• Journal of Korean Society for Atmospheric Environment
• /
• v.26 no.6
• /
• pp.666-682
• /
• 2010

The forecasting system for Today's and Tomorrow's PM10 was developed based on the statistical model and the forecasting was performed at 9 AM to predict Today's 24 hour average PM10 concentration and at 5 PM to predict Tomorrow's 24 hour average PM10. The Today's forecasting model was operated based on measured air quality and meteorological data while Tomorrow's model was run by monitored data as well as the meteorological data calculated from the weather forecasting model such as MM5 (Mesoscale Meteorological Model version 5). The observed air quality data at ambient air quality monitoring stations as well as measured and forecasted meteorological data were reviewed to find the relationship with target PM10 concentrations by the regression analysis. The PM concentration, wind speed, precipitation rate, mixing height and dew-point deficit temperature were major variables to determine the level of PM10 and the wind direction at 500 hpa height was also a good indicator to identify the influence of long-range transport from other countries. The neural network, regression model, and decision tree method were used as the forecasting models to predict the class of a comprehensive air quality index and the final forecasting index was determined by the most frequent index among the three model's predicted indexes. The accuracy, false alarm rate, and probability of detection in Tomorrow's model were 72.4%, 0.0%, and 42.9% while those in Today's model were 80.8%, 12.5%, and 77.8%, respectively. The statistical model had the limitation to predict the rapid changing PM10 concentration by long-range transport from the outside of Korea and in this case the chemical transport model would be an alternative method.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.750-750
• /
• 2002

The Airship PKNU is a roughly 12 m (32 ft) long blimp, filled with helium, whose two-gasoline power(3hp per engine) are independently radio controlled. The motors and propellers can be tilted and are attached to the gondola through an axle and supporting braces. Four stabilizing fins are mounted at the tail of the airship. To fill in the helium, a valve is placed at the bottom of the hull. The inaugural flight was on jul. 31.2002 at the Pusan, S.korea Most environment monitoring system\ problem use satellite image. But, Low resolution satellite image (multi-spectral) : 1km ∼ 250 m ground resolutions is lows. So, detail information acquisition is hard at the complex terrain. High resolution satellite image (black and white) 30m : The ground resolution is high. But it is high price, visit cycle and delivery time is long So. We want make high accuracy airship photogrammetry system. This airship can catch picture Multi. spectral Aerial photographing (visible, Near infrared and thermal infrared), and High resolution (over 6million pixel). It can take atmosphere datum (Temperature (wet bulb, dew point, general), Pressure (static, dynamic), Humidity, wind speed). this airship is very Quickness that aircraft install time is lower than 30 minutes, it is compact and that conveyance is easy. High-capacity save image (628 cut per 1time (over 6million and 4band(R,G,B,NIR)) and this airship can save datum this High accuracy navigatin (position and rotate angle) by DGPS tech. and Gyro system. this airship will do monitor about red-tide, sea surface temperate, and CH-A, SS and etc.

• Journal of Korea Water Resources Association
• /
• v.33 no.2
• /
• pp.229-235
• /
• 2000

Characteristics of hail occurred during 1989-1998 is studied. Hail is observed mainly at west coast, southwest inland, and Taegwallyong. Average diameter of hailstone is 0.6 cm, and 70% of the occurrence frequency of hail is observed at west coast. During winter and spring, the wet -bulb zero height (WBZ) is low enough to prevent the melting process of hail. But the lack of available low-level moisture (mean mixing ratio in lowest 100 hPa) makes the size of hail small. As a result, smaller size hail is observed frequently over west coast. On the contrary, WBZ is higher during summer, it means that hail is melted before it reaches ground, but the size of hail is bigger. Thus the larger hail is observed mainly Taegwallyong during summer. Hail is observed from 1100 LST to 1500 LST over west coast and around 1800 LST over Taegwallyong. It suggest that thermally driven mesoscale circulations such as land-sea breeze and mountain ridge-valley circulation aid in the formation of hail. Upper and surface air temperature is related to formation of hailstorm. Before formation of hailstorm in November 1998, the upper air temperature decreases. And hails is observed in the spot of strong temperature and dew point temperature gradient coincidently.

• Journal of Conservation Science
• /
• v.33 no.4
• /
• pp.283-295
• /
• 2017

It is crucial to measure meteorological elements in relation to the biodeterioration of building cultural heritages. The Beopjusa and Seonamsa temples located respectively in Chungbuk and Jeonnam provinces, Korea, exhibit biological damage to the building cultural heritages and cause noticeable climatic differences. To compare biodeterioration environments of the abovementioned temples, 10 meteorological elements were observed, and particulate matter (TSP) was collected at each location. Furthermore, a correlation analysis was conducted between meteorological elements, and between meteorological elements and TSP. The local meteorology at Beopjusa temple characteristically showcased high total horizontal radiation, UV radiation, evaporation, wind speed, and TSP concentration, whereas, that at Seonamsa temple showcased high temperature, humidity, dew point temperature, air pressure, precipitation and number of days with precipitation. An elemental analysis of TSP revealed the presence of sae-salts at Seonamsa temple, and compared to that of Beopjusa temple, the monthly frequencies of biogenic aerosol and Fe-containing particles were higher. The correlation analysis showed that wind speed and humidity were major meteorological factors at Beopjusa and Seonamsa temples, respectively. Subsequently, the characteristics of the local meteorology at Seonamsa temple are expected to affect the biological damage of the building cultural heritages, which is favorable for the growth of various organisms.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.6
• /
• pp.288-296
• /
• 2019

Radiation cooling has used ceilings or floors as cooling surfaces. In such cases, to avoid moisture condensation on the surface, the surface temperature needs be higher than the dew point temperature or an additional dehumidifier is added. In this study, with a goal for residential application, intentional moisture condensation on the cooling surface was attempted, which increased the cooling capacity and improved the indoor comfortness. This method included two separate refrigeration cycles - convection-type dehumidifying cycle and the panel cooling cycle. Test results on the panel cooling cycle showed that, at the standard outdoor ($35^{\circ}C/24^{\circ}C$) and indoor ($27^{\circ}C/19.5^{\circ}C$) condition, the refrigerant flow rate was 8.8 kg/h, condensation temperature was $51^{\circ}C$, evaporation temperature was $8.8^{\circ}C$, cooling capacity was 376 W and COP was 1.75. Furthermore, the panel temperature was uniform within $1^{\circ}C$ (between $13^{\circ}C$ and $14^{\circ}C$). As the relative humidity decreased, the cooling capacity decreased. However, the power consumption remained approximately constant. In the convection-type dehumidification cycle, the refrigerant flow rate was 21.1 kg/h, condensation temperature was $61^{\circ}C$, evaporation temperature was $5.0^{\circ}C$, cooling capacity was 949 W and COP was 2.11 at the standard air condition. When both the radiation panel cooling and the dehumidification cycle operated simultaneously, the cooling capacity of the radiation panel cycle was 333 W and that of the dehumidification cycle was 894 W, and the COP was 1.89. As the fan flow rate decreased, both the cooling capacity of the radiation panel and the dehumidification cycle decreased, with that of the dehumidification cycle decreasing at a higher rate. Finally, a possible control logic depending on the change of the cooling load was proposed based on the results of the present study.

• Journal of Korean Society of Forest Science
• /
• v.103 no.3
• /
• pp.483-489
• /
• 2014

This study aimed at a scientific examination of the relationship between NVOCs concentration and the physical environment of red pine forest in spring season. Atmospheric NVOC samples in red pine forest was collected through five trials conducted from March to May 2013, using Tanax-Ta-charged disposable tubes and mini-pumps. At each trial, measurements were taken at three different points in daytime (sunrise, southing and sunset). For maximum accuracy, two tubes were used for each measurement at the same location, and the mean value was used for analysis. Compound analysis on the NVOC samples was done using the HS-SPME method and GC-MS. Analysis of the relationship between NVOC and the physical forest environment found higher concentrations of most substances, including ${\alpha}$-pinene and ${\beta}$-pinene, with higher temperature, dew point, and lower concentrations with higher wind velocity. The findings of this study offer scientific evidence which can inform the creation of 'healing forests' and 'recreational forests' as well as forest environment in general, helping to promote public health and recreational activities.

• Journal of Astronomy and Space Sciences
• /
• v.24 no.4
• /
• pp.339-348
• /
• 2007

KASINICS (Korea Astronomy and Space Science Institute Near Infrared Camera System) is equipped with a InSb array which can observe $1-5\;{\mu}m$ bands in near-infrared. The absorption and emission by telluric water vapor becomes serious in the bands longer than $3\;{\mu}m$. We measured PWV (precipitable Water Vapor) levels above Bohyusan Optical Astronomy Observatory and Sobaeksan Optical Astronomy Observatory from July 2006 to August 2007 using the GPS PWV measurement system of KASI. We found that monthly averaged PWVs are lower than the prediction using dew-point temperature and as low as above Kitt Peak from September to February.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.2
• /
• pp.493-500
• /
• 2011

Recently, there has been an increase in the number of disaster victims locally due to climate change and a variety of frequently occurring natural disasters. The damage caused by abrupt weather change in local area by typical weather forecasting techniques is very limited and difficult. Recently local area weather monitoring system using wireless sensor network technology has been very actively studied. Thus an IEEE 802.15.4-based weather field server to measure and monitor the local weather changes was designed and developed in this study. The proposed weather field server utilizes a wireless sensor node and weather sensors to collect weather information such as temperature, humidity, illumination, dew point, barometric pressure, and water level. The integrated weather sensor board was designed to respond quickly to weather changes, and provide feedback to the server PC. Each weather information is analyzed in the server PC to establish a program to monitor and analyze the local area or the area of abrupt climate change in order to provide warning signals in case of disaster events in local.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.6 no.3
• /
• pp.171-178
• /
• 2008

Metal filter elements were newly introduced to the high temperature filter(HTF) system in the low- and intermediate-level radioactive waste vitrification plant. In order to evaluate the performance of various metal materials as filter media, elements made of AISI 316L, AISI 904L, and Inconel 600 were included to the test set of filter elements. At the visual inspection to the elements performed after completion of each test, a few dark spots were observed on the surface of some elements. Especially they were found much more at the AISI 316L elements than others. To check the dark spots are the corrosion phenomena or not, two kinds of analyses were performed to the tested filter elements. Firstly, the surfaces or the cross sections of filter specimens cut out from both normal area and dark spot area of elements were analyzed by SEM/EDS. The results showed that the dark spots were not evidences of corrosion but the deposition of sodium, sulfur and silica compounds volatilized from waste or molten glass. Secondly, the ring tensile strength were analyzed for the ring-shape filter specimens cut out from each kind of element. The result obtained from the strength tested showed no evidence of corrosion as well. Conclusionally, depending on the two kinds of analysis, no evidences of corrosion were found at the tested metal filter elements. But the dark spots formed on the surface could reduce the effective filtering area and increase the overall pressure drop of HTF system. Thus, continuous heating inside filter housing up to dew point will be required normally. And a few long-period test should be followed for the exact evaluation of corrosion of the metal filter elements.

• Journal of the Korean earth science society
• /
• v.36 no.6
• /
• pp.567-579
• /
• 2015

The accurate simulation of micro-scale weather phenomena such as fog using the mesoscale meteorological models is a very complex task. Especially, the uncertainty arisen from initial input data of the numerical models has a decisive effect on the accuracy of numerical models. The data assimilation is required to reduce the uncertainty of initial input data. In this study, the limitation of the mesoscale meteorological model was verified by WRF (Weather Research and Forecasting) model for a summer fog event around the Nakdong river in Korea. The sensitivity analyses of simulation accuracy from the numerical model were conducted using two different initial and boundary conditions: KLAPS (Korea Local Analysis and Prediction System) and LDAPS (Local Data Assimilation and Prediction System) data. In addition, the improvement of numerical model performance by FDDA (Four-Dimensional Data Assimilation) using the observational data from AWS (Automatic Weather System) was investigated. The result of sensitivity analysis showed that the accuracy of simulated air temperature, dew point temperature, and relative humidity with LDAPS data was higher than those of KLAPS, but the accuracy of the wind speed of LDAPS was lower than that of KLAPS. Significant difference was found in case of relative humidity where RMSE (Root Mean Square Error) for LDAPS and KLAPS was 15.7 and 35.6%, respectively. The RMSE for air temperature, wind speed, and relative humidity was improved by approximately $0.3^{\circ}C$, $0.2m\;s^{-1}$, and 2.2%, respectively after incorporating the FDDA.