• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.1
• /
• pp.45-52
• /
• 2021

The space vector control based voltage control method for a three-phase PWM rectifier requires a lot of effort to design an optimal switching pattern since a switching pattern for the switching section must be designed. In this study, a D-Q control based SPWM output voltage control algorithm was studied for the three-phase six-pulse CVS type rectifier. In the output voltage control algorithm, three-phase reference signals are obtained from the D-Q transformation based on the space vector representation method, instead of the switching pattern, SPWM method is used to generate rectifier switching control signals. Next, a three-phase six-pulse CVS PWM rectifier based on D-Q transformation and SPWM was modeled using EMTP-RV. Finally, the validity of the D-Q control-based SPWM voltage control algorithm was confirmed by comparing the output voltage waveform obtained through EMTP-RV simulation works with a reference value and confirming that the output voltage accurately follows the reference voltage.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.25 no.1
• /
• pp.54-60
• /
• 2020

A digital current control scheme using virtual d-q transformation for a boost single-phase power factor correction (PFC) converter is proposed. The use of virtual d-q transformation in single-phase power converters is known to improve current control performance. However, the conventional virtual d-q transformation-based digital current control scheme cannot be directly applied to the boost single-phase PFC converter because the current and average voltage waveforms of the inductor used in the converter are not sinusoidal. To cope with this problem, this study proposes a virtual sinusoidal signal generation method that converts the current and average voltage waveform of the inductor into a sinusoidal waveform synchronized with the grid. Simulation and experimental results are provided to show that the virtual d-q transformation-based digital current control is successfully applied to the boost single-phase PFC converter with the aid of the proposed virtual sinusoidal signal generation method.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.9 no.4
• /
• pp.397-404
• /
• 2004

This paper proposes a variable speed control scheme of grid-connected wind power generation systems using cage-type induction generators. The induction generator is operated in indirect vector control mode, where the d-axis current controls the excitation level and the q-axis current controls the generator torque, by which the speed of the induction generator is controlled according to the variation of the wind speed In order to produce the maximum output power. The generated power flows into the utility grid through the back-to-back PWM converter. The line-side converter controls the dc link voltage by the q-axis current control and can control the line-side power factor by the d-axis current control. Experimental results are shown to verify the validity of the proposed scheme.

• Journal of Korea Multimedia Society
• /
• v.15 no.3
• /
• pp.345-355
• /
• 2012

The WiMedia Alliance has specified a Distributed Medium Access Control (D-MAC)/WUSB protocol based on UWB for high speed wireless home networks and WPANs. In this paper, we propose a novel SoQ-based cooperative communication protocol adaptive to current UWB link transmission rate and QoS measure. The proposed SoQ-based cooperative communication protocol has compatibility with current WiMedia D-MAC/Wireless USB standard and is executed at each device according to a SoQ-based Relay Node Selection (RNS) criterion.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.6
• /
• pp.1324-1329
• /
• 2013

The WiMedia Alliance has specified a Distributed Medium Access Control (D-MAC) protocol based on UWB for high speed wireless home networks and WPANs. In this paper, firstly, the fair SoQ-based Distributed Reservation Protocol (DRP) for D-MAC is analyzed. And a novel SoQ-based relay transmission protocol is proposed to overcome DRP conflicts fast. In the proposed protocol, each device executes the Satisfaction of QoS (SoQ) time slot allocation algorithm independently. And, in order to give the loser device due to DRP conflicts another chance to maintain QoS resources, the proposed relay transmission protocol helps the device reserve another indirect link maintaining the required QoS resources via a relay node.

• Wind and Structures
• /
• v.30 no.5
• /
• pp.533-546
• /
• 2020

Large Eddy Simulation (LES) is used to study the effects of steady slot suction on the aerodynamic forces of and flow around a wall-mounted finite-length square cylinder. The aspect ratio H/d of the tested cylinder is 5, where H and d are the cylinder height and width, respectively. The Reynolds number based on free-stream oncoming flow velocity U_∞ and d is 2.78×10⁴. The suction slot locates near the leading edge of the free end, with a width of 0.025d and a length of 0.9d. The suction coefficient Q (= U_s/U_∞) is varied as Q = 0, 1 and 3, where U_s is the velocity at the entrance of the suction slot. It is found that the free-end steady slot suction can effectively suppress the aerodynamic forces of the model. The maximum reduction of aerodynamic forces occurs at Q = 1, with the time-mean drag, fluctuating drag, and fluctuating lift reduced by 3.75%, 19.08%, 40.91%, respectively. For Q = 3, all aerodynamic forces are still smaller than those for Q = 0 (uncontrolled case), but obviously higher than those for Q = 1. The involved control mechanism is successfully revealed, based on the comparison of the flow around cylinder free end and the near wake for the three tested Q values.

• Journal of the Korean Society for Precision Engineering
• /
• v.18 no.10
• /
• pp.184-193
• /
• 2001

In vector control technique, stator currents of an induction motor are transformed to equivalent d-q currents in a reference frame consist of d and q axis, each of which is coincide with flux and torque direction respectively. Since the current in q-axis is related to the torque in a synchronously rotating frame, torque is estimated as a function of q-axis current and flux. In this paper, a method to estimate torque of an induction motor based on the measurement of 3-phase currents and rotating velocity of a rotor is presented. Graphic-programming is used to measure signals, to estimate the torque and to show the result in the form of user friendly graph in window environment. To stabilize the fluctuation of estimated torque caused from the small measurement error of the rotor velocity, the stator current is reconstructed in a program based on measured signals. The experimental results executed under the velocity of 500 rpm, 1500 rpm without load and 1500 rpm with load show that the proposed method estimates the torque very well.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.4
• /
• pp.692-700
• /
• 2012

The WiMedia Alliance has specified a Distributed Medium Access Control (D-MAC) protocol based on UWB for high speed wireless home networks and Wireless USB. In this paper, firstly, the fair SoQ-based Distributed Reservation Protocol (DRP) for D-MAC is analyzed. And a novel SoQ-based relay transmission protocol is proposed to overcome DRP conflicts fast. In the proposed protocol, each device executes the Satisfaction of QoS (SoQ) time slot allocation algorithm independently. And, in order to give the loser device due to DRP conflicts another chance to maintain QoS resources, the proposed relay transmission protocol helps the device reserve another indirect link maintaining the required QoS resources via a relay node.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.8
• /
• pp.67-73
• /
• 2009

The magnetic saliency effect in surface-mounted permanent-magnet (SMPM) motors on the torque control at high speeds is first presented and analyzed in this paper. The d- and q- axes impedance are measured by proposed State-Filter. Measurement of the d- and q- axes impedance difference is performed to prove the existence of the magnetic saliency. Then, the saliency effects on the torque control performance in the flux weakening region are discussed. Based on the developed motor modeling with the reluctance torque, the proposed control adjusts the d- and q-axis current toward the operating point to track the commanded torque. The feasibility of the presented idea is verified by experimental results on a commercial 600[W] SMPM motor.

• ETRI Journal
• /
• v.38 no.1
• /
• pp.185-194
• /
• 2016

In this paper, a novel rate control scheme for low delay video coding of High Efficiency Video Coding (HEVC) is proposed. The proposed scheme is developed by considering a new temporal prediction structure of HEVC. In the proposed scheme, the relationship between bit rate and quantization step is exploited firstly to formulate an accurate quadratic rate-quantization (R-Q) model. Secondly, a method of determining the quantization parameters (QPs) for the first frames within a group of pictures is proposed. Thirdly, an accurate frame-level bit allocation method is proposed for HEVC. Finally, based on the proposed R-Q model and the target bit allocated for the frame, the QPs are predicted for coding tree units by using rate-distortion (R-D) optimization. We compare our scheme against that of three other state-of-the-art rate control schemes. Experimental results show that the proposed rate control scheme can increase the Bjøntegaard delta peak signal-to-noise ratio by 0.65 dB and 0.09 dB on average compared with the JCTVC-I0094 and JCTVC-M0036 schemes, respectively, both of which have been implemented in an HEVC test model encoder; furthermore, the proposed scheme achieves a similar R-D performance to Wang's scheme, as well as obtaining the smallest bit rate mismatch error of all the schemes.