• Korean Journal of Soil Science and Fertilizer
• /
• v.24 no.4
• /
• pp.278-285
• /
• 1991

This study was conducted to manufacture a good qualified organic fertilizer with cow dung through rapid composting process, and the proposal guideline of the degree of maturity could be estimated with the measurement of final product. It included total nitrogen content of above 2% on an oven-dry material basis, C/N ratio of below 20, CEC of more than about 60 me/100g, ratio of carbon in reducing sugar to the total carbon of below 35%, and temperature in pile of above $60^{\circ}C$. The total nitrogen content, the C/N ratio, and the Paper Chromatographic method couldn't be the guideline to evalute the maturity of cow dung compost. CEC was increased in increased fermentation and it was high in the high fermented temperature plots which were cow dung+ shredded bark in 1988, cow+dung+wood chips in 1989, and cow dung+rice straws in 1990. The ratio of carbon in reducing sugar to total carbon in 1990 was lower in cow dung+saw dust than cow dung+rice straws that was the highest temperature in pile. Generally cow dung was mixed well with saw dust and thus the total carbon of the product was high. The measurement of the temperature in pile seems to be a indirect guideline of maturity.

• Journal of the Korean GEO-environmental Society
• /
• v.10 no.7
• /
• pp.125-133
• /
• 2009

Wastewater sludge had normally filled up in land before revising the law of waste material management in 2003, which does not permit landfill of organic sludge in Korea. After the law, most sludge has been littered in the ocean up to now. However, due to the London Convention 96 Protocol, littering sludge in the ocean will also be prohibited after 2011. This Protocol makes countries find out new methods to treat wastewater sludge. There is no exception in Korea too. Many researchers have urgently try to find out better ways to treat sludge. One of ways is to make sludge recycle energy and the success of it depends on drying method. Specifically, it really depends how to make sludge dry ecologic friendly and economic efficiently. Therefore, wastewater sludge produced in Youngdong was analyzed to make it energy resources in this study. The sludge was tested to analyze the drying and chemical characteristics of it by irradiating microwave. In the result, it is sure that the sludge has little heavy metals as like as others in country side. High calories, 3370 Kcal, shows that it has good potential to be recycle energy. Moreover, weight deduction of the sludge vs. time shows long S-curve and has same deduction ratio. Specifically, S-curve can be divided by three sections based on the curvature points. There are steady state reduction ratio of weight and approximately 80% of weight duction in the second section. This results can be used to estimate the amount of sludge reduction in the full-scale microwave dryer. Drying capacity of microwave shows approximately 1.0 kg/kw/hr. It makes sure that sludge recycle energy has the potential of economic efficiency too.

• Journal of Korean Medical classics
• /
• v.24 no.6
• /
• pp.101-110
• /
• 2011

There are not a few cases in Oriental medicine where a different prescription should be given to some of the patients whose symptoms are similar to each other. In other words, there might happen a misdiagnosis due to an extremely delicate difference in symptoms of the same diseases, causing a patient's condition to get worse or to be even on the brink of death. In such a context, the records in "WooJam JabJeo(愚岑雜著)" are worthwhile to do in-depth research on. Jang-Taegyung described his first-hand experience in major medical treatment very vivaciously during his ages between 25 and 42. Particularly, most of the prescriptions recorded in this book include not only his empirical prescriptions on the patients who life was almost on the brink of death but it also so plentifully contained the process of overcoming the side effect caused by other clinics' misdiagnosis; thus, that this book is drawing attention in that it could be indispensable materials not only in the research on medical history but also for clinical treatment. Particularly, as regards two cases of insanity, this book mentions the reason for using totally different prescription on one case from the other case even though the two cases had a similar symptom, through which we can acquire somewhat concrete experience in curing scenes though indirectly during the period of the Joseon Dynasty. We were able to get the result from the analysis of the two cases of insanity as follows: 1. WooJam, in treating the two cases of insanity due to the severe exacerbation of yang energy, managed to treat the one case by inducing a bowel movement and the other case by inducing urination. Such a different treatment seems to be greatly attributable to the constitutional factor of the two patients. Such an Oriental-medicine-based method of diagnosis and prescription as WooJam's is rarely found in Western medicine-i.e., that's why more thorough research on Oriental medicine is deeply required. 2. In case of the second patient, the patient arrived at insanity due to another clinic's treatment on perspiration on the patient with severe mouth thirst. This medical story once again highlights the importance of a diagnosis in today's Oriental medicine and at the same time it's a good example showing how big the side effect caused by the abuse of medicinal herbs is. The second patient's body fluids ran dry and finally his yang energy got exacerbated all the more due to the treatment by perspiration.

• Journal of Environmental Impact Assessment
• /
• v.23 no.5
• /
• pp.406-416
• /
• 2014

When abnormal taste and odor were detected in the tap water of the North-Han river watershed during the dry season in late 2011, excessive nutrients with algal growth in the Lake Uiam and weather factors were considered to be among its causes. The nutrients, in particular, originated from domestic sewage in the Chuncheon area. This study was conducted to investigate relations between the algal growth in the Lake Uiam and the contribution of nutrients from public sewage treatment works (PSTWs) in Chuncheon city, and based on this to analyze the environmental impact. Nutrients in the Lake Uiam have already been accumulated to the level of eutrophication. Even in winter, the conditions in the lake such as retention time and water temperature were favorable to boost algal growth. After phosphorus treatment processes were introduced, the PSTWs in the Lake Uiam watershed were able to reduce the total phosphorus loads by 43%. The algal concentrations in the Lake Uiam also dropped by about 7%. The nitrogen treatment efficiencies in the PSTWs, on the other hand, remained almost the same after the introduction of the phosphorus treatment processes. To solve these problems more efficiently, it is necessary to develop management strategies for the upstream area of the Lake Uiam and set plans to improve nitrogen treatment operation and management for the PSTWs in Chuncheon.

• Clean Technology
• /
• v.18 no.3
• /
• pp.287-294
• /
• 2012

In this study, performances of two cleaning methods were analyzed and a cleaning system was designed to develop a cleaning process of electronic components to remanufacture old laser copy machine. First, plasma cleaning as a dry cleaning method was executed to test cleaning ability. In cleaning of printed circuit board (PCB) by plasma, some damages were found near the metal parts, and considering the productivity, this method was not adequate for the cleaning of electronic components. With 4 different cleaning agents, ultrasonic cleaning tests were executed to select an optimal cleaning agent, aqueous agents showed superior cleaning performance compared to semi-aqueous and non-aqueous agents. Cleaning with aqueous cleaning agent A and 28 kHz ultrasonic frequency can be completed in 30 sec to 1 min. Finally, an ultrasonic cleaning system was constructed based on the pre-test results. Optimal cleaning conditions of 40 kHz and $50^{\circ}C$ were found in the field test. The productivity and economic efficiency in remanufacturing of laser copy machine are expected to increase by adapting developed ultrasonic cleaning system.

• Korean Journal of Food Science and Technology
• /
• v.29 no.5
• /
• pp.947-954
• /
• 1997

Selected physical properties of cornmeal extrudates fortified with dairy products and extrusion process by $CO_2$ gas injection were analysed. Dairy products including whole milk powder, whey protein concentrate non-fat dry milk, and sodium caseinate were tested at the addition of 10% and 20%, based on cornmeal weight. $CO_2$ gas was injected to the barrel at the pressure of 0.7 and 1.4 MPa. Specific mechanical energy (SME) input was decreased by the addition of dairy products. Sodium caseinate had a little effect on decreasing the SME input, however whole milk powder tremendously reduced SME input when the concentration increased. An increase in milk product content resulted in increasing the piece density at the injection pressure of 0.7 MPa. At both 10% and 20% milk product content, the piece density was lowest at the injection pressure of 0.7 MPa. The sectional expansion index was highest at the injection pressure of 0.7 MPa. However, the specific length was constantly increased with the increase in $CO_2$ injection pressure. Water absorption index was decreased and water solubility index was increased by the addition of milk products. The injection pressure of $CO_2$ was optimum at 0.7 MPa. The addition of whole milk powder limited to puff the melt, but the other milk products tested resulted in puffing with $CO_2$ injection to 1.4 MPa.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.18 no.4
• /
• pp.242-252
• /
• 2016

A process-based ecosystem model, BIOME-BGC, was applied to simulate seasonal and inter-annual dynamics of carbon and water processes for potential evergreen needleleaf forest (ENF) biome in Korea. Two simulation sites, Milyang and Unljin, were selected to reflect warm-and-dry and cool-and-wet climate regimes, where massive diebacks of pines including Pinus densiflora, P. koraiensis and P thunbergii, were observed in 2009 and 2014, respectively. Standard Precipitation Index (SPI) showed periodic drought occurrence at every 5 years or so for both sites. Since mid-2000s, droughts occurred with hotter climate condition. Among many model variables, Cpool (i.e., a temporary carbon pool reserving photosynthetic compounds before allocations for new tissue production) was identified as a useful proxy variable of tree carbon starvation caused by reduction of gross primary production (GPP) and/or increase of maintenance respiration (Rm). Temporal Cpool variation agreed well with timings of pine tree diebacks for both sites. Though water stress was important, winter- and spring-time warmer temperature also played critical roles in reduction of Cpool, especially for the cool-and-wet Uljin. Shallow soil depth intensified the drought effect, which was, however, marginal for soil depth shallower than 0.5 m. Our modeling analysis implicates seasonal drought and warmer climate can intensify vulnerability of ENF dieback in Korea, especially for shallower soils, in which multi-year continued stress is of concern more than short-term episodic stress.

• Journal of Korea Water Resources Association
• /
• v.55 no.7
• /
• pp.515-529
• /
• 2022

Identifying the available water resources amount is an essential process in establishing a sustainable water resources management plan. Dam facility is a major infrastructure storing and supplying water during the dry season, and the water supply yield of the dam varies depending on dam inflow conditions or operation rule. In South Korea, water supply yield of dam is calculated by reservoir simulation based on observed historical dam inflow data. However, the water supply capacity of a dam can be underestimated or overestimated depending on the existence of historical drought events during the simulation period. In this study, probabilistic inflow data was generated and used to estimate the appropriate range of the water supply yield of hydropower dams. That is, a method for estimating the probabilistic dam inflow that fluctuates according to climatic and socio-economic conditions and the range of water supply yield for hydropower dams was presented, and applied to hydropower dams located in the Han river in South Korea. It is expected that the understanding water supply yield of the hydropower dams will become more important to respond to climate change in the future, and this study will contribute to national water resources management planning by providing potential range of water supply yield of hydropower dams.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.33 no.4
• /
• pp.517-527
• /
• 2023

Objectives: We examine cases of chemical poisoning that occurred in the cleaning of metal parts and the regulations on halogenated solvents in other countries and propose regulations necessary to prevent chemical poisoning from halogenated solvents. Methods: We collected cases of chemical poisoning through the website of the Korea Occupational Safety and Health Agency. A review of the literature was conducted focusing on regulations related to halogenated solvents in the United States and the European Union, particularly for cleaning metal parts. Among the Material Safety Data Sheets submitted to the government, MSDS containing eleven substances were extracted to confirm the composition and product use. We investigated cleaning methods for metal parts used in South Korea. For the hazard classification, the European Chemicals Agency or Japan's NITE's website was used. Results: In the case of poisoning, the cleaning methods involving trichloromethane were dipping and dry, which was not found in the literature. It was confirmed that many halogenated solvents and dimethyl carbonate were used for metal cleaning in South Korea. In vapor degreasing using TCE in the USA, even if the facility is strictly managed, such as by installing cooling coils in open cleaning facilities, the risk of exposure to TCE is considered to be not only carcinogenic but also a concern for acute and chronic effects. In comparison, exposure through Korean work methods such as dipping and drying operations is inevitably much higher. Conclusions: The transition to water-based cleaning with low-hazard chemicals should be a priority in the cleaning process. In the case of metal parts that require precise cleaning, if the use of a halogenated solvent is inevitable, a closed degreasing facility should be used to minimize exposure. The current regulations in the Occupational Safety and Health Act, the Chemical Substances Control Act, and the Air Environment Conservation Act do not require cleaning facilities to minimize emissions. To protect the health of workers using halogenated solvents to clean metal parts, regulations that require a fundamental reduction in exposure will be necessary.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.17 no.4
• /
• pp.205-212
• /
• 2024

This study developed a deep learning model that distinguishes the front (with garnish) and the back (without garnish) surface of the dried semi-finished product (dried bukak) for screening operation before transfter the dried bukak to oil heater using robot's vacuum gripper. For deep learning model training and verification, RGB images for the front and back surfaces of 400 dry bukak that treated by data preproccessing were obtained. YOLO-v5 was used as a base structure of deep learning model. The area, surface information labeling, and data augmentation techniques were applied from the acquired image. Parameters including mAP, mIoU, accumulation, recall, decision, and F1-score were selected to evaluate the performance of the developed YOLO-v5 deep learning model-based surface detection model. The mAP and mIoU on the front surface were 0.98 and 0.96, respectively, and on the back surface, they were 1.00 and 0.95, respectively. The results of binary classification for the two front and back classes were average 98.5%, recall 98.3%, decision 98.6%, and F1-score 98.4%. As a result, the developed model can classify the surface information of the dried bukak using RGB images, and it can be used to develop a robot-automated system for the surface detection process of the dried bukak before deep frying.