The progress of such reactions was monitored using peak intensities of reactants and products in TOF-SIMS spectra. The increasing abundance of tagged ions indicates that the reaction has progressed with time.