• JSTS:Journal of Semiconductor Technology and Science
• /
• 제14권4호
• /
• pp.463-470
• /
• 2014

A Verilog model is proposed for transmission lines to perform the all-Verilog simulation of high-speed chip-to-chip interface system, which reduces the simulation time by around 770 times compared to the mixed-mode simulation. The single-pulse response of transmission line in SPICE model is converted into that in Verilog model by converting the full-scale analog signal into an 11-bit digital code after uniform time sampling. The receiver waveform of transmission line is calculated by adding or subtracting the single-pulse response in Verilog model depending on the transmitting digital code values with appropriate time delay. The application of this work to a USB 2.0 high-speed PHY interface reduces the simulation time to less than three minutes with error less than 5% while the mixed-mode simulation takes more than two days for the same circuit.

• ETRI Journal
• /
• 제31권3호
• /
• pp.348-350
• /
• 2009

To fit the limited volume and power consumption of the passive radio frequency transmission system of the electronic time fuze, an improved coded mark inversion (CMI) is proposed in this letter. From the performance analysis, the energy transmission efficiency of this encoding method is at least 50% higher than that of CMI and NRZ. Finally, the experiment results show that by adopting this improved CMI, the change of DC voltage through magnetic coupling is lower than 0.2 V when the accuracy of data transmission is above 99.5%.

• ETRI Journal
• /
• 제29권2호
• /
• pp.255-257
• /
• 2007

We propose an improved selective randomized load balancing (ISRLB) robust scheme under the hose uncertainty model for a special double-hop routing network architecture. The ISRLB architecture maintains the resilience properties of Valiant's load balancing and reduces the network cost/propagation delay in all other robust routing schemes.

• ETRI Journal
• /
• 제28권1호
• /
• pp.99-102
• /
• 2006

In this letter, we study the protection problem in wavelength division multiplexing (WDM) optical networks, and propose a novel dynamic heuristic algorithm called differentiated reliable segment protection (DRSP). Differing from previous work, DRSP can effectively avoid the trap problem and is able to find a feasible solution for each connection request. Therefore, DRSP outperforms the previous work. Simulation results have shown to be promising.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1990년도 한국자동제어학술회의논문집(국제학술편); KOEX, Seoul; 26-27 Oct. 1990
• /
• pp.1116-1118
• /
• 1990

This paper describes the required frequency bandwidth which is used as a measure for the quality of the PFM transmission system to transmit the control signals. First, the PFM signal which has been distorted due to the frequency bandwidth limit on the transmission line is analyzed by Fourier transform and secondly distortion which has been observed at the receiver is numerically analyzed to make the frequency bandwidth required for transmitting the PFM signals. According to the analysis heretofore, the 50% threshold level for shaping the received PFM signal, which is of 50 % in TTL level, is superior than the 10- and 90-% threshold levels.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.145-146
• /
• 2006

In this paper, when concurrent transmission and diversity reception at each relay are assumed to increase bandwidth efficiency in linear multihop system, we analyze interference due to concurrent transmission and verify it. In the interference-free environment, more diversity sources at each relay result in better performance [1][2]. However, interference degrades BER performance because accumulated and propagated interference power surpasses original data power. Therefore, if we use the result of this paper, we can make bandwidth efficiency increase as well as BER performance good in linear multihop system by considering concurrent transmission with reuse factor and developing the algorithm which determines the number of diversity source.

• 한국항행학회논문지
• /
• 제20권1호
• /
• pp.59-64
• /
• 2016

본 논문은 CPW와 개방 스터브가 병렬 연결된 전송선로를 사용하여 높은 분배 비율의 비대칭 이중대역 분배기를 나타내었다. 이중대역 설계 방정식에 의하여 계산된 전송선로의 구현은 낮은 임피던스의 전송선로는 짧은 선로와 병렬로 개방 스터브가 주기적으로 연결된 형태로 그리고, 높은 임피던스 전송선로는 CPW 선로 형태로 구현하였다. 이러한 두 종류 전송선로를 이용한 이중대역 분배기의 설계방법의 타당성을 확인하기 위해서 중심 주파수가 1 GHz와 2 GHz인 10:1 비대칭 이중대역 전력분배기를 제작하였고, 이것의 측정 결과 특성이 시뮬레이션과 동일함을 확인하였다.

• Journal of Electrical Engineering and Technology
• /
• 제13권1호
• /
• pp.105-113
• /
• 2018

This paper proposes pre-analysis on planning of high-voltage direct current (HVDC) transmission system applied to Korea electric power grid. HVDC transmission system for interface lines has been considered as alternative solution for high-voltage AC transmission line in South Korea since constructing new high-voltage AC transmission lines is challenging due to political, environmental and social acceptance problems. However, the installation of HVDC transmission system as interface line in AC grid must be examined carefully. Thus, this paper suggests three scenarios to examine the influences of the installation of HVDC transmission system in AC grid. The power flow and contingency analyses are carried out for the proposed scenarios. Power reserves in metro area are also evaluated. And then the transient stability analysis focusing on special protection scheme (SPS) operations is analyzed when critical lines, which are HVDC lines or high voltage AC lines, are tripped. The latest generic model of HVDC system is considered for evaluating the impacts of the SPS operations for introducing HVDC system in the AC grid. The analyses of proposed scenarios are evaluated by electromechanical simulation.

• Transactions on Electrical and Electronic Materials
• /
• 제18권3호
• /
• pp.151-154
• /
• 2017

In this article, we investigated the various influencing factors that degraded the lifetime of suspension insulators in 154 kV transmission lines, and showed the possible solutions to avoid such breakdowns. With respect to achieve safety, reliability and aesthetical considerations, the characteristics of transmission and distribution network power cables should be improved. Suspension insulators are particularly important to study, as they have developed to be the main component of transmission lines due to their ability to withstand the electrical conductivity of high-voltage power transmission. Suspension insulators are mostly made from glass, rubber and ceramic material due to their high resistivity. In Korea, porcelain suspension insulators are typically used in the transmission line system, as they are cheaper and more flexible compared to other types of insulators. This is effective from preventing very high and steep lightening impulse voltages from causing the breakdown of suspension insulators used in power lines. Other influential factors affect the lifetime of suspension insulators that we studied include temperature, water moisture, contamination, mechanical vibration and electrical stress.

• 한국전자파학회논문지
• /
• 제23권8호
• /
• pp.985-994
• /
• 2012

본 논문에서는 wireless body area network(WBAN) 채널을 분석하기 위해 실제 채널을 측정하고, 그것의 통계적 특성들을 조사하였다. On-/off-body 채널에서, 인체의 움직임을 고려하기 위해 대표적인 움직임들을 같이 측정하여 그 분석 결과들을 비교하였다. 또한, 세 종류의 신호 전송 기법을 제한된 Outage 확률을 가질 때 최소 소비 전력을 분석하여, 이론적인 총 전력 소비를 계산하였다. 그리고 채널 측정 데이터들을 통해 이론과 실제의 차이를 분석하였다. 본 논문의 결과로 협력 통신을 통하여 전송 효율을 높일 수 있음을 알 수 있으며, 센서 노드의 부착 위치와 움직임이 신호 전송 전력에 어떠한 영향을 미치는지 확인할 수 있다.