• Clinical and Experimental Reproductive Medicine
• /
• v.49 no.3
• /
• pp.202-209
• /
• 2022

Objective: The aim of this study was to assess the correlation of oocyte number with serum anti-Müllerian hormone (AMH) levels measured by two automated methods (Access or Elecsys) in fresh stimulated in vitro fertilization (IVF) cycles. Methods: In this retrospective study at a university hospital, data were collected from 243 fresh stimulated IVF cycles performed from August 2016 to December 2020. The serum AMH level was measured by Access in 120 cycles and by Elecsys in 123 cycles. The cut-off of serum AMH for prediction of poor responders (three or fewer oocytes) or high responders (15 or more oocytes) was calculated by the receiver operating characteristic curve analysis. Results: For the two automated methods, the following equations were derived: total oocyte number=2.378+1.418×(Access-AMH) (r=0.645, p<0.001) and total oocyte number=2.417+2.163×(Elecsys-AMH) (r=0.686, p<0.001). The following combined equation could be derived: (Access-AMH)=0.028+1.525×(Elecsys-AMH). To predict poor responders, the cut-off of Access-AMH was 1.215 ng/mL (area under the curve [AUC], 0.807; 95% confidence interval [CI], 0.730-0.884; p<0.001), and the cut-off of Elecsys-AMH was 1.095 ng/mL (AUC, 0.848; 95% CI, 0.773-0.923; p<0.001). To predict high responders, the cut-off of Access-AMH was 3.450 ng/mL (AUC, 0.922; 95% CI, 0.862-0.981; p<0.001), and the cut-off of Elecsys-AMH was 2.500 ng/mL (AUC, 0.884; 95% CI, 0.778-0.991; p<0.001). Conclusion: Both automated methods for serum AMH measurement showed a good correlation with oocyte number and good performance for predicting poor and high responders in fresh stimulated IVF cycles. The Access method usually yielded higher measured serum AMH levels than the Elecsys method.

• Journal of Convergence for Information Technology
• /
• v.9 no.6
• /
• pp.175-182
• /
• 2019

This study was conducted to test the assessment validity and examine the cut-off scores for driving risk as a part of the Self-report Assessment Forecasting Elderly Driving Risk (SAFE-DR) development project. The 132 senior drivers were categorized as either risky of 58 or safe of 74 drivers through the Drivers 65 Plus. Based on this initial assessment, we analyzed the risk prediction cut-offs. Furthermore, we tested the construct, content, and predictive validity. The cut-off score for the prediction of driving risk was found to be 74.5 points. The positive predictive value was 88.6%, and the negative predictive value was 86.3% about the cut-off score, signifying an excellent level of discrimination. Convergent validity, nomological validity, and content validity were found to be appropriate. Therefore, this study confirms that SAFE-DR is an appropriate assessment that can be used to screen dangerous elderly drivers.

• Korean Journal of Child Studies
• /
• v.25 no.3
• /
• pp.87-99
• /
• 2004

The subjects of this investigation were 393 fourth and fifth graders from two elementary schools in Seoul and parents of these children. The level of fathers' emotional separation from the family of origin was higher than that of mothers'. Mothers were more warm acceptant and rejective restrictive than fathers; fathers were more permissive neglectful than mothers. Both fathers and mothers were more rejective restrictive of girls than of boys. Mothers with high scores in emotional separation from family of origin were more warm acceptant to their children and less rejective restrictive than those with low scores. Fathers with high scores in emotional cut off from the family of origin were more permissive neglectful behavior of their children than fathers with low scores.

• Physical Therapy Korea
• /
• v.23 no.4
• /
• pp.63-70
• /
• 2016

Background: The Pediatric Balance Scale (PBS) and the Fullerton Advanced Balance (FAB) scale were used to assess balance function in patients with balance problem. These multidimensional clinical balance scales provide information about potential risk factors for falls. Objects: The purpose of this study was to investigate and compare the predictive properties of the PBS and FAB scales relative to fall risk in children with cerebral palsy (CP) using a receiver operating characteristic analysis. Methods: In total, 49 children with CP (boy=21, girl=28) who were diagnosed with level 1 or 2 according to the Gross Motor Function Classification System participated in this study. The PBS and FAB were performed, and verified cut-off score, sensitivity, specificity, and the area of under the curve (AUC). Results: In this study, the PBS scale was as a predictive measure of fall risk, but the FAB was not significant in children with CP. A cut-off score of 45.5 points provided optimal sensitivity of .90 and specificity of .69 on the PBS, and a cut-off score of 21.5 points provided optimal sensitivity of .90 and specificity of .62 on the FAB. Both scales showed moderately accurate of AUC with .79 and .76, respectively. Conclusion: The PBS is a useful screening tool for predicting fall risk in children with cerebral palsy, and those who score 45.5 or lower indicate a high risk for falls and are in need of balance intervention.

• The Korean Journal of Food And Nutrition
• /
• v.21 no.1
• /
• pp.28-34
• /
• 2008

This study was performed in an effort to standardize the quality of fresh-cut products. Here, consumers' perceptions of fresh-cut products were surveyed to determine the quality factors in preparing quality standards for fresh-cut products. According to the surveys, freshness was the most important factor for consumers when choosing fresh-cut products at the market. Secondary indicators of good quality, i.e., "sensory qualities," were determined to be vibrant color, clean taste, nice feel, neat presentation, etc., as well as knowledge of whether it was organically grown. Off-odors decreased a product's marketability. Likewise, the more wilted or brown it appeared, the less a product was desired. From the results, the quality control indices for fresh-cut products were derived as freshness, discoloration, off-flavor, uniformity, prohibition of adulteration by alien substances, packaging and labeling. The quality of fresh-cut lettuce samples was measured against three storage temperatures: $20^{\circ}C,\;10^{\circ}C$ and $5^{\circ}C$. Sensory quality evaluations revealed the following: produce stored at $20^{\circ}C$ lost its marketability in less than one day; produce stored at $10^{\circ}C$ lost its marketability in less than two days; on the other hand, produced stored at $5^{\circ}C$, maintained its marketability for six days. At these respective points, browning started to occur around cut areas, and increased gradually once it began. Vitamin C content decreased with storage time, but storage at $5^{\circ}C$ maintained vitamin content the longest duration. Finally, further examinations were performed on the sensory qualities of fresh-cut lettuce samples at four levels of increased browning. Up to the third level, the product score for marketability was 5.6.

• Geotechnical Engineering
• /
• v.12 no.5
• /
• pp.5-16
• /
• 1996

When braced excavation with temporary retaining wall installation, is performed in loose sand with high ground water level boiling may be induced and considerable damage on the excavation works and structures in the vicinity can take place. Recently, for the purpose of reinforcement of ground and cut-off of ground water behind the temporary retaining wall, high pressure jet grouting is widely used. The purpose of this paper is to investigate the effects of jet grouting on ground reinforcement and cut -off of the ground water behind temporary retaining walls for braced excavation. A series of both laboratory and field tests has been performed. The test results show that high pressure jet grouting has sufficient effects on reinforcement of stiffness of ground and retaining wall. The permeability of the improved ground was 10-f_ 10-3cm l s smaller than those of the original ground. Therefore, the effect on cut off of ground water behind temporary retaining walls could be improved by high pressure jet grouting method.

• Transactions on Electrical and Electronic Materials
• /
• v.17 no.3
• /
• pp.178-181
• /
• 2016

In this study a coating experiment was performed to fabricate blue light cut films, which represent a 390~430 nm cut off rate of more than 40% and a transmittance rate of more than 90%, using a roll-to-roll nano micro coating system. The study also analyzed the characteristics of the blue light cut films. Thus, the hardness, which is more than 3H, is ensured through fabricating films using a Sol-Gel process that will determine the proper hardness level. Also, the experiment shows excellent results by cutting blue light through a mixing blue light powder.

• KIEAE Journal
• /
• v.14 no.1
• /
• pp.15-22
• /
• 2014

Among the various building envelope elements, the glass area takes up the largest portion in the office building design. However, a large area of glass can cause problems such as excessive solar radiation, thermal comfort, and glare. Thus it is important to install the glass area to an appropriate level, and control solar radiation and inflow of daylight with blind devices. This study aims to improve the visual performance of the work plane through the automatic control of the venetian blinds. A total of eight kinds of control strategies were chosen; Case 1 does not control the blinds, Case 2 with the blind slats fixed at the angle of 0 degree, Case 3 to 6 using the existing blind control programs, and Case 7 and 8 with improved blind control. Case 3 with 90 degrees had the best energy performance, but the average indoor illuminance was 113lux, which is below the standards. Cases 4 and 5 showed higher levels of interior daylight illuminance with the average of 281lux and 403lux respectively. However, the fixed angles may have difficulties controlling excessive direct sunlight coming into the room and may cause glare. Cases 6 and 7 used sun tracking angle control and cut-off angle control, and the average interior illuminance was measured 250lux and 385lux respectively. Case 8 used the cut-off angle control in an hourly manner, satisfying the standard illuminance of 400lux with an average interior illuminance of 561lux. It was evaluated to be the best method to control direct solar radiation and to guarantee proper level of interior illumination.

• Tuberculosis and Respiratory Diseases
• /
• v.47 no.1
• /
• pp.50-56
• /
• 1999

Background : Pleural effusion is a common clinical problem and many clinical and laboratory evaluations, such as tumor marks, have been studied to discriminate malignant pleural fluid from benign pleural fluid. However their usefulness in the diagnosis of pleural effusion is still not established fully. We studied the diagnostic value of cyfra 21-1 in diagnosis of malignant pleural effusion. Methods: Pleural fluid was obtained from 45 patients with malignant diseases(32 lung cancer patients, 13 metastatic malignant diseases) and 47 patients with benign diseases. The level of cyfra 21-1 in the pleural fluid and serum were determined using a CYFRA 21-1 enzyme immunoassay kit(Cis-Bio International Co.). The t-test was used for comparison between two diseases groups and receiver operating characteristic(ROC) curves were constructed by calculating the sensitivities and specificities of the cyfra 21-1 at several points to determine the diagnostic accuracy of the cyfra 21-1. Results: In patients with primary lung cancer, the level of cyfra 21-1 in the pleural fluid was significantly higher than those of patients with benign diseases and had positive correlations between the level of cyfra 21-1 in the pleural fluid and serum levels. In the ROC curve analysis of the pleural fluid, the curve for primary lung cancer group was located closer to the left upper comer and the cut off value, sensitivity and specificity of the cyfra 21-1 of the primary lung cancer group was determined as 22.25ng/ml, 81.8% and 78.7% respectively. Conclusions: Our data indicates that the measurement of cyfra 21-1 level in pleural effusion has useful diagnostic value to discriminate malignant pleural effusion in primary lung cancer from benign pleural effusion.

• 유체기계공업학회:학술대회논문집
• /
• 1998.12a
• /
• pp.105-114
• /
• 1998

Flow field and near-field noise of a centrifugal fan has been studied with an efrcient compressible method and STAR-CD. The flow field of the centrifugal fan is assumed two-dimensional. Most of the compressible studies has been done by inviscid solver because viscous simulation shows little difference. The near field noise is estimated in term s of sound pressure level in frequency domain transformed from the computed pressure fluctuations using FFT. The simulation has been done on various design elements such as impeller blade shapes, the number of blades and cut-off clearance. The comparison shows that the number of blades has a significant effect on near-field noise without losing aerodynamic performance.