• 한국인터넷방송통신학회논문지
• /
• 제13권6호
• /
• pp.79-85
• /
• 2013

이 논문에서는 먼저 디지털 하프토닝 영상을 생성하는 기존의 방법들과 DCT 변환에 대해서 설명한다. 그런후에 DCT 변환에 근간을 둔 새롭고 단순한 하프토닝 알고리즘을 제안한다. 이 논문은 제안한 알고리즘을 검정하기 위해서 실현 가능성 검증을 수행한다. 그래서 DCT 계수의 가중치를 조절하여 생성된 여러 가지 영상들을 평가하였다. 실험을 통해서 단순한 이상적인 계단 함수 형태의 가중치를 사용하는 것보다는 램프 함수 형태의 가중치를 사용하면 더 좋은 결과를 얻었다. 단순한 응용분야로서 MPEG 비디오에 제안한 알고리즘을 적용하여 하프토닝 비디오를 생성할 수 있다.

• 한국수자원학회논문집
• /
• 제33권1호
• /
• pp.39-50
• /
• 2000

일반적으로 동수역학 모형은 마찰인자(조도계수 또는 Chezy계수)와 와점성계수를 필요로 하고 수치계산에서 이들 계수의 갑은 통상 가정 또는 반복계산을 통하여 결정된다. 수치모형에서 와점성계수는 물리적인 확산뿐만 아니라 수치점성의 효과도 가지고 있어서 수치계산의 안정성에 영향을 미치므로 이들 계수의 일관된 결정방법이 필요하다. 수위 및 유량자료, 1차원 모형인 HEC-2와 NETWORK, 2차원 모형인 SMS를 이용하여 한강하류 구간에 대한 조도계수의 산정결과와 와점성 계수의 산정식이 제시되었으며 실측수위와 비교를 통해 검증되었다.

• Macromolecular Research
• /
• 제11권3호
• /
• pp.157-162
• /
• 2003

6FDA-based polyimides were prepared from the thermal imidization reaction of 6FDA with diamines of BAPAF, DAP, and DABA having a polar group of hydroxyL or carboxyl. Properties of the dense polyimide membranes were characterized and their gas permeation properties for H$_2$, $CO_2$, $O_2$, $N_2$, and CH$_4$ were investigated. Permeabilities, diffusion coefficients and diffusivity selectivities of polar group-containing polyimide membranes including 6FDA-BAPAF, 6FDA-DAP, and 6FDA-DABA polymer for the gases did not change largely. The separation properties of 6FDA-TrMPD polyimide membrane used as a reference polymer were compared with those of the polyimide membranes mentioned above. It was found that the polyimides of 6FDA-BAPAF, 6FDA-DAP, and 6FDA-DABA, which were soluble in alcohol or/and 2-methoxyethanol, could be applicable to the preparation of a dense composite membrane by dip-coating method.

• Journal of Pharmaceutical Investigation
• /
• 제22권1호
• /
• pp.63-68
• /
• 1992

An HPLC procedure with UV detection has been developed for the quantitation of flurbiprofen released into isopropyl myristate used as the receptor phase in an in vitro membraneless drug diffusion cell. The drug and the internal standard (oxaprozin) were extracted from isopropyl myristate with a mixture of dimethylsulfoxide:methanol:water (2:1:1) and quantitated using a reverse phase $C_{18}$ column. The chromatograms were completely free from interfering peaks, and the relative retention times of flurbiprofen and the internal standard were 4.9 and 6.8 min, respectively. Calibration plots were linear over the concentration range of $1-200\;{\mu}g/ml$ of flurbiprofen with correlation coefficients, all higher than 0.99. The mean intra-day precision and accuracy among three replicate sets of the assay in a day were 4.26 and 4.52%, respectively, whereas the mean inter-day precision and accuracy were 3.35 and 3.64%, respectively. The mean recovery of the drug was 92.5% over the calibration range. The method was simple, reliable and accurate for the quantitation of flurbiprofen in unpurified isopropyl myristate.

• Journal of Biosystems Engineering
• /
• 제31권5호
• /
• pp.410-415
• /
• 2006

This study was performed to develop thin layer drying equations for green rice. Thin layer drying tests of green rice were conducted at three temperature levels of 30, 40, $50^{\circ}C$ and two relative humidity levels of 30, 50% respectively. The measured moisture ratio were fitted to the selected four drying models (Page, Thompson, Simplified diffusion and Lewis model) using stepwise multiple regression analysis. The overall drying rate increased as the drying air temperature and as relative humidity was increased, but the effect of temperature increase was dominant. Half response time (Moisture ratio=0.5) of drying was affected by both drying temperature and relative humidity Drying rate was mainly affected by relative humidity at drying temperature of $50^{\circ}C$. The results of comparing coefficients of determination and root mean square error of moisture ratio for four drying models showed the Page model was found to ft adequately to all drying test data.

• Journal of Biosystems Engineering
• /
• 제22권1호
• /
• pp.11-20
• /
• 1997

Thin layer drying tests of short gain rough rice were conducted in an experimental dryer equiped with air conditioning unit. The drying tests were performed in triplicate at three air temperatures of $35^circ$, $45^circ$, $55^circ$, and three relative humidities of 40%, 55%, 70%, respectively. Previously published thin layer equations were reviewed and four different models widely used as thin layer drying equations for cereal grains were selected. The selected four models were Pages, simplified diffusion, Lewis's and Thompson's models. Experimental data were fitted to these equations using stepwise multiple regression analysis. The experimental constants involved in tow equations were represented as a function of temperature and relative humidity of drying air. The results of comparing coefficients of determination and root mean square errors of miosture ratio for low equations showed that Page's and Thompsons models were found to fit adequately to all drying test data with coefficient of determination of 0.99 or better and root mean square error of moisture ratio of 0.025.

• Journal of Biosystems Engineering
• /
• 제29권6호
• /
• pp.495-500
• /
• 2004

This study was performed to develop thin layer drying equations for low temperature. Thin layer drying tests of short grain rough rice were conducted at three low temperature levels of 15, 25, $35^{\circ}C$ and two relative humidity levels of 30, $50\%$, respectively. The measured moisture ratios were fitted to the selected four drying models (Page, Thompson, Simplified diffusion and Lewis model) using stepwise multiple regression analysis. The overall drying rate increased as the drying air temperature was increased and as relative humidity was decreased, but the effect of temperature increase was dominant. Half response time (Moisture ratio=0.5) of drying was affected by both drying temperature and relative humidity at drying temperature of below $25^{\circ}C$, but at $35^{\circ}C$ was mainly affected by drying temperature. The results of comparing coefficients of determination and root mean square error of moisture ratio for low drying models showed that Page model was found to fit adequately to all drying test data.

• Bulletin of the Korean Chemical Society
• /
• 제24권3호
• /
• pp.345-349
• /
• 2003

The quantity, process and kinetics of di-(2-ethylhexyl)phthalate (DEHP) migration in the 30/70 and 40/60 poly(vinylchloride) (PVC)/DEHP blends were investigated using gas chromatograph. A thin and flexible PVC sheet was soaked in surrounding medium (SM) of water/ethanol mixture and acetonitrile with constant stirring to release DEHP. By observed concentration of DEHP in the SM, it is found that acetonitrile is more intense in DEHP migration than water/ethanol mixture. In addition the amount of extracted DEHP is proportional to the leaching temperature and added ratio of DEHP. The behavior of DEHP migration from flexible PVC sheets was described by the Ficks's law with $2.72-10.1\;{times}\;10^{-10}$ cm²/s of the diffusion coefficients.

• Environmental Analysis Health and Toxicology
• /
• 제12권3_4호
• /
• pp.43-54
• /
• 1997

Species, doses and routes extrapolation can be sucessfully carried out by using a physiologically-based pharmacokinetic (PBPK) approach. And PBPK approach to assess risk of hazardous chemicals is reasonable whatever the exposure scenarios are happened. Both partitioning coefficients of chemical between tissue and blood and enzymatic metabolic rate constants are key parameters to build up the PBPK model. In this study, we tried to estimate in vitro metabolic rate constants using a special apparatus instead to measure the in vivo constants which are used to PBPK simulation since the in vitro tests are less expensive and more convenient than in vivo tests. For the purpose, we designed and tested the new system to measure continuously the headspace concentration of VOC. The newly designed system is composed with a diffusion chamber which generates gaseous substrate, a reaction vessel with a recirculating pump to establish a closed system, an autbmatic sampler from a gas phase, a gas chromatography to analyze the headspace. In addition, a cold water condenser is attached between the reaction vessel and pump to reduce the content of gaseous moisture which interferes with chemical analysis. To validate the newly developed methodology, in vitro metabolic rate constants of trichloroethylene (TCE) as a prototype VOC were estimated by simulating observed results with an ACSL program. The simulated results are consistent to those estimated by the other research groups. This finding suggests that our newly designed closed system may be a useful apparatus to estimate in vitro metabolic rate constants for VOC.

• Preventive Nutrition and Food Science
• /
• 제13권3호
• /
• pp.225-230
• /
• 2008

Onion slices were dehydrated in a single layer at drying air temperatures ranging from $50{\sim}70^{\circ}C$ in a laboratory scale convective hot-air dryer at an air velocity of 0.66 m/s. The effect of drying air temperature on the drying kinetic characteristics were determined. It was found that onion slices would dry within $210{\sim}460\;min$ under these drying conditions. Moisture transfer during dehydration was described by applying the Fick's diffusion model and the effective diffusivity changed between $1.345{\times}10^{-8}$ and $2.658{\times}10^{-8}\;m^2/s$. A non-linear regression procedure was used to fit 9 thin layer drying models available in the literature to the experimental drying curves. The Logarithmic model provided a better fit to the experimental drying data as compared to other models. Temperature dependency of the effective diffusivity during the hot-air drying process obeyed the Arrhenius relationship with estimated activation energy being 31.36 kJ/mol. The effect of the drying air temperature on the drying model constants and coefficients were also determined.