• Mycobiology
• /
• v.46 no.1
• /
• pp.79-83
• /
• 2018

Azo dyes containing effluents from different industries pose threats to the environment. Though there are physico-chemical methods to treat such effluents, bioremediation is considered to be the best eco-compatible technique. In this communication, we discuss the decolorization potentiality of five azo dyes by Podoscypha elegans (G. Mey.) Pat., a macro-fungus, found growing on the leaf-litter layer of Bethuadahari Wildlife Sanctuary in West Bengal, India. The fungus exhibited high laccase and very low manganese peroxidase activities under different culture conditions. Decolorization of five high-molecular weight azo dyes, viz., Orange G, Congo Red, Direct Blue 15, Rose Bengal and Direct Yellow 27 by the fungus was found to be positive in all cases. Maximum and minimum mean decolorization percentages were recorded in Rose Bengal (70.41%) and Direct Blue 15 (24.8%), respectively. This is the first record of lignolytic study and dye decolorization by P. elegans.

• Journal of Environmental Science International
• /
• v.5 no.1
• /
• pp.71-81
• /
• 1996

Direct Sky Blue-5B is an Azo dye known as general for staining of textile and leather, etc., and as materials which are difficult to be biodegraded in nature. The bacterium strain which could degrade direct Sky Blue-5B was isolated from activated sludge of dyeing factory and identified as Proteus sp. by experiment on morphological, cultural and biochemical characteristics, and so named Proteus sp. ST-1. The optimum condition of the strain for degradation of Sky Blue-5B were at about 35$^{\circ}C$ and PH 7~8. The strain had been capable of degradation with organic nitrogen effectively and had completely degraded 200mg/1 of the dye within 12hrs at 37$^{\circ}C$. The enzyme system related to degradation of Azo dye may be intracellular, and so degraded the dye after absorption into cell. The degradation products of Sky Blue-5B by Proton sp. 57-1 were analyzed by Gas Chromatography /Mass Spectrometry and Spectrophotomer, from this observation, it may be infered that the strain degraded the dye directly without any mediate.

• Membrane and Water Treatment
• /
• v.4 no.3
• /
• pp.203-214
• /
• 2013

Laboratory tests were performed to determine the efficiency of dye solution desalination by electrodialysis. The study involved anionic dye and mineral salt recovery by obtaining two streams from a salt and dye mixture - dye-rich solution and salt solution. A standard anion-exchange and cation-exchange membranes or monovalent selective anion-exchange membranes were used in the ED stack. It was found that the separation efficiency was strongly dependent on the dye molecular weight. The best results for standard ion-exchange membranes were achieved for the desalination of Direct Black solution. Furthermore, the obtained results implied that the application of monovalent selective anion-exchange membranes improved the recovery of dye and salt solutions - the dye concentration in the diluate remained constant irrespective of the molecular weight of anionic dyes, whereas the salt recovery remained very high (99.5%).

• Journal of the Korean Society of Clothing and Textiles
• /
• v.27 no.11
• /
• pp.1300-1306
• /
• 2003

Cotton fibers were treated, with 1, 2, 3, 4-butanetetracarboxylic acid (BTCA) which is formaldehyde-free reagent to impart durable press performance. The dyeability, dyeing rate, and diffusion coefficient, of BTCA treated cottons were compared to prove the changes of pore size structure using direct dyes and disperse dyes. Diffusion coefficients of BTCA treated cotton fibers were determined at acidic conditions to figure out the effect of swelling. Since the dyeability of BTCA treated cotton fibers dyed with direct dyes were reduced, it is considered that the dyeability to direct dyes is related to the quantity of residual large pores. But, the dyeability to disperse dyes were increased due to the less reduction of small pore sizes and the increase of hydrophobicity in BTCA treated cotton cellulose. The dyeability to direct dye and disperse dye were decreased more at acidic conditions than at neutral conditions. It seemed that the swelling of pores in the fiber were inhibited.

• Journal of Korean Society on Water Environment
• /
• v.26 no.6
• /
• pp.963-968
• /
• 2010

This study has carried out to evaluate the performance of direct and indirect oxidation electrode for the purpose of decolorization of Rhodamine B (RhB) in water. Four kinds of electrodes were used for comparison: Pt and JP202 (indirect oxidation electrode), Pb and boron doping diamond (BDD, direct oxidation electrode). The effect of applied current (0.5 ~ 2.5 A), electrolyte type (NaCl, KCl, HCl, $Na_2SO_4$ and $H_2SO_4$) and electrolyte concentration (0.5 ~ 2.5 g/L), solution pH (3 ~ 11) and initial RhB concentration (25 ~ 125 mg/L) were evaluated. Experimental results showed that RhB removal efficiency were increased with increase of current, NaCl dosage and decrease of the pH. However, the effect of operating parameter on the RhB removal were different with the electrode type. JP202 electrode was the best electrode from the point of view of performance and energy consumption. The order of removed RhB concentration per energy lie in: JP202>Pt>Pb>BDD.

• Textile Coloration and Finishing
• /
• v.21 no.6
• /
• pp.12-21
• /
• 2009

The dyeing property of direct-spinning type and seaisland type 0.2D micro polyester nonwoven fabrics was characterized by three disperse dyes (Dorosperse Red KFFB, Blue KGBR, Yellow KRL) at $120^{\circ}C$ and $130^{\circ}C$. Before and after reduction cleaning, dyeing fastness was evaluated and the thermomigaration after heat setting at $180^{\circ}C$ for 60 min were also evaluated. Direct-spinning type fabric showed better dyeing property, wash fastness, and light fastness, but worse rub fastness than seaisland type fabric. The dyeing property and fastness of direct-spinning type fabric increased at higher dyeing temperature, whereas seaisland type fabric exhibited lower dyeing fastness and the increase of thermomigration at higher dyeing temperature. Non-fixed dye in fiber surface was removed by reduction cleaning process, then dyeing fastness was improved and thermomigration decreased. The higher dye uptake of direct-spinning type non-woven fabric caused the increase of dye molecule migration from fiber internal to fiber surface, so this fabric showed larger thermomigration than seaisland type non-woven fabric.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.30 no.12 s.159
• /
• pp.1730-1736
• /
• 2006

To utilize hanji for fashion accessory efficiently, dyeability of Hanji should be improved. Though Hanji mostly consists of cellulose such as cotton and ramie, also has various impurities, and has the different internal and surface structure from textile materials. Because of them, Hanji might show different dyeing behavior. As physical properties of Hanji are reduced in wet condition, dyeing process would damage the physical properties of Hanji Therefore, in this study, dyeing properties of Hanji using direct dye were examined in comparison with cotton and ramie. Effect of dyeing on tensile strength, and bleeding of direct dye by water from Hanji, colorfastness to light were also estimated. While Hanji showed the maximun dye exhaustion at $25^{\circ}C$, cotton and ramie showed those at $60^{\circ}C$. Tensile strength of Hanji reduced after Hanji was dyed. When Hanji was dyed at $25^{\circ}C$, the more bleeding occurred than at higher dyeing temperature. Hanji which had higher K/S values were bled more than those had lower K/S value. Colorfastness to light of Hanji dyed with direct dye was not inferior to those of cotton and ramie.

• The Research Journal of the Costume Culture
• /
• v.11 no.3
• /
• pp.423-430
• /
• 2003

Cotton fabric md nylon fabric were chosen as base fabric specimens for dyeing using Japanese pagoda tree colorants through chitosan, treatment. With the chitosan treatment, the dye-uptake of the treated fabric increased. This treatment is also expected to be effective in terms of environment-friendliness. The effect of the dyeing methods, mordanting or non-mordanting, and chitosan treatment on the dye-uptake and air permeability of the treated fabrics was investigated. In case of cotton fabric, Al mordanted dyeing resulted in higher dye-uptake through the chitosan treatment. Therefore, the chitosan treatment is effective in this case. Japanese pagoda tree seems to have direct affinity for nylon fabric without the mordanting treatment. In case of cotton fabric, it seems that the cellulose molecules, colorants, and the chitosan make a complex, thereby reducing the air permeability. In case of nylon fabric, due to the fact the Japanese pagoda tree colorant molecules form direct physical bonding with the nylon molecules, it seems that there is not much of air permeability reduction.

• Textile Coloration and Finishing
• /
• v.21 no.5
• /
• pp.51-57
• /
• 2009

Since heavy metal pollution is a significant global environmental problem and very dangerous to human health, the improved methods for detecting heavy metals are required recently. Colorimetric chemosensors are now considered as one of the most effective analytical method used in the environment monitoring. New direct dyes having the function of colorimetric chemosensors were synthesized. When metal ions such as $Al^{3+}$, $Ca^{2+}$, $Cd^{2+}$, $Cr^{3+}$, $Cu^{2+}$, $Fe^{2+}$, $Fe^{3+}$, $Hg^{2+}$, $Li^+$, $Mg^{2+}$, $Na^+$, $Ni^{2+}$, $Pb^{2+}$ and $Zn^{2+}$ were added each solution of new direct dyes, the color of solution was changed and can be easily detected with naked eyes without expensive experimental equipment such as atomic absorption spectrometer (AAS) or inductively coupled plasma?mass spectrometer (ICP-MS). The new benzidine analogues were diazotized and reacted with couplers such as H-acid, J-acid, Chromotropic acid, Nevill-winther acid and gamma acid to synthesize new direct dyes. The structures of the new direct dyes were confirmed by high resolution mass spectrometer (FAB ionization) and evaluated with UV-Vis spectroscopy. The UV-VIS spectroscopy was measured for the dye solutions by adding various concentrations of metal ions. It was observed that the absorbance in UV-Vis spectra was changed as the heavy metal ions were added.

• Journal of the Korean Home Economics Association
• /
• v.35 no.3
• /
• pp.115-124
• /
• 1997

In this study, Water Repellent Finish was carried out before dyeing on cotton fabrics. It was aimed to improve on dyeing properties of cotton fabrics with direct dye. The results obtained were summerized as follows: 1. The K/S value of water repellent finished cotton fabrics increased. This phenomena in water repellent finished cotton fabrics were much more noticiable than unfinished cotton fabrics. 2. The color fastness(light, washing, and rubbing) of water repellent finished cotton-dyed were worse than those of unfinished cotton-dyed with direct dye. △E of water repellent finished cotton fabrics wasn't showed significant difference as compared with that of unfinished cotton fabrics. 3. The water repellency of finished cotton after dyeing got down from 100 to 70. That of finished-cotton before dyeing was 100. 4. Moisture regain, stiffness and weight of finished cotton fabrics were not almost differenciated with unfinished cotton fabrics. Moreover, the tensile strength of finished cotton fabrics was increased compared to that of unfinished cotton fabrics. As conclusion, according to the above results when the cotton fabrics were dyed with direct dye, it was much more effective that water repellent finished cotton fabrics were dyed rather than trational process, that is pre-dyeing after-finishing even if, by low liquor ratio. The physical properties of fabrics were maintained or increased.